The objective of this work is to determine the sugar profiles in commercial fruit juices, and to obtain chemometric characteristics. Sugar compositions of fruit juices were determined by HPLC-RID and GC-FID via methoxymation and trimethylsilylation with BSTFA. The appearance of multiple peaks in GC analysis for carbohydrates was disadvantageous as described in earlier literatures. Fructose, glucose, and sucrose were major carbohydrates in most fruit juices. Glucose/fructose ratios obtained by GC were lower than those by HPLC. Orange juices are similar to pineapple juices in the sugar profiles. However, grape juices are characterized by its lower or no detectable sucrose content. In addition, it was also found that unsweeten juices contained considerable level of sucrose. Chemometric technique such as principal components analysis was applied to provide an overview of the distinguishability of fruit juices based on HPLC or GC data. Principal components plot showed that different fruit juices grouped into distinct cluster. Principal components analysis was very useful in fruit juices industry for many aspects such as pattern recognition, detection of adulterants, and quality evaluation.

Response surface method was applied to the predicting optimum conditions of benzene synthesis for radiocarbon dating. The weight of carbon dioxide, the temperature of lithium container for producing acetylene and the activation temperature of catalyst which was used for the cyclization of acetylene to benzene were used as experimental factors. The yields of benzene synthesis were measured from twelve experiments which were carried out under various experimental conditions. The polynomial equation was obtained by using three experimental factors and yields. The validity of polynomial equation was confirmed by comparing the calculated yields with the experimental ones.

Isotope ratios of K, Ca, Cr and Fe are measured at cool plasma condition generated using high carrier flow rate and relatively low RF power of 900 W. Background molecular ions are suppressed to below 100 counts which give isobaric interference to the analytes. The background ions show different attenuation characteristics at increased carrier flow rate and hence for each element different carrier flow rate should be used to measure isotope ratios without isobaric interference. Isotope ratios are measured at both scan and peak-hopping modes and compared with certified or accepted ratios. The measured isotope ratios show some mass discrimination against low mass due to low ion energy induced from a copper shield to eliminate capacitive coupling of plasma with load coil.

In an effort to enhance the lipophilicities, thereby, the penetration into the cell membrane and to increase the antitumor activities of modified derivatives of 2',3'-didehydro-3'-deoxythymidine (d4T, 1), derivatives of 1 were designed and synthesized. Starting from thymidine, 1, 2',3'-didehydro-3'-deoxythymidine-5'-phosphate, disodium salt (d4T-p, 7), and two nicotinate esters of 1; 2',3'-didehydro-3'-deoxy-5'-O-(3-pyridinylcarbonyl)thymidine (d4T-NA, 5) and 2',3'-didehydro-3'-deoxy-5'-phosphoryl-O-(3-pyridinylcarbonyl)thymidine (d4T-p-NA, 8) were synthesized. The lipophilicities of the synthesized compounds were measured by P-values and antitumor activities of those were estimated against mouse leukemia P388, murine mammary carcinoma FM3A, and human histiocytic lymphoma U937 tumor cells in vitro. Although the lipophilicities of the nicotinate esters, 5 and 8 were increased 2.75- and 9.71-fold relative to that of 1 and 7, respectively, the synthesized compounds, 1, 5, 7, and 8 were found to be inactive against P388 and FM3A cells except weak antitumor activity against U937 cell.

In order to study the dielectric properties of the oriental lacquer films, three different films have been prepared differing purification and curing procedures. Dielectric properties were measured in the frequency range of 1 Hz to 105 Hz at various temperatures between - 50 ℃ and 150 ℃. The DEA using 1 Hz showed that glass transition and secondary relaxation temperatures of oriental lacquer film are very time dependent. In addition, the frequency-independent negative peak between 25 ℃ and 45 ℃ was observed, which could represent the formation of crosslink by laccase enzyme during heating. On the contrary, the high temperature cured film showed a hardly noticeable negative peak at the temperature range. The relationship between thermodynamic properties and chemical structures has been discussed based on the analysis of the dielectric relaxation behavior using the Cole-Cole plot and the dielectric relaxation intensity.

The interface between two different polymers is characterized theoretically by using a model. This model is based on the assumption that the monomeric friction coefficients of the two polymers are identical but a strong function of the matrix composition. This model predicts that the concentration profiles are highly asymmetric with substantial swelling of the slower-diffusing component by the faster component. To predict the behavior of interdiffusion, three quantities are used: distance of interface Z*(t) due to the swelling, interfacial width W(t) which is most sensitive to the detailed composition profiling, and mass transport M(t) due to interdiffusion. It is found that the more dissimilar polymer pairs, the faster the movement of the interface, the quicker its interfacial width saturates to a limiting value and the slower its mass transport. These results are in qualitative agreement with some experiments.

Monofluoroiron(Ⅲ) tetraphenylporphyrin, Fe(TPP)F, and difluoroiron(Ⅲ) tetraphenylporphyrin, [Fe(TPP)F2]- were generated in a various non-aqueous solvents by the reaction between Fe(TPP)Cl and tetrabutylammonium fluoride TBAF 3H2O. Formation of the these complexes was detected by the appearance of the ν(F-Fe) (ν, stretching vibration) at 506 cm-1 for Fe(TPP)F and the ν(F-Fe-F) at 448 cm-1 for [Fe(TPP)F2]-, simultaneously, with 441.6 nm excitation by Resonance Raman (RR) spectroscopy. These assignments were confirmed by observed frequency shifts due to 56Fe/54Fe and TPP/TPP-d8/TPP-N15 isotopic substitutions. Difluoroiron complex is an iron(Ⅲ) high-spin complex with the oxidation sensitive band at 1347 cm-1 for ν4 and core size/spin state sensitive band at 1541 cm-1 for ν2.

5-Nitrouracil and 5-nitrouridine derivatives which C-2 and C-4 oxo-groups of the pyrimidine base were replaced by thio groups were synthesized. The lipophilicities of thiopyrimidine bases were enhanced significantly as indicated by P-values. Oxygen-sulfur exchange leading to 2-thiouracil (2) and 2,4-dithiouracil (3) were associated with 1.4- and 2.6-fold increase in P-value relative to that of uracil (1). The P-values of 5-nitro-2-thiouracil (5) and 5-nitro-2,4-dithiouracil (6) were increased 13.2- and 79.8-fold relative to that of 5-nitrouracil (4). Most of the 5-nitrothiopyrimidine bases and their nucleosides were found to be moderately active against Staphylococcus aureus and Escherichia coli except 5-nitrouracil (4).

The influence of cyclic treatments with H2O2/DIW (1 : 10) and HF/DIW (1 : 100) on the roughness of silicon surface in the wet chemical processing was investigated by atomic force microscopy (AFM). During the step of the SC-1 cleaning, there is a large increase in roughness on the silicon surface which will result in the poor gate oxide breakdown properties. The roughness of the silicon wafer after the SC-1 cleaning step was reduced by cyclic treatments of hydrogen peroxide solution and hydrofluoric acid solution instead of HF-only cleaning. AFM images after each step clearly illustrated that the average roughness of silicon surface after three times treatments with H2O2 and HF solutions was reduced by 10 times compared with that after the SC-1 cleaning step.

The ionic conductivity of several simulated borosilicate glasses was measured in the temperature range 150-600℃ in air. Leaching experiments were also carried out using Soxhlet apparatus at 100 ℃ for 7 days. As Li+ ion increased in simulated borosilicate glasses, both the ionic conductivity and leaching rate increased. The activation energy in the ionic conduction of the simulated borosilicate glasses was 1.38-1.45 eV in the high temperature region and 0.93-1.1 eV in the low temperature region.

Local structure refinement of the BaFe1-xSnxO3-y system (x=0.00-0.50) has been carried out with Fe K-edge x-ray absorpion spectroscopic studies. It is found out that the Fe ions are placed in two different symmetric sites such as tetrahedral and octahedral sites in the compounds by comparison with Fe K-edge x-ray absorption near edge structure (XANES) spectrum of the γ-Fe2O3 compound as a reference. Small absorption peaks of dipole-forbiden transitions appear at a pre-edge region of 7111 eV due to the existence of Fe ions in the tetrahedral and octahedral sites. The peak intensity decreases with the substitution amount of Sn ion. Three different absorption peaks of 1s→4p dipole-allowed transition appear on the energy region between 7123 and 7131 eV. The peaks correspond to 1s→4p main transition of Fe ions in tetrahedral and octahedral sites and 1s→4p transition followed by the shakedown process of ligand to metal charge transfer. The bond distances between Fe ions in the tetrahedral site and nearest neighboring oxygen atom (Fe-4O), and those in octahedral site (Fe-6O) are determined with the extended x-ray absorption fine structure (EXAFS) analysis. Two different interatomic distances increase with the substitution amount of Sn ion and also the bond lengths of Fe-4O are shorter than those of Fe-6O in all compounds.

Rate constants have been measured spectrophotometrically for the reactions of alkali metal ethoxides (EtOM) with S-p-nitrophenyl 2-thiofuroate (1b) and 2-thiophenethiocarboxylate (2b) in absolute ethanol at 25.0±0.1 ℃. 1b is observed to be more reactive than 2b toward all the EtOM studied. The reactivity of EtOM is in the order EtOK > EtONa > EtO- > EtOLi for both substrates, indicating that K+ and Na+ behave as a catalyst while Li+ acts as an inhibitor in the present system. Equilibrium association constants of alkali metal ions with the transition state (KaTS) have been calculated from the known equilibrium association constants of alkali metal ion with ethoxide ion (Ka) and the rate constants for the reactions of EtOM with 1b and 2b. The catalytic effect (KaTS/Ka) is larger for the reaction of 1b than 2b, and decreases with decreasing the size of the alkali metal ions. Formation of 5-membered chelation at the transition state appears to be responsible for the catalytic effect.

Through a sequence of reactions including Diels-Alder cycloaddition of a furan diene as the key step, 11-oxatricyclo[6.2.1.01,6]undecyl rings were synthesized from 5-methylfurfural with the goal of developing a synthetic protocol to 11-oxabicyclo[6.2.1]undecyl system. The strategy to incorporate an oxygen atom at C6 carbon of tricyclic 11 or 16 by Baeyer-Villiger oxidation was unsuccessful, implicating that there is too much steric congestion around the carbonyl ketone. As an alternative approach, bicyclic 23 and 24 were prepared from 2-methylfuran via known tricyclic 20. Cyclization of bicyclic 23 and 24 under several reaction conditions also failed to produce hydroxylated product 25 and 26.

Phospholipase C from Clostridium perfringens is known to catalyze the hydrolysis of phospholipids in biological membranes. In this study, a simple and sensitive method for assaying phospholipase C was developed by using liposomes entrapping calcein as a fluorescent marker. Phospholipase C-induced lysis of liposomes was determined by measuring the fluorescence intensity of calcein released out from liposomes, Various liposomes with different compositions were prepared by reverse-phase evaporation method to investigate the effect of liposomal composition on the lytic activity of phospholipase C. The calcein-entrapping efficiency of liposomes was affected by the chain length of fatty acid in phosphatidylcholine constituting liposomes. The lytic activity of phospholipase C was the highest against liposomes prepared with eggPC. The lytic activity decreased with increasing chain length of fatty acid in phosphatidylcholine. Incorporation of cholesterol more than 20% into the liposomal bilayer inhibited the phospholipase C-induced lysis. The lysis of liposomes was more greatly increased by the addition of 10 mM of calcium. The lytic activity of phospholipase C was also affected by the surface charge of liposomes. Taken together, it was concluded that reverse-phase evaporation vesicles composed of dipalmitoylphosphatidylcholine and cholesterol in the molar ratio of 9 : 1 allowed to detect the lowest concentration of phospholipase C (0.10 μg/assay volume). This study suggested that the use of liposomes can provide a simple, sensitive and inexpensive method for assaying phospholipase C.