When 1H NMR spectra of pyridine, 4-amino-, 4-methyl-, and 4-cyanopyridine coordinated to the paramagnetic polyoxometalate, [SiW11CoⅡO39]6- in D2O are compared, both α- and β-proton peaks are shifted upfield as the basicity of the ligand decreases. The isotropic shifts are separated into contact and pseudocontact contributions by assuming that the contact shifts are proportional to the isotropic shifts of the same ligands coordinated to [SiW11NiⅡO39]6-. This separation reveals that the shift variations with the axial ligand basicity are dominated by changes in the magnetic anisotropy (pseudocontact shift) of [SiW11CoⅡ(ptl)O39]6- (ptl=pyridine-type ligand). The magnitude of the magnetic anisotropy in a series of pyridine-type ligands increases linearly as the pKa of their conjugate acids decreases.

The rate constants for the nucleophilic addition of thiophenol derivatives (p-OCH3, H, p-CH3, m-CH3, p-Br and p-NO2) to 4'-[N-(9-acridinyl)]-1'-(N-methanesulfonyl)-3'-methoxyquinonediimide (AMQD) were determined by ultraviolet spectrophotometer in water at 5 ℃, and rate equations which can be applied over a wide pH range were obtained. On the basis of pH-rate profile, Bronsted plot, adduct analysis, general base catalysis and substituent effect, a plausible mechanism of this addition reaction was proposed: Below pH 2.5, the reaction proceeded by the addition of thiophenol molecule to 6'-position of quinonoid after protonation at the acridinyl nitrogen. Above pH 6.2, the addition of sulfide anion to 6'-position of quinonoid was rate controlling. However, in the range of pH 3.0-6.0, these two reactions occured competively.

High quality MCM-41 is prepared from a gel of molar composition SiO2:0.20 CTACl:0.18 TMAOH:25 H2O aged at 20 ℃ for 24 hours before crystallization lasting for 48 hours. The (110) and (200) peaks of XRD pattern of high quality MCM-41 are unusually well resolved and the FWHM (full-width-at-half-maximum) of the (100) peak is 0.13° for as-prepared MCM-41 and 0.21° for calcined one, which indicate well-developed crystals. The properties of the crystal depend on the source and concentration of the reactants and the gel aging time. There is no induction period in the course of the synthesis, which is conveniently monitored by pH measurement. Gel aging, during which a spatial distribution of silicate polyanions and micellar cations is established, is essential for preparing high quality MCM-41. Surfactants with the same cationic organic group but different counteranions change the crystallization behavior. Highly basic gel (pH=12.6) favours the lamellar product; the quality of MCM-41 is lower as insufficient TMAOH is available to dissolve the silica.

We report on the development of a new method to control the coverage of a metal film prepared with immersion method. An Sb species in solution adsorbed irreversibly at an open circuit potential (∼0.2 V) as an oxygenous Sb(Ⅲ) on a clean Au electrode, and the adsorbates showed voltammetric features in the potential range from 0.1 V to - 0.4 V. The full coverage of the Sb adsorbates was ∼0.45. On the contrary, the Sb species in solution did not adsorb at all on iodine-covered Au electrode surfaces, when the iodine coverages were more than 0.25. As the iodine coverage decreased below 0.25, however, the irreversible adsorption of Sb took place and the coverage of Sb increased accordingly. This electrochemical behavior has been interpreted as the penetration of the adsorbing Sb species in solution through open spaces among the iodine adlattices of coverages less than 0.25. With the manipulation of the iodine coverage, the controllable range of Sb coverage was from 0 to 0.45, i.e. the full coverage of Sb. In addition, the reversible deposition of Sb on an iodine-saturated Au electrode with voltammetric scan has been observed, which is contrasted with the adsorptive behavior of Sb on the clean Au electrode.

Nucleophilic substitution reactions of 2-thiopheneethyl benzenesulfonates (2-TEB) and 3-thiopheneethyl benzenesulfonates (3-TEB) with anilines and N,N-dimethylanilines (DMA) are investigated in acetonitrile at 60.0 ℃. The cross-interaction constants ρxz determined for the reactions with anilines are large negative (- 0.50) which are comparable to those for the similar predominantly frontside-attack SN2 reactions of 1-phenylethyl (1-PEB), 2-phenylethyl (2-PEB) and cumyl benzenesulfonates. A large negative ρxz value (- 0.4∼- 0.8) is considered to provide a mechanistic criterion for the frontside-attack SN2 mechanism with a four-center transition state. In agreement with this proposal the kinetic isotope effects, kH/kD, involving deuterated aniline nucleophiles are all greater than one reflecting partial N-H(D) bond cleavage in the transition state. The MO theoretical reactant structures of 1-PEB, 2-PEB and 2-TEB based on the PM3 calculation show that the benzene ring blocks the backside nucleophile approach to the reaction center carbon (Cα) enforcing the frontside-attack SN2 mechanism.

The substituent effects in the gas-phase rearrangement of carbenes to ketenes involved in the Wolff reaction have been investigated theoretically using the AM1 method. In the initial state, carbene, there is a relatively strong vicinal n-σ* interaction between the lone pair (n) and carbonyl group (σ*). In the bridged transition state (TS), electronic charge is transferred from the migrating ring (Z-ring) toward the nonmigrating ring (Y-ring). The carbenes are stabilized by an electron donor Y (δσY < 0) whereas the TS is stabilized by an electron acceptor Y (δσY > 0). Multiple regression analysis of log (kYZ/kHH)(=-δΔG≠/2.3RT) leads to a relatively large negative cross-interaction constant, ρYZ=-0.53, log (kYZ/kHH)=2.96 σY--1.40 σZ-0.53 σY-σZ reflecting an extensive structural change in the transition state due to the stabilization of the initial state by the vicinal n-σ* overlap. When the solvent (water) effects are accounted for by the SM2.1 model of the Cramer and Truhlar method, the magnitude of all the selectivity parameters, ρY-, ρZ and ρYZ (=-0.66) are increased.

Olefinic and cyclopropyl group substituted arenes (C6H5Y) react with [Cp*Ir(CH3COCH3)3]A2 (A=ClO4-, OTf-) to give η6-arene complexes, [Cp*Ir(η6-C6H5Y)]2+ (1a: Y=-CH=CH2 (a),-CH=CHCH3 (b),-C(CH3)=CH2 (c),-CH-CH2-CH2 (d)). Complex 1b-1d are readily converted into η3-allyl complexes, [Cp*(CH3CN)Ir(η3-CH(C6H5)CHCH2)]+ (2a) and [Cp*(CH3CN)Ir(η3-CH2(C6H5)CH2)]+ (2b), in the presence of Na2CO3 in CH3CN. The η6-styrene complex, 1a reacts with NaBH4 to give η5-cyclohexadienyl complex, [Cp*Ir(η5-C6H6-CH=CH2)]+ (3), while with H2 it gives η6-ethylbenzene complex [Cp*Ir(η6-C6H5CH2CH3)]2+ (4). Complex 1a and 1c react with HCl to give [Cp*Ir(η6-C6H5CH2CH2Cl)]2+ (5a) and [Cp*Ir(η6-C6H5CH(CH3)CH2Cl]2+ (5b), respectively.

The various cobalt(Ⅱ) complexes were synthesized and characterized using tris-(2-benzimidazolylmethyl)amine (ntb) as a ligand where the ntb plays as a tripodal tetradentate ligand to form complexes with a trigonal pyramidal geometry. The complexes have 5 and 6 coordinate cobalt(Ⅱ) ions depending on the additional ligand used. In each complex the additional ligand, chloride anion, or acetate anion occupies the "open" site trans to the apical tertiary nitrogen atom of ntb ligand. Complex 1, [Co(Ⅱ)(ntb)Cl]Cl has a trigonal bipyramidal geometry. This geometry was easily constructed using ntb as a tetradentate ligand and chloride as a monodentate ligand. The complex is isostructural to the corresponding manganese(Ⅱ) complex. Crystal data are as follows: [Co(Ⅱ)(ntb)Cl]Cl·MeOH, 1. triclinic space group P1; a=13.524(2) Å, b=14.037(2) Å, c=17.275(1) Å; α=78.798(9), β=84.159(8)°, γ=65.504(9)°; V=2929.6(6) Å3; Z=4; R1=0.0715, wR2=0.1461 for reflections of I > 2σ(I). Six coordinate complex 2 [Co(ntb)(OAc)](OAc) was synthesized using ntb as a tetradentate ligand and acetate as a bidentate chelating ligand.

Several calixarene derivatives of 5,11,17,23-tetra-tert-butyl-25-(3,5-dinitrobenzoyloxy)-26,27,28-trihydroxycalix[4]arene 2 were synthesized by the reaction of 2 with several acyl and alkylating agents in the presence of base such as pyridine and K2CO3 in THF. Acylation of monobenzoylated p-tert-butylcalix[4]arene 2 yielded their corresponding 1,3-diacylated calix[4]arenes 3a-3g. On the other hand, alkylation of 2 produced a variety calix[4]arene derivatives such as 1,2- and 1,3-disubstituted calix[4]arenes 4a-4c, 4e-4f, or 1,2,4-trisubstituted calix[4]arene 4d. 1,2-Disubstituted calix[4]arenes are chiral. All derivatives exist as a cone conformation based on NMR studies.

Conformational flexibilities of the GlcNAc(β1,3)Gal(β)OMe are investigated through NMR spectroscopy and molecular modeling. Adiabatic energy map generated with a dielectric constant of 50 contains three local minima. All of the molecular dynamics simulations on three local minimum energy structures show fluctuations between two low energy structures, N2 at φ=80° and ψ=60° and N3 at φ=60° and ψ=-40°. We have presented adequate evidences to state that GlcNAc(β1,3)Gal(β)OMe exists in two conformationally discrete forms. Two state model of N2 and N3 conformers with a population ratio of 40:60 is used to calculate the effective cross relaxation rate and reproduces the experimental NOEs very well. Molecular dynamics simulation in conjunction with two state model proves successfully the dynamic equilibrium existed in GlcNAc(β1,3)Gal(β)OMe and can be considered as a powerful method to analyze the motional properties in the structure of carbohydrate. This observation also cautions against the indiscriminate use of a rigid model to analyze NMR data.

To study the NMR chemical shift arising from the 5f-electron orbital angular momentum and the 5f-electron spin dipolar-nuclear spin angular momentum interactions, the evaluation of the hyperfine integrals has been extended to any pairs of SCF type 5f orbitals adopting a general method which is applicable to a general vector R, pointing in any direction in space. From the electronic wavefunctions for 5f orbitals expressed in common coordinate system, the radial part of the hyperfine interaction integrals are derived by translating the exponential part, r2 exp(-2βr), in terms of R, rN and the modified Bessel functions. The radial integals for 5f orbitals are tabulated in analytical forms. When two of the hyperfine integrals along the (100), (010), (001), (110), and (111) axes are calculated using the derived radial integrals, the calculated values for the 5f system change sign for R-values larger than R　0.35 nm. But the calculated values for the 4f systems change sign for R-values larger than R　0.20 nm.

The dephosphorylation specificity of protein phosphatase 2A (PP2A), calcineurin (PP2B) and protein phosphatase 2C (PP2C) were studied in vitro using myelin basic protein (MBP) as a model substrate which was fully phosphorylated at multiple sites by protein kinase C (PKC) or cyclic AMP-dependent protein kinase (PKA). In order to determine the site specificity of phosphates in myelin basic protein, the protein was digested with trypsin and the radioactive phosphopeptide fragments were isolated by high performance liquid chromatography (HPLC) on reversed-phase column. Subsequent analysis and/or sequential manual Edman degradation of the purified phosphopeptides revealed that Thr-65 and Ser-115 were most extensively phophorylated by PKA and Ser-55 by PKC. For the dephosphorylation kinetics, the phosphorylated MBP was treated with calcineurin or PP2C with various time intervals and the reaction was terminated by direct tryptic digest. Both Thr-65 and Ser-115 residues were dephosphorylated more rapidly than any other ones by phosphatases. However it can be differentiated further by first-order kinetics that the PP2B dephosphorylated both Thr-65 and Ser-115 with almost same manner, whereas PP2C dephosphorylated somewhat preferentially the Ser-115.

(p-Methylbenzyl)-o-cyanopyridinium hexafluoroantimonate, a new catalyst, was synthesized by the reaction of o-cyanopyridine with α-bromo-p-xylene followed by exchange of counteranion with SbF6θ. We examined the effect of the catalyst on the bulk polymerization of tetrahydrofuran under various conditions. The catalytic activity was best in the presence of 1 : 1 of epichlorohydrin used as cocatalyst versus catalyst concentration. The resulting polymers had relatively low conversions in 1.0-40%. Their number average molecular weights were in the range of 800 to 5300. Propagation rate increased with increase in temperature according to an Arrhenius expression giving an activation energy of 62 KJ/mol. We also found catalyst proceeds via a cationic mechanism.