ln this work, the feasibility of using a UV laser for micromachining of powder injection molded parts is examined experimentally. The results, although preliminary, indicate that microfabrication of various parts by laser micromachining of the injection molded parts and then sintering is promising. Particularly, micromachining of a mixture composed of stainless steel particles and polyrner binders was studied using a KrF excimer laser.

Crystallization of 100 nm thick amorphous silicon (a-Si) films on glass substrates was carried out by using a double laser irradiation method. Depending on a-Si deposition method or glass types, the quality of crystallized silicon film varies significantly. For a-Si films deposited with high concentration of impurities, large grains or high crystallinity can not be achieved. Crystallization with different a-Si deposition methods confirmed that for the polycrystallization of a-Si films on glass substrates, controlling the impurity density during substrate preparation is critical.

Indium tin oxide (ITO) provides high electrical conductivity and transparency in the visible and near IR (infrared) wavelengths. Thus, it is widely used as a transparent electrode for the fabrication of liquid crystal displays (LCDs) and organic light emitting diode displays (OLRDs), photovoltaic devices, and other optical applications. Lasers have been used for removing coating on polymer substrate for flexible display and electronic industry. In selective removal of ITO layer, laser wavelength, pulse energy, scan speed, and the repetition rate of pulses determine conditions, which are efficient for removal of ITO coating without affecting properties of the polymer substrate. ITO coating removal with a laser is more environmentally friendly than other conventional etching methods. In this paper, pattering of ITO film from polymer substrates is described. The Yb:KGW femtosecond laser processing system with a pulse duration of 250fs, a wavelength of 1030nm and a repetition rate of 100kHz was used for removing ITO coating in air. We can remove the ITO coating using a scanner system with various pulse energies and scan speeds. We observed that the amount of debris is minimal through an optical and a confocal microscope, and femtosecond laser pulses with 1030nm wavelength are effective to remove ITO coating without the polymer substrate ablation.

The studies on the fine processing on the surface of the metal utilizing the technique for LST (Laser surface texturing) have been performed recently. This study has acquired the lower frictional coefficient and endurance in the harsh environment of motion in the low lubricating range of low frictional coefficient in addition to storing of lubricant through fine processing on the frictional part of metal.