• Proceedings of the IEEK Conference
• /
• 2004.06a
• /
• pp.289-292
• /
• 2004

In this paper, we propose parallel Viterbi decoders applied to UWB(Ultra Wide Band). In consideration of power dissipation and ease of design, we design the architecture, using 132MHz clock instead of 528MHz clock in Baseband. Because Deinterleaver writes and reads the transmitted data per 6Ncbps(The number of coded bits per symbol). using the difference between the number of sampling clock per symbol and the number of coded bits per symbol, we reduce performance degradation of parallel Viterbi decoders. In comparison with using 528MHz clock, the result is little difference.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.6 no.4
• /
• pp.567-573
• /
• 2002

In this paper, we propose a new symbol time synchronization scheme suitable for the OFDM system with an interpolator. The proposed scheme performs the following three steps. In the first step, the coarse symbol time synchronization is achieved by continuously measuring the average power of the received envelope signal. Based on this average power, the detection possibility for the symbol time synchronization is determined. It the signal is sufficient for synchronization, we next perform a relatively accurate symbol time synchronization by measuring the correlation between a short training signal and the received envelope signal. Finally, an additional frequency synchronization is performed with a long training signal to correct symbol synchronization errors caused by the phase rotation. From the simulation results, one can see that the proposed synchronization scheme provides a good synchronization performance over frequency selective channels.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.6A
• /
• pp.500-505
• /
• 2009

In this paper, We present a low complexity candidate list generation scheme in iterative MIMO receiver. Since QAM modulation can be decomposed into HP symbols and LP symbol and HP symbol is robust in error capability, we generate HP symbol list with simple ZF detector output and its corresponding neighbor HP symbols, Then, based on HP symbol list, the LP symbol list is generated by using the sphere decoder. From the second iteration, since apriori value from channel decoder is available, the candidate list is updated based on demodulated apriori value. Through the simulation, we observe that at the first iteration, the BER performance is worse than LSD. However, as the number of iteration is increased, the proposed scheme has almost same performance as LSD. Moreover, the proposed one has reduced candidate list generation time and lower number of candidate list compared with LSD.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.6
• /
• pp.34-42
• /
• 2014

This paper presents a low-complexity and high-throughput symbol detector for two-spatial-stream multiple-input multiple-output systems based on the modified maximum-likelihood symbol detection algorithm. In the proposed symbol detector, the cost function is calculated incrementally employing a multi-cycle architecture so as to eliminate the complex multiplications for each symbol, and the slicing operations are performed hierarchically according to the range of constellation points by a pipelined architecture. The proposed architecture exhibits low hardware complexity while supporting complicated modulations such as 256 QAM. In addition, various modulations and antenna configurations are supported flexibly by reconfiguring the pipeline for the slicing operation. The proposed symbol detector is implemented with 38.7K logic gates in a $0.11-{\mu}m$ CMOS process and its throughput is 166 Mbps for $2{\times}$3 16-QAM and 80Mbps for $2{\times}3$ 64-QAM where the operating frequency is 478 MHz.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.5
• /
• pp.117-121
• /
• 2014

In the orthogonal frequency division multiplexing system, the prefix inserted between data symbols should be eliminated to apply the Fourier transform on the valid symbol interval. This functional procedure should be based on the accurate symbol timing detection. The symbol timing detection at the receiver side provides the reference for determining the beginning time index of each symbol whose initial point is located at the boundary between the preamble and the payload part. Also, the detection error is one of the main factors in the overall system performance. In this paper the effect of the bandwidth of the moving average filter on the symbol timing detection is discussed. Simulations are carried out to analyze the detection performance for the varying values of the window size of the moving average filter which is related to the filter bandwidth.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.7
• /
• pp.545-551
• /
• 2013

Timing recovery loop composed of the Timing Error Detector(TED), loop filter and resampler is widely used for the timing synchronization in MQASK receivers. Since TED is sensitive to the delay between the symbol period of the signal and sampling period, the output is averaged out when the symbol rate and sampling rate are quite different the recovery loop cannot work at all. This paper presents a sampling frequency discriminator (SRD), which detects the frequency offset of the sampling clock to the symbol clock of the MQASK data transmitted. Employing the SRD, the closed loop timing recovery scheme performs the frequency-aided timing acquisition and achieve the synchronization at extremely high sampling frequency offset, which can be used in variable symbol rate MQASK receivers.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.213-216
• /
• 2005

The time synchronization method for Multi-band UWB systems is proposed. We analyze the performance in symbol synchronization using a training symbol with two identical halves. The two halves of the training symbol are made identical by transmitting a modulated sequence on the even frequencies, while zeros are used on the odd frequencies.

• Journal of Electrical Engineering and information Science
• /
• v.3 no.1
• /
• pp.73-79
• /
• 1998

In this paper, a new traffic sign detection algorithm.. and a symbol recognition algorithm are proposed. For traffic sign detection, a dominant color transform is introduced, which serves as a tool of highlighting a dominant primary color, while discarding the other two primary colors. For symbol recognition, the curvilinear shape distribution on a circle centered on the centroid of symbol, called a circular pattern vector, is used as a spatial feature of symbol. The circular pattern vector is invariant to scaling, translation, and rotation. As simulation results, the effectiveness of traffic sign detection and recognition algorithms are confirmed, and it is shown that group of circular patter vectors based on concentric circles is more effective than circular pattern vector of a single circle for a given equivalent number of elements of vectors.

• ETRI Journal
• /
• v.28 no.6
• /
• pp.793-795
• /
• 2006

When quadrature error exists, the shape of the M-ary phase shift keying (MPSK) signal constellation becomes skewed-elliptic. Each MPSK symbol takes on a different symbol error probability (SEP) value. The analytical results presented thus far have been derived from studies which examined the SEP problem assuming that the SEP of each MPSK symbol is equally likely; therefore, those results should not be treated as offering a complete solution. In this letter, we present a new and more complete solution to the SEP problem of MPSK by relaxing the above assumption and finding the expressions for the average as well as individual SEP in the presence of quadrature error.

• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.2059-2062
• /
• 2002

For detection of digitally modulated signals, the receiver must be provide with accurate carrier phase and symbol timing estimates. So far, tots of algorithms have been suggested for those purposes. In general, a interpolation filter with TED(Timing Error Detection) like Gardner algorithm is popularly used for symbol timing estimate of digital communication receiver. Apart from the performance point of view, a multiplicative operation of any interpolation filter limits the symbol rate of the system. Hence, we suggest a new symbol timing estimate algorithm for high speed burst-mode fixed wireless communication system and analyze its performance in the AWGN channel.