• 전기학회논문지
• /
• 제57권6호
• /
• pp.1081-1086
• /
• 2008

This paper presents the $3^{rd}$ 4bit sigma delta modulator with the block and timing diagrams of DWA(Data Weighted Averaging) to optimize a operating time. In the modulator, the proposed DWA structure has a stable operation and timing margin so as to remove three latches and another clock. Because the modulator with proposed DWA structure improve timing margin about 23%. It can increase sampling frequency up to 244MHz. Through the MATLAB modeling, the optimized coefficients are obtained to design the modulator. The fully differential SC integrators, DAC, switch, quantizer, and DWA are designed by considering the nonideal characteristics. The designed $3^{rd}$ order 4bit modulator has a power consumption of 40mW and SNR(signal to noise ratio) of 77.2dB under 1.2V supply and 64MHz sampling frequency.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 학술회의 논문집 정보 및 제어부문 A
• /
• pp.75-78
• /
• 2003

In this paper, a second-order 3-bit DSM using DWA(Data Weighted Averaging) algorithm is designed for bluetooth Zero-IF Receiver. The designed circuit has two integrators using a designed OTA, nonoverlapping two-phase clerk generator, 3-bit A/D converter, DWA algorithm and 3-bit D/A converter An ideal model of second-order lowpass DSM with a 3-bit quantizer was configured by using MATLAB, and each coefficients and design specification of each blocks were determined to have 10-bit resolution in 1MHz channel bandwidth. The designed second-order 3-blt lowpass DSM has maximum SNR of 74dB and power consumption is 50mW at 3.3V.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 1999년도 High Temperature Superconductivity Vol.IX
• /
• pp.48-53
• /
• 1999

We demonstrate small-scale high-T$_c$ superconductor RSFQ(Rapid Single Flux Quantum) circuits using multilayer bicrystal technology. An RSFQ balanced comparator is demonstrated with good current resolution, and its operating conditions are discussed in some detail. A single-loop delta-sigma modulator is realized adding a feedback loop to the comparator. The effect of the feedback is confirmed by dc measurement and simulation. A design of an RSFQ toggle flip-flop with the same multilayer bicrystal technology is suggested.

• 대한전자공학회논문지
• /
• 제27권5호
• /
• pp.808-815
• /
• 1990

This paper treats with the design method for the single loop oversampled Sigma-Delta A/D converter with one delay and the digital integrator. Such an integrator was kgenerated by means of the bilinear transform of the analog integrator. The frequency spectrums of the quantizer and the decimator output signal are evaluated by FFT respectively. With the performance evaluation system, the values of SNR are obtained versus the input sinusoidal signal amplitude, frequency, the oversampling ratio, the DC-input level, the loop gain and the limitting value of the integrator. As compared with existing results, values of SNR versus the input signal amplitude and the oversampling ratio for the suggested system are about 6dB higher then previously reported results respectively. Furthermore, this approach achieves an about 60dB input dynamic range.

• 전자공학회논문지 IE
• /
• 제46권1호
• /
• pp.1-6
• /
• 2009

본 논문에서는 광대역 주파수 합성기의 구현을 위하여 주파수 검출 범위와 락킹 시간을 개선한 디지털 PLL의 구조 및 설계에 대하여 기술한다. 제안된 구조에서는 광대역의 고속 주파수 비교기를 위하여 광역 디지털 로직 직교상관기를 사용하였고, 2 비트 업-다운 카운터 및 시그마-델타 변조기를 적용하여 디지털 제어 발진기의 주파수가 제어되도록 하였다. 따라서 양자화에 의한 잡음으로부터 추가되는 위상 잡음을 감소시킬 수 있으며, 최근의 휴대용 멀티미디어 통신 단말기 등에서 요구되는 고속의 락킹 및 광대역 지원, 그리고 저전력 현에 적합하다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2008년도 하계종합학술대회
• /
• pp.609-610
• /
• 2008

In this paper, a 110 dB, 1.024 MHz fourth-order single-loop Delta-Sigma sigma modulator has been presented with an over-sampling ratio of 128 and an overload factor of -6 dB for a bandwidth of 4 kHz. In particular, this ${\Sigma}-{\Delta}$ modulator is well suited for high accuracy measure systems. The whole modulator consumes only 3-mW from a single 3.3V supply in a $0.35-{\mu}m$ CMOS technology.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2008년도 하계종합학술대회
• /
• pp.437-438
• /
• 2008

This paper proposes a 8th-order single loop band-pass sigma-delta modulator that satisfies a wide bandwidth of 6MHz, which is required for a HDTV application. The proposed architecture is based on a simple analog structure that enlarges the noise shaping with a low OSR. In addition, a feedforward scheme is used to relax op-amp performance requirements. The proposed modulator has been simulated using the 0.18um 1.8v TSMC technology. The simulation results show that the bandwidth is 6MHz and SNQR is 70dB.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 추계종합학술대회 논문집(2)
• /
• pp.152-155
• /
• 2000

Oversampling modulators based on high-order sigma-delta modulation provide an effective means of achieving high-resolution A/D conversion in a VLSI technology. Because high-order noise shaping great]y reduces the quantization noise in the signal band. This paper introduces a third-order cascaded sigma-delta modulator that is stable for large input level. Modulator was simulated 3.3V single power supply voltage in 0.65$\mu\textrm{m}$ CMOS technology. It achieves 80㏈ SNR for a 20㎑ input signal bandwidth. A lock frequency is 3㎒ that is 80 oversampling ratio.

• 전기전자학회논문지
• /
• 제17권3호
• /
• pp.248-253
• /
• 2013

주파수 판별기는 주파수를 디지털 비트 신호로 변환해주는 회로로서 변조기, 동기화 회로 등에 쓰인다. 본 논문에서는 여러 종류의 일차, 이차 주파수 판별기의 구조를 모델링하고 양자화 잡음 성능을 분석하며, 새로운 구조의 델타-시그마 주파수 판별기 구조를 제안한다. 이론적 분석과 유도된 수식으로부터 출구 잡음을 구하고 모의실험으로 타당성을 검증하였다. 제안된 주파수 판별기는 전 디지털 회로로서 전 디지털 위상 잠금 루프의 궤환 경로에 적용될 수 있다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 하계종합학술대회 논문집
• /
• pp.982-985
• /
• 1999

An efficient technique to trade off speed for resolution is the sigma-delta modulation (SDM). This paper proposes a new SDM architecture to improve conversion rates and SNR(Signal-to Noise Ratio) by using master clock and four divided clock. The charateristics of the proposed SDM are simulated in MATLAB environment. and optimizing the capacitor sizes is done by iterative processing. other analog characteristics are simulated using 0.65${\mu}{\textrm}{m}$ n-well CMOS process, double poly and single metal. The result of simulation shows that more increasing the effective bits of internal ADC/DAC, bigger the improvement of SNR.