• Journal of Biosystems Engineering
• /
• v.9 no.1
• /
• pp.22-33
• /
• 1984

Husk separator is an indispensable equipment in rice milling plants. However, any basic research on the designing and operating criteria of the husk separator have rarely been conducted in Korea. According to the survey results reported recently, grain loss occurs in the process of rice husk separation at custom rice milling plants in Korea and the performance of husk separator has also not been identified. With this regard this study was conducted with a typical commercial husk separator to investigate the effect of the operational factors such as feed rate, blower speed and opening ratio on the velocity distribution in the air duct and the performance of the separator. The results are summerized as follows: 1. The average wind velocity in the primary air duct increased linearly with the blower rpm and the size of air inlet port in both cases of double type and single type operations. 2. The coefficient of variation in the horizontal wind velocities in the primary air duct was the minimum when the opening ratio was 0.22 ($0.052m^2$ of air inlet port) in both cases of single type and double type operations regardless of the blower speeds used in this test. The average wind velocity at the upper part of air duct was greater by 2-5 m/s than the velocity at the bottom part in double type operation. In case of single type operation, however, the average velocity in the middle part was greater than the upper or bottom part when the opening ratio was greater than 0.74. 3. The relationship between the overall effectiveness of separation(Ed for double type and Es for single type) and the average wind velocity (Va) in the primary air duct was expressed in the following quadratic functions. $$Ed=-190.84+106.18Va-10.052Va^2$$ ($r^2$ = 0.97782) $$Es=-223.76+106.23Va-9.1935Va^2$$ ($r^2$ = 0.97029) The average wind velocity required to obtain the overall effectiveness of separation more than 80% ranged from 4.04 m/sec to 5.84 m/sec in case of double type operation, and from 4.70 m/sec to 6.20 m/sec in case of single type. 4. An optimum wind velocity can be obtained with an increase in the blower speed or the size of air inlet port as presented in Figure 8. There was a tendency that the faster the blower speed, the narrower the control range of the air inlet port. 5. The feed rates (1850kg/hr and 2100kg/hr) adopted in this experiment did not bring about a significant difference in both the overall effectiveness of separation and the power consumption. 6. The energy consumption increased cubically with the blower speed but linearly with the size of the air inlet port. On the basis of the results described in items 1, 3, and 6, it would be more economic to adjust the size of the air inlet port larger with a relatively low blower speed than to adjust the size smaller with a relatively high speed.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.2
• /
• pp.632-638
• /
• 2018

Recently, damage to waterside structures, such as bridges or retaining walls, is increasing due to typhoons, flooding, aging, etc. In such cases, the damage is not limited to the structures themselves, but can include effects on a wider scale, such as the suspension of and restriction of access to the facilities, human injury, economic loss, etc. To preclude such damage, recovery methods suitable for the particular field circumstances should be applied when damage occurs. By enforcing prompt repairs, the material and human damage and losses that can occur can be minimized. Since the impact of losses caused by damage and disaster increases with the elapse of time, emergency recovery is even more important. In the emergency recovery process, appropriate repair and reinforcement is crucial. In the present study, the derivation scenarios of the emergency recovery method were applied to some field recovery cases, and their applicability was verified by comparison with the recovery methods actually used. It is expected that the results of this study will be useful for practical application, by suggesting more appropriate recovery methods.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.5
• /
• pp.257-265
• /
• 2020

Parts obsolescence is a component type, in which raw materials or parts that make up a weapons system, are developed and produced according to demand, but they age due to changes in technology or market conditions. The weapon system equipment currently being used by the military is having difficulty in procurement, maintenance, and operation because of the obsolescence of parts. Parts obsolescence during the life cycle of a weapons system affects not only the combat readiness of the military but also the economic loss of material, parts, and equipment manufacturers and suppliers. On the other hand, advanced technology has reduced the life span of electronic components that make up the weapons system. In addition, because of the nature of the weapons system, the obsolescence of components takes decades from development to disposal, which has a serious adverse effect on equipment readiness and life cycle costs. Therefore, it is necessary to manage systematically the parts obsolescence from development until the disposal of the weapons system equipment. This study examined the system of component control in developed countries to present a proper management plan for local situations and propose development plans for the early settlement of component control.

• Cartoon and Animation Studies
• /
• s.23
• /
• pp.1-17
• /
• 2011

The paper analyzed the metaphoric expressions appeared in whose cinematic quality has been subjectively recognized on the global stage by winning the Oscar for Best Animated Short Film. Many contents and visual effects of the film were expressed with metaphor. Story and sequence were analyzed through the language system-based 'Conceptual Metaphor Analysis Framework'. In addition, characters have been analyzed through the 'Visual Metaphor Analysis Framework'. The framework is to analyze visual dimensions which are derived when concepts are structuredin animation. This paper has attempted to investigate and reveal patterns how animation self-organizes or how animation self-realizes through linguistic objectives. That is, it is to reveal how animation communicates with the audience from the metaphoric perspective among many conventional ones. In an animated film, metaphor is a fundamental means to connect fragmented images, produce a holistic view and therefore induce creative communication with the audience. The essential motive of metaphor which is expressed in various styles in is modern people's feeling of loss and sense of missing something. Train, bottle top, food, lost-and-found center, in-between space and lost items have significance across the movie. According to an analysis, metaphor offers simplicity and freshness as an aesthetic function. In addition, the metaphor expresses lengthy contents and various meanings implicitly, delivering an economic function. With a creative function, metaphor is a tool to generate new meanings. In other words, an animated film is a medium to inspire and move the general public as a means of communication and thinking, not just an entertainment for young generations. After all, metaphoric expressions have been used to deliver diverse and deep meanings in animated films.

• Journal of Microbiology and Biotechnology
• /
• v.30 no.7
• /
• pp.955-961
• /
• 2020

Lactic acid bacteria (LAB) have caused many microbiological incidents in the brewing industry, resulting in severe economic loss. Meanwhile, traditional culturing method for detecting LAB are time-consuming for brewers. The present review introduces LAB as spoilage microbes in daily life, with focus on LAB in the brewing industry, targeting at the spoilage mechanism of LAB in brewing industry including the special metabolisms, the exist of the viable but nonculturable (VBNC) state and the hop resistance. At the same time, this review compares the traditional and novel rapid detection methods for these microorganisms which may provide innovative control and detection strategies for preventing alcoholic beverage spoilage, such as improvement of microbiological quality control using advanced culture media or different isothermal amplification methods.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.9
• /
• pp.482-496
• /
• 2016

Algal blooms of cyanobacteria (blue-green Algae) due to the eutrophication of rivers and lakes can cause not only the damage by its biological toxins but also the economic loss in drinking water treatment. The natural algae coagulant, a commercial product known as W.H. containing the algicidal and allelopathic material derived from oak, can control algal problems proactively through the coagulation flotation process. However, because there have been no applications of the process for pre-treatment in drinking water plants, we could find no report on the optimum injection dose of W.H.. In this study, we have conducted several sets of jar-tests while changing W.H. dose and concentration of chl-a for (1) Han-river samples and (2) subcultured cyanobacteria samples, and monitored the removal mechanisms of algae intensively. Based on these jar-test results, two linear equations with variables of chl-a and turbidity have been deduced to predict the optimal W.H. dose after the multiple regression analysis using IBM-SPSS. Also, prototypes of automatic control logic have been suggested to inject the optimal W.H. dose promptly in response to the variation of water quality.

• Korean Journal of Construction Engineering and Management
• /
• v.18 no.6
• /
• pp.57-64
• /
• 2017

Recently, the disaster situation has been diversified and compounded worldwide as well as in Korea. And the damage scale of each disasters have increased, and following economic loss is also increasing immensely. In Korea, especially the out break frequency of large-scale disasters has increased. Disasters caused by earthquakes are also very likely to occur. When a major accident such as Mauna resort collapse accident, Ferry sewol sinking accident occurred, systematic emergency medical care at the site at the time of disaster occurred in order to operate an emergency medical facility corresponding to the site, which is not systematic. The need for this service is urgent. If highly reliable emergency medical system function at appropriate times in the disaster site, secondary damage can be reduced and the whole situation would be back to normal shortly. Therefore, it is necessary to provide an emergency medical system capable of quickly and safely responding to disaster sites in relation to various damage scale. For the purpose, thorough analysis on mobile medical units of inside and outside the country was accomplished. As a result, Mobile Medical Unit of outside the country are trailer type, tent type, container type etc. At home, these types have been studied and will be proposed early next year as a temporary solution. Here we introduce suitable types for our country.

• Korean Security Journal
• /
• no.49
• /
• pp.187-214
• /
• 2016

In the mordern society, the reliance on the cyber domain and the cyber connectivity has been increasingly strengthened. Due to this phenomenon, the cyberterror against critical infrastructures and state organs might lead to fatal consequences. Lately, North Korea's cyberattacks against South Korea's national organizations and financial computer networks are becoming more and more intelligent and sophisticated. The cyberattacks against such critical infrastructures have caused enormous economic loss and social disorder. This paper is designed to examine comparatively the cyberterror related laws and organizations of the advanced countries such as U.S. and U.K. and to draw implications. Although those countries are under different institutional and cultural backgrounds with varying security envrionments, they are identically pursuing measures by establishing government-wide counterterror system for coordination and cooperation. They are also commonly focusing upon creating new organizations equipped with new system and upon enhancing intelligence performance and devising punishment regulations. Korea is lack of framework laws regulating cyber security, having only scattered individual laws. Since such legal base is far from efficient counterterror activities, it is necessary that the legal and policy response of the advanced countries should be closely studied for selective introduction. That will eventually lead to legislation of cyber security law. With such legislation on hand, it is subsequently required to strengthen crisis management for prevention of cyberterror and to create joint response team, cooperating with private organizations.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.25 no.6
• /
• pp.708-716
• /
• 2019

After the Sewol ferry disaster, the maritime safety supervisor system was introduced to strengthen maritime safety control for coastal vessels. If any critical defect is found in vessel facilities during periodical or occasional guidance and supervision on a vessel, a maritime safety supervisor takes an administrative measure: detention of the vessel until it has been completely corrected. The detention order is one of the most powerful regulations exercised by a maritime safety supervisor. It would not be an overstatement to say that the guidance and supervision conducted by a maritime safety supervisor is very important for the safety of a vessel and protection of the maritime environment. However, the regulatory level of each Regional Office of Oceans and Fisheries toward vessels may vary with the enforcers, and an individual's intentional act or negligence might occur during the execution process. Detention of a coastal vessel by the Regional Office of Ocean and Fisheries can easily lead to delayed navigation, and a vessel owner may suffer economic loss from suspension of a charter party. Nevertheless, the Maritime Safety Act does not prescribe filing a petition for objection to the measure of detention order by a maritime safety supervisor. To overcome this problem, therefore, the objection procedure under the Maritime Safety Act has to be reformed to reclaim a right against an inappropriate detention order measure caused by an individual's intentional act or negligence through a formal objection.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.14 no.2
• /
• pp.54-68
• /
• 2015

The advantage of electric taxies is that people who are not familiar with electric vehicle(EV) can have easily experience to ride EV. So, EV taxi would be a reasonable strategy for triggering EV market expansion. However, the EV taxi can be adopted by taxi companies with financial benefits. Therefore the feasibility study should be required by analyzing the cost with the points of view of the taxi company. In this study we suggested the methodology for feasibility study of the EV taxi based on the real taxi data and presented political implication. According to the study result, EV taxies could have economic value under the specific conditions such that the government subsidy is added to the purchase price of the vehicle. Also, the charging time should be used as drivers' rest time or mealtime in order not to consider the loss cost. We suggest that the new feasibility study which compares an EV taxi with other alternative vehicles such as PHEV or with an old EV taxi is needed as the future works.