• Journal of Bio-Environment Control
• /
• v.17 no.2
• /
• pp.157-161
• /
• 2008

This experiment was conducted to make eatable fruit of oriental melon with peel, we covered oriental melon fruit with pear, apple and grape paper bag. Temperature inside paper bags was lower than air temperature in daytime but reversed in night. Relative humidity inside paper bags was higher than outside humidity in daytime but reversed in night. Covering with paper bags seemed to make fruit length shorter, fruit width narrower, flesh thickness thinner and fruit weight heavier but no difference was found among treatments. Soluble solid contents of flesh and placenta seemed lower with covering with paper bags but also difference did not find among treatments. Increasing of soluble solid contents of fruits was observed at 5 days after removing paper bags but not immediately at removing paper bags. Fruit hardness and chromaticity were dropped by covering paper bags. Decrease of fruit hardness by covering paper bags made more eatable with peel but more study have to be taken to improve chromaticity and soluble solid of fruits.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.10
• /
• pp.188-198
• /
• 2013

Maximally flat (MAXFLAT) half-band filters usually have wider transition band than other filters. This is due to the fact that the maximum possible number of zeros at $z={\pm}1$ is imposed, which leaves no degree of freedom, and thus no independent parameters for direct control of the frequency response. This paper describes a novel method for the design of FIR halfband filters with an explicit control of the transition-band width. The proposed method is based on a generalized Lagrange halfband polynomial (g-LHBP) with coefficients parametizing a 0-th coefficient $h_0$, and allows the frequency response of this filter type to be controllable by adjusting $h_0$. Then, $h_0$ is modeled as a steepness parameter of the transition band and this is accomplished through theoretically analyzing a polynomial recurrence relation of the g-LHBP. This method also provides explicit formulas for direct computation of design parameters related to choosing a desired filter characteristic (by trade-off between the transition-band sharpness and passband & stopband flatness). The examples are shown to provide a complete and accurate solution for the design of such filters with relatively sharper transition-band steepness than MAXFLAT half-band filters.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.3
• /
• pp.140-149
• /
• 2002

This paper describes the characteristics of beam-tilting slot away waveguide antennas for mobile DBS reception. As a basic study of slotted waveguide array, design for 16 slot elements located on a broad-wall waveguide is considered. Design parameters such as slot length, space between each slot and cross slot angle of antennas with the beam-tilting characteristics are calculated by method of moments. Based on these results, the radiation waveguide antennas with 16-element $\times$16-array are designed and fabricated. The measured main beam direction angles of the fabricated antennas are 48$^{\circ}$to 50$^{\circ}$depending on the measured frequencies and it shows good agreement with prediction. The measured 3 dB beam width of elevation pattern is about 13$^{\circ}$, and the axial ratio and the gain measured at DBS band are observed 2.8 dB below and 24 dBi above, respectively. In order to evaluate a performance of the fabricated waveguide planar antenna, it is combined with the satellite tracking control system and the field performance test of antenna mounted on a mobile vehicle is carried out at highway. During the measurement, it was possible to watch television without a break signal in a driving vehicle and an excellent performance of the proposed antennas was demonstrated.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.35 no.2
• /
• pp.259-267
• /
• 2008

This in vitro study aimed to investigate the influence of flowable composite lining with different thicknesses on the marginal quality. One hundred twenty cavities, each preparated with proximal boxtype( 3mm of bucco-lingual width, 2mm of mesio-distal depth and gingival margin of 1mm supra-CEJ) were randomly dived into four groups. group I : Tetric ceram filling alone(control group) group II: 0.5mm thickness Tetric flow + Tetric ceram filling group III: 1.5mm thickness Tetric flow + Tetric ceram filling group IV: 2.5mm thickness Tetric flow + Tetric ceram filling The followings are the results: 1. Group II showed significantly less microleakage compared to group I(control group)(p<0.05). 2. There was no statistically significant difference between group III, IV and group I(p>0.05). 3. Group II showed significantly less microleakage compared to group III, IV(p<0.05). 4. There was microleakage more or less in all group. It was concluded that 0.5mm flowable composite lining improved cavity adaptation and marginal sealing.

• Journal of Korean Society of Forest Science
• /
• v.104 no.3
• /
• pp.403-410
• /
• 2015

This study was conducted to analyze the forest environmental characteristics on a total of 20 forest environmental factors affecting the debris flow against 272 sites of risk areas. In the case of environmental factors, it showed the high risk of debris flow under the following conditions such as soil depth of less than 30cm, west slope, altitude of 200~300 m, mountain average slope of $25{\sim}30^{\circ}$, sandy loam, igneous rocks, and composite slope. Among the rainfall factors, 50~100 mm of maximum hourly rain fall and 300 mm of maximum rain fall per day have been shown the high risk of debris flow. Furthermore, the high risk of debris flow was related to the river-bed average slope of $10{\sim}20^{\circ}$, the river-bed average width of >10 m, the small amount of debris in river-bed (less than 20% of river-bed structure), the drainage density of >$1km/km^2$, the 40~60% of area with more than $20^{\circ}$ slope, and the 40~60% of areas with risk grade 2 of landslide. In addition, forest environmental factors including the driftwood, soil erosion control structures, age-class 3, crown density (density), and mixed forest were important factors causing the high risk of debris flow.

• Journal of the Korean Home Economics Association
• /
• v.46 no.9
• /
• pp.99-112
• /
• 2008

The increasing rate of obesity in school aged children has become a conspicuous social phenomenon in Korea. This has been linked to greater economic growth, increasingly westernized dietary habits, and a consumer driven society. Given that obesity can lead to social exclusion or unfavorable attention by other students in a school setting, the design of plus-size garments have become important for effective appearance management skills. This research aimed to establish a somatotype database for obese school boys, aged 10 to 12, in order to develop a sizing system for plus-size upper garments. In order to measure somatotype of average and obese school boys, five categories were recorded; height, obesity, length of trunk, thickness of neck and chest. For obese boys, subcutaneous fat thickness and position of B.P/shoulder point factors were recorded. Obesity factor was subdivided into overall and specific ones, and while the deviation of obese body types was severe compared to the average type. Obese body type showed significantly higher measurements in width, girth, thickness. This is linked to the fact that the frequency ratio of obesity increases with age. Stature and chest were chosen as control dimensions for boys' wear. As crosstabulation of stature(5cm interval) and chest girth(2, 3 and 4cm), and stature(5cm interval)/chest girth(3cm interval) sizing system showed, the most effective cover ratio and adaptability to the data distribution $25{\sim}75$ quartile. Based on the findings, 10 sizes were formulated for average body type, while 18 sizes were formulated for obese type, whose size cover ratios were 48% and 62.9%, respectively. The primary ranges of stature were $145cm{\sim}150cm$, while those of chest girth were $79{\sim}82cm$. Each size was declared as "chest-somatotype{A(average)/O(obesity)-stature". This study proposed a plus-size upper garment sizing systems for obese boys, accompanied with reference measurements for suit, casual wear and underwear. The finding showed that the two systems were totally separate and not overlapping, meaning that plus-size sizing system is essential for obese school boys. The obesity type system had more size and wider range specs.

• Journal of Bio-Environment Control
• /
• v.26 no.3
• /
• pp.208-214
• /
• 2017

This study aimed to determinate the effect of fluorescent light and light-emitting diodes on the leaf morphology, growth and antioxidant capacity of Salvia plebeia. The plants were grown for 56 days after transplanting (DAT) under the fluorescent light (FL) and LEDs (White, Red and Blue (R+B, ratio 2:1), Blue, Red LED) under the same light intensity and photoperiod ($130{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$, 12 hours). Leaf length, width and number of Salvia plebeia at the 56 DAT were significantly higher under the FL and red LED, and lower in the RB LED and white LED. The highest fresh and dry weights of shoot and leaf area were observed in the red LED, followed by the FL and blue LED, and the lowest in the RB LED and white LED. After 21 DAT, leaf apinasty symptom was appeared in plants grown under red LED and RB LED. The chlorophyll content was lower in the red LED. The specific leaf weight, the ratio of leaf dry weight to area, was higher in the blue LED, and lowest in the FL. No significant difference in DPPH radical scavenging activity of Salvia plebeia under the different light sources. All the integrated results suggest that the FL light is a proper light conditions for a closed cultivation of Salvia plebeia.

• Journal of Mushroom
• /
• v.18 no.3
• /
• pp.268-273
• /
• 2020

This study aimed to assess the feasibility of composting spent mushroom substrate (SMS) materials of Lentinula edodes (Le), Hericium erinaceus (He), and Pleurotus ostreatus (Po). The different SMSs were composted for 7 to 10 days at high temperatures over 50℃; the composting procedure was completed in 30 days. A maturity test was conducted using the radish seed germination index and CoMMe-100. The composted SMS (CSMS) from Le and He showed gemination indices of 130% and 81%, respectively, that satisfied the criteria of maturity standard (gemination index over 70%) and the CoMMe-100 analysis. The physicochemical changes of CSMSs included an increase in the pH range from 4-5 to 6-7, slight reduction in the EC to 1-1.4 dS/m, and an organic content of 36.9% in LeCSMS. In LeCSMS, the contents of N, P, and K were 1.2%, 2.3%, and 0.77%, respectively, and heavy metals were detected below the standard value in all CSMSs; the Ca and Mg contents in the CSMSs were increased from 30% to 60% when compared to those in the SMSs. The C/N ratio (from 26-33) in LeSMS and HeSMS decreased to 15.3-15.9 in CSMSs. The growth effect of LeCSMS treatment on pepper seedlings was 60% higher than that in the control groups, one of which was treated with commercial organic compost; the former showed a superior growth effect on the leaf width, leaf length, and leaf number compared to other control groups. In conclusion, LeCSMS and HeCSMS could be utilized as compost resources capable of efficient soil amendment and plant growth promotion.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2002.11a
• /
• pp.147-153
• /
• 2002

Due to the growth of population and industrial development at the coastal cities, there has been much increase in necessity to effective control of the wastes into the coastal water and river. The amount of disposal at those waters has been increased rapidly and it is necessary for us to track of it in order to keep the water clean. The investigation and research related to the water quality in this region have been conducted continuously but the systematic survey of the disposed wastes at the bottom was neglected and/or minor. In this study we surveyed the status of disposed waste distribution at the bottom coastal water and river from the scanned images. The intensity of sound received by the side scan sonar tow vehicle from the sea floor provides information as to the general distribution and characteristics of the superficial wastes. The port and starboard side scanned images produced from a transducer borne on a tow fish connected by tow cable to a tug boat have the area with width of 22m∼112m, and band of 44m∼224m. All data are displayed in real-time on a high-resolution color display (1280 ${\times}$ 1024 pixels) together with position information by DGPS. From the field measurement and analysis of the recorded images, we could draw the location and distribution of bottom disposals. Furthermore, we made a database system which might be fundamental for planning the waste reception and process control system.

• Journal of Korean Society of Environmental Engineers
• /
• v.32 no.11
• /
• pp.1024-1029
• /
• 2010

Use of polymeric soil amendments is an emerging way to reduce soil erosion, and improve crop productivity and soil quality. Objective of this study was to evaluate the effects of anionic polyacrylamide (PAM) and synthetic biopolymer on soil erosion, crop growth and soil quality. The aqueous solutions of PAM and biopolymer at 40 kg/ha were applied to loamy soil plots (3 m width by 18 m long) having a 20% slope during radish (Raphanus sativus) cultivation. Results showed that PAM and biopolymer treatments increased aggregate stability up to 11% compared to the untreated control. Treatments of PAM and biopolymer also increased leaf length of radish but there was no significant difference in crop yield. Soil loss was decreased by up to 41% using the polymeric soil amendments; however, no difference in runoff was found, compared to the untreated control. Soil loss was logarithmically increased against an increase in rainfall intensity ($R^2=0.85$). Our findings suggest that proper use of polymeric soil amendments would be beneficial to maintain soil quality and reduce soil erosion in sloping uplands.