• Journal of the Korean Society of Food Science and Nutrition
• /
• v.30 no.2
• /
• pp.344-349
• /
• 2001

The removal of chlorine from aqueous solutions on dried Chlorella vulgaris(DCV) and green tea powder(GTP) were investigated as a function of contact time, pH and initial chlorine concentration. Removal by DCV and GTP reached equilibrium after 3hrs and 0.5hr, respectively. Optimum removal pH values of DCV and GTP were determined as above 10. Both Langmuir and Freundlich adsorption models were suitable for describing the short-term removal of chlorine by DCV and GTP. According to Langmuir adsorption isotherms the maximum removal capacity of DCV (2.75mg $Cl_2/mg$) was nearly two times greater than those of GTP (1.53mg $Cl_2/mg$) and activated carbon (1.47mg $Cl_2/mg$). These results suggested that Chlorella vulgaris biomass might potentially be used as an alternative to traditional water treatment materials for removal of residual chlorine in drinking water or process waste-water.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.8 no.3
• /
• pp.263-268
• /
• 2020

The purpose of this study is to investigate the damping properties of polyurethane composites incorporating waste tire rubber powder and preplaced coarse aggregates. Four types of polyurethane-based composites were manufactured, and longitudinal impact tests were performed. And vibration signals in the time domain and frequency domain were measured and values of damping ratio for each specimen were calculated. Test results showed that the damping ratios of polyurethane composites, in which the amount of polyurethane was reduced by 10.6% and 21.2% through incorporation of rubber particles, were 8.4% and 4.6% lower than that of pure polyurethane. The damping ratio of the polyurethane composite produced in a similar manner to the prepact concrete production method was found to be 22% lower than that of pure polyurethane, however, the amount of polyurethane was reduced by 50% and the stiffness was 25.7 times higher than that of pure polyurethane.

• Resources Recycling
• /
• v.14 no.6 s.68
• /
• pp.37-43
• /
• 2005

[ $LiCoO_{2}$ ] nanoparticles were synthesized from leach liquor of lithium ion battery waste using flame spray pyrolysis. Electrode Materials containing lithium and cobalt could be concentrated with thermal and mechanical treatment. After dissolution of used cathode materials of the lithium battery with nitric acid, the molar ratio of Li/Co in the leach liquor was adjusted at 1.0 by adding a fresh $LiNO_{3}$ solution. The nanoparticles synthesized by the flame spray pyrolysis showed clear crystallinity and were nearly spherical, and their average primary particle diameters ranged from 11 to 35 nm. The average particle diameter increased with an increase in the molar concentration of the precursor. Raising the maximum flame temperature by controlling the gas flow rates also led to an increase in the average diameter of the particles. The $LiCoO_{2}$ powder was proved to have good characteristics as cathode active materials in charge/discharge capacity and cyclic performance.

• Resources Recycling
• /
• v.12 no.3
• /
• pp.25-30
• /
• 2003

The synthesis of SiC used for the parts of the gas turbine and the heat exchanger, was carried out. In this study, wire cutting slurry of silicon wafer and the graphite rod of spent zinc-carbon battery were applied to the starting materials for the synthesis. The powders of Si or Si+SiC were obtained from the waste material by filtration, gravity separation and magnetic separation. Graphite powder was produced by dismantling, grinding and gravity separation from spent zinc-carbon battery. The synthesis of SiC could be completed from the mixture powders of Si and C or Si+SiC and C at the condition of equivalent ratio of Si and C, atmosphere of Ar or vacuum, temperature of above 1$600^{\circ}C$ and 2 hours reactions. The purity of synthesized Si-C was above 99%.

• Korean journal of food and cookery science
• /
• v.15 no.4
• /
• pp.370-376
• /
• 1999

The red pepper seeds(RPS), an industrial waste produced from red pepper powder industry, were investigated for its possible use as natural hot taste seasoning. The RPS was extracted with water with addition of salt, sugar, phosphate and citric acid at 70-100$^{\circ}C$ Effects of preheat treatments of steaming at 100$^{\circ}C$ and roasting at 215$^{\circ}C$ and 330$^{\circ}C$ were also studied on the flavor of the RPS extracts. The results showed that steaming and roasting increased the solid yield and reduced the turbidity. The hot flavor of RPS extracts was generally decreased by steaming and roasting. Extraction of RPS at the temperature range of 70-100$^{\circ}C$ for 10-60 minutes showed that solid yield were relatively high of 27% at 80$^{\circ}C$ for 30 minutes with the highest score of hot flavor. When the extraction was carried out with addition of NaCl, sucrose, Na$_2$HPO$_4$ and citric acid, the solid yield was little affected by their addition except a little increase by 0.5% NaCl and 0.2% Na$_2$HPO$_4$ and hot flavor was little affected.

• Resources Recycling
• /
• v.17 no.1
• /
• pp.59-65
• /
• 2008

The adsorption features of nickel ion in wastewater on manganese dioxide from spent batteries were investigated for its usage as an adsorbent. The aquatic behavior of nickel ion was characterized by MINTEQ program and the considered influential variables on the adsorption of nickel ion were its initial concentration, reaction temperature, the amount of adsorbent, and pH. The adsorption ratio of nickel ion decreased with increasing its initial concentration and thermodynamic estimation has been carried out based on the adsorption characteristics of nickel ion depending on temperature. In addition, the adsorption of nickel ion was shown to be promoted according to the amount of manganese dioxide and a lot of nickel ions were adsorbed as the solution pH was raised.

• Journal of Sericultural and Entomological Science
• /
• v.45 no.2
• /
• pp.103-107
• /
• 2003

Entomopathogenic nematodes were isolated through the investigation in soils collected from cultivated and non-cultivated fields using silkworms (Bombyx mori) and Galleria mellonella trap. The detectable rate of entomopathogenic nematodes of silkworms trap was higher than the G. mellonella trap. This study indicates the detection of entomopathogenic nematodes from soils that silkworms are sensitive superior to the G. mellonella to entomopathogenic nematodes. The steinernema, rhabditidae, and diplogatroidae strains successfully cultured on the silkworms host as well as on artificial media. Reproductivity in the living silkworm larva and pupa was 1.5 to 3.5${\times}$ 10$\^$5/ nematodes per host However, G. mellonella could be multiplied less than 5${\times}$l0$\^$5/ nematodes. The dried pupa of the silkworm following mositurize was cultured 0.5 to 2${\times}$10$\^$5/) nematodes per host. The culture methods of the steinernema, rhabditidae, and diplogatroidae strains, using silkworm powder, extracted chicken intestine, and food waste fertilizer could be applicative, but rate of reproduction was low.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.24 no.2
• /
• pp.103-114
• /
• 2021

The purpose of this study is to provide basic data for habitat restoration by implementing a series of processes of capturing and translocating Kaloula borealis and managing them in artificial breeding facilities. The study site in Samcheon, Jeonju-si, Jeollabuk-do was a waste landfill site in the past, and Kaloula borealis was found during the Samcheon Ecological River Restoration Project around March 2018. To restore the habitat, a plan was established to capture, translocate, artificially breed, and release Kaloula borealis at the site. The capture methods of adult Kaloula borealis were pitfall trap and drift fence, direct capture, and deep barrels. During 2018-2019, 86 adults of Kaloula borealis were captured and translocated to artificial breeding facilities. VIE-tagging was inserted under the skin for monitoring. For artificial breeding, Gryllus bimaculatus with oyster powder and vegetables were regularly supplied to feed Kaloula borealis. At the end of October 2020, 150 young Kaloula borealis raised in artificial breeding facilities were found not entering hibernation, so they were managed in a separate artificial breeding facility. Some young and adult Kaloula borealis currently hibernating will be scheduled to be continuously managed in artificial breeding facilities and released to the restored habitat in the spring of 2021.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.31 no.1
• /
• pp.16-23
• /
• 2021

Lithium carbonate recovered from the waste solution generated during the lithium secondary battery manufacturing process contains heavy metals such as cobalt, nickel, and manganese. In this study, the recrystallization of lithium carbonate was performed to remove heavy metals contained in the powder and to increase the purity of lithium carbonate. First, the leaching efficiency of lithium carbonate according to pH in the aqueous hydrochloric acid solution was examined, and the effect on the recrystallization of lithium carbonate according to the equivalent and concentration of sodium carbonate was confirmed. As the equivalent and concentration of sodium carbonate increased, the recovery rate of lithium carbonate improved. And the SEM image showed that the crystal shape was changed depending on the reaction conditions with sodium carbonate. Finally, the high purity lithium carbonate of 99.9% or more was recovered by washing with water.

• Journal of the Korean Wood Science and Technology
• /
• v.51 no.5
• /
• pp.334-344
• /
• 2023

Dregs from the sugar palm (Arenga pinnata) starch industry are considered a waste product of the agricultural industry and have not yet been optimally utilized. Therefore, this study aimed to manufacture particleboards from dregs using different amounts of adhesive and particle size ratios. Sugar palm dregs, which had been separated into fibers and powder/fine particles, were used as raw material for making particleboards. The fiber had an average length of 6.84 ± 3.23 cm, while the fine particles were of a size that passed through size 10 mesh and remained in size 60 mesh. Three ratios of fiber to fine particles (100:0, 75:25, and 50:50 wt%) with three different amounts of sucrose-citric acid adhesive (10, 15, and 20 wt%) were used in this study. Increasing the amount of fine particles and the resin content can improve the physical properties and the internal bond strength of boards made from sugar palm dregs. The fine particles possibly filled the gap between the fibers in the particleboard, while the fibers exhibited a high bending strength. As a result, a high-performance particleboard can be attained by combining the composition ratio of fiber/fine particles and resin content. In this study, particleboards made from fiber/fine particles (75:25 wt%) and adhesive content of 15 wt% and 20 wt% had the mechanical properties that met the requirements of Japanese Industrial Standard (JIS) A 5908 type 18. Sugar palm dregs have the potential to be used as raw materials to create value-added particleboards.