• Smart Structures and Systems
• /
• v.20 no.2
• /
• pp.231-246
• /
• 2017

A recent work by the authors has demonstrated the feasibility of scour evaluation for Kao-Ping-Hsi Cable-Stayed Bridge simply based on ambient vibration measurements. To further attain the goal of scour monitoring, a key challenge comes from the interference of several environmental factors that may also significantly alter the pier frequencies without the change of scour depth. Consequently, this study attempts to investigate the variation in certain modal frequencies of this bridge induced by several environmental factors. Four sets of pier vibration measurements were taken either during the season of plum rains, under regular summer days without rain, or in a period of typhoon. These signals are analyzed with the stochastic subspace identification and empirical mode decomposition techniques. The variations of the identified modal frequencies are then compared with those of the corresponding traffic load, air temperature, and water level. Comparison of the analyzed results elucidates that both the traffic load and the environmental temperature are negatively correlated with the bridge frequencies. However, the traffic load is clearly a more dominant factor to alternate the identified bridge deck frequency than the environmental temperature. The pier modes are also influenced by the passing traffic on the bridge deck, even though with a weaker correlation. In addition, the variation of air temperature follows a similar tendency as that of the passing traffic, but its effect on changing the bridge frequencies is obviously not as significant. As for the effect from the alternation of water level, it is observed that the frequency baselines of the pier modes may positively correlate with the water level during the seasons of plum rains and typhoon.

• Asian-Australasian Journal of Animal Sciences
• /
• v.13 no.5
• /
• pp.673-680
• /
• 2000

An experiment was conducted with day-old 300 commercial male broiler chicks (Arbor Acres$^{(R)}$) to evaluate the efficacy of crude phytase preparerations produced from a culture of Aspergillus ficcum. The experiment consisted of five dietary treatments; T1, com-soy control diet with 0.45% non-phytate phosphorus (NPP) for starter period and 0.35% NPP for grower period; T2, control - 0.1% NPP; T3, control 0.2% NPP; T4, T3+600 U of crude phytase (broth+cell); and T5, T3+600 U of crude phytase (broth). The body weight gain, feed intake, and feed/gain of chickens fed T1 diet was highest (p<0.01) among treatments. BW gain and feed intake of T4 and T5 were greater than those of T3 but were less than those of T1 and T2. T3 was highest in mortality among treatments. Decreasing the NPP level lowered availability of DM, crude ash, ether extract, crude fiber, Zn, and Fe but supplementation of crude phytase preparations improved the availability of these nutrients as well as those of Ca, P and Cu. Excretion of P and Cu significantly decreased as the NPP level in the diet decreased. Further reduction of P and Cu excretion and reduction of Ca, Mg and Fe excretion were achieved by supplementation of crude phytase preparations. The serum concentrations of Ca, P, Mg, Zn, Fe, and Cu were significantly increased by crude phytase supplementation. The weight and length of tibia, and contents of crude ash, Ca, P, Mg, and Zn were adversely affected by lowering NPP level but partially recovered by supplementation of crude phytase preparations. In conclusion, lowering NPP level in the broiler diet significantly depressed the performance. Supplementation of crude phytase preparations produced from Aspergillus ficuum could partially recover the depression.

• Journal of radiological science and technology
• /
• v.44 no.5
• /
• pp.451-457
• /
• 2021

Recently, the number of interventional procedures has increased dramatically as an alternative of invasive surgical procedure and patient radiation exposure is also increasing accordingly. In this study, we evaluated the patient dose of major interventional procedures nationwide and we established our Korean database. With these results, we tried to suggest the reference dose level for major interventional procedures. We evaluated patent dose data in the field of interventional radiology from foreign countries. Measurement of radiation dose exposure for 11 major interventional procedures was conducted using embedded DAP meters in 10,006 patients from 47 hospitals, and reference level of each interventional procedure was suggested. The DRLs of each intervenional procedure are as follows: TACE 206(Gy·cm²), AVF 12(Gy·cm²), LE intervention 43(Gy·cm²), TFCA 122(Gy·cm²), Cerebral aneurysm coil embolization 214(Gy·cm²), PTBD 22(Gy·cm²), Biliary stent 60(Gy·cm²), PCN 7(Gy·cm²), Hickman catheter 2.1(Gy·cm²), Chemoport 1.4(Gy·cm²), BAE 104(Gy·cm²). Compared with the previously established DRL in 2012, the radiation dose decreased in all 10 interventional procedures. In the future, continuous publicity and education on the radiation dose reduction will be needed.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.19 no.6
• /
• pp.26-36
• /
• 2020

The use of existing macroscopic research of pedestrian behavior on the walking link as data is limited in determining an individual pedestrian's moving route and the level of service. In macroscopic studies, it is difficult to make quantitative indices, such as pedestrian flow rate, occupied space, density, and speed for determining the level of service on pedestrian roads. Therefore, the microscopic pedestrian route is required to establish appropriate pedestrian policies. In this study, the Yeok-Sam subway station network was examined using a micro-simulation VISSIM, which was then calibrated and validated statistically. The Pedestrian Road's Level of Service of Yeok-Sam subway station area was evaluated using the pedestrian speed as the evaluating index on the Korean highway capacity handbook.

• Progress in Medical Physics
• /
• v.32 no.4
• /
• pp.92-98
• /
• 2021

Purpose: This study automatically discriminates homogeneous and structure edge regions on computed tomography (CT) images, and it evaluates the noise level and edge preservation ratio (EPR) according to the different types of iterative reconstruction (IR). Methods: The dataset consisted of CT scans of 10 patients reconstructed with filtered back projection (FBP), statistical IR (iDose⁴), and iterative model-based reconstruction (IMR). Using the 10th and 85th percentiles of the structure coherence feature, homogeneous and structure edge regions were localized. The noise level was estimated using the averages of the standard deviations for five regions of interests (ROIs), and the EPR was calculated as the ratio of standard deviations between homogeneous and structural edge regions on subtraction CT between the FBP and IR. Results: The noise levels were 20.86±1.77 Hounsfield unit (HU), 13.50±1.14 HU, and 7.70±0.46 HU for FBP, iDose⁴, and IMR, respectively, which indicates that iDose⁴ and IMR could achieve noise reductions of approximately 35.17% and 62.97%, respectively. The EPR had values of 1.14±0.48 and 1.22±0.51 for iDose⁴ and IMR, respectively. Conclusions: The iDose⁴ and IMR algorithms can effectively reduce noise levels while maintaining the anatomical structure. This study suggested automated evaluation measurements of noise levels and EPRs, which are important aspects in CT image quality with patients' cases of FBP, iDose⁴, and IMR. We expect that the inclusion of other important image quality indices with a greater number of patients' cases will enable the establishment of integrated platforms for monitoring both CT image quality and radiation dose.

• 한국터널공학회:학술대회논문집
• /
• 2005.04a
• /
• pp.63-74
• /
• 2005

The environmental influence in tunnel construction is the drying of the ground water, the drop of the ground water level, and noise and vibration by tunnel excavation. The environmental influence can cause the change of natural ecosystem and the source of popular complaints. In case of popular complaints, the tunnel construction can be stopped or the construction period can be extended. Also, the financial loss may be reached to hundreds of billions won. The technology development to minimize the environmental influence in the tunnel construction is very important in order to control popular complaints and to preserve ecosystem. It should be required the investigation, the evaluation, and the assessment of environmental impact to reduce environmental influence in the tunnel construction. The objective of this research is to review the environmental impact assessment in Korea and to introduce the environmental protection technology which minimizes the environmental influence generated in the tunnel construction.

• Proceedings of the Korean Society for Language and Information Conference
• /
• 2007.11a
• /
• pp.415-421
• /
• 2007

This paper proposes a convolution tree kernel-based approach for relation extraction where the parse tree is expanded with entity features such as entity type, subtype, and mention level etc. Our study indicates that not only can our method effectively capture both syntactic structure and entity information of relation instances, but also can avoid the difficulty with tuning the parameters in composite kernels. We also demonstrate that predicate verb information can be used to further improve the performance, though its enhancement is limited. Evaluation on the ACE2004 benchmark corpus shows that our system slightly outperforms both the previous best-reported feature-based and kernel-based systems.

• Journal of Korea Technology Innovation Society
• /
• v.8 no.3
• /
• pp.932-954
• /
• 2005

The purpose of this paper is to evaluate of The University of Science and Technology (UST) as field-oriented graduate school model. The UST is unique in world-wide because of its operating system through the synergy effect of research and education and its interdisciplinary major system differentiated from the traditional graduate school, It first deals with measuring the users satisfaction by using a five-point Likert scale to analyze the general and special factors of UST, through which some findings are pointed out as follows; the education aims and visions are highly satisfied while essential factors in field-oriented education such as curriculum composition, apprentice and tailored education system, field training are not so high level. Finally it points out some suggestions for the UST development.

• Proceedings of the KIEE Conference
• /
• 2003.07a
• /
• pp.366-368
• /
• 2003

In this paper, a parametric evaluation method of protection ability is proposed. The adequacy of every parameter is evaluated for the setting rules. Then the results are combined to give protection level of a whole protective system. The setting rules are categorized into three groups for hierarchical calculation. The proposed scheme is applied to a location problem of a new protective device to show its effectiveness.

• Journal of Technologic Dentistry
• /
• v.33 no.2
• /
• pp.121-128
• /
• 2011

Purpose: The purpose of this study is to investigate the level of each metal in non-precious metal alloys dental casting, still used even banned for use and trade by the law, for oral health. Methods: Two kinds of metal alloys were analyzed. One was Ticonium 100 for removable prosthesis and the other was Rexillium V for dental porcelain. Two samples of each metal alloy were made in 0.5g, 1.0g, and 1.5g. Total number of samples were 12. Two kinds of lactic acid Solution, pH7 and pH4.6, were injected into each samples. After injection, each samples had been for 21days ${\pm}$ 1 hour in the water tank of which temperature was $37^{\circ}C$. The level of metal was measured in each sample by inductively couplled plasma-atomic emission spectrometer. Results: In both metal alloys, metals, chrome, nickel, beryllium, and molybdenum, were founded. In Ticonium 1000, the highest level of nickel was 2.531ppm in 1.5g pH4.6 sample while the highest level of nickel was 4.062ppm in 1.5g pH4.6 sample of Rexillium V. In chemical composition of these methal alloys, chrome(14~17%) was much more than beryllium(1.95~1.99%) and molybdenum(5.0~9.0%) but berllium and molybdenum were founded more than chrome in samples. Therefore, chrome showed better anti-corrosion than other metal alloys. In both metal alloys, more metals were founded in higher pH level and more mass. Levels of chrome was significantly different in samples of both metal alloys in each pH level(p<0.05). Levels of nickels was significantly different in samples of both metal alloys in each pH level(p<0.05). Conclusion: For oral health, further studies are needed in nickel-chrome metal alloy and cobalt metal alloy of non-beryllium in addittion to beryllium metal alloy and also long-term studies needed in various period and other non-percious metal alloys for dental casting.