• Journal of Environmental Science International
• /
• v.23 no.10
• /
• pp.1745-1753
• /
• 2014

Sediment microbial fuel cell (SMFC), equipped with Zn, Al, Cu, Fe or graphite felt (GF) anode and marine sediment, was performed. Graphite felt was used as a common cathode. SMFC was single chambered and did not use any redox mediator. The aim of this work was to find efficient anodic material. Oxidation reduction potential (ORP), cell voltage, current density, power density, pH and chemical oxygen demand (COD) were measured for SMFC's performance.. The order of maximum power density was $913mWm^{-2}$ for Zn, $646mWm^{-2}$ for Fe, $387.8mWm^{-2}$ for Cu, $266mWm^{-2}$ for Al, and $127mWm^{-2}$ for graphite felt (GF). The current density over voltage was found to be strongly correlated with metal electrodes, but the graphite felt electrode, in which relatively weaker electricity was observed because of its bio-oriented mechanism. Metal corrosion reactions and/or a complicated microbial electron transfer mechanism acting around the anodic compartment may facilitate to generate electricity. We presume that more sophisticated selection of anodic material can lead to better performance in SMFC.

• Korean Chemical Engineering Research
• /
• v.54 no.2
• /
• pp.171-174
• /
• 2016

Enzyme fuel cells were composed of enzyme cathode and PEMFC anode. Enzyme cathode was fabricated by compression of a mixture of graphite particle, laccase as a enzyme and ABTS as a redox mediator, and then coated with Nafion ionomer. Open circuit voltage (OCV) were measured with variation of cathode manufacture factors, to find optimum condition of enzyme cathode. Optimum pressure was 4.0 bar for enzyme cathode pressing process. Highest OCV was obtained at 95% graphite composition in enzyme cathodee. Optimum glucose concentration was 0.4 mol/l in cathode substrate solution.

• Journal of the Korean Electrochemical Society
• /
• v.8 no.3
• /
• pp.117-124
• /
• 2005

Electrochemical oxidation of ethanol at nickel electrodes has been studied in 1 M KOH solution containing 0.20M ethanol using electrochemical impedance spectroscopy. Equivalent circuits have been worked out by simulating the impedance data, and the results were used to model the oxidation of ethanol as well as the passivation of the electrode. The maximum rate of oxidation of $Ni(OH)_2$ to NiOOH was observed at about 0.37V vs. Ag/AgCl reference electrode, while the maximum rate of ethanol oxidation at the Ni electrode was observed at about 0.42V, The charge-transfer resistance for oxidation of the electrode itself became smaller in the presence of ethanol than in its absence. These results suggest that the $\beta-Ni(OH)_2/\beta-NiOOH$ redox couple is acting as an effective electron transfer mediator far ethanol oxidation. The kinetic parameters also were obtained by the experimental and simulated results.

• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1520-1522
• /
• 2003

Molecular self-assembled of surfactant viologen are of recent interest because they can from functional electrodes as well as micellar assemblies, which can be Profitably utilized for display devices, photoelectrochemical studies and electrocatalysis as electron acceptor or electron mediator. Fromherz et al studied the self-assembly of thiol and disulfide derivatives of viologens bearing long n-alkyl chains on Au electrode surface. The electrochemical behavior of self-assembled viologen monolayer has been investigated with QCM, which has been known as nano-gram order mass detector. The self-assembly process of viologen was monitored using resonant frequency (${\Delta}$F) and resonant resistance (R). The redox process of viologen was observed with resonant frequency (${\Delta}$F).

• Molecules and Cells
• /
• v.46 no.3
• /
• pp.165-175
• /
• 2023

The transcription factor Nrf2 was originally identified as a master regulator of redox homeostasis, as it governs the expression of a battery of genes involved in mitigating oxidative and electrophilic stress. However, the central role of Nrf2 in dictating multiple facets of the cellular stress response has defined the Nrf2 pathway as a general mediator of cell survival. Recent studies have indicated that Nrf2 regulates the expression of genes controlling ferroptosis, an iron-and lipid peroxidation-dependent form of cell death. While Nrf2 was initially thought to have anti-ferroptotic function primarily through regulation of the antioxidant response, accumulating evidence has indicated that Nrf2 also exerts anti-ferroptotic effects via regulation of key aspects of iron and lipid metabolism. In this review, we will explore the emerging role of Nrf2 in mediating iron homeostasis and lipid peroxidation, where several Nrf2 target genes have been identified that encode critical proteins involved in these pathways. A better understanding of the mechanistic relationship between Nrf2 and ferroptosis, including how genetic and/or pharmacological manipulation of Nrf2 affect the ferroptotic response, should facilitate the development of new therapies that can be used to treat ferroptosis-associated diseases.

• Journal of the Korean Electrochemical Society
• /
• v.17 no.1
• /
• pp.30-36
• /
• 2014

Redox complexes to transport electrons from enzyme to electrodes are very important part in glucose sensor. Pentacyanoferrate-bound aniline ($Fe(CN)_5$-aminopyridine), was prepared as a potential redox mediator in a glucose dehydrogenase (GDH)-glucose sensor. The synthesized pyridyl-$NH_2$ to pentacyanoferrate was characterized by the electrochemical and spectroscopic methods. A amperometric enzyme-linked electrode was developed based on GDH, which catalyses the oxidation of glucose. Glucose was detected using GDH that was co-immobilized with an $Fe(CN)_5$-aminopyridine and gold nano-particles (AuNPs) on ITO electrodes. The $Fe(CN)_5$-aminopyridine and AuNPs immobilized onto ITO electrodes provided about a two times higher electrochemical response compared to that of a bare ITO electrode. As glucose was catalyzed by wired GDH, the electrical signal was monitored at 0.4 V versus Ag/AgCl by cyclic voltammetry. The anode currents was linearly increased in proportion to the glucose concentration over the 0~10 mM range.

• Journal of Hydrogen and New Energy
• /
• v.26 no.2
• /
• pp.179-183
• /
• 2015

In this study, we propose a catalyst structure including enzyme and metal nano rod for glucose sensing. In the catalyst structure, glucose oxidase (GOx) and gold nano rod (GNR) are alternatingly immobilized on the surface of carbon nanotube (CNT), while poly(ethyleneimine) (PEI) is inserted in between the GOx and GNR to fortify their bonding and give them opposite polarization ($[GOx/GNR]_nPEI/CNT$). To investigate the impact of $[GOx/GNR]_nPEI/CNT$ on glucose sensing, some electrochemical measurements are carried out. Initially, their optimal layer is determined by using cyclic voltammogram and as a result of that, it is proved that $[GOx/GNR/PEI]_2/CNT$ is the best layer. Its glucose sensitivity is $13.315{\mu}AmM^{-1}cm^{-2}$. When it comes to the redox reaction mechanism of flavin adenine dinucleotide (FAD) within $[GOx/GNR/PEI]_2/CNT$, (i) oxygen plays a mediator role in moving electrons and protons generated by glucose oxidation reaction to those for the reduction reaction of FAD and (ii) glucose does not affect the redox reaction of FAD. It is also recognized that the $[GOx/GNR/PEI]_3/CNT$ is limited to the surface reaction and the reaction is quasi-reversible.

• Microbiology and Biotechnology Letters
• /
• v.48 no.4
• /
• pp.463-470
• /
• 2020

The JS18 strain was isolated from an old tree forest and produced extracellular enzymes that decolorize synthetic melanin. Phylogenetic analysis, based on the internal transcribed spacer (ITS) sequence, indicate that JS18 belongs to the Trametes velutina species. JS18 demonstrated laccase activity but no manganese peroxidase or lignin peroxidase activity. Batch culture indicated that the melanin decolorization activity of JS18 strain originated from the laccase. Syringic acid and CuSO4 induced maximum laccase production, yielding 98 U/ml laccase activity after cultivation for 7 days at 25℃. T. velutina secretes an extracellular laccase in GYP medium, and this enzyme was purified using (NH4)2SO4 precipitation, Hi-trap Q Sepharose columns and gel filtration. The molecular weight of the purified enzyme was estimated to be 67 kDa using sodium dodecyl sulfate polyacrylamide gel electrophoresis. This enzyme produced 80% of its melanin decolorization activity within the first 24 h of evaluation in the presence of 1-hydroxybenzotriazole (HBT), while only about 4% of the melanin was decolorized in the absence of the mediator. The greatest decolorization was observed at 1.5 mM/l HBT, which decolorized 81% of the melanin within the first 24 h. The optimum pH and temperature for this decolorization were found to be 5.0 and 37℃, respectively. Our results suggest the possibility of applying HBT induced T. velutina JS18 laccase-catalyzed melanin decolorization.

• Journal of Microbiology and Biotechnology
• /
• v.27 no.6
• /
• pp.1120-1127
• /
• 2017

Marasmius scorodonius secretes an extracellular laccase in potato dextrose broth, and this enzyme was purified up to 206-fold using $(NH_4)_2SO_4$ precipitation and a Hi-trap Q Sepharose column. The molecular mass of the purified laccase was estimated to be ~67 kDa by SDS-PAGE. The UV/vis spectrum of the enzyme was nontypical for laccases, and metal content analysis revealed that the enzyme contains 1 mole of Fe and Zn and 2 moles of Cu per mole of protein. The optimal pH for the enzymatic activity was 3.4, 4.0, and 4.6 with 2,2'-azino-bis(3-ethylbenzothazoline-6-sulfonate) (ABTS), guaiacol, and 2,6-dimethoxy phenol as the substrate, respectively. The optimal temperature of the enzyme was $75^{\circ}C$ with ABTS as the substrate. The enzyme was stable in the presence of some metal ions such as $Ca^{2+}$, $Cu^{2+}$, $Ni^{2+}$, $Mg^{2+}$, $Mn^{2+}$, $Ba^{2+}$, $Co^{2+}$, and $Zn^{2+}$ at a low concentration (1 mM), whereas $Fe^{2+}$ completely inhibited the enzymatic activity. The enzymatic reaction was strongly inhibited by metal chelators and thiol compounds except for EDTA. This enzyme directly decolorized Congo red, Malachite green, Crystal violet, and Methylene green dyes at various decolorization rates of 63-90%. In the presence of 1-hydroxybenzotriazole as a redox mediator, the decolorization of Reactive orange 16 and Remazol brilliant blue R was also achieved.

• Korean Chemical Engineering Research
• /
• v.53 no.6
• /
• pp.667-671
• /
• 2015

Enzyme fuel cells were operated with cells composed of enzyme anode and PEMFC cathode. Enzyme anodes was fabricated by compression of a mixture of graphite particle, glucose oxidase(Gox) as a enzyme and ferrocene as a redox mediator, and then coated with Nafion ionomer solution. Performances of enzyme unit cell were measured with variation of anode manufacture factors, to find optimum condition of enzyme anode. Optimum pressure was 8.89MPa for enzyme anode pressing process. Highest power density was obtained at 60% graphite composition in enzyme anode. Optimum glucose concentration was 1.7 mol/l in anode substrate solution. The enzyme anode was stabilized by two times of deeping in Nafion solution for 1 sec.