• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.25 no.1
• /
• pp.133-142
• /
• 2001

Investigation on ignition and flame propagation of pyrolyzing fuel in a cylindrical enclosure is accomplished. The pyrolyzing fuel of cylindrical shape is located in an outer cylinder sustained at high-temperature. Due to gravity, the buoyancy motion is inevitably incurred in the enclosure and this affects the flame initiation and propagation behavior. The radiative heat transfer plays an important role since a high temperature difference is involved in the problem. Therefore in all cases presented here, the intrinsic radiation effects are considered. Numerical studies have been performed over various governing parameters, such as Grashof number, overheat ratio, and vertical fuel eccentricity. Depending on the Grashof number, the flame behavior is found to be totally different: a separated visible flame appears as the Grashof number reaches 10(sup)7. The location of flame onset is also affected by the vertical eccentricity of inner pyrolyzing fuel as well as thermal conditions applied.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.13 no.1
• /
• pp.115-124
• /
• 1989

Near-threshold fatigue crack-growth behavior at room temperature for a duplex stainless steel weldments was investigated to evaluate the effect of load ratio, microstructural change, and residual stresses. Near-threshold fatigue crack propagation behavior is found to show a marked sensitivity to .alpha./.gamma. phase ratio, and little residual stress effects. Threshold values in the heat affected zones are higher than those of base metals and threshold values for crack growth decrease with increasing the load ratio in the base metals and weldments. The fractrographic features in base metals, weldments and heat affectred zones were discussed in terms mechanism of crack growth.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.16 no.6
• /
• pp.1-8
• /
• 2012

An experimental study has been conducted to scrutinize into the influence of ultrasonic standing wave on the propagating behavior and structural stabilization of propane/air premixed flame at various equivalence ratios in half-open rectangular duct. Evolutionary features of the flame fronts are caught by high-speed images, and the variation of flame structure and local flame velocities along the propagation are analyzed. It is revealed that the propagation velocity agitated by the ultrasonic standing wave is greater than that without the agitation: the velocity enhancement diminishes as the equivalence ratio approaches the stoichiometric. Influence of standing wave on the flame overwhelms that of the buoyancy which slants the flame front towards top of the duct, and thus the standing wave contributes to the structural stabilization of propane/air premixed flame.

• Journal of the Society of Naval Architects of Korea
• /
• v.28 no.2
• /
• pp.228-240
• /
• 1991

Many experimental data of fatigue crack propagation show that the fatigue crack propagation process is stochastic. Therefore, the study on the crack propagation must be based on the probabilistic approach. In the present paper, fatigue crack propagation process is assumed to be a discrete Markov process and the method is developed, which can evaluate the reliability of the structural component by using Markov chain model(Unit step B-model) suggested by Bogdanoff. In this method, leak failure, plastic collapse and brittle fracture of the critical component are taken as failure modes, and the effects of initial crack distribution, periodic and non-periodic inspection on the probability of failure are considered. In this method, an equivalent load value for random loading such as wave load is used to facilitate the analysis. Finally some calculations are carried out in order to show the usefulness and the applicability of this method. And then some remarks on this method are mentioned.

• Nuclear Engineering and Technology
• /
• v.55 no.6
• /
• pp.2053-2068
• /
• 2023

Following a loss of coolant accident (LOCA), prestressing concrete containment vessels (PCCVs) may experience high thermal load as well as internal pressure. The high temperature stress would increase the risk of premature damage to the containment, which reduces the safety margin during the increasing internal pressure. However, current investigations cannot clearly address the issues of thermal-pressure coupling effect on damage propagation and thus safety of the containment. Thus, this paper offers three simple and powerful damage parameters to differentiate the severity of damage of the containment. Moreover, despite of the temperature action severely threatening the pressure performance of the containment, the research regarding the improvement of the resistant performance of the containment is quite scarce. Therefore, in this paper, a comprehensive comparison of damage propagation and mechanism between conventional and fiber-reinforced concrete (FRC) containments is performed. The effects of fiber characteristics parameters on damage propagation of structures following the LOCA are also specifically revealed. It is found that the proposed damage indices can properly indicate state of damage in the containment body and the addition of fiber can be used to obviously mitigate the damage propagation in PCCV considering the thermal-pressure coupling.

• Journal of The Korean Astronomical Society
• /
• v.56 no.1
• /
• pp.117-124
• /
• 2023

A Forbush decrease (FD) is a depression of cosmic ray (CR) intensity observed by ground-based neutron monitors (NMs). The CR intensity is thought to be modulated by the heliospheric magnetic structures including the interplanetary coronal mass ejection (ICME) surrounding the Earth. The different magnitude of the decreasing in intensity at each NM was explained only by the geomagnetic cutoff rigidity of the NM station. However, sometimes NMs of almost the same cutoff rigidity in northern and southern hemispheres observe the asymmetric intensity depression magnitudes of FD events. Thus, in this study we intend to see the effects on CR intensity modulation of FD event recorded at different NMs due to different ICME propagation directions as an additional parameter in the model explaining the CR modulation. Fortunately, since 2006 the coronagraphs of twin spacecraft of the STEREO mission allow us to infer the propagation direction of ICME associated with the FD event in 3-dimension with respect to the Earth. We suggest the hypothesis that the asymmetric CR modulations of FD events are determined by the propagation directions of the associated ICMEs.

• Journal of the Korean Mathematical Society
• /
• v.33 no.3
• /
• pp.557-573
• /
• 1996

When we attempt to describe the propagation of nonlinear dispersive waves, it is frequently necessary to take account of diffipative effects.

• Explosives and Blasting
• /
• v.22 no.1
• /
• pp.57-65
• /
• 2004

Explosive blasting in tunnel excavation produces ground vibration and air blast as its side effects, which may cause complaints from nearby residents. This study was intended to investigate the propagation characteristics of ground vibration induced by tunnel blasting and to evaluate its effects on the residential structures near the site. We have conducted field measurements for 6 blasts and acquired vibration data from 70 measuring points, some of which on positioned inside the tunnel for comparative reason. Various documentation was reviewed to determine an allowable level of peak particle velocity for the residential structures in the area and the allowable limit was set to 0.5 cm/sec. Propagation equations for peak particle velocities were derived from regression analyses using the data acquired at both the surface and the underground tunnel. Finally we proposed appropriate predictive equations for the two areas and a safe blasting criterion.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.51 no.1
• /
• pp.42-46
• /
• 2018

Fetal bovine serum (FBS) is essential for cell culture and is used in the determination of infectivity titer and propagation of viruses. To clarify the effects of FBS on the propagation of viral haemorrhagic septicaemia virus (VHSV), which is a causative agent of mass mortalities of olive flounder Paralichthys olivaceus in Korea, VHSV was inoculated into an EPC (epithelioma papulosum cyprinid) cell line supplemented with MEMs (minimal essential medium) with FBS concentrations of 0%, 2%, 5%, and 10% (MEM0, MEM2, MEM5, and MEM10), respectively, and infectivity titers were compared. Cytopathic effects were observed in all experimental groups at 2 days post virus inoculation (dpi) and all cells were detached from cell culture flasks at 7 dpi. Infectivity titers increased to 3 dpi, persisted to 7 dpi, and decreased when cells were detached. The titer of VHSV in EPC cells in MEM0 was the lowest while those in the other experimental groups showed similar levels. In conclusion, 2% (v/v) of FBS was sufficient to propagate VHSV in EPC cells and the withdrawal of VHSV from cell culture flasks should be performed before cell detachment.

• Korean Journal of Medicinal Crop Science
• /
• v.9 no.1
• /
• pp.55-61
• /
• 2001

In this study, effects of wiling peduncle on production yield and crude saponin content in Anemarrhena asphodeloides Bunge were investigation. The peduncle cutting were conduct on May 30, June 15, June 30, non-cutting of seed propagation type and young plant propagation type in Anemarrhena asphodeloides Bunge. The highest rhizome yield was 276.9g/plant on May 30, cutting puduncle in seed propagation type. The rhizome yield at seed propagation type was increased about 40.8%, compared to that at non-cutting. Crude saponin content in rhizome was 7.50% on May 30, cutting puduncle in seed propagation type. The crude saponin content at seed propagation type was increased about 32.2%, compared to that at non-cutting.