• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.4
• /
• pp.939-947
• /
• 2010

The LDPC(Low-Density Parity-Check) code, which is one of the channel encoding methods in IEEE 802.11n wireless LAN standard, has superior error-correcting capabilities. Since the hardware complexity of LDPC decoder is high, it is very important to take into account the trade-offs between hardware complexity and decoding performance. In this paper, the effects of LLR(Log-Likelihood Ratio) approximation on the performance of MSA(Min-Sum Algorithm)-based LDPC decoder are analyzed, and some optimal design conditions are derived. The parity check matrix with block length of 1,944 bits and code rate of 1/2 in IEEE 802.11n WLAN standard is used. In the case of $BER=10^{-3}$, the $E_b/N_o$ difference between LLR bit-widths (6,4) and (7,5) is 0.62 dB, and $E_b/N_o$ difference for iteration cycles 6 and 7 is 0.3 dB. The simulation results show that optimal BER performance can be achieved by LLR bit-width of (7,5) and iteration cycle of 7.

• The KIPS Transactions:PartC
• /
• v.12C no.7 s.103
• /
• pp.1039-1046
• /
• 2005

TCP SACK is the unique mechanism to reflect the situation of sink's sequence space, some TCP variants and proposals can perform in conjunction with SACK mechanism for achieving optimal performance. By definition of RFC 2018, however, each contiguous block of data queued at the data receiver is defined in the SACK option by two 32-bit unsigned integers in network byte order. Since TCP Options field has a 40-byte maximum length, when error bursts now, we note that the available option space may not be sufficient to report all blocks present in the receiver's queue and lead to unnecessarily force the TCP sender to retransmit Packets that have actually been received by TCP sink. For overcoming this restriction, in this thesis, a new solution named 'one-byte offset based SACK mechanism' is designed to further improve the performance or TCP SACK and prevent those unwanted retransmissions. The results or both theory analysis and simulation also show that his proposed scheme operates simply and more effectively than the other existing schemes by means of the least bytes and most robust mechanism to the high packet error rates often seen in networks environment.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.5 no.3
• /
• pp.206-215
• /
• 2005

In this paper, we propose a new design method of Genetic Algorithm Processor(GAP) and Evolvable Hardware(EHW). All sorts of creature evolve its structure or shape in order to adapt itself to environments. Evolutionary Computation based on the process of natural selection not only searches the quasi-optimal solution through the evolution process, but also changes the structure to get best results. On the other hand, Genetic Algorithm(GA) is good fur finding solutions of complex optimization problems. However, it has a major drawback, which is its slow execution speed when is implemented in software of a conventional computer. Parallel processing has been one approach to overcome the speed problem of GA. In a point of view of GA, long bit string length caused the system of GA to spend much time that clear up the problem. Evolvable Hardware refers to the automation of electronic circuit design through artificial evolution, and is currently increased with the interested topic in a research domain and an engineering methodology. The studies of EHW generally use the XC6200 of Xilinx. The structure of XC6200 can configure with gate unit. Each unit has connected up, down, right and left cell. But the products can't use because had sterilized. So this paper uses Vertex-E (XCV2000E). The cell of FPGA is made up of Configuration Logic Block (CLB) and can't reconfigure with gate unit. This paper uses Vertex-E is composed of the component as cell of XC6200 cell in VertexE

• KIPS Transactions on Computer and Communication Systems
• /
• v.12 no.6
• /
• pp.181-188
• /
• 2023

Block cipher is not expected to be safe for quantum computer, as Grover's algorithm reduces the security strength by accelerating brute-force attacks on symmetric key ciphers. So it is necessary to check the post-quantum security strength by implementing quantum circuit for the target cipher. In this paper, we propose the optimal quantum circuit implementation result designed as a technique to minimize the use of quantum resources (qubits, quantum gates) for SIMECK lightweight cryptography, and explain the operation of each quantum circuit. The implemented SIMECK quantum circuit is used to check the estimation result of quantum resources and calculate the Grover attack cost. Finally, the post-quantum strength of SIMECK lightweight cryptography is evaluated. As a result of post-quantum security strength evaluation, all SIMECK family cipher failed to reach NIST security strength. Therefore, it is expected that the safety of SIMECK cipher is unclear when large-scale quantum computers appear. About this, it is judged that it would be appropriate to increase the block size, the number of rounds, and the key length to increase the security strength.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.3
• /
• pp.230-236
• /
• 2020

A trash screen is installed in front of the inflow channel of a drainage pumping station, sewage treatment plant, and a power plant to block floating contaminants. The bottleneck phenomenon, which decreases the water inflow, causes damage to the damper as a result of clogging in between the screen if string type obstacles are not removed. In this paper, the apron was removed, and the screen was expanded, to prevent breakage of the bottleneck phenomenon and string type obstacles. This was designed using an extended rake by adding an inner rake in between the screen interspace to remove the bottleneck phenomenon and string type obstacles. To design the inner rake that satisfies the allowable stresses of the existing damper rake, the experiment points were determined according to the experimental design method using the inner rake vertical length and the thickness of the reinforced section as parameters. The use of the ANSYS static structural module and statistical analysis tool R software gives the optimized shape according to the response surface method. The relative error between the response surface analysis results and the simulation results was 1.63% of the determined optimal design-point rake length of 210.2 mm and the reinforcement section thickness of 2 mm. Through empirical experiments, a test rake was constructed to the actual size, and approximately 97% of the bottleneck phenomenon and string type obstacles could be removed.

• Horticultural Science & Technology
• /
• v.34 no.1
• /
• pp.67-76
• /
• 2016

This study was conducted to examine the optimal environmental condition for promoting the growth of sowthistle as affected by light quality and photoperiod in a closed-type plant production system. Seeds were sown in 240-cell plug trays and then germinated for 3 days at a 24-hour photoperiod in a closed-type plant production system with LED lights (R:B:W = 8:1:1). Seedlings were transplanted and grown under 3 types of LED (R:B:W = 8:1:1, R:W = 3:7, or R:B = 8:2) and 4 photoperiods (24/0, 16/8, 8/16, or 4/20 hours) with $230{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ light intensity at a density of $20cm{\times}20 cm$. The experimental design was a randomized complete block design. Plants were cultured for 40 days un der the condition of $21{\pm}2^{\circ}C$ and $70{\pm}10%$ relative humidity after transplanting. Plants were fed with a recycling nutrient solution (pH 7.0 and EC $2.0dS{\cdot}m^{-1}$) contained in a deep floating tank. Fresh weight and dry weight of shoot or root, leaf length, and leaf area were the greatest in the photoperiod of 24/0 (light/dark) with RW LED. The highest number of leaves occurred in the photoperiod of 16/8 (light/dark) with RB LED, while the incidence of tip burn was higher in the photoperiod of 24/0 (light/dark) compared to the other treatments. Chlorophyll value was the highest in the 16/8 (light/dark) photoperiod and there was no significant difference by light quality. Chlorophyll fluorescence was the lowest in the photoperiod of 24/0 (light/dark) compared with other treatments. Therefore, in terms of economic feasibility and productivity for Ixeris dentata Nakai cultivation in a closed-type plant production system, the results obtained suggest that plants grew the best when kept in a photoperiod of 16/8 (light/dark) and light quality of combined LED RW (3:7).

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.44 no.2
• /
• pp.64-70
• /
• 2024

The experiment was conducted to determine the changes in seed productivity of Italian ryegrass (Lolium multiflorum Lam.) according to nitrogen fertilization levels in the southern region of Korea. Italian ryegrass (IRG) variety 'Green Call' was sown in the fall of 2021 in Jinju, Gyeongsangnam-do. The experiment consisted of three nitrogen fertilizer levels (100, 120, and 140 N kg/ha) with three replications using a randomized complete block design. Harvesting was done approximately 30 days after heading on May 18th. There was no difference in heading date among treatments, which occurred on April 18th. The longest IRG was observed in the 140 N kg/ha treatment, but there was no significant difference. No significant differences were observed in lodging, disease resistance, and cold tolerance among treatments, but lodging was severe in all treatments. The length of the spike averaged 44.95 cm, with no difference among treatments, and the number of seeds per spike was highest in the 120 N kg/ha treatment. Seed yield increased with increasing nitrogen fertilizer levels, averaging 3,707 kg/ha (as-fed basis). DM content of seed and straw averaged 76.95% and 62.19%, respectively, with no significant differences among treatments. The remaining straw after harvesting averaged 6,525 kg/ha on a dry matter basis, with the highest value observed in the 140 N kg/ha treatment. Overall, considering the results, the optimal nitrogen fertilizer application rate for seed production of Italian ryegrass in the southern region when sown in autumn was found to be 120 N kg/ha.