• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2006년도 하계종합학술대회
• /
• pp.577-578
• /
• 2006

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제9권1호
• /
• pp.61-66
• /
• 2009

We have investigated the noise sensitivity of low noise amplifier (LNA) at different frequency. This noise sensitivity analysis provides insights about noise parameters and it is very beneficial for making appropriate design trade-offs. From this work, the circuit designer can choose the adequate noise parameters tolerances.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제9권1호
• /
• pp.55-60
• /
• 2009

The channel backscattering coefficient and injection velocity have been extracted experimentally in 65nm MOSFETs. Thanks to an experimental extraction methodology taking into account multi-subband population, we demonstrate that the short channel ballistic efficiency is slightly greater than long channel ballistic efficiency.

• IEIE Transactions on Smart Processing and Computing
• /
• 제4권6호
• /
• pp.434-442
• /
• 2015

In this paper, we propose an integrated spatial and view scalable video codec based on high efficiency video coding (HEVC). The proposed video codec is developed based on similarity and uniqueness between the scalable extension and 3D multi-view extension of HEVC. To improve compression efficiency using the proposed scalable multi-view video codec, inter-layer and inter-view predictions are jointly employed by using high-level syntaxes that are defined to identify view and layer information. For the inter-view and inter-layer predictions, a decoded picture buffer (DPB) management algorithm is also proposed. The inter-view and inter-layer motion predictions are integrated into a consolidated prediction by harmonizing with the temporal motion prediction of HEVC. We found that the proposed scalable multi-view codec achieves bitrate reduction of 36.1%, 31.6% and 15.8% on the top of ${\times}2$, ${\times}1.5$ parallel scalable codec and parallel multi-view codec, respectively.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제10권1호
• /
• pp.45-48
• /
• 2010

An inter-pin skew compensation scheme is proposed, which minimizes the inter-pin skew of parallel interface induced by unequal trace length and loading of printed circuit board (PCB). The proposed scheme measures the inter-pin skew and compensates during power-up with simple hardware. The proposed scheme is applied to 3.2-Gb/s/pin DDR4 SDRAM and implemented in a 0.18 m CMOS process. The inter-pin skew is compensated in 324-cycles of 400-MHz clock and the skew is compensated to be less than 24-ps.

• 한국국방경영분석학회지
• /
• 제31권2호
• /
• pp.105-115
• /
• 2005

To ensure interoperability among TADILs, we need inter-operational system of tactical data link that allows sharing of specific, planned information among different TADILs. In this paper, we have proposed the design of a conceptual software architecture of inter-operational system. For developing of a conceptual software architecture, we analyze the actual condition of ADSI used in the US military and identify functions and quality-attributes. Based on these factors, we design the conceptual software architecture for inter-operational system of tactical data link using Attribute-Driven Design(ADD) method. ADD is consist of three phases - choose the module to decompose, refine the module, repeat the steps for every module that needs further decomposition. To evaluate of ADD results, we apply the Software Architecture Analysis Method(SAAM) which is consist of making evaluation scenarios, choosing indirect scenarios, evaluation scenarios' interaction, and creating an overall evaluation. Through the evaluation, we verify the conceptual software architecture of inter-operational system.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제6권1호
• /
• pp.361-378
• /
• 2012

Most of the current frequency hopping (FH) based dynamic spectrum access (DSA) methods concern a reactive channel access scheme with synchronous inter-channel spectrum sensing, i.e., FH is reactively triggered by the primary user (PU)'s return reported by spectrum sensing, and the PU channel to be switched to is assumed precisely just sensed or ready to be sensed, as if the inter-channel spectrum sensing moments are synchronous. However, the inter-channel spectrum sensing moments are more likely to be asynchronous, which risks PU suffering more interference. Moreover, the spectrum sensing is usually erroneous, which renders the problem more complex. To address this problem, we propose a proactive FH based DSA method against both erroneous spectrum sensing and asynchronous inter-channel spectrum sensing (moments). We term it as proactive DSA. The optimal FH sequence is obtained by dynamic programming. The complexity is also analyzed. Finally, the simulation results confirm the effectiveness of the proposed method.

• 한국정보처리학회:학술대회논문집
• /
• 한국정보처리학회 2008년도 춘계학술발표대회
• /
• pp.999-1002
• /
• 2008

Many schemes to reduce the inter-MAP handoff delay in hierarchical mobile IPv6 have been proposed but the previous schemes waste relatively large network resources to decrease the path rerouting delay. In this paper, we propose the 2-layered MAP concept, where the seamless inter-MAP handoff can be supported regardless of path rerouting time. As a result, the waste of wired resources and the rate of the inter-MAP handoff can be reduced. From the performance analysis and simulation, the inter-MAP handoff rate for non-real-time traffic is only about 1/3 of the conventional result. Such advantageous features of the proposed scheme neither incur any increase of the total handoff rate nor require additional MAPs.

• Journal of Information Technology Applications and Management
• /
• 제21권4_spc호
• /
• pp.381-401
• /
• 2014

This study proposes the accurate economic effect (employment inducement coefficient, hiring inducement coefficient, index of the sensitivity of dispersion, index of the power of dispersion, and ratio of value added) of Korea software industry by analyzing the inter-industry relation using the modified inter-industry table. Some previous studies related to the inter-industry analysis were reviewed and the key problems were identified. First, in the current inter-industry table publishedby the Bank of Korea, the output of software industry includes not only the output of pure software industry (package software and IT services) but also the output of non-software industry due to the misclassification of the industry. This causes the output to become bigger than the actual output of the software industry. Second, during rewriting the inter-industry table, the output is changing. The inter-industry table is the table in the form of rows and columns, which records the transactions of goods and services among industries which are required to continue the activities of each industry. Accordingly, if only an output of a specific industry is changed, the reliability of the table would be degraded because the table is prepared based on the relations with other industries. This possibly causes the economic effect coefficient to degrade reliability, over or under estimated. This study tries to correct these problems to get the more accurate economic effect of the software industry. First, to get the output of the pure software section only, the data from the Korea Electronics Association(KEA) was used in the inter-industry table. Second, to prevent the difference in the outputs during rewriting the inter-industry table, the difference between the output in the current inter-industry table and the output from KEA data was identified and then it was defined as the non-software section output for the analysis. The following results were obtained: The pure software section's economic effect coefficient was lower than the coefficient of non-software section. It comes from differenceof data to Bank of Korea and KEA. This study hasa signification from accurate economic effect of Korea software industry.

• 한국전산구조공학회논문집
• /
• 제24권6호
• /
• pp.707-714
• /
• 2011

층간변위율은 구조물의 내진성능을 평가하는데 널리 사용되는 지표 중의 하나이다. 지진에 의해 발생하는 층간변위율이 클수록 지진에 의한 손상이 커지는 것으로 알려져 있다. 이러한 이유로 층간변위율을 감소시키는 설계기술은 내진설계분야에서 중요한 이슈이다. 그럼에도 불구하고 현재까지는 지진하중을 받는 구조물에 대한 현실적인 층간변위설계기법이 제시되고 있지 않다. 본 연구는 재분배 기법을 이용하여 철골모멘트골조의 내진성능을 향상시키기는 최적 층간변위설계기법을 제시한다. 이 기법은 층간변위율 차이를 최소화함으로써 구조물의 층별 층간변위율을 고르게 분포시키고, 최대 층간변위율을 감소시킨다. 이 기법은 단위하중법으로 계산된 변위기여도를 이용하여 구조재의 단면성능을 재설계하기 때문에 반복적인 구조해석없이 구조물의 내진성능을 향상시킬 수 있는 장점을 가진다. 이 기법의 효율성 검증을 위해 철골모멘트골조 예제 적용을 실시하였다.