• Journal of Electrochemical Science and Technology
• /
• v.11 no.4
• /
• pp.421-429
• /
• 2020

This report describes the simultaneous detection of the two dyes most commonly used in food, tartrazine (TZ) and sunset yellow (SY), based on a microcomposite of carbon paste decorated with La₂O₃ and TiO₂. Anodic currents for SY-TZ were observed at 0.89-1.21 V by cyclic voltammetry (CV) separated with a ΔV of 0.32 V. The increased anodic peak currents compared to that of the unmodified carbon paste electrode were almost 50 and 41% for SY-TZ, respectively. The detection limits with the optimal amount of La₂O₃-TiO₂ were 0.02 and 0.03 µmol/L, respectively. The relative standard deviation (RSD) based on fifty measurements was less than 3%. The versatility and novelty of the sensor were tested with food samples containing these substances and other substances.

• 한국연소학회:학술대회논문집
• /
• 2002.11a
• /
• pp.113-121
• /
• 2002

The distribution of volume fraction, mean diameter and number density of soot particles are measured quantitatively in a co-flow ethylene diffusion flame using a simultaneous LII/LIS measurement technique. The LII/LIS system and the measured values are, respectively, calibrated and evaluated by comparing to the informations obtained from laser light. extinction/scattering experiments, LII signal shows some sensitivity to the laser light intensity when laser power density exceeds a certain value(threshold). It is also found that there is an optimal laser intensity and a delay time in order to obtain the best result using the simultaneous LII/LIS measurement technique.

• Journal of Korean Society for Atmospheric Environment
• /
• v.16 no.6
• /
• pp.685-691
• /
• 2000

In order to provide basis for an accurate concentration determination of volatile organic compounds(VOCs) in air, four different institutions participated in simultaneous measurements of several VOC species under the experimental scheme of the Measurement and Analysis Division(MAD) of the Korea Society for Atmospheric Environment(KOSAE). Two types of experiments were undertaken by collecting and analyzing ambient air samples from the 7th floor of Natural Science Building, Han Tang University during two day periods of the late May 1998. The first typer of experiment was conducted as five consecutive experiments at 2-hour intervals by two institutions. On the other hand. the second type of experiment was performed as two -10hr sampling by three different institutions. The data obtained from different type of experiments were examined using various statistical approaches. In general, the results of these experiments indicated that the VOC data produced by a number of Korean institutions be fairly agreeable.

• Macromolecular Research
• /
• v.14 no.1
• /
• pp.45-51
• /
• 2006

We conducted simultaneous, small-angle, X-ray scattering/differential scanning calorimetry (SAXS/DSC) and simultaneous, wide-angle, X-ray scattering (WAXS)/DSC measurements for a polymer blend of poly($\varepsilon$-caprolactone)/poly(ethylene glycol)(PCL/PEG). The time-dependent SAXS/DSC and WAXS/DSC results, measured while the system was quenched below the melting temperature of PCL from a melting state, revealed the competitive behavior between liquid-liquid phase separation and crystallization in the polymer blend. The time-dependent structural evolution extracted from the SAXS/WAXS/DSC results can be characterized by the following four stages in the PCL crystallization process: the induction (I), nucleation (II), growth (III), and late (IV) stages. The influence of the liquid-liquid phase separation on the crystallization of PCL was also observed by phase-contrast microscope and polarized microscope with 1/4$\lambda$ compensator.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.4 no.1
• /
• pp.37-42
• /
• 1986

This paper deals with comparison of simultaneous geodetic networks between with geographical coordinates and with plane coordinates. The adjustment computation is performed by variation of coordinates. Provisional values for observation equations are computed by extended Guass mid-latitude formula using, official coordinates ($\varphi,\lambda$) in geographical network abjustment, measurements are reduced to plane by origin scale factor (＝1.0000) Bessel ellipsoid and unit weight are adopted, and geographical coordinates are projected by Guass conformal double projection. The processing results of a test-network by distances yield the average root mean square error of position 6ㆍ2cm for adjustment with $\varphi,\lambda$ and 5.8cm for adjustment with X, Y. RMSE of discrepancy between two methods is 1.7cm. This result conform to required accracy.

• Analytical Science and Technology
• /
• v.20 no.3
• /
• pp.255-260
• /
• 2007

A new method for the simultaneous determination of low molecular weight amines and quaternary ammonium ions based on the separation by IC with a suppressor and the detection by MS with ESI has been developed. The method has been applied to the analysis of a mixture containing tetramethylammonium ion, tetraethylammonium ion, tetrapropylammonium ion, triethanolamine, trimethylamine and triethylamine. The constituents were separated by isocratic elution using an IonPac CS17 column, a cation-exchange column, and detected by conductivity and mass spectrometry. The newly developed method for the six components demonstrated that the repeatability in terms of relative standard deviation for three measurements was in the range of 0.1-0.5 %. The detection limits were between 0.2 and $0.9{\mu}g/mL$ by the IC/ESI-MS.

• Journal of Korean Association for Spatial Structures
• /
• v.19 no.1
• /
• pp.117-126
• /
• 2019

Micro-Electro-Mechanical Systems (MEMS) sensors have been widely used in Structural Health Monitoring due to their convenience and lower costs in comparison to conventional sensors. Triggered measurements are relevant in events such as earthquakes because unlike continuous measurements, they only record the structural response once an event happens. This is more cost effective and it makes the data more manageable because only the required measurements from the event are recorded. The most common method of triggering is amplitude triggering. However, lower input amplitudes (less than 0.1g) cannot be triggered by using this method. In this paper, sound triggering was introduced to allow triggered measurements for lower input amplitude values. The performance of the sound triggering and amplitude triggering were compared by a series of shaking-table tests. It was seen that sound-triggering method has a wider frequency (0.5~10Hz) and amplitude (0.01~1.0g) range of measurements. In addition, the sound triggering method performs better than the amplitude triggering method at lower amplitudes. The performance of the amplitude triggering, in terms of the triggering being simultaneous improves at higher input amplitudes.

• Journal of the Korean earth science society
• /
• v.37 no.7
• /
• pp.398-407
• /
• 2016

We cooperated with four domestic educational astronomical observatories to construct a baseline and perform simultaneous observations to determine the geocentric parallax, distance, and motion of 1036 Ganymed, an Amor asteroid near the Earth. Observations were made on the day when simultaneous observations were possible from September to November 2011. Measured distances of 1036 Ganymed were 0.394 AU on Sept. 26, 0.365 AU on Oct. 11, and 0.340 AU on Oct. 25, respectively, which were within the error range as compared with the measured distances proposed by the US Jet Propulsion Laboratory. The 1036 Ganymed showed a tilting motion during the observation period, and the tangential angular velocities were measured at $0.037-0.052^{{\prime {\prime}}\;sec^{-1}$. Through this study, it was shown that the simultaneous observations among educational astronomical observations can obtain distance measurements with an error range of about 5% for asteroids near 0.4 AU. And it expected to be used as a research & education program emphasizing collaborative observation activities based on a network between observatories.

• Restorative Dentistry and Endodontics
• /
• v.23 no.1
• /
• pp.68-93
• /
• 1998

The physical properties of polymer are greatly influenced by the extent to which a resin cures. The presence of un reacted monomer can, have a plasticizing effect on the polymer, thereby altering the physical and mechanical properties of dentin bonding agent (DBA). If the DBA does not polymerize sufficiently, it will leave a weak bonding layer and lead to lower bond strength. The purpose of this study was to evaluate the shear bond strengths(SBS) and the degree of conversion (DC) of 4 commercialy avilable dentin bonding systems which are composed of 2 multi-bottle systems [Scotchbond Multi-Purpose (SMP), AeliteBond(AB)] and 2 onebottle systems [SingleBond(SB), One-Step(OS)]. For shear bond strength measurement, labial surfaces of freshly extracted bovine incisors were ground with # 600 grit SiC paper to expose dentin. Four different groups of samples were formed, with 10 samples. being made for each of the 4 commercial DBA in each group according to the curing sequences of DBA and overlayer thickness of composites: Group I (standard cure and 1mm thick composites) : The DBA was light cured and the composites of 1mm thickness was applied ; Group II (standard cure and 2mm thick composites) : The DBA was light cured and the composites of 2mm thickness was applied; Group III (simultaneous cure and 1mm thick composites) : The DBA was not light-cured and simultaneously cured with composites of 1mm thickness; Group N (simultaneous cure and 2mm thick composites) : The DBA was. not light-cured and simultaneously cured with composites of 2mm thickness. The SBS was measured immediately after the composites was bonded to the bovine dentin using an Instron machine. The DC of the DBA was examined in a thin film under simulated conditions of the experimental groups according to the curing sequences and overlayer thickness of composites in the SBS test. using a Fourier transform Infrared(FTIR) spectrometer. The following results were obtained from SBS tests and DC measurements 1. In SBS tests, the multi-bottle DBA(SMP, AB) had a generally higher bond strength values than the one bottle DBA(SB, OS). In DC measurements, the one bottle DBA(SB, OS) had a significantly higher DC than the multi-bottle DBA(SMP, AB). 2. In all DBAs except OS, there was no significant difference between the bond strength of group I (standard cure and 1mm thick composites) and that of group III (simultaneous cure and 1mm thick composites). SMP, SB in Group I had a significantly higher DC than those in group III, but AB, OS in group I had a significantly lower DC than those in group III 3. All DBAs in Goup II (standard cure and 2mm thick composites) had significantly higher bond strength and DC than those in Group N (simultaneous cure and 2mm thick composites). 4. In all DBAs, there was no significantly different SBS and DC between Group I and Group II, but all DBAs in Group III had significantly higher SBS and DC than those in Group IV.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.943-945
• /
• 2006

The experiment on study of ambient nose generated by large-amplitude internal waves in Luzon Strait is analyzed. Simultaneous observations of internal waves and characteristics of ambient noise generated by them were carried out. Fast 50-m solitary internal wave propagated to the northwest direction with speed more than 3 m/s was observed. It was revealed an enhancing of ambient noise level (at frequency range 1-2 kHz) at a time of passing the face side of the solitary wave.