• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07a
• /
• pp.36-39
• /
• 2002

Polycrystalline silicon (poly-Si) thin film transistor (TFT) technology is emerging as a key technology for active matrix liquid crystal displays (AMLCD), allowing the integration of both active matrix and driving circuit on the same substrate (normally glass). As high temperature process is not used for glass substrate because of the low softening points below 450$^{\circ}C$. However, high temperature process is required for getting high crystallization volume fraction (i.e. crystallinity). A poly-Si thin film transistor has been fabricated to investigate the effect of high temperature process on the molybdenum (Mo) substrate. Improve of the crystallinity over 75% has been noticed. The properties of structural and electrical at high temperature poly-Si thin film transistor on Mo substrate have been also analyzed using a sputtering method

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1263-1265
• /
• 2007

The electrical characteristics of low temperature poly-Si (LTPS) thin-film transistors (TFT) with channel parallel and perpendicular to the direction of lateral growth were studied. The poly-Si film was crystallized using sequential lateral solidification (SLS) laser crystallization technique. The channel orientation dependent turn-on characteristics were investigated by using gated-diodes and capacitance-voltage measurements

• Journal of the Korean Physical Society
• /
• v.73 no.9
• /
• pp.1329-1333
• /
• 2018

We investigated the mechanism of mobility enhancement after the dehydrogenation process in polycrystalline silicon (poly-Si) thin films. The dehydrogenation process was performed by using an in-situ CVD chamber in a $N_2$ ambient or an ex-situ furnace in air ambient. We observed that the dehydrogenated poly-Si in a $N_2$ ambient had a lower oxygen concentration than the dehydrogenated poly-Si annealed in an air ambient. The in-situ dehydrogenation increased the (111) preferred orientation of poly-Si and reduced the oxygen concentration in poly-Si thin films, leading to a reduction of the trap density near the valence band. This phenomenon gave rise to an increase of the field-effect mobility of the poly-Si thin film transistor.

• ETRI Journal
• /
• v.29 no.1
• /
• pp.45-49
• /
• 2007

The poly-Si thin film transistor (TFT) shows large variations in its characteristics due to the grain boundary of poly-crystalline silicon. This results in unacceptably large input offset of low-voltage differential signaling (LVDS) receivers. To cancel the large input offset of poly-Si TFT LVDS receivers, a full-digital offset compensation scheme has been developed and verified to be able to keep the input offset under 15 mV which is sufficiently small for LVDS signal receiving.

• Korean Journal of Materials Research
• /
• v.18 no.9
• /
• pp.507-510
• /
• 2008

Electrical properties of multi-channel metal-induced unilaterally precrystallized polycrystalline silicon thin-film transistor (MIUP poly-Si TFT) devices and circuits were investigated. Although their structure was integrated into small area, reducing annealing process time for fuller crystallization than that of conventional crystal filtered MIUP poly-Si TFTs, the multi-channel MIUP poly-Si TFTs showed the effect of crystal filtering. The multi-channel MIUP poly-Si TFTs showed a higher carrier mobility of more than 1.5 times that of the conventional MIUP poly-Si TFTs. Moreover, PMOS inverters consisting of the multi-channel MIUP poly-Si TFTs showed high dynamic performance compared with inverters consisting of the conventional MIUP poly-Si TFTs.

• Journal of the Korean Vacuum Society
• /
• v.10 no.1
• /
• pp.72-80
• /
• 2001

In this paper, we present a systematic method of extracting the input parameters of poly-Si TFT(Thin-Film Transistor) for Spice simulations. This method has been applied to two different types of poly-Si TFTs such as ELA (Excimer Laser Annealing) and SMC (Silicide Mediated Crystallization) with good fitting results to experimental data. Among the Spice circuit simulators, the PSpice has the GUI(graphic user interface) feature making the composition of complicated circuits easier. We added successfully the poly-Si TFT model of AIM-Spice to the PSpice simulator, and analyzed easily to compare the electrical characteristics of pixels without or with the line RC delay. In the comparative results, the ELA poly-Si TFT is superior to the SMC poly-Si TFT in the charging time and the kickback voltage for the TFT-LCD (Thin Film Transistor-Liquid Crystal Display).

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.1
• /
• pp.1-4
• /
• 2008

The electrical characteristics of polycrystalline silicon (poly-Si) thin film transistor (TFT) crystallized by excimer laser annealing (ELA) method were evaluated, The polycrystalline silicon thin-film transistor (poly-Si TFT) has higher electric field-effect-mobility and larger drivability than the amorphous silicon TFT. However, to poly-Si TFT's using conventional processes, the temperature must be very high. For this reason, an amorphous silicon film on a buried oxide was crystallized by annealing with a KrF excimer laser (248 nm)to fabricate a poly-Si film at low temperature. Then, High permittivity $HfO_2$ of 20 nm as the gate-insulator was deposited by atomic layer deposition (ALD) to low temperature process. In addition, the solid phase crystallization (SPC) was compared to the ELA method as a crystallization technique of amorphous-silicon film. As a result, the crystallinity and surface roughness of poly-Si crystallized by ELA method was superior to the SPC method. Also, we obtained excellent device characteristics from the Poly-Si TFT fabricated by the ELA crystallization method.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.4
• /
• pp.292-297
• /
• 2003

We fabricated a single crystal silicon thin film transistor for active matrix organic light emitting displays(AMOLEDs) using silicon on insulator wafer (SOI wafer). Poly crystal silicon thin film transistor(poly-Si TFT) Is actively researched and developed nowsdays for a pixel switching devices of AMOLEDs. However, poly-Si TFT has some disadvantages such as high off-state leakage currents and low field-effect mobility due to a trap of grain boundary in active channel. While single crystal silicon TFT has many advantages such as high field effect mobility, low off-state leakage currents, low power consumption because of the low threshold voltage and simultaneous integration of driving ICs on a substrate. In our experiment, we compared the property of poly-Si TFT with that of SOI TFT. Poly-Si TFT exhibited a field effect mobility of 34 $\textrm{cm}^2$/Vs, an off-state leakage current of about l${\times}$10$\^$-9/ A at the gate voltage of 10 V, a subthreshold slope of 0.5 V/dec and on/off ratio of 10$\^$-4/, a threshold voltage of 7.8 V. Otherwise, single crystal silicon TFT on SOI wafer exhibited a field effect mobility of 750 $\textrm{cm}^2$/Vs, an off-state leakage current of about 1${\times}$10$\^$-10/ A at the gate voltage of 10 V, a subthreshold slope of 0.59 V/dec and on/off ratio of 10$\^$7/, a threshold voltage of 6.75 V. So, we observed that the properties of single crystal silicon TFT using SOI wafer are better than those of Poly Si TFT. For the pixel driver in AMOLEDs, the best suitable pixel driver is single crystal silicon TFT using SOI wafer.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.75-76
• /
• 2007

Poly-Si Schottky barrier Thin Film Transistor (SB-TFT) is manufactured with erbium silicided source/drain. High quality poly-Si film was obtained by crystallizing the amorphous Si film with Excimer laser annealing (ELA) method. The fabricated poly-Si SB-TFT devices showed low leakage current and large on/off current ratio. Moreover, the electrical characteristics were considerably improved by 3% $H_2/N_2$ gas annealing, which is attributed to the reduction of trap states at the grain boundaries and interface trap states at gate oxide/poly-si channel.

• Transactions on Electrical and Electronic Materials
• /
• v.1 no.2
• /
• pp.7-11
• /
• 2000

a-Si:H and poly-Si TFT(thin film transistor) characteristics were investigated using an inverted staggered type TFT. The TFT an as-grown a-Si:H exhibited a low field effect mobility, transconductance, and high gate threshold voltage. The poly-Si films were achieved by using an isothermal and RTA treatment for glow discharge deposited a-Si:H films. The a-Si:H films were cystallized at the various temperature from 600$^{\circ}C$ to 1000$^{\circ}C$. As anneal temperature was elevated, the TFT exhibited increased g$\sub$m/ and reduced V$\sub$ds/. V$\sub$T/. The poly-Si grain boundary passivation with grain boundary trap types and activation energies as a function of anneal temperature. The poly-si TFT showed an improved I$\sub$nm//I$\sub$off/ ratio of 10$\^$6/, reduced gate threshold voltage, and increased field effect mobility by three orders.