• Journal of the Korean Ceramic Society
• /
• v.35 no.3
• /
• pp.259-263
• /
• 1998

WSi2/CVD-Si/SiO2/Si-substrate의 폴리사이드 구조에서 실리콘 증착 POCl3 확산 그리고 WSi2 증착 유무에 따른 Thin oxide 특성을 연구했다 WSi2 막을 증착하지 않은 CVD-Si/SiO2/Si-substrate 구조에서 CVD-Si을 po-lycrystalline-Si으로 증착한 시편이 amorphous-Si을 증착한 시편보다 산화막 불량이 적다 WSi2 를 증착시킨 WSi2/CVD-Si/SiO2./Si-substrate의 구조에서 CVD-Si의 polycrystalline-Si 혹든 amorphous-Si 의 막 증착에 따른 thin oxide의 불량율 차이는 미미하다 산화막 불량은 CVD-Si에 확산시킨 인(P) 증가 즉 면저항(sheet resistance) 감소로 증가한다. Thin oxide의 절연특성은 WSi2 증착으로 저하된다 WSi2 증착으로 산화막 두께는 증가하나 막 특성은 열등해져 산화막 절연성이 떨어진다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.17 no.2
• /
• pp.265-270
• /
• 2017

4H-SiC has attracted attention for high-power and high-temperature metal-oxide-semiconductor field-effect transistors (MOSFETs) for industrial and automotive applications. The gate oxide in the 4H-SiC MOS system is important for switching operations. Above $1000^{\circ}C$, thermal oxidation initiates $SiO_2$ layer formation on SiC; this is one advantage of 4H-SiC compared with other wide band-gap materials. However, if post-deposition annealing is not applied, thermally grown $SiO_2$ on 4H-SiC is limited by high oxide charges due to carbon clusters at the $SiC/SiO_2$ interface and near-interface states in $SiO_2$; this can be resolved via low-temperature deposition. In this study, low-temperature $SiO_2$ deposition on a Si substrate was optimized for $SiO_2/4H-SiC$ MOS capacitor fabrication; oxide formation proceeded without the need for post-deposition annealing. The $SiO_2/4H-SiC$ MOS capacitor samples demonstrated stable capacitance-voltage (C-V) characteristics, low voltage hysteresis, and a high breakdown field. Optimization of the treatment process is expected to further decrease the effective oxide charge density.

• Journal of the Korean institute of surface engineering
• /
• v.33 no.4
• /
• pp.217-221
• /
• 2000

The gate oxide thickness is becoming thinner and thinner in order to speed up the semiconductor CMOS devices. We have investigated very thin$ SiO_2$ gate oxide layers and found anomaly between the thickness determined with capacitance measurement and these obtained with cross-sectional high resolution transmission electron microscopy. The thicknesses difference of the two becomes important for the thickness of the oxide below 5nm. We propose that the variation of dielectric constant in thin oxide films cause the anomaly. We modeled the behavior as (equation omitted) and determined $\varepsilon_{bulk}$=3.9 and $\varepsilon_{int}$=-4.0. We predict that optimum $SiO_2$ gate oxide thickness may be $20\AA$ due to negative contribution of the interface dielectric constant. These new results have very important implication for designing the CMOS devices.s.

• Journal of the Korean Society for Heat Treatment
• /
• v.20 no.6
• /
• pp.299-305
• /
• 2007

The effect of spray deposition of oxide particles on oxidation behaviors of as-cast Mo-14.2Si-9.6B (at%) alloys at $1200^{\circ}C$ up to for 100 hrs has been investigated. Various oxide powders are utilized to make coatings by spray deposition, including $SiO_2,\;TiO_2,\;ZrO_2,\;HfO_2$ and $La_2O_3$. It is demonstrated that the oxidation resistance of the cast Mo-Si-B alloy can be significantly improved by coating with those oxide particles. The growth of the oxide layer is reduced for the oxide particle coated Mo-Si-B alloy. Especially, for the alloy with $ZrO_2$ coating, the thickness of oxide layer becomes only one fifth of that of uncoated alloys when exposed to in air for 100 hrs. The reduction of oxide scale growth of the cast Mo-Si-B alloy due to oxide particle coatings are discussed in terms of the change of viscosity of glassy oxide phases that form during oxidation at high temperature.

• Electrical & Electronic Materials
• /
• v.7 no.1
• /
• pp.25-31
• /
• 1994

Properties of oxynitride films reoxidized by $N_2{O}$ gas after thermal oxidation and $N_2{O}$ oxide films directly oxidized by using $N_2{O}$ gas on the bare silicon wafer have been studied. From the AES analysis, nitrogen pile-up at the interface of Si/oxynitride and Si/$N_2{O}$ oxide has observed. $N_2{O}$ oxide and oxynitride films have the self-limited characteristics. Therefore, it will be possible to obtain ultra-thin films. Nitrogen pile-up at the interfaces of Si/oxynitride and Si/$N_2{O}$ oxide strengthens film structure and improves dielectric reliability. Although fixed charge densities and interface trap densities of N20 oxide and oxynitride films have somewhat higher than those of thermal $SiO_2{O}$, $N_2{O}$ oxide and oxynitride films showed improved I-V characteristics and constant current stress.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.8 no.3
• /
• pp.424-430
• /
• 1998

Film characteristics of thin ONO dielectric layers for MONOS (metal-oxide-nitride-oxide-semiconductor) EEPROM was investigated by AES, SIMS, TEM and AFM. The ONO films with different dimension of tunneling oxide, nitride, and blocking oxide were fabricated. During deposition of the LPCVD nitride films on tunneling oxide, this thin oxide was nitrized. When the blocking oxide were deposited on the nitride film, the oxygen not only oxidized the nitride surface, but diffused through the nitride. The results of ONO film analysis exhibits that it is made up of $SiO_2$(blocking oxide)/O-rich SiOxNy (interface)/ N-rich SiOxNy(nitride)/O-rich SiOxNy(tunneling oxide). In addition, the SiON phase is distributed mainly near the tunneling oxide/nitride and nitride/blocking oxide interfaces, and the $Si_2NO$ phase is distributed mainly at nitride side of each interfaces and in tunneling oxide.

• Journal of the Korean Vacuum Society
• /
• v.10 no.3
• /
• pp.328-334
• /
• 2001

The characteristics of $NO/N_2O$ nitrided oxide and reoxidized nitrided oxide being studied as super thin gate oxide and gate dielectric layers of nonvolatile semiconductor memory(NVSM) was investigated by dynamic secondary ion mass spectrometry(D-SMS), time-of-flight secondary ion mass spectrometry(ToF-SIMS), and x-ray photoelectron spectroscopy (XPS). The specimen was annealed in $NO/N_2O$ ambient after initial oxide process. The result of D-SIMS exhibits that the center of nitrogen exists at the initial oxide interface and the distribution of nitrogen is wider in the annealing process with $N_2O$ than with NO annealing process. For investigating the condition of nitrogen that exists within the nitrided oxide, ToF-SIMS and XPS analysis were carried out. It was shown that the center of nitrogen investigated by D-SIMS was expected the SiON chemical bonds. The nitrogen near the newly formed reoxide/silicon substrate interface was appeared as $Si_2NO$ chemical bonds, and it is agreed with the distribution of SiN and $Si_2NO$ species by ToF-SIMS.

• Electrical & Electronic Materials
• /
• v.10 no.7
• /
• pp.659-667
• /
• 1997

The influence of SiO$_2$on the microstructure and electrical properties of zinc oxide varistor was investigated. Zn$_2$SiO$_4$third phase in the sintered body was found at grain boundaries, multiple grain junctions, and occasionally within ZnO grains. This phase acted as a grain growth inhibitor, which retard the grain growth of the ZnO matrix by impeding migration on the grain boundaries. As SiO$_2$ addition increases, average grain size decreased from 40.6${\mu}{\textrm}{m}$ to 26.9${\mu}{\textrm}{m}$ due to the pinning effect by Zn$_2$SiO$_4$ and drag effect by Si segregation at grain boundaries, the breakdown voltage consequently increased. When SiO$_2$ addition is increased, interface state density decreased, however, the barrier height increased by decrease of donor concentration, as a result, the nonlinear exponent increased and leakage current decreased. While, as SiO$_2$ addition increase, it was found that the apparent dielectric loss factor shows a tendency of decrease. Wholly, electrical properties of zinc oxide varistor can be said to be improved by SiO$_2$addition.

• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.29-32
• /
• 2001

In this paper, the thermal oxidation behaviors and the electrical characteristics of the thermal oxide grown on SiC are discussed. For these studies the oxide layers with various thickness were on SiC in wet $O_2$ or dry $O_2$ at l15$0^{\circ}C$ and the MOS capacitors using the 350$\AA$ gate oxide grown in wet $O_2$ were fabricated and electrically characterized. It was found from the experimental results that the oxidation rate of SiC with the Si-face and with the carbon-face were about 10% and 50% of oxidation rate of Si. The C-V measurement results of the SiC oxide showed abnormal hysterisis properties which had ever been not observed for the Si oxide. And the hysterisis behavior was seen more significant when initial bias voltage was more negative or more positive. The hysterisis property of the SiC oxide was believed to be due the substantial amount of the deep level traps to exist at the interface between the oxide and the SiC substrate. The leakage of the SiC oxide was found to be one order larger than the Si oxide, but the breakdown strength was almost equal to that of the Si oxide.

• Journal of the Korean Ceramic Society
• /
• v.32 no.3
• /
• pp.371-377
• /
• 1995

Silicon oxide films were grown on single-crystal silicon substrates at low temperatures (25~205$^{\circ}C$) in a low pressure electron cyclotron resonance (ECR) oxygen plasma. The growth rate of the silicon oxide film increased as the temperature increased or the pressure decreased. Also, the thickness of the silicon oxide film increased at negative bias voltage, but not changed at positive bias voltage. The growth law of the silicon oxide film was approximated to the parabolic form. Capacitance-voltage (C-V) and current density-electric field (J-E) characteristics were studied using Al/SiO2/p-Si MOS structures. For a 10.2 nm thick silicon oxide film, the leakage current density at the electric field of 1 MVcm-1 was less than 1.0$\times$10-8Acm-2 and the breakdown field was higher than 10 MVcm-1. The flat band voltage of Al/SiO2/p-Si MOS capacitor was varied in the range of -2~-3 V and the effective dielectric constant was 3.85. These results indicate that high quality oxide films with properties that are similar to those of thermal oxide film can be fastly grown at low temperature using the ECR oxygen plasma.