• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.9
• /
• pp.940-946
• /
• 2010

In this paper, we proposed the internal antenna on PCB(Planar Circuit Board) for achieving WWAN(Wireless Wide Area Network) operation in the laptop computer. The proposed antenna has a metal structure instead of printed pattern on PCB to improve the antenna characteristics for GSM850/900 bands. Compared to PCB embedded antenna without metal structure, the proposed antenna occupies similar area of $74{\times}11{\times}0.5\;mm^3$ with before and the bandwidth of the proposed one for GSM850/900 bands is increased 13 MHz than before. Further we confirmed that the proposed antenna has higher radiation gain of -4.45~-2.29 dBi for GSM850/900 bands than PCB embedded antenna without metal structure.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.6C
• /
• pp.560-569
• /
• 2005

This paper proposes an algorithm for transmit antenna selection in a multi-input multi-output(MIMO) spatial multiplexing system with per antenna rate control(PARC) and an ordered successive interference cancellation (OSIC) receiver. The active antenna subset is determined at the receiver and conveyed to the transmitter using feedback information on transmission rate per antenna. We propose a serial decision procedure consisting of a successive process that tests whether antenna selection gain exists when the antenna with the lowest pre-processing signal to interference and noise ratio(SINR) is discarded at each stage. Furthermore, we show that 'reverse detection ordering', whereby the signal with the lowest SINR is decoded at each stage of successive decoding, widens the disparities among fractions of the whole capacity allocated to each individual antenna and thus maximizes a gain of antenna selection. Numerical results show that the proposed reverse detection ordering based serial antenna selection approaches the closed-loop MIMO capacity and that it induces a negligible capacity loss compared with the heuristic selection strategy even with considerably reduced complexity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.11A
• /
• pp.1812-1819
• /
• 2001

In this paper, it investigated the permitted limit of the analog nonideality for the SOSOC Σ-Δ modulator design which is satisfied with 1 [MHz] signal bandwidth and 12-bit resolution in the OSR=25. Firstly, it get the SOSOC Σ-Δ modulator model and gain coefficient which is suitable in low voltage for the Σ-Δ modulator design which is satisfied with the specification in the supply voltage 3.3 [Vl. And it provided the performance prediction of the Σ-Δ modulator and the permitted limit of the nonideality by adding the performance degradation facts of the Σ-Δ modulator such as the finite gain of the amplifier, the SR, the closed-loop pole, the switch ON resistance and the capacitor mismatch to the ideal Σ-Δ modulator model. When designed the Σ-Δ modulator which is satisfied with the specification by the base above, it will be able to predict the performance of the Σ-Δ modulator and the guide for the specification of the circuit which composes the Σ-Δ modulator.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.1A
• /
• pp.27-33
• /
• 2009

This paper proposes transmit power control techniques with fading channel prediction scheme based on recurrent neural network for high-speed mobile communication systems. The operation result of recurrent neural network which is derived interpretively solves complexity problems of neural network circuit, and channel gain of multiple transmit antenna is derived with maximum ratio combining(MRC) by using the operation result, and this channel gain control transmit power of each antenna. simulation results show that proposed method has a outstanding performance compared to method that is not to be controlled power based on channel prediction. Most of legacy studies are for robust receive technique of fading signals or channel prediction of fading signals limited low-speed mobility, but in open loop Power control, proposed channel prediction method decrease system complexity with removal of fading effect in transmitter.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.12
• /
• pp.1380-1387
• /
• 2012

The transmit/receive(T/R) module is a key component in the active phased array system. The brick-type T/R module has been widely used and the miniaturization has been an important factor to get the flexibility of the system configuration. For the miniaturization, multi-function chips(MFC) having a common leg configuration are suitable to reduce the number of required MMICs and a high isolation between transmit and receive paths is necessary for the high gain T/R modules. In this work, we propose a bias timing scheme for the compact T/R module and show the optimum timing based on measurements, in order to improve the feed-back path loop problem and the consequent isolation problem of the common leg configuration. We have implemented high power(7 W/channel) and high T/R gain(35 dB transmit and 30 dB receive gains) within the half size($140{\times}80{\times}16mm^3$) of the conventional T/R modules.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.229-234
• /
• 2006

Acquisition is to detect the presence of the GPS signal. Once the signal is detected, the estimated frequency and code phase are passed to a tracking loop to demodulate the navigation data. In order to detect the weak signal, multiple length of data integration is always needed. In this paper, we present five different acquisition approaches based on circular correlation and Fast Fourier Transform (FFT), using coherent as well as non-coherent integration techniques for the multiple length of collected GPS satellite signal. Moreover a general approach of determining the acquisition threshold is introduced based on noise distribution which has been proved effective, and independent of the hardware. In the end of this paper, the processing speed and acquisition gain of each method are illustrated, compared, and analyzed. The results show that coherent approach is much more time consuming compared to noncoherent approaches, and in the case of multiple length of data integration from 2ms to 8ms, the processing times consumed by the fastest non-coherent acquisition method are only 25.87% to 1.52% in a single search, and 34.76% to 1.06% in a global search of those in the coherent acquisition. However, coherent acquisition also demonstrates its better performance in the acquisition gain, and in the case of 8ms of data integration it is 4.23 to 4.41 dB higher than that in the non-coherent approaches. Finally, an applicable scheme of combining coherent and non-coherent acquisition approaches in the development of a real-time Software GPS receiver in the University of Tokyo is provided.

• Journal of Advanced Navigation Technology
• /
• v.8 no.2
• /
• pp.184-190
• /
• 2004

A feedforward linear power amplifier (FLPA) has been developed for UHF-band RFID reader applications. The main and error amplifiers are composed of a 2 stage so that linearity of the FLPA can be improved. The FLPA has been implemented on an FR-4 substrate (Er=4.7 and thickness=0.8 mm) with 3-dB and 10-dB hybrid couplers for input/output power divider and combiner. For 2-tone measurement (input level=-11 dBm at $f_1$=915 MHz and $f_2$=916 MHz), the FLPA exhibits a -18.52 dBm of $IMD_3$, which indicates that $IMD_3$ cancellation with feedforward loop is more than 27 dB. From 890 to 960 MHz, 1-dB gain compression output power and power gain of the FLPA are higher than 30 dBm and 40 dB, respectively.

• Smart Structures and Systems
• /
• v.13 no.2
• /
• pp.281-303
• /
• 2014

In order to suppress the wind-induced vibrations of the Canton Tower, a pair of active mass driver (AMD) systems has been installed on the top of the main structure. The structural principal directions in which the bending modes of the structure are uncoupled are proposed and verified based on the orthogonal projection approach. For the vibration control design in the principal X direction, the simplified model of the structure is developed based on the finite element model and modified according to the field measurements under wind excitations. The AMD system driven by permanent magnet synchronous linear motors are adopted. The dynamical models of the AMD subsystems are determined according to the open-loop test results by using nonlinear least square fitting method. The continuous variable gain feedback (VGF) control strategy is adopted to make the AMD system adaptive to the variation in the intensity of wind excitations. Finally, the field tests of free vibration control are carried out. The field test results of AMD control show that the damping ratio of the first vibration mode increases up to 11 times of the original value without control.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.7 s.98
• /
• pp.671-680
• /
• 2005

The CFL linearisation chip which is one of key devices in ultra-narrowband mobile radio transmitter using CQPSK digital modulation method is designed and implemented with $0.35{\mu}m$ CMOS technology. The reduced size and low cost of transmitter are available by the use of direct-conversion and CFL ASIC chip, which improve the power effi챠ency and linearity of transmitting path. In addition, low power operation is possible through CMOS technology The performance test results of transmitter show -25 dBc improvement of IMD level at the 3 kHz frequency offset and then satisfy FCC 47 CFR 90.210 E emission mask in the operation of CFL ASIC chip. At that time, the transmitting power is about PEP(Peak-to-Envelope Power) 5 W. The main parameters to improve the transmitting characteristic and to compensate the distortion in feed back loop such as DC-offset, loop gain and phase value are interfaced with notebook PC to be controlled with S/W.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.42 no.6
• /
• pp.23-36
• /
• 2005

PLLs have been widely used for many applications including communication systems. This paper presents a VCO with an improved negative skewed delay scheme and a PLL using this VCO. The proposed VCO and PLL are intended for replacing traditional LC oscillators and PLLs used in communication systems and other applications. The circuit designs of the VCO and PLL are based on 0.18um CMOS technology with 1.8V supply voltage. The proposed VCO employs subfeedback loops using pass-transistors and needs two opposite control voltages for the pass transistors. The subfeedback loops speed up oscillation depending on the control voltages and thus provide a high oscillation frequency. The two voltage controls have opposite frequency gain characteristics and result in low phase-noise. The 7-stage VCO in 0.18um CMOS technology operates from $3.2GHz\~6.3GHz$ with phase noise of about -128.8 dBc/Hz at 1MHz frequency onset. For 1.8V supply voltage, the current consumption is about 3.8mA. The proposed PLL has dual loop-filters for the proposed VCO. The PLL is operated at 5GHz with 1.8V supply voltage. These results indicate that the proposed VCO can be used for radio frequency operations replacing LC oscillators. The circuits have been designed and simulated using 0.18um TSMC library.