• Journal of the Korean Society for Precision Engineering
• /
• v.24 no.12
• /
• pp.104-110
• /
• 2007

Internal defects are mainly caused by a corrosive action and degradation in the pipe used in a nuclear power plant or factory. The ESPI method have the many advantages when compared with conventional method. The advantage are the area measurement ability at one time and non-contact measurement ability in the real-time. In this paper, we studied on the measurement of a internal defect by using out of plane ESPI technique. Here, we compared the experimental results using out of plane ESPI with the FEM results.

• Proceedings of the KIEE Conference
• /
• 2002.07d
• /
• pp.2252-2254
• /
• 2002

The Reactor internal structures which consist of many complex components are subjected to flow-induced vibration due to high temperature and pressure in Reactor coolant system. The above flow-induced vibration causes degradation of structural integrity of the Reactor and may result in loosing mechanical binding component which might impact other equipment and component or cause flow blockage. It is important to analyze reactor noise signal for the early detection of potential problem or failure in order to diagnosis reactor integrity in the point of view of safety and plant economics. Detailed composition of diagnostic system reactor internal structures using neutron noise(RIDS).

• Proceedings of the KIPE Conference
• /
• 2005.07a
• /
• pp.170-172
• /
• 2005

Internal battery ohmic measurements have been a hot topic amongst battery users and battery manufacturers. As a battery deteriorates and loses its capacity, the internal resistance of the battery increases. Everyone seems to agree that measuring the internal parameters of a cell can be very useful in determining a battery's state of health. In this paper experiences show that if a cell's resistance increases by more than25% above its baseline value(known good resistance of new 100% capacity cell), the cell will no loger be able to deliver 80% or more of the rated capacity.

• Proceedings of the KIEE Conference
• /
• 2001.07d
• /
• pp.2166-2168
• /
• 2001

Reactor Noise is defined as the fluctuations of measured instrumentation signals during full-power operation of reactor which have informations on reactor system dynamics such as neutron kinetics. The Reactor internal structures which consist of many complex components are subjected to flow-induced vibration due to high temperature and pressure in reactor coolant system. The above flow-induced vibration causes degradation of structural integrity of the reactor and may result in loosing mechanical binding component which might impact other equipment and component or cause flow blockage. It is important to analyze reactor noise signal for the early detection of potential problem or failure in order to diagnosis reactor integrity in the point of view of safety and plant economics. Detailed design of hardware diagnostic system reactor internal structures using neutron noise(RIDS).

• Journal of the Earthquake Engineering Society of Korea
• /
• v.12 no.6
• /
• pp.65-71
• /
• 2008

A one-dimensional site response analysis program (KODSAP) was developed using cyclic soil behavior model by using the modified parallel IWAN model. The model is able to predict the cyclic hardening and degradation of soil through the adjustment of the internal slip stresses of its elements beyond the cyclic threshold, and satisfies Bauschinger's effect and the Masing rule in terms of its own behavior characteristics. The program (KODSAP) used the direct integration method in the time domain. The elasticity of the base rock was considered as a viscous damper boundary condition. The effects of cyclic hardening or degradation of soil on site response analysis were evaluated through parametric studies. Three types of analyses were performed to compare the effect of analysis and cyclic parameter on site response. The first type was equivalent linear analysis, the second was nonlinear analysis, and a third was nonlinear analysis using the cyclic hardening or degradation model.

• Journal of the Korean Wood Science and Technology
• /
• v.31 no.6
• /
• pp.31-39
• /
• 2003

The enzymatic isolation of residual lignins obtained from spruce and beech pulps (obtained by sulfite, kraft, ASAM and soda/AQ/MeOH pulping processes) and their characterization was described in previous publications. Here, the residual lignins have been submitted to potassium permanganate oxidation (KMnO₄ degradation), and 9 aromatic carboxylic acids (3 of them are dimeric) were identified after methylation with diazomethane by GC/MS. The analytical challenge during qantification by the internal standard methods was the partly high protein content of the samples, which resulted in elevated anisic acid yields in the degradation mixture of sulfite residual lignins. The results are compared with the KMnO₄ degradation of the corresponding MWLs and discussed in terms of S/G ratios and degrees of condensation. The latter was calculated as a quotient between the aromatic carboxylic acids derived from condensed and non-condensed lignin structures. Typical degradation patterns for the various processes have been observed. Among other parameter, the relative compositions between iso-hemipinic acid (which is for condensation in pos. 5 of the aromatic ring) and meta-hemipinic acid and 3,4,5-trimethoxyphthalic acid (both are for condensation in pos. 6 of the aromatic ring) was found to be process specific. Kraft and soda/AQ/MeOH residual lignins yielded higher amounts of iso-hemipinic acid. In contrast, the relative yields of meta-hemipinic acid and 3,4,5-trimethoxyphthalic acid (the latter in beech lignins) are higher in sulfite and particularly in ASAM residual lignin. In case of beech residual lignins the amount of acids originated from non-condensed syringyl type lignin units was surprisingly high. The condensation degree of residual lignins was shown to be generally higher than that of MWLs. This was especially true for the G units. ASAM residual lignin exhibited very high S/G ratios and degrees of polymerization. Causality between condensation degree and total yield of degradation products was demonstrated.

• Journal of Microbiology
• /
• v.45 no.6
• /
• pp.521-527
• /
• 2007

Several yeast strains degrading malic acid as a sole carbon and energy source were isolated from Korean wine pomace after enrichment culture in the presence of malic acid. Among them, the strain designated as KMBL 5774 showed the highest malic acid degrading ability. It was identified as Issatchenkia orientalis based on its morphological and physiological characteristics as well as the nucleotide sequences of the internal transcribed spacer (ITS) 1-5.8S rDNA-ITS II region. Phylogenetic analysis of the ITS I-5.8S rDNA-ITS II sequences showed that the KMBL 5774 is the closest to I. orientalis zhuan 192. Identity of the sequences of the KMBL 5774 was 99.5% with those of I. orientalis zhuan 192. The optimal pH of the media for the growth and malic acid degradation by the yeast was between 2.0 and 3.0, suggesting that the strain is an acidophile. Under the optimized conditions, the yeast could degrade 95.5% of the malic acid after 24 h of incubation at $30^{\circ}C$ in YNB media containing 2% malic acid as a sole carbon and energy source.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.19 no.4
• /
• pp.107-113
• /
• 2011

Coolant rubber hoses for automotive radiators under thermal and mechanical loadings can be degraded and thus failed due to the influences of the locally formed electricity. In this study, an advanced test method was developed to simulate the failure problem of the rubber hose. For carbon black filled EPDM (ethylene-propylene dine monomer) rubber used as a radiator hose material the ageing behaviors by the electro-chemical stresses combined with a tensile strain were analyzed. As the tensile strain increased, the current of the rubber specimen reduced indicating an increase of the internal defects and electrical resistance of the rubber specimen. Elongation at break and IRHD hardness rapidly decreased with increasing the ageing time. Both electro-chemical stress and mechanical tensile stress clearly accelerated the degradation of EPDM rubber.

• Korean Journal of Oriental Medicine
• /
• v.16 no.3
• /
• pp.155-166
• /
• 2010

Objetives : The purpose of this study was to examine the pathway of anti-allergic effects of Aconiti Ciliare Tuber (ACT). Methods : We examined cell viability, ${\beta}$-hexosaminidase release, pro-inflammatory cytokines secretion and mRNA expressions, nuclear factor-kappa B (NF-${\kappa}B$) (p65) activation, inhibitor kappa B-alpha ($I{\kappa}B-{\alpha}$) degradation, and MAPKs activation from RBL-2H3 cells pre-treatment by ACT of 1.0 mg/ml, 2.0 mg/ml separately. Results : We observed that ACT reduced the secretion of ${\beta}$-hexosaminidase, TNF-${\alpha}$, IL-4 and the expression of COX-2 mRNA in RBL-2H3 cells. Futhermore, ACT inhibited the levels of activation of NF-${\kappa}B$ (p65) protein, ERK MAPK, and degradation of $I{\kappa}B-{\alpha}$ in RBL-2H3 cells. Conclusions : These results show that ACT has an anti-histamine effect and inhibitory effect of NF-${\kappa}B$ (p65) through regulation of $I{\kappa}B-{\alpha}$ degradation. This improves that ACT could be used as an anti-allergic medicine.

• BMB Reports
• /
• v.50 no.2
• /
• pp.91-96
• /
• 2017

Nuclear factor erythroid 2-related factor 2 (Nrf2) provides a cellular defense against oxidative stress by inducing the expression of antioxidant and detoxification enzymes. The calcium antagonist, verapamil, is an FDA-approved drug prescribed for the treatment of hypertension. Here, we show that verapamil acts as a potent Nrf2 activator without causing cytotoxicity, through degradation of Kelch-like ECH-associated protein 1 (Keap1), a Nrf2 repressor. Furthermore, verapamil-induced Keap1 degradation is prominently mediated by a p62-dependent autophagic pathway. Correspondingly, verapamil protects cells from acetaminophen-induced oxidative damage through Nrf2 activation. These results demonstrated the underlying mechanisms for the protective role of verapamil against acetaminophen-induced cytotoxicity.