• Journal of Environmental Science International
• /
• v.27 no.9
• /
• pp.753-762
• /
• 2018

The present study set out to investigate the adsorption of Cd(II) ions in an aqueous solution by using Peanut Husk Biochar (PHB). An FT-IR analysis revealed that the PHB contained carboxylic and carbonyl groups, O-H carboxylic acids, and bonded-OH groups, such that it could easily adsorb heavy metals. The adsorption of Cd(II) using PHB proved to be a better fit to the Langmuir isotherm than to the Freundlich isotherm. The maximum Langmuir adsorption capacity was 33.89 mg/g for Cd(II). The negative value of ${\Delta}G^o$ confirm that the process whereby Cd(II) is adsorbed onto PHB is feasible and spontaneous in nature. In addition, the value of ${\Delta}G^o$ increase with the temperature, suggesting that a lower temperature is more favorable to the adsorption process. The negative value of ${\Delta}H^o$ indicates that the adsorption phenomenon is exothermic while the negative value of ${\Delta}S^o$ suggests that the process is enthalpy-driven. As an alternative to commercial activated carbon, PHB could be used as a low-cost and environmentally friendly adsorbent for removing Cd(II) from aqueous solutions.

• Applied Chemistry for Engineering
• /
• v.33 no.5
• /
• pp.502-522
• /
• 2022

Clay minerals are natural materials that show widespread applications in various branches of science, including environmental sciences, in particular the remediation of water contaminated with various water pollutants. Modified clays and minerals have attracted the attention of researchers in the recent past since the modified materials are seemingly more useful and efficient for removing emerging water contaminants. Therefore, modified engineered materials having multi-functionalities have received greater interest from researchers. The advanced clay-based materials are highly effective in the remediation of water contaminated with organic and inorganic contaminants, and these materials show enhanced selectivity towards the specific pollutants. The review inherently discusses various methods employed in the modification of clays and addresses the challenges in synthesizing the advanced engineered materials precursor to natural clay minerals. The changes in physical and chemical properties, as investigated by various characterization techniques before and after the modifications, are broadly explained. Further, the implications of these materials for the decontamination of waterbodies as contaminated with potential water pollutants are extensively discussed. Additionally, the insights involved in the removal of organic and inorganic pollutants are discussed in the review. Furthermore, the future perspectives and specific challenges in the scaling up of the treatment methods in technology development are included in this communication.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.35 no.1
• /
• pp.27-32
• /
• 2003

To understand the chemical structure of sewer sludge in comparison with commercial compost and charcoal used as a soil improver, it was carried out to analyse their ash contents and metal ions, and to elucidate the chemical structure of their residuals after a sequential treatment of alcohol-benzene(1:2) extraction in Soxhlet, 3% HCl reflux and 79% H₂SO₄ hydrolysis, using CHNS analyzer and solid C-13 NMR spectrometer. The results obtained were as follows: 1. Ash content of sludge was about 46% that is higher than those of compost (17%) and charcoal (4%). 2. The residual of sludge after a sequential treatment of HCl and H₂SO₄ hydrolyses had high ash content about 23%, too. 3. The sludge seems to be suitable to the soil improver because the content of heavy metal ions in sludge was near the compost and below the organic fertilizer standard. 4. Elemental composition of sludge residual after HCl-H₂SO₄ hydrolyes was C/sub 56/H/sub 91/O/sub 12/N₂S = (C/sub 6/H/sub 10/O/sub 5/)/sub 7/(C/sub 6/H₄)/sub 7/C₂H/sub 43/O₂N₂S, similar to C/sub 103/H/sub 122/O/sub 33/N/sub 6/S = (C/sub 6/H/sub 10/O/sub 5/)/sub 6/(C/sub 6/H₄)/sub 10/C/sub 7/H/sub 22/O₃N/sub 6/S of compost. 5. The sludge residual had proved to have both considerable aliphatic and aromatic groups, but the compost residual to have mainly aliphatic groups and the charcoal to have mainly aromatic groups, through the peak analysis of solid C-13 NMR charts. 6. So, the sewer sludge is proved to have a considerable amount of aromaticity like in woody biomass containing lignin.

• Resources Recycling
• /
• v.10 no.2
• /
• pp.13-19
• /
• 2001

Several hydrolyzed extruded PAN's were prepared through reaction of extruded PAN (7.5% methyl acrylate) with NaOH in methanol at various temperatures and times. These were amidoximated with hydroxylamine in MeOH and/or $H_2$O to introduce an excellent adsorption capacity of heavy metal ions. Amidoximated hydrolyzed extruded fAN showed superior swellability to non-hydrolyzed extruded PAM. The amidoximated extruded PAN hydrolyzed for 6h at $60^{\circ}C$ showed the best dimensional stability. Amidoximated hydrolyzed extruded PAN has more adsorption capacity of $Cu^{2+}$ than that of $Ni^{ 2+}$ These PAN derivates also showed an excellent selectivity for adsorption of metal ions.

• Journal of Environmental Health Sciences
• /
• v.12 no.1
• /
• pp.1-14
• /
• 1986

This investigation was carried out on the study of Ferrite formation by aerial oxidation of Fe $(OH)_2$ suspension of aqueous solution containing heavy metal ions. In this study the optimum reactionary condition of the Ferrite formation in Batch reactor wa studied by aerial oxidation which are subjected to various reaction time and temperature, under the different kinds of R(2NaOH/$FeSO_4$) Values, pH, Air flow rate, and $Fe^2+/M^2+$ mole ratio. The optimum condition for the Ferrite formation in Batch reactor was such that residence Time was 90 min., Temperature $65{\circ}$C, pH 11.0, Air flow rate 2.0l/min and $Fe^{2+}/M^{2+}$ mole ratio 4.0, which was observed by X-Ray diffraction analysis. The relation R-value, pH and ORP affecting the formation of Ferrite is that the jump step in pH 11.0, when a amount of NaOH is added, is steady state to the formation of Ferrite. Effect of R-value of $FeSO_4$ and $FeCl_2$ on the formation of Ferrite in different from each other the optimum condition of the in different from each other the optimum condition of the $FeCl_2$ is R-value 0.7, pH 11.0 and the $FeSO_4$ R-value 1.2, pH 11.0.

• Journal of Environmental Science International
• /
• v.1 no.1
• /
• pp.13-21
• /
• 1992

The inhibitory effects of mercury ions on the growth of barley seedlings were studied and the distribution of metal elements in the organs of treated plants was investigated by using synchrotron radiation induced X-ray emission (SRIXE). Although the treatment of mercury ions caused growth inhibition, the mercury-specific increase in variable fluorescence and the abolishment of energy-dependent quenching in broken barley chloroplasts as shown by Moon et at. (1992) were not observed in the leaves of growth-inhibited seedlings. Instead the treatment of mercury decreased Fmax and Fo values. However, Fmax/Fo ratio and photochemical and nonphotochemical quenching coefficients were not affected significantly. By SRIXE analysis of $10\mu\textrm{m}$ mercury chloride treated seedlings, accumulation of mercury in roots was observed after 1 hour of treatment and similar concentration was sustained for 48 hours. Relative contents of mercury was high in roots and underground nodes where seeds were attachedl but was very low in leaves. Iron and zinc were also distributed mainly in the lower parts of the seedlings. However after 72 hours of treatment the contents of these metals in roots decreased and their distribution became more uniform, which may lead to death of the plants. These results suggest that the observed inhibitory effects on barley seedlings upto 48 hours after the treatment is not due to direct damages in the photosynthetic apparatus, but due to its accumulation in roots and the consequent retardation of the growth of barley seedlings. The decrease in Fmax and Fo is probably due to the decrease in chlorophyll and protein contents caused by the retardation of growth. The observed slow expansion of primary leaves could be also explained by the retardation of growth, but the fluorescence induction pattern from the leaves did not show characteristic symptoms of leaves under water stress.

• Journal of Life Science
• /
• v.13 no.4
• /
• pp.421-427
• /
• 2003

A natural habit at bacterium, Enterobacter intermedious KH410 was isolated from freshwater plant root and identified. Adsorption of heavy metals such as lead, cadmium, and copper by this strain was examined. The minimal inhibitory concentrations(MIC) for each metal were 1.78 mM for lead, 0.17 mM for cadmium and 1.39 mM for lopper, respectively. Maximum production of dried cell was 2.56 g/$\ell$ in LB medium containing 0.5% NaCl, 1% yeast extract and 1% of lactose. Optimal conditions for adsorption were 0.6 dry g-biomass, at pH 4.0 and the temperature of $20^{\circ}C$. Adsorption equilibrium reached maximum after 30 min in 400 mg/$\ell$ metal solution. The adsorption capacity (K) of copper was 1.5 times higher than that of cadmium and lead was 1.1 times higher than that of cadmium. from the results obtained in this study, Freundlich adsorption model was applicable for all metals. Adsorption strength (1/n) of heavy metal ions were in the order of cadmium>copper>lead. The adsorption of dried cell for lead, cadmium, and copper was 56.2, 58.0, 55.8 mg/g-biomass, respectively. Pretreatment to increase ion strength was the most effective with 0.1 M NaOH whereas slight difference was found both KOH and $CaCl_2$ upon same concentration. Effective desorption was induced by 0.1 M EDTA for lead and 0.1 M $HNO_2$ for cadmium and copper.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.12 no.1 s.26
• /
• pp.27-35
• /
• 1988

In order to investigate a practical application of the fibrous adsorbent to heavy metal ions, acrylic fibers were treated with the hydroxylamine solution that was producted by hydroxylamine hydrochloride and potasium hydroxide in a condition of strong alkaline and $70^{\circ}C$. The adsorption mechanism of copper(2) ion on the fibrous adsorbent, that is hydroxylaminated acrylic fibers, was studied. The adsorption of copper(2) ion was explained in terms of the activated adsorption that are formed the complex with the ligand, such as C=N, N-H, NHOH, on the surface of the adsorbent. The activation energy was evaluated to be 3.8 Kcal/mol. and the times of adsorption equilibrium was approximately 10 minutes. The uptake of copper(2) ion was found to be effected with the increase of temperatures and the pH dependence.

• Journal of Korean Society of Rural Planning
• /
• v.5 no.1 s.9
• /
• pp.45-55
• /
• 1999

The applicability of resistivity cone for contaminant investigation in farm land was examined in laboratory and in-situ. To verify the resistivity variations in sand with contaminants, laboratory experiment used soil resistivity test box was performed. Heavy metal and others ions were appeared steep variations in low concentration. Pilot test results were the same as laboratory test results. In the in-situ test used resistivity cone, resistivities of waste landfill layer were low than the common soil layers and resistivities had been difference with concentration of contaminant components. Therefore contaminant investigation in farm land using resistivity cone was expected very effective.

• YAKHAK HOEJI
• /
• v.23 no.3_4
• /
• pp.147-152
• /
• 1979

Experiments were carried out to investigate for the interaction between FAD solution and synthetic resin containers made of polyvinylchloride(PVC), polyethylene(PE), and polycarbonate(PC), and for the effect of glycyrrhizine or malic acid on stabilization of FAD in aqueous solution by accelerated stability analysis. Analysis of FAD was determined by means of spectrometer and by separating by paper chromatography and metal ions were detected by atomic absorption spectrophotometer, which were extracted from containers by means of Food and Additive Regulation Standard. The thermal decomposition of FAD in aqueous solution was pseudo first order reaction and it was inhibited by adding glycyrrhizine or malic into the solution. PVC, PE and PC containers accelerated the decomposition of FAD in solution. It is assumed that bivalent heavy metals in resin containers may catalize the hydrolysis of FAD. The metals detected from the containers were Ca, Zn, Cu, Fe, Pb and Cd. And the total amounts of detected metals from PVC were 6.2mcg/cm$^{2}$, PE, 5.5mcg/cm$^{2}$, and PC, 2.7mcg/cm$^{2}$ which were proportional to the rate constant of FAD decomposition in aqueous solution.