• Bulletin of the Korean Chemical Society
• /
• v.26 no.1
• /
• pp.131-135
• /
• 2005

Gallium nitride (GaN) powders and nanowires were prepared by using tris(N,N-dimethyldithiocarbamato)gallium(III) (Ga(DmDTC)$_3$) and tris(N,N-diethyldithiocarbamato)gallium(III) (Ga(DeDTC)$_3$) as new precursors. The GaN powders were obtained by reaction of the complexes with ammonia in the temperature ranging from 500 to 1100 ${^{\circ}C}$. The process of conversion of the complexes to GaN was monitored by their weight loss, XRD, and $^{71}$Ga magic-angle spinning (MAS) NMR spectroscopy. Most likely the complexes decompose to $\gamma$ -Ga$_2$S$_3$ and then turn into GaN via amorphous gallium thionitrides (GaS$_x$N$_y$). The reactivity of Ga(DmDTC)$_3$ with ammonia was a little higher than that of Ga(DeDTC)$_3$. Room-temperature photoluminescence spectra of asprepared GaN powders exhibited the band-edge emission of GaN at 363 nm. GaN nanowires were obtained by nitridation of as-ground $\gamma$ -Ga$_2$S$_3$ powders to GaN powders, followed by sublimation without using templates or catalysts.

• Journal of the Microelectronics and Packaging Society
• /
• v.28 no.4
• /
• pp.25-29
• /
• 2021

This paper demonstrates the utility of the Ni-Pd and carbon-nanotube (Ni-Pd-CNT)-based nanoalloy to improve the α-Ga₂O₃ crystal quality using the halide-vapor-phase epitaxy (HVPE) method. As result, the overall thickness of the α-Ga₂O₃ epitaxial layer increased from a Ni electroless plating time of 40 s to 11 ㎛ after growth. In addition, the surface morphologies of the α-Ga₂O₃ epilayers remained flat and crack-free. The full-width half-maximum results of the X-ray diffraction analysis revealed that the ($10{\bar{1}}4$) diffraction patterns decreased with increasing nominal thickness.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.1
• /
• pp.86-92
• /
• 2022

Despite otherwise advantageous properties, the performance and reliability of devices manufactured in β-Ga₂O₃ on semi-insulating Ga₂O₃ substrates may degrade because of poorly mitigated self-heating, which results from the low thermal conductivity of Ga₂O₃ substrates. In this work, we investigate and compare self-heating and device performance of β-Ga₂O₃ MESFETs on substrates of semi-insulating Ga₂O₃ and 4H-SiC. Electron mobility in β-Ga₂O₃ is negatively affected by increasing lattice temperature, which consequently also negatively influences device conductance. The superior thermal conductivity of 4H-SiC substrates resulted in reduced β-Ga₂O₃ lattice temperatures and, thus, mitigates MESFET drain current degradation. This, in turn, allows practically reduced device dimensions without deteriorating the performance and improved device reliability.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.36 no.6
• /
• pp.576-581
• /
• 2023

The Ga₂O₃ thin films were deposited using an RF sputtering system and the effect of crystallographic and optical properties under rapid thermal annealing conditions on Ga₂O₃ thin film was evaluated. A rapid thermal annealing method can fabricate a crystalline Ga₂O₃ thin film which is applied to various fields with a low cost and a high efficiency compared with the conventional post-annealing method. In this study, the Ga₂O₃ treated at 900℃ for 1 min showed the beta and gamma phases in XRD measurement. In optical properties, the crystalline Ga₂O₃ represented a high transmittance of more than 80% in the visible region and was calculated with a high optical bandgap energy of 4.58 eV. The beta and gamma phases Ga₂O₃ can be obtained by adjusting the rapid thermal annealing temperatures, and the various properties such as the optical bandgap energy can be controlled. Moreover, it is expected that crystalline Ga₂O₃ can be applied to various devices by controlling not only temperature but process time.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.33 no.2
• /
• pp.83-90
• /
• 2023

The β-Ga₂O₃ has the most thermodynamically stable phase, a wide band gap of 4.8~4.9 eV and a high dielectric breakdown voltage of 8MV/cm. Due to such excellent electrical characteristics, this material as a power device material has been attracted much attention. Furthermore, the β-Ga₂O₃ has easy liquid phase growth method unlike materials such as SiC and GaN. However, since the grown pure β-Ga₂O₃ single crystal requires the intentionally controlled doping due to a low conductivity to be applied to a power device, the research on doping in β-Ga₂O₃ single crystal is definitely important. In this study, various source powders of un-doped, Sn 0.05 mol%, Sn 0.1 mol%, Sn 1.5 mol%, Sn 2 mol%, Sn 3 mol%-doped Ga₂O₃ were prepared by adding different mole ratios of SnO₂ powder to Ga₂O₃ powder, and β-Ga₂O₃ single crystals were grown by using an edge-defined Film-fed Growth (EFG) method. The crystal direction, crystal quality, optical, and electrical properties of the grown β-Ga₂O₃ single crystal were analyzed according to the Sn dopant content, and the property variation of β-Ga₂O₃ single crystal according to the Sn doping were extensively investigated.

• Journal of the Semiconductor & Display Technology
• /
• v.21 no.2
• /
• pp.85-89
• /
• 2022

We reported on annealing effect on Ga₂O₃/Al₂O₃/SiC devices grown by radio frequency sputtering method. Post-deposition annealing at 900 ℃ was performed, which results in crystallization in the Ga₂O₃ films. The major peaks (-401) and (403) of Ga₂O₃ which was thermally treated at 900 ℃ appears in the x-ray diffraction (XRD) results. Auger electron spectroscopy (AES) shows that Ga and Al atoms seems to be diffused into the opposite direction Al₂O₃ and Ga₂O₃ after annealing. Transfer and output characteristics of back-gate transistor were analyzed where SiC substrate is used as gate material. On-state current and on/off ratio increased almost 10⁹ and 10⁶ times higher in the 900 ℃ annealed sample.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.19 no.2
• /
• pp.161-176
• /
• 2021

In this study, the electrochemical behavior of Sm on the binary liquid Al-Ga cathode in the LiCl-KCl molten salt system is investigated. First, the co-reduction process of Sm(III)-Al(III), Sm(III)-Ga(III), and Sm(III)-Ga(III)-Al(III) on the W electrode (inert) were studied using cyclic voltammetry (CV), square-wave voltammetry (SWV) and open circuit potential (OCP) methods, respectively. It was identified that Sm(III) can be co-reduced with Al(III) or Ga(III) to form Al_zSm_y or Ga_xSm_y intermetallic compounds. Subsequently, the under-potential deposition of Sm(III) at the Al, Ga, and Al-Ga active cathode was performed to confirm the formation of Sm-based intermetallic compounds. The X-ray diffraction (XRD) and scanning electron microscopy-energy dispersive spectroscopy (SEM-EDS) analyses indicated that Ga₃Sm and Ga₆Sm intermetallic compounds were formed on the Mo grid electrode (inert) during the potentiostatic electrolysis in LiCl-KCl-SmCl₃-AlCl₃-GaCl₃ melt, while only Ga₆Sm intermetallic compound was generated on the Al-Ga alloy electrode during the galvanostatic electrolysis in LiCl-KCl-SmCl₃ melt. The electrolysis results revealed that the interaction between Sm and Ga was predominant in the Al-Ga alloy electrode, with Al only acting as an additive to lower the melting point.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.4
• /
• pp.330-337
• /
• 2005

La/sub 0.8/Sr/sub 0.2/Ga/sub 0.8/Mg/sub 0.2/O/sub 3-δ/-based solid electrolytes in which Mg site was partially substituted by Fe, Co or Ni (0.05, 0.1, 0.15 at.％) were fabricated by conventional solid-state reaction and their sintered densities were above 94％ of theoretical density. X-ray diffraction analysis and microstructure observation for the sintered specimens were performed. The ac complex impedance were measured at 400。C to l000。C in air and fitted with a Solatron ZView program. The electrical conductivity of La/sub 0.8/Sr/sub 0.2/Ga/sub 0.8/Mg/sub 0.2/O/sub 3-δ/-based solid electrolytes substituted by Fe, Co or Ni was higher than that of pure La/sub 0.8/Sr/sub 0.2/Ga/sub 0.8/Mg/sub 0.2/O/sub 3-δ/. The electrical conductivity of La/sub 0.8/Sr/sub 0.2/Ga/sub 0.8/Mg/sub 0.05/Ni/sub 0.15/O/sub 3-δ/ electrolyte was 3.4×10/sup -2/ Scm/sup -1/ at 800。C and the highest value of the whole electrolytes.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.33 no.1
• /
• pp.78-82
• /
• 2020

In this study, MOSFETs fabricated on Si-doped, MBE-grown β-Ga₂O₃ are demonstrated. A Si-doped Ga₂O₃ epitaxial layer was grown on a Fe-doped, semi-insulating 1.5 cm × 1 cm Ga₂O₃ substrate using molecular beam epitaxy (MBE). The fabricated devices are circular type MOSFETs with a gate length of 3 ㎛, a source-drain spacing of 20 ㎛, and a gate width of 523 ㎛. The device exhibited a good pinch-off characteristic, a high on-off drain current ratio of approximately 2.7×10⁹, and a high breakdown voltage of 1,080 V, which demonstrates the potential of Ga₂O₃ for power device applications including electric vehicles, railways, and renewable energy.

• Journal of IKEEE
• /
• v.28 no.1
• /
• pp.104-109
• /
• 2024

In this research, we explored the influence of post-annealing atmospheres on the electrical properties of Ga₂O₃/SiC heterojunction diodes. We fabricated Ga₂O₃/SiC heterojunction diodes by RF sputtering and after the fabrication the post-annealing in various gas atmospheres was performed. We measured the changes in deep-level defects using Deep Level Transient Spectroscopy (DLTS) and we conducted an electrical characteristic of J-V measurement and Hall measurement to analyzed the effects of annealing atmosphere on Ga₂O₃/SiC heterojunction diode. In the N₂ annealed devices, the highest on-state current was measured as 3.06 × 10^-2 A/cm^2, and an increase in carrier concentration of 3.8 × 10¹⁴ cm^-3 was observed. This confirms that the variations in deep level defects due to the post-annealing atmosphere can influence the electrical properties.