• 대한전자공학회논문지SD
• /
• 제42권2호
• /
• pp.9-14
• /
• 2005

본 논문에서는bulk dynamic threshold voltage MOSFET(B-DTMOS)와 bulk MOSFET(B-MOS)에서 hot carrier 현상으로 인한 RF 성능 저하를 비교하였다. Normal 및 moderate 모드에서 B-DTMOS의 차단주파수 및 최소잡음지수의 열화가 B-MOS 소자 보다 심하지 않음을 알 수 있었다. 실험 견과로부터 hot carrier에 의한 RF 성능 저하가 DC 특성 열화 보다 심함을 알 수 있었다. 그리고 처음으로 hot carrier 현상으로 인한 B-DTMOS 소자의 RF 전력 특성 저하를 측정하였다.

• 한국전기전자재료학회논문지
• /
• 제21권2호
• /
• pp.182-187
• /
• 2008

This paper dealt with the detection algorithm of series arcing, which is a cause of electric fires in low-voltage wiring systems. To find the distinguished electrical features of series arc, we simulated series arcing by the arc generator specified in UL1699. An electric heater, an inverter-controlled vacuum cleaner, and a phase-controlled incandescent lamp were used as loads to generate series arcing. A high-pass filter (HPF) with the low cut-off frequency of 3 kHz at -3 dB was fabricated and applied to separate the series arc signal from the AC voltage source. The experiment showed that the high frequency signal generates randomly during series arcing, and the phase-controlled incandescent lamp produces high frequency pulses even in normal state. In this case, the magnitude, the width, and the randomness of high frequency signal should be analyzed to estimate series arcing precisely.

• Bulletin of the Korean Chemical Society
• /
• 제30권4호
• /
• pp.817-820
• /
• 2009

To meet the high current load requirement from the high energy density realized by metal oxide and high power density graphite, we propose a novel hybrid supercapacitor consisting of Nb2O5 and KS6 graphite in 1.0 M LiPF6-EC:DEC (1:2). This new system exhibits a sloping voltage profile from 2.7 to 3.5 V during charging and presents a high operating voltage plateau between 1.5 and 3.5 V during discharging. The cell was tested at a current density of 100 mA/g with a cut-off voltage between 3.0 and 1.0 V. This novel energy storage system delivers the highest initial discharge capacity of 55 mAh/g and exhibits a good cycle performance.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2005년도 추계종합학술대회
• /
• pp.208-211
• /
• 2005

This paper presents an ultra-low partial discharge(PD) measurement system that has been accepted as a non-destructive method to estimate electrical insulation of low-voltage electric devices. The PD measurement system is composed of a coupling network, a low noise amplifier, and associated electronics. A shielding box is used to make a better condition against electromagnetic interference. A low cut-off frequency of the coupling network was 1MHz(-3 dB). Calibration tests on laboratory set-up have shown that the PD measurement system has a stable sensitivity of 11.4mV/pC. In an application experiment on a low-voltage induction motor(5HP), we could detect 0.77pC level of partial discharge pulse at the applied voltage of AC 664 V$_{peak}$.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 제38회 하계학술대회
• /
• pp.371-372
• /
• 2007

The major causes of electrical fire are classified to short circuit fault, overload fault, electric leakage and electric contact failure. The occurrence factor of the fire is electric arc or spark accompanied with electrical faults. Residual Current Protective Device (RCD), that is Earth Leakage Circuit Breaker(ELB) and Molded_case Circuit Breaker (MCB), of high sensitivity type used at low voltage wiring cuts off earth leakage and overload, but the RCD can't cut off electric arc or spark to be a major factor of electrical fire. As the RCDs which are applied low voltage distribution panel are prescribed to rated breaking time about 30[ms] (KS C 4613), the RCDs can't perceive to the periodic electric arc or spark of more short wavelength level. To be improved on such problem, this research development is proposed to a auxiliary control apparatus for RCD trip on electric arc or spark due to electrical fire. Some experimental results of the proposed apparatus is confirmed to the validity of the analytical results.

• 한국항해항만학회지
• /
• 제29권10호
• /
• pp.859-863
• /
• 2005

본 논문은 광범위한 전력제어가 가능하고, PC 직렬통신 방식에 의해 원거리에서 시스템을 ON-OFF할 수 있으며, 시스템의 상태를 모니터링 할 수 있는 선박비상조명시스템의 전력제어특성 개선에 관해 연구한다. 제안된 시스템은 강압형 컨버터, 비상급전회로, 반 브리지 인버터, 형광램프기동회로, 마이크로프로세서 제어 및 멀티통신회로 등으로 구성된다. 실험을 통하여 과전류에 의한 해당 시스템의 정지와 주전원 차단시의 비상전원에 의한 신속한 급전을 확인할 수 있고, 입력전력은 35[$\%$] 범위까지 제어됨을 확인한다. 또한, 원거리에서 원하는 시스템을 ON-OFF 하고, 시스템의 전력, 전압, 전류, 배터리 전압 등의 모니터링도 한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2008년도 하계학술대회 논문집
• /
• pp.103-105
• /
• 2008

In grid-interconnection system, a fast, robust and precise phase angle detector is most important to grid synchronization and the active power control. The phase angle can be easily estimated by synchronous dq PLL system. On the other hand under unbalanced voltage condition, synchronous dq PLL system has problem that harmonics occur to phase angle or magnitude of grid voltage because of the effect of the negative sequence components. So, To eliminate the negative sequence components, the PLL method using APF (All Pass Filter) in a stationery reference frame to extract positive sequence components under unbalanced voltage condition is researched. In this paper, we propose a new PLL method with decoupling network using APF in a synchronous reference frame to extract the positive sequence components of the grid voltage under unbalanced grid. The cut-off frequency of APF in a synchronous reference frame can be set to twice of the fundamental frequency comparing with that of APF in a stationery reference frame which is the fundamental frequency. The proposed PLL strategy can detect the phase angle quickly and accurately under unbalanced gird voltages. Simulation and experimental results are presented to verify the proposed strategy under different kind of voltage dips.

• 전기전자학회논문지
• /
• 제15권1호
• /
• pp.57-63
• /
• 2011

본 논문에서는 대역폭 조정이 가능한 다중 생체 신호 처리용 대역 통과 필터 회로에 관한 것이다. 일반적인 대역 통과 필터는 출력 단에 연결되는 커패시터 배열의 값을 조절하여 고역 -3dB 차단 주파수를 결정한다. 하지만 본 논문에서 제안하는 대역 통과 필터 회로는 커패시터 대신에, 증폭기에 사용되는 바이어스 전압을 통해 증폭기의 트랜스 컨덕턴스 값을 조절하여 차단 주파수를 조절한다. 이러한 방법은 기존의 방식보다 칩 면적을 최소한 1/10로 줄일 수 있어 저면적 설계가 가능하다. 조정 가능한 고역 -3dB 차단 주파수의 대역은 100Hz에서 1KHz이며 사용된 공정은 0.18um CMOS 표준 공정이다. 저 전력 설계를 위해 회로는 서브 스레쉬 홀드 영역에서 동작하며 공급전압은 1V이고, 회로의 총 전류 소모는 1uA이다.

• Smart Structures and Systems
• /
• 제20권3호
• /
• pp.329-342
• /
• 2017

In this paper, the dispersion characteristics of elastic waves propagation in sandwich nano-beams with functionally graded (FG) face-sheets reinforced with carbon nanotubes (CNTs) is investigated based on various high order shear deformation beam theories (HOSDBTs) as well as nonlocal strain gradient theory (NSGT). In order to align CNTs as symmetric and asymmetric in top and bottom face-sheets with respect to neutral geometric axis of the sandwich nano-beam, various patterns are employed in this analysis. The sandwich nano-beam resting on Pasternak foundation is subjected to thermal, magnetic and electrical fields. In order to involve small scale parameter in governing equations, the NSGT is employed for this analysis. The governing equations of motion are derived using Hamilton's principle based on various HSDBTs. Then the governing equations are solved using analytical method. A detailed parametric study is conducted to study the effects of length scale parameter, different HSDBTs, the nonlocal parameter, various aligning of CNTs in thickness direction of face-sheets, different volume fraction of CNTs, foundation stiffness, applied voltage, magnetic intensity field and temperature change on the wave propagation characteristics of sandwich nano-beam. Also cut-off frequency and phase velocity are investigated in detail. According to results obtained, UU and VA patterns have the same cut-off frequency value but AV pattern has the lower value with respect to them.

• 대한전자공학회논문지SD
• /
• 제39권1호
• /
• pp.83-88
• /
• 2002

HFET 소자의 선형성과 게이트-트레인 항복특성을 향상시키기 위해 부분채널 도핑된 Al/sub 0.25/Ga/sub 0.75/As/In/sub 0.25/Ga/sub 0.75/As/Al/sub 0.25/Ga/sub 0.75/As 이종접합 구조를 갖는 FET를 제안하였다. 제안된 HFET는 게이트 전극 아래로 도핑되지 않은 AlGaAs 진성공급층을 두어 -2OV 의 높은 항복전압을 얻었다. 또한 소자의 InGaAs 채널에 부분 도핑을 실시하여, 균일 채널 도핑을 실시한 경우보다 향상된 선형성을 유도하였고, 2차원 전산모사 견과와 제작 및 측정결과를 통해 선형성의 향상을 확인하였다. 본 실험에서 제안된 HFET소자는 DC측정 결과와 고주파측정 결과 모두에서 기존의 FET소자들에 비해 향상된 선형성을 나타내었다.