• Kyungpook Mathematical Journal
• /
• 제63권3호
• /
• pp.345-353
• /
• 2023

Reduced solutions of size 2 and degree n of the Tarry-Escott problem over M₂(ℚ) are determined. As an application, the diophantine equation αAⁿ + βBⁿ = αCⁿ + βDⁿ, where α, β are rational numbers satisfying α + β ≠ 0 and n ∈ {1, 2}, is completely solved for A, B, C, D ∈ M₂(ℚ).

• Journal of electromagnetic engineering and science
• /
• 제6권2호
• /
• pp.110-116
• /
• 2006

A reflective array type surface acoustic wave(SAW) dispersive delay line(DDL) with high time-bandwidth at the V/UHF-band is designed and fabricated for compressive receiver applications. This type of the SAW DDL has the properties of the relative bandwidth of 20 %, the time delay of 49.89 usec, the insertion loss of 38.5 dB and the side lobe rejection of 39 dB. In comparison with a commercial SAW DDL, the insertion loss, amplitude ripple and side lobe rejection are improved by $1.5dB{\pm}0.6dB$ and 4 dB respectively. Using the fabricated SAW DDL, the prototype of the compressive receiver is developed. It is composed of RF converter, fast tunable LO, chirp LO, A/D converter, signal processing unit and control unit. This prototype system shows a fine frequency resolution of below 30 kHz with high scan rate.

• Journal of Mechanical Science and Technology
• /
• 제15권2호
• /
• pp.192-198
• /
• 2001

We consider an interpolation problem with nonuniform rational B-spline curves given ordered data points. The existing approaches assume that weight for each point is available. But, it is not the case in practical applications. Schneider suggested a method which interpolates data points by automatically determining the weight of each control point. However, a drawback of Schneiders approach is that there is no guarantee of avoiding undesired poles; avoiding negative weights. Based on a quadratic programming technique, we use the weights of the control points for interpolating additional data. The weights are restricted to appropriate intervals; this guarantees the regularity of the interpolating curve. In a addition, a knot placement is proposed for pleasing interpolation. In comparison with integral B-spline interpolation, the proposed scheme leads to B-spline curves with fewer control points.

• 한국통신학회논문지
• /
• 제31권3A호
• /
• pp.356-359
• /
• 2006

A monolithic SiGe HBT variable gain driver amplifier(VGDA) with high dB-linear gain control and high linearity has been developed as a driver amplifier with ground-shielded microstrip lines for 5-GHz transmitters. The VGDA consists of three blocks such as the cascode gain-control stage, fixed-gain output stage, and voltage control block. The circuit elements were optimized by using the Agilent Technologies' ADSs. The VGDA was implemented in STMicroelectronics' 0.35${\mu}m$ Si-BiCMOS process. The VGDA exhibits a dynamic gain control range of 34 dB with the control voltage range from 0 to 2.3 V in 5.15-5.35 GHz band. At 5.15 GHz, maximum gain and attenuation are 10.5 dB and -23.6 dB, respectively. The amplifier also produces a 1-dB gain-compression output power of -3 dBm and output third-order intercept point of 7.5 dBm. Input/output voltage standing wave ratios of the VGDA keep low and constant despite change in the gain-control voltage.

• Journal of electromagnetic engineering and science
• /
• 제13권1호
• /
• pp.44-50
• /
• 2013

In this paper, we present a circularly polarized (CP) composite cavity-backed crossed dipole antenna for global positioning system (GPS) applications. We produce the CP radiation by crossing two dipoles through a $90^{\circ}$ phase delay line of a vacant-quarter printed ring, which also has a broadband impedance matching characteristic. Two techniques, insertion of meander lines in the dipole arm and arrowhead-shaped trace at its end, are employed to reduce the sizes of the primary radiation element. The compact radiator is backed by a cavity reflector to achieve a wide CP radiation beamwidth. The proposed antenna exhibits a measured bandwidth of 1.450~1.656 GHz for a voltage standing wave ratio (VSWR) < 2 and 1.555~1.605 GHz for AR < 3-dB. At 1.575 GHz, the antenna has a gain of 7 dBic, a frontto-back ratio of 27 dB, AR of 1.18 dB, and 3-dB AR beamwidths of $130^{\circ}$ and $132^{\circ}$ in the x-z and y-z planes, respectively.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 C
• /
• pp.2108-2110
• /
• 2004

In this paper, a novel tunable bandpass filter using tunable series inductors and MEMS switches for wireless LAN applications was proposed. The proposed tunable filter was fabricated using a micromachining technology and performances of the fabricated filter were estimated. The filter consists of spiral inductors, MIM capacitors and direct-contact type MEMS switches, and its frequency tunability is achieved by changing the inductance that is induced by ON/OFF actuations of the MEMS switches. The actuation voltage of the MEMS switches was 58 V, and the measured center frequencies were 2.55 GHz and 5.1 GHz, respectively. The passband insertion loss and 3-dB bandwidth were 4.2 dB and 22.5 % at 2.55 GHz, and 5.2 dB and 23.5 % at 5.1 GHz, respectively.

• Kyungpook Mathematical Journal
• /
• 제46권4호
• /
• pp.565-571
• /
• 2006

In this paper, we present the explicit formula of the generalized inverse $A^{(2)}_{T,S}$, and we apply this result to solve restricted linear equation $Ax+y=b$, $x{\in}T$, $y{\in}S$ and $Ax+By=b$, $x{\in}T$, $y{\in}S$.

• Nonlinear Functional Analysis and Applications
• /
• 제28권4호
• /
• pp.887-902
• /
• 2023

In this article, we investigate an approximate quadratic Lie *-derivation of a quadratic functional equation f(ax + by) + abf(x - y) = (a + b)(af(x) + bf(y)), where ab ≠ 0, a, b ∈ ℕ, associated with the identity f([x, y]) = [f(x), y²] + [x², f(y)] on a 𝜌-complete convex modular *-algebra χ_𝜌 by using ∆₂-condition via convex modular 𝜌.

• Journal of Magnetics
• /
• 제20권3호
• /
• pp.258-264
• /
• 2015

In this paper, an adequate B-H curve extrapolation method is proposed and its reliability is verified through experiments. A method is developed to estimate the magnetic saturation induction from the density of the lamination core and electrical resistivity. The magnetic saturation induction of electrical steels measured using a vibration sample magnetometer are compared with the analytical results to validate the accuracy of the proposed estimation method. It is found that the predicted error in the magnetic saturation induction of the electrical steels are approximately 1.2% when the proposed method is used. The performance of interior permanent magnet synchronous motors that applies the proposed method are evaluated via 2D nonlinear finite element analysis and through experiments. Based on the obtained results, the extrapolated B-H curves from the estimated saturation induction can be used for various analyses in saturation region.

• Current Optics and Photonics
• /
• 제7권2호
• /
• pp.166-175
• /
• 2023

We theoretically analyze and experimentally demonstrate a polarization-diversified four-channel optical demultiplexer (DeMUX) comprising a hybrid mode conversion-type polarization splitter rotator (PSR) and delayed Mach-Zehnder interferometer optical DeMUX for use in coarse wavelength division multiplexing (CWDM)-based optical interconnect applications. The Si wire-based device fabricated by a complementary metal-oxide semiconductor-compatible process exhibited nearly the same filter spectral response irrespective of the input polarization state under the PSR. The device had an extremely low insertion loss of <1.0 dB, polarization-dependent loss of <1.0 dB, and interchannel imbalance of <0.5 dB, suppressing unwanted wavelength and polarization crosstalk from neighboring channels of <-20 dB at each peak transmission channel grid.