• Applied Chemistry for Engineering
• /
• v.25 no.6
• /
• pp.624-631
• /
• 2014

In this study, a new series of conjugated polymer 3-(5-(5,6-bis(octyloxy)-7-(thiophen-2-yl)benzo[c][1,2,5]thiadiazol-4-yl)thiophen-2-yl)-10-(4-(octyloxy)phenyl)-10H-phenothiazine (P1) and 3-(5-(5,6-bis(octyloxy)-7-(thiophen-2-yl)benzo[c][1,2,5]thiadiazol-4-yl)thiophen-2-yl)-10-(4-((2-ethylhexyl)oxy)phenyl)-10H-phenothiazine (P2) were synthesised and organic photovoltaics (OPVs) properties were characterized. The push-pull structure polymer consisted of phenothiazine derivative as an electron donor and benzothiadiazole derivative as an electron acceptor. The aliphatic chain substituted aromatic ring was substituted at the position of N in phenothiazine for the electron-rich and improved solubility. Excellent thermal stabilities of P1 and P2 were confirmed by measured Td values as 321.9 and $323.7^{\circ}C$, respectively and the degrees of polymerization were 4,911 (P1) and 5,294 (P2). The maximum absorption wavelength of P1 and P2 were 549 and 566 nm, respectively. The device was fabricated and the OPVs property was measured. As a result, the power efficiency of conversion for P1 and P2 were 0.96 and 0.90%, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.2
• /
• pp.149-158
• /
• 1998

The SAR patterns of biological objects contacted with coaxial waveguide antennal has been investigated, in which the biological object was modeled by a homogeneous and four-layered lossy human body. We derived the finite-difference time-domain(FDTD) algorithm and equation of MUR and generalized perfectly matched layer(GPML) ABCs in cylindrical coordination. The coupling between coaxial waveguide antenna and a biological object was analyzed by use of MUR and GPML ABCs in the FDTD method to obtain the absorbed power patterns in the media. The specific absorption rates (SAR) distribution which was corresponding to the temperature distribution was calculated in each region by use of the steady-state response in the FDTD method. The SAR patterns of the FDTD method using MUR absorbing boundary conditions(ABCs) was compared with those of the FDTD method using GPML ABCs. The comparison exhibits that the penetration depth of the SAR patterns using MUR ABCs is deeper than that of the SAR patterns using GPML ABCs because of loss in free space. However, the spread in the lateral directions of the SAR patterns using GPML ABCs is smaller than of the SAR patterns using MUR ABCs.

• Journal of Pharmaceutical Investigation
• /
• v.30 no.3
• /
• pp.191-199
• /
• 2000

Genomics is providing targets faster than we can validate them and combinatorial chemistry is providing new chemical entities faster than we can screen them. Historically, the drug discovery cascade has been established as a sequential process initiated with a potency screening against a selected biological target. In this sequential process, pharmacokinetics was often regarded as a low-throughput activity. Typically, limited pharmacokinetics studies would be conducted prior to acceptance of a compound for safety evaluation and, as a result, compounds often failed to reach a clinical testing due to unfavorable pharmacokinetic characteristics. A new paradigm in drug discovery has emerged in which the entire sample collection is rapidly screened using robotized high-throughput assays at the outset of the program. Higher-throughput pharmacokinetics (HTPK) is being achieved through introduction of new techniques, including automation for sample preparation and new experimental approaches. A number of in vitro and in vivo methods are being developed for the HTPK. In vitro studies, in which many cell lines are used to screen absorption and metabolism, are generally faster than in vivo screening, and, in this sense, in vitro screening is often considered as a real HTPK. Despite the elegance of the in vitro models, however, in vivo screenings are always essential for the final confirmation. Among these in vivo methods, cassette dosing technique, is believed the methods that is applicable in the screening of pharmacokinetics of many compounds at a time. The widespread use of liquid chromatography (LC) interfaced to mass spectrometry (MS) or tandem mass spectrometry (MS/MS) allowed the feasibility of the cassette dosing technique. Another approach to increase the throughput of in vivo screening of pharmacokinetics is to reduce the number of sample analysis. Two common approaches are used for this purpose. First, samples from identical study designs but that contain different drug candidate can be pooled to produce single set of samples, thus, reducing sample to be analyzed. Second, for a single test compound, serial plasma samples can be pooled to produce a single composite sample for analysis. In this review, we validated the issue whether the second method can be applied to practical screening of in vivo pharmacokinetics using data from seven of our previous bioequivalence studies. For a given drug, equally spaced serial plasma samples were pooled to achieve a 'Pooled Concentration' for the drug. An area under the plasma drug concentration-time curve (AUC) was then calculated theoretically using the pooled concentration and the predicted AUC value was statistically compared with the traditionally calculated AUC value. The comparison revealed that the sample pooling method generated reasonably accurate AUC values when compared with those obtained by the traditional approach. It is especially noteworthy that the accuracy was obtained by the analysis of only one sample instead of analyses of a number of samples that necessitates a significant man-power and time. Thus, we propose the sample pooling method as an alternative to in vivo pharmacokinetic approach in the selection potential lead(s) from combinatorial libraries.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.4 no.4
• /
• pp.349-355
• /
• 2016

This study is about the reuse of bottom ash, which is released as a necessity in thermal power plant. In general, coal-ash are classified as fly-ash, bottom-ash, cinder-ash. Of these, a large amount of fly ash is being recycled as cement substitutes. While, recycling rates of bottom ash are the lowest due to its porosity and high absorption. In this study, the durability of the concrete using bottom ash as a concrete fine aggregate was evaluated. The using level of the bottom ash ranges to step-by-step from 0% to 30%. According to the result of the durability test, regardless of the presence of the bottom ash, freeze-thaw durability could be secured by air entrainment. In case of the resistance to chloride ions penetration, the length change, and the effects on heavy metals, the replacement of bottom ash as fine aggregate was not critical. Although carbonation penetration was higher as the replacement level of bottom ash increased, the experiment showed that it could be possible to use bottom ash as concrete fine aggregate with proper mix design.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.4 no.4
• /
• pp.418-424
• /
• 2016

This study is an experimental study on the recycling of bottom ash in coal ash discharged from a thermal power plant. Bottom ash has limited research on recycling because it has more porous and higher water absorption ratio than fly ash. In this paper, the bottom ash was pulverized to a specific surface area of $4,000cm^2/g$ in order to use as a binder, and the flow, compressive strength test and microstructure analysis of the bottom ash based geopolymer mortar were performed. The flow measurement results of the geopolymer mortar showed that the flow rate was improved by increasing mixing water as the molar concentration of activator was increased. Compressive strength increased with increasing curing temperature and molar concentration. Through the microstructure analysis, we could confirm the geopolymer gel produced by the reaction of the condensation polymerization. It is considered that it is possible to make the bottom ash based geopolymer concrete through proper molar concentration of activator and high temperature curing.

• Food Science and Preservation
• /
• v.18 no.4
• /
• pp.597-603
• /
• 2011

The in-vitro whitening and anti-wrinkle effect of ethanol extracts from apple flesh and peel were investigated. The EtOAc fractions from the ethanol extracts of apple flesh and peel showed in-vitro antioxidant activities in a dose-dependent manner on ABTS radical-scavenging activity and ferric-reducing/antioxidant power, and had the highest total phenolic contents (84.25 and 318.25 mg GAE/g). In addition, the EtOAc fractions generally showed strong UV absorption within the UV-B range. In the cellular system, the melanin synthesis of the B16/F10 melanoma cells was decreased by the EtOAc fractions of apple peel in a concentration-dependent manner. The EtOAc fractions of apple peel also showed a great elastase inhibition of 46.40% at 100 ${\mu}g$/mL, thus showing good in-vitro anti-wrinkle characteristics. These results suggest that the EtOAc fractions from the ethanol extract of apple peel can be used as whitening and anti-wrinkle agents as well as antioxidant resources.

• Journal of Sasang Constitutional Medicine
• /
• v.10 no.2
• /
• pp.163-180
• /
• 1998

In 1492 year, the corn originated in America continent had spread all over the world after spreading into Europe by Columbus. Since the Corn had a similar shape with adlai's one (Yulmoo(율무)), it had been written by the different name of adlai (Yulmoo) at the "訓蒙字會(Hun-mong-ja-hoe)(1527)". Therefore we should consider "Hun-mong-ja-hoe" is the first record of the corn and it is a significant historic record in the civilization exchange between the Orient and the Occident that this record has the only difference of around 30 years later after the spreading corn to Europe. However, this is on the assumption that it is correct for a scholar of Korean literature to persist in that '叡山本' of "Hun-mong-ja-hoe" could be considered as the first edition. The corn had been once classified as a same kind of the Chinese millet because the people had been recognized the corn as a similar group of the Chinese millet and the Indian millet. The Chinese millet contains a summer vigor and becomes as an ingredient of alcoholic drink. And we can find out that $C_4$ type plant (such as corn, Chinese millet, Indian millet, foxtail millet) mostly have a tendency to belong to the food for "Taeumin(太陰人)", because of its high energy efficiency, a flourishing absorption of fertilizing and a strong emission power. The fried corn with a strong summer vigor and a raised feature has a good effect to the treatment of the teethridge disease. And the tea of corn with an warm feature, thanks to its functions of making the stomach and intestines comfortably as well as urination, is a proper food for the 'Taeumin" who is apt to overeat themselves.

• Journal of the Korean Magnetics Society
• /
• v.14 no.4
• /
• pp.131-137
• /
• 2004

For the aim of thin electromagnetic wave absorbers used in mobile telecommunication frequency band (0.8-2.0㎓), we investigate high-frequency magnetic, dielectric and microwave absorbing properties of iron particles dispersed in rubber matrix in this study. The major experimental variables are particle shape (sphere and flake) and initial particle size (in the range 5-70 $\mu\textrm{m}$) of iron powders. High value of magnetic permeability and dielectric permittivity can be obtained in the composites containing thin plate-shape (flake) iron particles (of which thickness is less than skin depth in ㎓frequency), which can be produced by mechanical forging of spherical iron powders using an attrition mill. This result is attributed to the reduction of eddy current loss (increase of permeability) and the increase of space charge polarization (increase of permeability). The optimum initial particle size is found to be about 10 $\mu\textrm{m}$ for the attainment of the material parameters (particularly, real part of complex permeability) satisfying the wave impedance matching. With the iron powders controlled in size and shape as absorbent fillers in rubber matrix, the thickness can be reduced to about 0.7mm with respect to -5㏈ reflection loss (70% power absorption) in mobile telecommunication frequency band.

• Korean Journal of Food Science and Technology
• /
• v.44 no.1
• /
• pp.94-99
• /
• 2012

We investigated the in vitro antioxidant and antimelanogenesis effects of ethanol extracts from eggplant (Solanum melongena L.) peels. The total phenolics and chlorogenic acid in ethanol extracts were 2,465 mg/100 g and 2.08 mg/100 g, respectively. ABTS radical scavenging activity, ferric reducing/antioxidant power assay, and malondialdehyde (MDA) inhibitory effect of the extracts increased in a dose-dependent manner. In addition, the extracts generally showed strong UV absorption in the range of UV-B (290-320 nm). The $IC_{50}$ of mushroom tyrosinase inhibitory activity of ethanol extracts from eggplant peels was 870 ${\mu}g/mL$. Importantly, the melanin syntheses of B16/F10 melanoma cells were decreased by extracts in a concentration-dependent manner. Overall, these results suggest that eggplant peels can be potentially applied as a anti-melanogenic agent as well as an antioxidant resource.

• Korean Journal of Food Science and Technology
• /
• v.46 no.3
• /
• pp.341-346
• /
• 2014

This study was conducted to evaluate the effect of trehalose on the rheological properties of bread flour dough. Farinographic and viscographic properties, pH, total titratable acidity (TTA), and fermentation power were analyzed for flour dough rheology. Flour dough containing trehalose showed greater water absorption capacity and longer development time. However the stability, degree of softening, and farinograph quality number (FQN) were lower for the trehalose-containing flour dough, however, these factors decreased with increasing amounts of trehalose. Trehalose did not affect the beginning of gelatinization temperature and maximum viscosity temperature of flour. The maximum viscosity was the lowest with 6% trehalose, the end of final holding period, breakdown and setback values decreased with increasing amounts of trehalose. Flour dough with 4% trehalose had the lowest pH value for 120 min fermentation at $30^{\circ}C$, and the highest TTA value. Addition of 4% and 6% trehalose showed larger fermentation volume of dough than the control. The results suggested that trehalose positively affected the rheological properties of flour dough such as bread volume, softness, and staling delay.