• The Journal of Engineering Geology
• /
• v.17 no.3
• /
• pp.367-379
• /
• 2007

This study intended to evaluate hydrogeological characteristics in relation to subsurface geology data obtained from borehole, groundwater level, borehole flowmeter test, and field hydraulic tests. The regression equation of groundwater level (Y) versus ground elevation (X) is expressed by Y=0.75X-7.00 with quite high correlation coefficient of 0.78. Relationship between groundwater level and thickness of landfill, alluvium, and weathered zone results in higher correlation of groundwater level (Y) versus natural log value of weathered tone (A) than other correlations, with the regression equation Y= exp(9.974A)-14.155. The result of groundwater flow measurement in the boreholes indicates that groundwater flows towards between south and southwest, and this approximately agree with regional distribution of groundwater levels.

• The Journal of Engineering Geology
• /
• v.24 no.1
• /
• pp.69-79
• /
• 2014

This study aims to elucidate the relative importance of geological characteristics, soil slope, and rainfall intensity in relation to soil erosion. To this end, indoor rainfall simulation experiments were carried out under different conditions of rainfall intensities, soil slope, and geological characteristics. The test results show that the factors affect soil erosion in the order of soil slope > rainfall intensity > organic content in the soil. Erosion rates were proportional to rainfall, and increase with increasing clay content. Therefore, the soil erosion rate increases strongly with increasing organic content and clay content. The results show that the soil erosion rate in areas of metamorphic rocks shows a marked increase compared with areas of steep slope and sedimentary rocks. These results indicate that the geological characteristics to produce soil are closely related to sedimentation before and after erosion, providing basic information for the development of models to predict soil erosion rates.

• The Journal of Engineering Geology
• /
• v.28 no.4
• /
• pp.661-672
• /
• 2018

Radon concentration was measured in a total of 5,453 groundwater samples from wells across Korea. The radon concentrations showed the values ranging from 0.1 Bq/L to 7,218.7 Bq/L, with a median of 48.8 Bq/L which is lower than those of other countries having similar geological conditions. The distribution of radon concentrations was lognormal. The median value is high in the granite areas (63.5-105.1 Bq/L) while it is low in the sedimentary rocks and Cheju volcanic area (16.0-20.3 Bq/L). When grouping the groundwater with well depth, the median radon value is high in weathering and/or upper bedrock zone (61.4 Bq/L) while it is low in alluvium and/or weathering zone (28.5 Bq/L). About 17.7% of the total samples exceeded 148 Bq/L of USEPA guideline value. The exceeding radon ratio more than 148 Bq/L in groundwater is highest in Jurassic granite area, however, the exceeding radon rates more than 300 Bq/L and 500 Bq/L are highest in CGRA area.

• The Journal of Engineering Geology
• /
• v.34 no.2
• /
• pp.207-216
• /
• 2024

This study clarified the flow path of Choosan Spring, Nari Basin, Ulleung Island, South Korea. The orientations of faults and fractures developed on the inner edge of the caldera were identified as major factors affecting the flow path. The main flow paths include fracture zones oriented N-S and E-W. The spring also flows in a NE or NNE direction under the influence of the irregular shape of the caldera, which slopes to the NNE. Using Entrobacteriaceae species as tracers, it was found that Nari groundwater flows toward Choosan Yongchulso. However, the small number of water samples used in the analysis limits our understanding of the flow path from Sungin Valley to Nari Basin and Choosan Yongchulso.

• Tunnel and Underground Space
• /
• v.32 no.6
• /
• pp.530-548
• /
• 2022

The site selection process for deep geological disposal of high-level radioactive waste will be conducted in stages, and 103 evaluation parameters related to site selection have been proposed. In the field of rock mechanics and rock engineering, there are 33 evaluation parameters for intact rock, joint and rock mass, and they are applied in the basic and detailed investigation stages. In this report, uniaxial compressive strength, in-situ stress, joint distribution, and rock mass classification were selected as the main evaluation parameters, and among them, uniaxial compressive strength and in situ stress were selected as key evaluation parameters. Statistical techniques or regression analysis were performed for granite in Wonju and Chuncheon to evaluate the distribution range for the selected key evaluation parameters. The average of the uniaxial compressive strength in the Wonju area estimated through the posterior distribution is about 171 MPa, and about 123 MPa in the Chuncheon area. The maximum in situ stress acting in the Wonju area was less than 30 MPa and less than 40 MPa in the Chuncheon area. The direction of the maximum horizontal stress calculated by regression analysis was 101° in Wonju, and in the case of Chuncheon, it was 95°, respectiviely.

• The Journal of Engineering Geology
• /
• v.15 no.1
• /
• pp.41-55
• /
• 2005

This research is aimed at investigating the ground characterization of the Cheongju granite area using the geophysical methods. Test site was chosen from the building site in Chungbuk University, Chongju, Chungbuk province. Furthermore, geophysical methods are employed on the outcrops in the east to map the distribution of fault and intrusion and reveal the degree of weathering. The subsurface structure mapped from seismic re-fraction survey mainly consists of two units of weathered soil and rock. Threshold of the units were determined on the basis of seismic velocity of 800 m/s, supported from the standard classification table. From the results of standard penetrating test(SPT), these units are found to show medium-high and high density, respectively. Weathering soil is subdivided in unsaturated layer and saturated layer with thresholds of seismic velocity (500 m/s) and resistivity (200 ohm-m). In particular, unsaturated layer is again classified into dry and wet portions using the GPR section. The boundary between unsaturated and saturated weathering soils corresponds to the groundwater table at depth of approximately 5～6.2 m, which is well correlated with the one from drill-core data. However, bedrock is not delineated by geophysical methods. In the GPR section, fault and intrusion observed on the outcrop are revealed not to extend to the building site. With respect to weathering degree, the outcrop characterized by low resistivity and velocity corresponds to the grade of 'completely weathered' from the geotechnical investigations.

• The Journal of Engineering Geology
• /
• v.18 no.4
• /
• pp.459-470
• /
• 2008

Types of slope failure related to cut slope stability are interpreted through case analyses, and also factors affecting structurally controlled instability investigated, which are developed by geologic structures along a national road No. 25 across the Cheongwon and Boeun-Guns, Chungbuk. Engineering properties such as orientation, persistence, roughness and uniaxial compressive strength of joints are analyzed by square-inventory method in three areas with well-preserved outcrops. The study area is located in Ogcheon folded bet, and are composed of quartz-schist and quartzite in the Midongsan Formation and phyllite in the Ungyori Formation. Flexural beds by folding, schistosity and cleavage besides joints are developed due to slight metamorphism. Various types of joints developed by folding are formed such as strike-parallel, strike-perpendicular, wedge and wrench joint sets by both initially regional and later superposed folding. Factors of slope instability are created by crossing the orientations of joint, cleavage, bedding and slope one another. In the case that the orientation of a slope is coincident with one of beds, factors causing large-scale failure including plane failure are increased greatly. Also in the region that orientations of the slope and bed are crossed each other at high angle, only local and minor failures are shown in the slope.

• The Journal of Engineering Geology
• /
• v.5 no.3
• /
• pp.249-258
• /
• 1995

The landslide occurred in the Nongong area of Dalseong - gun, Kyeongbuk, is described and analysed in terms of structural geology and clay mineralogy to understand the causes of the landslide. The result of the analyses shows that the slip direction and the scale of the landslide of the study area were controlled by the attitude of the major discontinuity planes m the area such as joints, faults and dikes. In addition, the surface of the slip planes of the landslide is composed of clay minerals, which are mostly tri - octahedral vermiculite and smectite. From this study it can be concluded that the presence of expandable clay minerals within the bedding joints and fracture zones in bed rock played an important role in causing the landslide of the study area.

• The Journal of Engineering Geology
• /
• v.10 no.1
• /
• pp.27-38
• /
• 2000

We hydrogeologically studied a mountainous area and its vulnerability to groundwater contamination. Groundwater flow and recharge occur mainly through a network of fractures in this areaTransmissivity and storativity obtained from slug, slug interference, and pumping tests range from 3.2$\times$10$^{-3}$ to 2.0$\times$10$^{-2}$$m^2$/min and 1.3$\times$10$^{-7}$ to 9.15$\times$10$^{-4}$, respectively. The groundwater was contaminated bylivestock activities in the upgradient. The groundwater in the downgradient residential area wasthreatened by the upgradient livestock activities.

• The Journal of Engineering Geology
• /
• v.1 no.1
• /
• pp.109-120
• /
• 1991

Applications of microtremor to geological engineering are widely reviewed and observed microtremors are processed to show evidences of close relationship between the predominant periods of microtremor and underground structure. The ground vibrates continuously at all times and the elastic vibration is called microtremor (0.5-20Hz) or microseisms (0.01-0.1Hz) according to their frequency range. The vibration is believed to have propagative nature like those of the dispersive surface waves or multireflected shear waves. Microtremors were recorded at selected thress places of which subsoil structures are well distinguished in the Kyongsang Sedimentary Basin. It is found that the underground structures estimated from microtremor analysis coincide well with the known structures. The microtremor analysis of the long period range can be an inexpensive and effective tool in geological engineering for the evaluation of the underground structure, site-specific reponse spectrum, and seismic microzonations.