• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.8 no.1
• /
• pp.7-10
• /
• 1975

The catches of mackerel by monofilament and multifilament net were compared by means of $x^2$ and t-test method. In order to improve the netting twine of drift nets, 6 shoots 5 different mesh and nylon-monofilament netting twines $(B\times2,\;C\;D,\;F,)$ and 2 shoe nylon-multifilament $(A\times2)$ which are using near the Jeju Island in contemporary days were used for the experiment. These gill no were connected in order of A, ,B, C, A, B, E, F and operated fly fishing boat Taeann Ho (7T) near sea of Jeju Ialand from May 1974 to August 1974. The results obtained are as follows: 1. B type nylon-monofilament gill nets were superior to nylon-multifilament gill nets in catch according to the result of $X^2$ test and t-test, and the catch ratio was $M_A:\;M_B=1:1.8$. 2. 75mm mesh size C, D nylon-monofilament gill nets were superior to 85mm mesh size nylonmonofilament gill nets, and their catch ratio were E, F: C, D=1:2.8. 3. The catch ratio C, D and E, F type nets were compared by means of t-teat, however could not recognized their relationship.

• Journal of IKEEE
• /
• v.3 no.2 s.5
• /
• pp.186-195
• /
• 1999

In this paper, the RF-modules composed of front-end, frequency synthesizer, modulator/demodulator and power control multi channel WLL personal system for W-CDMA using 10 [MHz] RF channel bandwidth has been implemented and considered. The measured transmission power is 250 [mW] which is very close to the required value. The measured flatness of power at the final output stage is ${\pm}1.5[dB]$ over the required bandwidth of the receiver. In addition, it is found that the chip rate transmitting spread signal is set to 8.192 [MHz], the required rate. The frequencies of RF_LO signal and LO signal of the modulator and the demodulator measured by a frequency synthesizer are satisfied with design requirements. The operating range of the receiving strength signal indicator and AGC units shows 60 [dB] respectively. Also the measured phasor diagram and eye pattern for deciding the RF modules compatible with baseband digital signal processing part are shown good results.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.17 no.3
• /
• pp.162-173
• /
• 1997

Automatic on-line surface inspection systems have been applied for monitoring a quality of steel strip surfaces. One of the important issues in this application is the performance of on-line defect classifiers. Rule-based classification table methods which are conventionally used for this purpose have been suffered from their low performances. In this work, probabilistic neural networks and the enhanced classification tables which are newly proposed here are applied as alternative on-line classifiers to identify types of surface defects on cold rolled strips. Probabilistic neural networks have shown very excellent performance for classification of surface defects.

• The KIPS Transactions:PartC
• /
• v.12C no.6 s.102
• /
• pp.817-826
• /
• 2005

BcN(Broadband convergence Network) is being developed in order to support a variety of network applications, with enhanced capabilities of QoS(Quality of Service) provisioning and security, and IPv6. In a high-speed network environment such as BcN, it if more likely for the network resources to be exposed to various intrusion activities. The propagation speed of intrusion is alto expected to be much faster than in the existing Internet In this paper, we present a multi-domain security management framework which my be used for a global intrusion detection at multiple domains of BcN and describe its characteristics. For the performance evaluation, we first present test results for the security node and compare with other products. Then we design and Implement an OPNET simulator for the proposed framework, and present some simulation results. In the simulation model, we focus on the performance of alert information in the security overlay network.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.6 no.4
• /
• pp.257-263
• /
• 2008

We analyzed the statistical properties for the conductive background fractures in the Low and Intermediate Level Waste(LILW) disposal site to conceptualize of its groundwater flow system. The background fractures were classified to fracture sets based on their trends and plunges that were obtained from the borehole logging data, and then the fracture transmissivity distribution was inferred from the fixed interval hydraulic test results. The fracture size distribution of each fracture set was estimated using the fracture density and fracture mapping data. To verify the analyzed results, we compared observed field data to simulated one from the DFN model that was constructed with the analyzed statistical properties of the background fractures, and they showed a good agreement.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.41 no.3
• /
• pp.199-206
• /
• 2005

As the basic study about improvement of yellow croaker drift gill net fishing implement and development of the fishing system, this study drew problem after synthetically analyzing hauling system of yellow croaker drift gill net used in the coast of Chuja Island and tested several characters and analyzed in hauling process with 5 step net hauler model for improving the problem. The analysis results are as follows. When the angle between axises of drum centers was small, it showed the tendency that hauling time was fast. Hauling time was faster when drum was 5 step rather than 3 step. When drum was 5 step, slippery phenomenon was small and hauling was stable. Tension was larger when drum was 5 step rather than 3 step. When drum was 5 step, the range of change of the maximum and minimum value was small and hauling was stable. When drum was 3 step, there was following formula between hauling time ($Ht_3$) and angle between axises of drum centers ($A_g$) $Ht_3$ : ($7.15Hs^{-0.81}$) $A_g^{-0.81}$, when drum was 5 step there was following formula.$Ht_5$ : ($6.45Hs^{-0.75}$) $A_g0.10$, here, Hs is hauling speed. When drum was 3 step and hauling speed was 28cm/sec, tension was $T=0.08A_8^3-1.60A_g^3-0.49A_g+369.56(r=0.99)$, when drum was 5 step, tension was, $T=-0.01A_g^3+1.96A_g^2-34.05A_g+414.58$ (r-0.99), here, T was tension(g).

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.30 no.2
• /
• pp.199-210
• /
• 2012

This paper is designed to put forth a proposal for configuration of an optimized observation network based on GNSS CORS with a view to continued monitoring of crustal deformation in the East-Asian region. For this purpose, a comprehensive analysis of the results of the testing of various forms of GNSS CORS observation network tentatively constructed based on the Asia-Pacific IGS station has confirmed that geometrically arranged minimum five and ten or more reference points and an EAREF, constructed with a baseline length no longer than 2,500km, can produce an optimum outcome. And an EAREF-applied analysis on the effects of the Great Eastern Japan Earthquake of March 2011 shows that there were conspicuous positional movements in Japan and Korea while there was no significant movement in other regions.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.34 no.2
• /
• pp.135-138
• /
• 1998

This paper describes the construction and experimetal results of prototype digital telesounder developed to monitor remotely the fish school entered in setnet. The telesounder consists of the sea station and land station. The former consists of an ultrasonic transceiving part of 50 KHz, a hand made 16 bits single board computer (SBC), and a RF MODEM of 9600 bps for data link. The SBC controls the trigger signal to transmit the ultrasonic pulse, maximum detection range, sampling rate in analog to digital converter and data link. The sampling rate of echo data was 80 ${\mu}$s. The later consists of a RF MODEM same as the former one and 486 notebook computer which displays the echogram and saves its raw data. The authors carried out some experiments to confirm the practical use of the telesounder. At results the echogram obtained on the land station is sufficiently good and clear to monitor the behavior of fish school in setnet.

• Smart Media Journal
• /
• v.1 no.2
• /
• pp.12-22
• /
• 2012

Today we are witnessing an increasingly widespread use of cameras in our lives for video surveillance, robot vision, and mobile phones. This has led to a renewed interest in computer vision in general and an on-going boom in human activity recognition in particular. Although not particularly fancy per se, human gait is inarguably the most common and frequent action. Early on this decade there has been a passing interest in human gait recognition, but it soon declined before we came up with a systematic analysis and understanding of walking motion. This paper presents a set of DBN-based models for the analysis of human gait in sequence of increasing complexity and modeling power. The discussion centers around HMM-based statistical methods capable of modeling the variability and incompleteness of input video signals. Finally a novel idea of extending the discrete state Markov chain with a continuous density function is proposed in order to better characterize the gait direction. The proposed modeling framework allows us to recognize pedestrian up to 91.67% and to elegantly decode out two independent gait components of direction and posture through a sequence of experiments.

• Journal of Aquaculture
• /
• v.16 no.1
• /
• pp.44-50
• /
• 2003

This study aimed to develop the methods of growing Enteromorpha prolifera natural seedlings in its natural habitat and artificial indoor seedlings by inducing spore release. Likewise, the study examined the possibility of mass production by developing cultivation techniques with cultivating examination. The natural seedling of E.prolifera thrived in a sea area composed of sand and mud, which Is its natural habitat. Growing of this alga on the seedling frame 20 cm high from the bottom at the intertidal zone in summer and 40 cm high in fall was found to be very effective. However, enabling the best attachment rate for artificial indoor seedling requires inducing spore release after drying the mature thalli in a dark place fur about 12∼24 hours and setting seedling nets in a dark water tank (spore solution) for 24 hours. Breeding E.prolifera in a pole-system farm is best done in shallow sea areas with mud or mud and sand geological feature. However, floating-system lam is better for deep-sea areas with fast current. Ideal farming places are sea areas with plenty of nutritional salt and safe places that protect the lam facilities against billows. Furthermore, an exposure method on seawater surface to produce larger output should be used.