• Journal of the Korean Society of Safety
• /
• v.27 no.4
• /
• pp.38-42
• /
• 2012

This paper describes electrical fire on residential environment such as apartment and detached house caused by defect of interior wiring. We carried out experimental study on short circuit characteristics by the interior wiring length. We were measured arc current, arc energy and interrupting time of earth leakage current circuit breaker(ELB), when an interior wiring break out short circuit in residential environment. From the experiment results, the longer of the interior wiring, the magnitude of arc current decreased and the interrupting time of ELB increased. When applied the A maker's ELB, the strength of arc current and interrupting time of ELB was 254 A and 245 ms respectively at 30 m interior wiring length. In 3 m interior wiring length, arc current and interrupting time was 716 A and 4.24 ms respectively. Arc energy was dependent on the magnitude of arc current and the interrupting time of ELB, the longer the interrupting time, arc energy increasing. In this paper, minimum arc energy was 277 J using C maker's ELB and 3 m interior wiring length(arc current 283 A, interrupting time of breaker 6.28 ms). Therefore in the residential environment, short circuit caused by defect of the interior wiring lead to electrical fire.

• Journal of the Korean Society of Safety
• /
• v.32 no.6
• /
• pp.22-28
• /
• 2017

According to the National Fire Data System (NFDS), more than 5,000 vehicle fires have occurred every year for the last 10 years. Vehicle fires are primarily caused by mechanical (breaking system and engine), electrical (wiring and battery), and chemical (oil and fuel gas leakage) problems. The electrical factor has increased with the installation of driver convenience equipment. For example, today, the black box is widely used to provide video data recording of motor vehicle accidents. The black box consists of a front camera, rear camera, and wires. The black box wires are directly connected to the junction box or fuse box from the start battery that operates to provide normal on power supplying for engine stop. It is extremely dangerous when the wires short circuit due to insulation aging, mechanical and electrical stress, etc. In this study, the black box wiring fire risk have been analyzed and investigated when the steady state and abnormal operations, and under the following conditions: wiring arrangements with a high temperature condition, insulation aging, poor contact, and short circuits. The results showed that black box wiring short circuits had a higher fire risk than the other fire hazard elements. To prevent fire hazards caused by black box wiring, the black boxes must be installed by qualified service personnel. Do not modify the wiring, remove the fuse and secure the wiring using cable ties or insulation tape.

• Journal of the Korea Safety Management & Science
• /
• v.23 no.4
• /
• pp.23-29
• /
• 2021

The purpose of this study is to reduce the probability of occurrence of electric fires as a preemptive preventive measure, and to strengthen the capability of preventing electric fires by strengthening the cooperative function between electric fire-related departments and establishing a cooperative system. In this study, the general aspects of electric fires were identified by reviewing the literature such as ignition mechanisms of electric fires. And the major electrical fires that occurred in the last 10 years were classified into ignition factors (short circuit, overload/overcurrent, and earth leakage/ground fault) and ignition sources (wiring/wiring appliances, electrical equipment/household appliances). And the 4M technique was used to analyze the potential causes of ignition at the fire site and to suggest preventive measures. In the case In this study, out of 48 electrical fires in the past 10 years, 16 short-circuit fires, 3 overload/overcurrent fires, 3 short-circuit and earth fault fires, 16 fires in wiring/wiring appliances, and 10 fires in electrical equipment/home appliances classified as cases. And prevention measures were presented in terms of human, machine, media, and management by using the 4M technique. For the preemptive prevention of electric fires, strengthening the compulsory electrical safety inspection and making it mandatory to report when new or expanding electric facilities, charging a fee for electric safety inspection for detached houses and granting benefits subject to inspection completion, improvement of the electric safety voluntary inspection table and safety indications; It was suggested as a policy to organize and operate electrical safety inspection personnel in a two-person team (mixed), establish a close work cooperation system with related organizations, and strengthen electrical safety education and publicity.

• Journal of Yeungnam Medical Science
• /
• v.2 no.1
• /
• pp.59-63
• /
• 1985

Treatment of olecranon fractures by prolonged immobilization often results in limited elbow motion. With the use of tension band wiring, anatomical reduction was obtainable, and only a short period of immobilization was needed. We reviewed the cases of 17 patients who underwent surgical treatment of the olecranon fracture. All patients were treated by tension band wiring. In the over-all series, we were able to obtain 53 per cent excellent, 30 per cent good, and 17 per cent fair results.

• Fire Science and Engineering
• /
• v.17 no.2
• /
• pp.1-5
• /
• 2003

Recently, the occurrences of electrical fire have been suppressed by a residual current protective devices(RCD), a molded case circuit breaker(MCCB) and a fuse in case of an earth leakage, a short circuit and an over current. But it is impossible for the RCD to break the circuit in the case of the conductor fractures, the failure of pressure contacts on connecting points and the momentary short circuit of low voltage wiring. Therefore, it is require to study the constructive problem of the RCD. In this paper, we have tested the operation characteristics of the RCD according to the R load and R-L load in the conductor fractures, the failure of pressure contacts on connecting points and the momentary short circuit of low voltage wiring.

• Korean Journal of Organic Agriculture
• /
• v.27 no.1
• /
• pp.33-44
• /
• 2019

This study was initiated to find possibility of substitute of gibberellin acid and to prevent negative girdling effect such as slow growth of 'Niitaka' (Pyrus pyrifolia Nakai) trees, a major pear cultivar, at harvest and at 60-, 90-, and 120-d after storage. Seasonal wiring with 3.0-mm-diameter were applied on the main branch at 70, 80, 90, 110, and 130 days after full bloom (DAF) to compare the fruit quality and storability. Fruit weight and sugar contents were the greatly increased by the wiring treatment at 110 DAF, with the lowest values observed for the wiring at 70 DAF. All the wiring treatments reduced fruit acidity but did not affect fruit firmness. a-value on fruit skin was the highest for wiring at 110 DAF and 130 DAF, advancing fruit ripening. The lowest fruit weight loss was occurred at wiring at 110 DAF. a-value on fruit skin was the highest for wiring at 90 DAF and 110 DAF. Wiring at 80 DAF the most increased floral bud diameter, resulting in the lowest L:D ratio of 1.74 observed. As for the mineral nutrients concentrations of floral buds, the concentration of K (0.63%) and Mg (0.31%) were the highest after 80 DAF wiring treatment, whereas Ca and P concentrations did not differ among treatment plots. The leaf K concentrations was the highest in the 130-day wiring treatment (0.76%) and in the control plot (0.78%), whereas there was no significant difference in the concentrations of either Ca or P among treatment plots. Short periods of wiring increased foliar Mg concentrations. In floral buds, carbohydrates showed a tendency for accumulating at a lower concentrations (7.75%) after 70 DAF wiring treatment, which was a relatively short treatment period. On the other hand, the carbohydrate concentrations in leaves showed a tendency for accumulating at lower concentrations after 130 DAF wiring treatment (2.51%), which is a long treatment period, and in the control plot (2.43%). Wiring increased the size and sugar content of fruits, and influenced fruit storability. For the wiring treatment period was delayed, the carbohydrate concentration in flower buds showed curvilinear correlation and the negative correlation with the carbohydrate in leaf tissue.

• Journal of Veterinary Clinics
• /
• v.37 no.6
• /
• pp.363-366
• /
• 2020

A 2-month-old, 50 kg male Korean native calf was referred with bilateral mandibular fractures. The bilateral mandible was hanging loose, with inability to use the jaw, indicated by excessive salivation. Radiography revealed a long oblique fracture in the right mandible, and a short oblique fracture in the left mandible. Computerized Tomography, a different form of radiography, revealed the fracture in the left mandible to be a comminuted fracture. In order to stabilize the bilateral mandible fractures, a combination of bone plate and wiring was applied; in addition, resin was applied to enhance stabilization of the mandible. Six weeks after surgery, the calf was able to masticate and ruminate well. In this case, application of the plate and wiring with resin to bilateral mandibular fractures presented a successful functional recovery. Accordingly, the combination of bone plate and wiring with resin can be an effective technique for treating mandibular fractures.

• Journal of the Korea Institute of Construction Safety
• /
• v.1 no.1
• /
• pp.31-39
• /
• 2018

It is reported that about 20 % of all fires in Korea are caused by the electric equipment and installations. In complex and large-scale buildings, the sizes of electric fires are becoming larger as property damage and casualties increase. Among the causes of various electric fires, fire by short circuit accounts for about 71.5% of overall fires, and in the classification by electric equipment and installation, fire caused by wiring and wiring equipment accounts for approximately 38.3% of overall fires. The purpose of this study is to propose methods to prevent electric fires due to short circuit by improving indoor wiring currently in use and to find the fundamental measures to prevent wiring equipment caused fires by improving the socket and plug which are commonly used in wiring equipment. It is expected that the electric fire prevention measures presented through this study can be used as a measure to protect many people and properties by eliminating the root cause of electric fire.

• Proceedings of the KIEE Conference
• /
• 2000.07c
• /
• pp.1557-1559
• /
• 2000

In this paper, we intend to establish the judgement of electrical fire through analysis of PT(Potential Transformer) using the power installation. The columnar structure and the void generated by abrupt heat grew at the tenter of boundary-face on the metallurgical microscope analysis. The detection of OK lines was confirmed by EDX(Energy Dispersive X-ray spectroscopy) as melting and recombination due to the layer-short of the wiring. We found that the thermal-weight decrease occurred at 300$^{\circ}C$ in case of being the thermal-deterioration on the base of the result that analyzed the insulated-materials by using TGA, and the thermal reaction limited-value of PT insulator was about 300$^{\circ}C$ on the DSC curve. As this analysis, we confirmed what the layer-short appeared in the wiring of PT.

• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2004.11a
• /
• pp.287-291
• /
• 2004