• Journal of the Korean Data and Information Science Society
• /
• v.28 no.1
• /
• pp.39-47
• /
• 2017

Precipitation is an important component for hydrological and water control study. In general, AWS data provides more accurate but low dense information for precipitation while radar data gives less accurate but high dense information. The objective of this study is to construct adjusted precipitation field based on hierarchical spatial model combining radar data and AWS data. Here, we consider a Bayesian hierarchical model with spatial structure for hourly accumulated precipitation. In addition, we also consider a redistribution of hourly precipitation to 2.5 minute precipitation. Through real data analysis, it has been shown that the proposed approach provides more reasonable precipitation field.

• Journal of Ecology and Environment
• /
• v.35 no.3
• /
• pp.203-212
• /
• 2012

The physiological effects of elevated $CO_2$ concentration and temperature were examined for Quercus gilva and Q. glauca grown under control (ambient $CO_2$ and temperature) and treatment (elevated $CO_2$ and temperature) conditions for 39 months. The objective of the study was to measure the long-term responses, in physiological parameters, of two oaks species exposed to elevated $CO_2$ and temperature. The photosynthetic rate of Q. gilva was found to be decreased, but that of Q. glauca was not significantly affected, after long-term exposure to elevated $CO_2$ and temperature. Stomatal conductance of Q. glauca was reduced by 21.7%, but that of Q. gilva was not significantly affected, by long-term exposure to $CO_2$ and temperature. However, the transpiration rate of the two oak species decreased. Water use efficiency of Q. gilva was not significantly affected by elevated $CO_2$ and temperature, while that of Q. glauca was increased by 56.6%. The leaves of Q. gilva grown under treatment conditions had an increased C:N ratio due to their reduced nitrogen content, while those of Q. glauca were not significantly affected by long-term exposure to elevated $CO_2$ and temperature. These results suggest that the long-term responses to elevated $CO_2$ and temperature between Q. gilva and Q. glauca are different, and that Q. gilva, the endangered species, is more sensitive to elevated $CO_2$ and temperature than Q. glauca.

• Journal of Environmental Science International
• /
• v.18 no.1
• /
• pp.21-32
• /
• 2009

The short-term variations of the mesozooplankton community structure were investigated in Gamak Bay during summer season, 2006. The study was based on a comprehensive survey constituting from 12 stations on June 19, July 28, August 4, and August 29, respectively. Mean of temperature and chlorophyll ${\alpha}$ concentrations in the surface layer were significantly higher than those in bottom layer, and those concentrations were significantly higher in the inner bay than those in the outer bay. A total of 40 taxa including 19 copepods were observed in Gamak Bay during summer season. Mean abundance of total mesozooplankton varied from 1,859 to 26,111 indiv. $m^{-3}$. The dominant species were Noctiluca scintillans, Penilia avirostris, Evadne tergestina, Paracalanus parvus s. 1., Acartia omorii and Cirriped nauplii and cyprii in Gamak Bay, and they contributed 90% of mean abundance of total mesozooplankton. Noctiluca scintillans was high after the rainfall. Cluster analysis showed that the mesozooplankton community could be divided into 4 distinct groups, indicating rapid change of the community in the short-term of this survey. The relative contribution of each group of the N. scintillans, P. avirostris, E. tergestina, and P. parvus s. 1. showed differences during the phytoplankton bloom period. The mesozooplankton community compositions were highly associated with water temperature, and salinity in physical conditions, and food organisms affect short-term variations in mesozooplankton composition. Interestingly, protozoa N. scintillans, and Cladocera appeared to be one of the key organisms to extinguish the phytoplankton bloom. Therefore, this study suggests that N. scintillans, and Cladocera could be a key player to control the mesozooplankton community structure during summer season, 2006.

• Journal of Aquaculture
• /
• v.11 no.1
• /
• pp.91-97
• /
• 1998

This paper introduces to a simple culture method and growth of axenic (bacteria-free) rotifer Brachionus rotundiformis for seed stock of rotifer mass culture. This rotifer axenic culture method is based on the washing and transferring with sterilized sea water and modified antibiotic mixture AM9 solution. Population growth (final density on day 16) of axenic cultured rotifer were maintained with a high density and stable growth compared with the control of non-axenic culture (general culture style) through the 3 times-rerunning experiments (trial 1, 2 and 3). But the egg carrying rates of amictic females were not different between the axenic-and non-axenic culture condition. Although, rotifer density was higher in axenic culture, the food (Nannochloropsis oculata) was still remained unutilized than that of the non-axenic culture in third trial culture. These results suggest the possible existence of harmful bacteria for the rotifer population growth in the trial 1 and 3 of non-axenic culture compared to the trial 2. This axenic rotifer culture method is valuable for seed stock of the stable rotifer mass cultures.

• The Journal of Advanced Prosthodontics
• /
• v.9 no.6
• /
• pp.423-431
• /
• 2017

PURPOSE. The goal of this study was to evaluate the fracture resistances of various monolithic crowns fabricated by computer-aided design and computer-aided manufacturing (CAD/CAM) with different thickness. MATERIALS AND METHODS. Test dies were fabricated as mandibular molar forms with occlusal reductions using CAD/CAM. With different occlusal thickness (1.0 or 1.5 mm), a polymer-infiltrated ceramic network (Enamic, EN), and zirconia-reinforced lithium silicate (Suprinity, SU and Celtra-Duo, CD) were used to fabricate molar crowns. Lithium disilicate (e.max CAD, EM) crowns (occlusal: 1.5 mm) were fabricated as control. Seventy crowns (n=10 per group) were bonded to abutments and stored in water for 24 hours. A universal testing machine was used to apply load to crown until fracture. The fractured specimens were examined with a scanning electron microscopy. RESULTS. The type of ceramics and the occlusal thickness showed a significant interaction. With a recommended thickness (1.5 mm), the SU revealed the mean load similar to the EM, higher compared with those of the EN and CD. The fracture loads in a reduced thickness (1.0 mm) were similar among the SU, CD, and EN. The mean fracture load of the SU and CD enhanced significantly when the occlusal thickness increased, whereas that of the EN did not. CONCLUSION. The fracture loads of monolithic crowns were differently influenced by the changes in occlusal thickness, depending on the type of ceramics. Within the limitations of this study, all the tested crowns withstood the physiological masticatory loads both at the recommended and reduced occlusal thickness.

• Journal of Radiation Protection and Research
• /
• v.3 no.1
• /
• pp.6-22
• /
• 1978

High energy electron beams took effect for tumor radio-therapy, however, had a lot of problems in clinical application because of various conversion factors and complication of physical reactions. Therefor, we had experimentally studied the important properties of high energy electron beams from the linear accelerator, LMR-13, installed in Yonsei Cancer Center. The results of experimental studies on the problems in the 8, 10, 12 Mev electron beam therapy were reported as following. 1. On the measurements of the outputs and absorbed doses, the ionization type dosimeters that had calibrated by $^{90}Sr$ standard source were suitable as under 3% errors for high energy electrons to measure, but measuring doses in small field sizes and the regions of rapid fall off dose with ionization chambers were difficult. 2. The electron energy were measured precisely with energy spectrometer consisted of magnet analyzer and tele-control detector and the practical electron energy was calculated under 5% errors by maximum range of high energy electron beam in the water. 3. The correcting factors of perturbated dose distributions owing to radiation field, energy and material of the treatment cone were checked and described systematically and variation of dose distributions due to inhomogeneous tissues and sloping skin surfaces were completely compensated. 4. The electron beams, using the scatterers; ie., gold, tin, copper, lead, aluminium foils, were adequately diffused and minimizing the bremsstrahlung X-ray induced by the electron energy, irradiation field size and material of scatterers, respectively. 5. Inproving of the dose distribution from the methods of pendulum, slit, grid and focusing irradiations, the therapeutic capacity with limited electron energy could be extended.

• Journal of the Korean Society of Costume
• /
• v.56 no.3 s.102
• /
• pp.73-80
• /
• 2006

This study is aimed to produce natural dyeing garments, which contain the sentiments and color sense of Koreans, by using various household supplies, with a view to increase the values added and utilization of natural dyeing. The dyes mainly used for this study are multi-colored ones which are durable after dyeing and can represent various colors. They include Lithodpermum officinale, Caesalpinia sappan, Rubia Cordifolia, Pellodendron Bak, Curcuma Longa L., fallen Ginkgo Biloba, Artemisia Princeps, and Quereus acutissima carr shell. Considering water pollution and other things, aluminum acetate and ferrous chloride were used as mordants. Cheap and practical materials such as cotton cloth and those with traditional patterns and elegance such as silk and ramie fabrics were used to produce baby goods, household supplies, clothes, and accessories. The produced supplies closely contact with our body, so they may have a great effect on human body. The household supplies produced include rug, bedclothes, room bedclothes, curtain, bedding set, cushion, and sunlight blind, in consideration of the functionality or medical actions of the goods which are closely related to the human skin. The infant supplies produced include longcloth for newborn baby, bedding set, gauze handkerchief, and doll. The clothes include night gown, shirt, bath gown, and Korean traditional clothes. The accessories include tablecloth, cup pad, bag, wrapping cloth, mouse and keyboard cushion, and scarf. Nowadays, consumers prefer environment-friendly naturally dyed garments and products. In order to control the naturally dyed garments and products which are traded in the domestic market, it is urgent to introduce such ecological marks as 'Toxproof' and 'Ecoproof.' Currently, many ordinary persons, who are not experts, have interest and participate in natural dyeing, but they simply produce naturally dyed garments, not artistic works or everyday supplies. The present author expects this study will contribute to the production of household goods by such persons. The author also hopes that they will develop and commercialize such designs as suit to modern tastes and senses based on the unique cultural assets of Koreans, so that Korean naturally dyed products may be recognized as reliable commodities equipped with international competitiveness.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.2
• /
• pp.131-136
• /
• 2012

This paper investigated the combustion and exhaust gas characteristics of gasoline direct injection engines for various cooling water temperature. The engine-out nanoparticle emission number and size distribution were measured by a DMS-500 equipped upstream of the catalyst. A CLD-400 and an HFR-400 were equipped at the exhaust port to analyze the cyclic NOx and total hydrocarbon emission characteristics. The results showed that the nanoparticle emission number greatly increased at low coolant temperatures and that the exhaust mainly contained particulate matter of 5.10 nm. THC also increased under low temperature conditions because of fuel film on the combustion chamber. NOx emissions decreased under high temperature conditions because of the increase in internal exhaust gas recirculation. In conclusion, an engine management system control strategy for driving coolant temperature up rapidly is needed to reduce not only THC and NOx but also nanoparticle emissions.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.4
• /
• pp.337-344
• /
• 2011

The humidification of reactant gases is crucial for efficiently operating PEM (polymer electrolyte membrane) fuel cell systems and for improving the durability of these systems. The recycle of the energy and water vapor of exhaust gas improves the system performance especially in the case of automotive application. The available humidification methods are steam injection, nozzle spray, humidification by enthalpy wheel, membrane humidifier, etc. However, these methods do not satisfy certain requirements such as compact design, efficient operation and control. In this study, a hybrid humidification system consisting of a membrane humidifier and exhaust-air recirculation units was developed and the humidification performance of this hybrid humidifier was analyzed. Finally, a new practical method for optimal design of PEM-fuel-cell humidification system is proposed.

• Fisheries and Aquatic Sciences
• /
• v.12 no.4
• /
• pp.350-353
• /
• 2009

As a result of human industrial development, carbon dioxide ($CO_2$) is currently accumulating in the atmosphere and dissolving into the oceans. Sequestration into the deep sea has been proposed as a possible solution to this increasing atmospheric $CO_2$, although the impact of such a program on marine ecosystems is unknown. We examined the effects of increased $CO_2$ levels on the growth of the olive flounder, Paralichthys olivaceus. Juvenile olive flounder 40 days post hatching were exposed to two levels of $CO_2$ (3.60-7.55 and 4.05-11.46 kPa) in running seawater for 26 days. During the exposure period, the pH and $CO_2$ levels of the water were measured, and the numbers of dead individuals were counted in each aquarium. Following the exposure period, the total lengths (mm) and body weights (mg) of the juvenile fish were measured. Both $CO_2$ treatments significantly increased fish mortality compared to controls ($19.87\pm4.53%$ vs. 7.14% and $75.96\pm1.36%$ vs. 7.14% for high and low doses, respectively). After the high $CO_2$ treatment, total length ($14.98\pm6.58$ mm vs. $19.52\pm1.83$ mm) and body weight ($28.92\pm13.85$ mg vs. $67.35\pm18.32$ mg) of the exposed flounder were reduced compared to the control fish; however, no significant differences in these values were observed after the low $CO_2$ dose. These results suggested that $CO_2$ exposure inhibits growth in the juvenile stage and that $CO_2$-enriched seawater is toxic in the early life stages of olive flounder.