• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.13 no.3
• /
• pp.105-110
• /
• 2003

The ZnSe epilayers were grown on the GaAs substrate by hot wall epitaxy. After the ZnSe epilayers treated in the vacuum-, Zn-, and Se-atmosphere, respectively, the defects of the epilayer were investigated by means of the low-temperature photoluminescence measurement. The dominant peaks at 2.7988 eV and 2.7937 eV obtained from the PL spectrum of the as-grown ZnSe epilayer were found to be consistent with the upper and the lower polariton peak of the exciton, $I_{2}$ ($D^{\circ}$, X), bounded to the neutral donor associated with the Se-vacancy. This donor-impurity binding energy was calculated to be 25.3 meV, The exciton peak, $I_{1}^{d}$ at 2.7812 eV was confirmed to be bound to the neutral acceptor corresponded with the Zn-vacancy. The $I_{1}^{d}$ peak was dominantly observed in the ZnSe/GaAs : Se epilayer treated in the Se-atmosphere. This Se-atmosphere treatment may convert the ZnSe/GaAs : Se epilayer into the p-type. The SA peak was found to be related to a complex donor like a $(V_{se}-V_{zn})-V_{zn}$.

• Carbon letters
• /
• v.6 no.1
• /
• pp.15-24
• /
• 2005

Sixteen clinically healthy New Zealand white rabbits of either sex were divided into two equal groups I and II of 8 animals each. Under thiopental sodium (2.5%) anaesthesia a linear full thickness abdominal wall defect of 3 cm in length was created and repaired with continuous suture pattern using 3000 filaments of carbon fibres and 1~0 black braided nylon suture, ingroup I and II respectively. Increased vascularity was observed in carbon fibres (group I) and on day 30 the carbon fibres were covered by white fibrous tissue. Significantly higher (P < 0.05) values of glucose was seen on day 14 in group I, whereas, decrease in glucose value was observed in group II. Histopathologically, the carbon fiber implant induced extensive fibrous tissue (collagen fiber) reaction. Negligible inflammatory cells in the stroma indicate the host tissue tolerance to carbon fibers. Histochemically, gradually increased alkaline phosphatase activity up to day 14 in group I, suggested the proliferation of fibroblasts in early stages.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.2
• /
• pp.180-186
• /
• 2005

As a driving method of AC-PDP, Address-Display Separated(ADS) driving has been widely adopted for its simple architecture and low discharge failure rate. However, a high definition like a HDTV has defect of long addressing time by reason of a number of pixels. Priming effect isn't fully sustained because of long addressing time during the address period. Therefore, it has different wall charge and luminance of each addressing time in the sustain period. In this study, we suggest a new driving waveform on the address period to improve these defects. We applied a ramp waveform, instead of a square waveform, to an address period in ADS, for operating on the AC-PDP, which used the conventional gas [He-Ne-Xe]. When the ramp waveform is applied to the address period, we experimented for uniform wall charge and the improved luminance by sustained Priming effect at each addressing time in the sustain period.

• Structural Engineering and Mechanics
• /
• v.61 no.1
• /
• pp.1-13
• /
• 2017

The effectiveness of the repair scheme for the damaged captive-columns with CFRPs (Carbon Fiber Reinforced Polymer) was investigated in terms of response quantities such as strength, ductility, dissipated energy and stiffness degradation. Two 1/3 scale, one-story one-bay RC (Reinforced Concrete) frames were designed to represent the substandard RC buildings in Turkish building stock. The first one, which is the reference specimen, is the bare frame without infill wall. Partial infill wall with opening was constructed between the columns of the second frame and this caused captive column defect. Severe damage was observed with the concentration of shear cracks in the second specimen columns. Then, the damaged members were repaired by CFRP wrapping and retested. For the three test series, similar reversed cyclic lateral displacement under combined effect of axial load was applied to the top of the columns. Overall response of the bare frame was dominated by flexural cracks. Brittle type of shear failure in the column top ends was observed in the specimen with partial infill wall. It was observed that former capacity of damaged members of the second frame was recovered by the applied repair scheme. Moreover, ultimate displacement capacity of the damaged frame was improved considerably by CFRP wrapping.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.15 no.3
• /
• pp.252-259
• /
• 1990

This paper present new scheme for a Side Wall Masked Isolation(SWAMI) technology which take all the advatages provided by conventional LOCOS process. A new SWAMI process incorporates a sloped sidewall by reactive ion etch and a layer of thin nitride around the side walls such that both intrinsic nitride stress and volume expansion induced stress are greatly reduced. As a fabricate results, a defect-free fully recessed zero bird's beak local oxidation process can be realized by the sloped wall anisotropic oxide isolation. No additional masking step is required. The leakage current of PN diodes of this process were reduced than PN diode of conventional LOCOS process. On the other hand, the edge junction part was larger than the flat juction part in the density of leakage current.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.152-153
• /
• 2007

$CuInSe_2$ single crystal thin film was deposited on thoroughly etched semi-insulating GaAs(100) substrate by the hot wall epitaxy (HWE) system. After the as-grown $CuInSe_2$ single crystal thin films was annealed in Cu-, Se-, and In-atmospheres, the origin of point defects of $CuInSe_2$ single crystal thin films has been investigated by the photoluminescence(PL) at 10 K. The native defects of $V_{Cu}$, $V_{Se}$, $Cu_{lnt}$, and $Se_{lnt}$ obtained by PL measurements were classified as a donors or acceptors type. And we concluded that the heat-treatment in the Cu-atmosphere converted $CuInSe_2$ single crystal thin films to an optical n-type. Also, we confirmed that In in $CuInSe_2$/GaAs did not form the native defects because In in $CuInSe_2$ single crystal thin films existed in the form of stable bonds.

• Journal of Ocean Engineering and Technology
• /
• v.35 no.6
• /
• pp.403-413
• /
• 2021

As the size of ships increases, the size and output power of their thrusters also increase. When a large ship berths or unberths, the jet flow produced from its thruster has an adverse effect on the stability of quay walls. In this study, we conducted a numerical analysis to examine the impact of the thruster jet flow of a 30,000 TEU container ship, which is expected to be built in the near future, on the stability of a quay wall. In the numerical simulation, we used the fluid-structure interaction analysis technique of LS-DYNA, which is calculated by the overlapping capability using an arbitrary Lagrangian Eulerian formulation and Euler-Lagrange coupling algorithm with an explicit finite element method. As the ship approached the quay wall and the vertical position of the thruster approached the mound of the quay wall, the jet flow directly affected the foot-protection blocks and armor stones. The movement and separation of the foot-protection blocks and armor stones were confirmed in the area affected directly by the thruster jet flow of the container ship. Therefore, the thruster jet flows of ultra-large ships must be considered when planning and designing ports. In addition, the stability of existing port structures must be evaluated.

• Archives of Plastic Surgery
• /
• v.38 no.1
• /
• pp.113-116
• /
• 2011

Purpose: Many fingertip injuries are associated with nail injury and it is hard to repair to original shape due to its unique characteristic. Mucosal graft is used for a defect of the nail bed injury. Hereby, we introduce a DAP flap and buccal mucosal graft, with which we could reduce the defect size of the injured fingertip and donor site morbidity at the same time, without any need for harvesting additional skin from other part of hand. Also, mucosal graft makes good cosmetic and functional outcome of nail. Methods: This method was performed in a 56-year-old man with fingertip injury on dorsal side of left thumb due to electrical saw. First, DAP flap was performed on the injured finger to reduce the size of the defect of fingertip and cover the bone exposure. Second, nail bed part of the DAP flap was de-epithelized and buccal mucosal graft was done from left side of intraoral cavity wall. Results: Flap and graft survived without any necrosis but some nail bed could not be covered with flap due to insufficient flap size. All wounds healed well and did not present any severe adversary symptoms. Conclusion: DAP flap with mucosal graft is an effective method that we can easily apply in reconstruction of fingertip injury. We suggest that the combination of the two procedures makes good functional and cosmetic outcome compared to the usual manner, especially in cases of nail bed injury without distal phalanx bone defect.

• Archives of Plastic Surgery
• /
• v.34 no.4
• /
• pp.448-454
• /
• 2007

Purpose: The objective of this study was to evaluate the outcomes of using the free flap in the reconstruction of maxillary defects. Methods: 27 consecutive cases of maxillary reconstruction with free flap were reviewed. All clinical data were analyzed, including ideal selection of flap, time of reconstruction, recurrence of cancer, postoperative complications, flap design, and follow-up results. The main operative functional items, including speech, oral diet, mastication, eye globe position and function, respiration, and aesthetic results were evaluated. Results: Among the 24 patients who underwent maxillary reconstruction with the free flap, 14 patients underwent immediate reconstruction after maxillary cancer ablation, and 10 patients underwent delayed reconstruction. There occurred 1 flap loss. Recurrences of the cancer after the reconstruction happened in 2 cases. Postoperative complications were 3 cases of gravitational ptosis of the flap, 2 cases of the nasal obstruction, and 1 case of fistula formation. Out of 27 free flaps, there were 15 latissimus dorsi myocutaneous flaps, 5 radial forearm, 4 rectus abdominis myocutaneous flaps, 1 scapular flap, 2 fibula osteocutaneous flap, respectively. Flaps were designed such as 1 lobe in 9 cases, 2 lobes in 9 cases, and 3 lobes in 5 cases. Among the 14 patients who had intraoral defect or who had palatal resection surgery, 2 patients complained the inaccuracy of the pronunciation due to the ptosis of the flap. It was corrected by the reconstruction of the maxillary buttress and hung the sling to the upper direction. All of the 14 patients were able to take unrestricted diets. In 6 patients who had reconstruction of inferior orbital wall with rib bone graft, they preserved normal vision. Aesthetically, most of the patients were satisfied with the result. Conclusion: LD free flap is suggested in uni-maxilla defect as the 1st choice, and fibular osteocutaneous flap and calvarial bone graft to cover the larger defect in bi-maxilla defect.

• Archives of Reconstructive Microsurgery
• /
• v.10 no.2
• /
• pp.163-168
• /
• 2001

The defects of the abdominal wall could be brought about either congenitally, for instances in such cases as omphalocele or gastroschisis, or by various acquired causes-trauma, excision of tumors, excision of burn scar, tissue necrosis caused by infection, hematoma after abdominal surgery, tissue necrosis after radiation therapy and so on. As for the techniques of the reconstruction of the abdominal wall defects, many authors have developed and reported diverse methods. To summarize, primary closure, skin graft, local skin flaps, various myocutaneous flaps, free flap, fascia graft, artificial mesh, tissue expansion, etc could be used in the reconstruction of the abdominal wall defects. The periumbilical perforator-based island skin flap has a many advantages such as no significant sacrifice of the rectus abdominis muscle, wide rotation arc, reliable blood flow of the perforator, short elevation time for flap, and for middle-aged, obese patients, the donor site may be the best from the cosmetic point of view. We used perforator-based island skin flap in 5 cases with reasonable result from March 1999 to May 2001. There were no significant complications and donor sites could be repaired primarily.