• Journal of the Korean Wood Science and Technology
• /
• 제35권2호
• /
• pp.16-22
• /
• 2007

The behavior of ramie fibers and some wood elements in the early stage of alkali swelling was examined. When the fibers were treated with alkali solution, they significantly shrank in length and swelled in wall thickness. Ramie fibers showed a shrinkage averaging 23% in length and a swelling averaging 92% in width in 100 seconds treating time. Dimensional changes showed different fashion in each element of woods. The tracheids of latewood especially in Pinus densiflora and Larix kaempferi woods swelled intensively and showed balloon swelling, but in the case of Cryptomeria japonica, it was hardly observed. The swelling morphology of libriform fibers was similar to that of tracheids. The walls of vessel elements and parenchyma cells also swelled considerably in thickness but, no balloon swelling was found in both elements. The differences of swelling in different elements can be interpreted in terms of the differences of organization and/or chemical components of the cell walls.

• 전기학회논문지
• /
• 제59권3호
• /
• pp.575-580
• /
• 2010

This paper is to design an optimum power conversion device for the system required for development of a low cost 3-phase power inverter. For this purpose, in order to meet with endurance required by the industry, failure mode is standardized to guarantee lifetime of a power semiconductor by monitoring real time power loss and to facilitate failure mode analysis. As normality of heat loss of a power semiconductor is identified remaining in a certain range by comparing heat rise slope between that is calculated by using average current or average loss and that is measured at a heat sink, its feasibility is confirmed by experiment.

• 대한기계학회논문집
• /
• 제1권3호
• /
• pp.141-145
• /
• 1977

In this paper, approximate solutions of the von Karman equations for the free flexural vibration of a transversely isotropic thin rectangular plate with two simply supported edges and two clamped edges are obtained. Applying one term Ritz-Galerkin procedure, the spatial dependent part of the equation is separated and time dependent function is found to be the Duffing's equation. Then the relation between nonlinear period and amplitude of the vibration is obtained by using averaging method which is a method of the perturbation procedure. It can be seen that averaging method is easy and agrees well with prior results.

• 전자공학회논문지S
• /
• 제34S권10호
• /
• pp.89-97
• /
• 1997

To extract time-varying evoked potential (EP), segement latency corrected average method is presented. This method is composed of three steps. First, adaptive filtering for reducing the effect of artifacts and removing background noise is performed. Next, validated intervals of individual segments are aligned, and latency components are detected by cross-correlation between the previously obtained and measured EPs within the intervals. Finally, after the detected latency component, responses of segments are groupe and averaged, the shole corrected EP signal is obtained. In the experiments, the resutls of the conventional methods including simple averaging, Woody's method, and peak component latency corrected averaging are obtained, the results compared with the present method for evaluating performance. Therefore, the presented method confirms that it reflects the latency variations of fundamental peaks and gets the improved EP.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제53권9호
• /
• pp.650-656
• /
• 2004

This paper presents block and timing diagrams of the DWA(data weighted averaging) to optimize a feedback time delay of the sigma-delta modulator. Through the Matlab modeling, the optimized coefficients of the integrators are obtained to design the modulator. And then the fully differential SC integrators, feedback DAC, 9-level quantizer, and DWA are designed by considering the nonideal characteristics of the modulator. The designed second-order multibit modulator is fabricated in a 0.35$\mu\textrm{m}$ CMOS process. The designed modulator achieves 73dB signal-to-noise ratio and 72dB dynamic range at 1.2Vp-p 585kHz input singal and 52.8MHz sampling frequency.

• Structural Engineering and Mechanics
• /
• 제52권3호
• /
• pp.525-540
• /
• 2014

The Lyapunov exponent and moment Lyapunov exponents of Hill's equation with frequency and damping coefficient fluctuated by correlated wideband random processes are studied in this paper. The method of stochastic averaging, both the first-order and the second-order, is applied. The averaged $It\hat{o}$ differential equation governing the pth norm is established and the pth moment Lyapunov exponents and Lyapunov exponent are then obtained. This method is applied to the study of the almost-sure and the moment stability of the stationary solution of the thin simply supported beam subjected to time-varying axial compressions and damping which are small intensity correlated stochastic excitations. The validity of the approximate results is checked by the numerical Monte Carlo simulation method for this stochastic system.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제6권3호
• /
• pp.578-597
• /
• 2014

Understanding of 'spatial' pressure distribution is required to determine design loads on local structures, such as plating and framing. However, obtaining a practical 'spatial' pressure distribution is a hard task due to the sensitivity of the data acquisition frequency and resolution. High-resolution Pessure-Idicating Flm (PIF) was applied to obtain pressure distribution and pressure magnitude using stepped crushing method. Different types of PIF were stacked at each test to creating a pressure distribution plot at specific time steps. Two different concepts of plotting 'spatial' pressure-area curve was introduced and evaluated. Diverse unit pixel size was chosen to investigate the effect of the resolution in data analysis. Activated area was not significantly affected by unit pixel size; however, total force was highly sensitive.

• 호남수학학술지
• /
• 제44권3호
• /
• pp.402-418
• /
• 2022

Noise is a fundamental factor to increased validity and regularity of spike propagation and neuronal firing in the nervous system. In this paper, we examine the stochastic version of the Izhikevich-FitzHugh neuron dynamical model. This approach is based on techniques presented by Luo and Guo, which provide a general framework for the bifurcation and stability analysis of two dimensional stochastic dynamical system as an Itô averaging diffusion system. By using largest lyapunov exponent, local and global stability of the stochastic system at the equilibrium point are investigated. We focus on the two kinds of stochastic bifurcations: the P-bifurcation and the D-bifurcations. By use of polar coordinate, Taylor expansion and stochastic averaging method, it is shown that there exists choices of diffusion and drift parameters such that these bifurcations occurs. Finally, numerical simulations in various viewpoints, including phase portrait, evolution in time and probability density, are presented to show the effects of the diffusion and drift coefficients that illustrate our theoretical results.

• 수산해양기술연구
• /
• 제39권4호
• /
• pp.347-357
• /
• 2003

연근해 소형 어선에 널리 탑재되어 있는 소형 레이더 장치에 radar target extractor를 인터페이스하여 레이더 선호를 수록, 처리 및 해석하기 위한 PC based radar system 을 구축하고, cell averaging CFAR 처리장치를 통해 실제의 레이더 echo 신호를 처리하여 오경보 확률의 설정치 변화에 따른 echo영상의 변화패턴을 레이더 스코프상에서 직접 비교, 분석한 결과 및 레이더 영상신호의 음영구역의 발생대역폭을 추정한 결과를 요약하면 다음과 같다. 1. 레이더 선호의 해석을 통해 추출된 표적의 운동벡터 및 방위, 거리, 속력, CPA, TCPA 등과 같은 ARPA 정보를 실시간으로 이동 궤적과 함께 PC 모니터상에 구현하고 있기 때문에 소형 레이더 시스템에 이 장치를 부착하면 저가의 비용으로써 ARPA 정보의 취득이 기능하다. 2. ideal threshold 에 의한 표적검출성능을 개선시키기 위해 cell averaging CFAR processor 의 CUT전후에 각각 3 개의 guard cell과 이 cell의 좌$.$우측에 각각 20개씩, 총 40개의의 reference cell를 설치하여 레이더의 video 신호를 입벽한 후, 오경보 확률 10$\^$-0.25/∼10$\^$-1.0/의 범위에 대하여 설정치를 점차증가시켜 갈 때, 레이더 영상신호는 10$\^$-0.75/ 의 설정치에서 가장 양호한 clutter 제거효과를 나타내었다. 3. 레이더 스코프상에서 영상신호를 관찰하면서 cell averaging CFAR 의 오경보 확률을 적정하게 제어하면 지금까지의 ideal threshold level 에 의한 잡음억제기법에서 나타나는 선박영상의 과도한 레벨약화현상을 보완할 수 있을 것으로 판단한다. 4. 부산 용호만에 정박중인 예인선의 레이더 신호를 해석하여 영상의 음영패턴과 음영 대역폭을 추정한 결과, 예인선의 유효높이는 약 1.2 m 이었고, 이들 음영효과의 정량적 해석을 통한 해상표적의 형상정보는 향후 3차원 레이더 영상을 구현하는 데 그 기초자료가 될 것으로 판단된다.

• 한국대기환경학회지
• /
• 제5권1호
• /
• pp.1-10
• /
• 1989

The sensitivity analysis is a method to quantify to what extent the output of a model changes with the values of input parameters. This will lead to increase model accuracy through measurement validation. Three line source air quality models, HIWAY 2, PAL, and CALINE 3 were selected for this study. The input parameters analysed included wind speed, wind direction, stability, emission rate, mixing height, receptor distance, initial dispersion coefficient, surface roughness, and averaging time. It turned out that PAL model generally showed higher concentration than other two models, and that between CALINE 3 and HIWAY 2, CALINE 3 showed higher concentration than HIWAY 2 model near the line sources, but beyond a certain downwind distances HIWAY 2 model showed higher concentration. The modesl were very sensitive to wind speed especially in the range of 0 $\sim$ 1 m/s and to wind direction near the parallel wind to streets. In case of emission rate, the output concentration was directly proportional to these input parameters. And the sensitivity of the input parameters such as stability, mixing height, initial dispersion coefficient, surface roughness, and averaging time were not very significant.