• Journal of Mechanical Science and Technology
• /
• v.17 no.4
• /
• pp.599-605
• /
• 2003

For practical calculations, the Reynolds equation is frequently used to analyze the lubricating flow. The full Navier-Stokes Equations are used to find validity limits of Reynolds equation in a lubricating flow regime by result comparison. As the amplitude of wavy upper wall increased at a given average channel height, the difference between Navier-Stokes and lubrication theory decreased slightly : however, as the minimum distance in channel throat increased, the differences in the maximum pressure between Navier-Stokes and lubrication theory became large.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.23 no.8
• /
• pp.734-741
• /
• 2013

In contrast of external excitations, parametric excitations can produce a large response when the excitation frequency is away from the linear natural frequencies. The Mathieu equation is the simplest differential equation with periodic coefficients, which lead to the parametric excitation. The Mathieu equation may have the unbounded solutions. This work conducted the stability analysis for the Mathieu equation, using Floquet theory and numerical method. Using Lindstedt's perturbation method, harmonic solutions of the Mathieu equation and transition curves separating stable from unstable motions were obtained. Using Floquet theory with numerical method, stable and unstable regions were calculated. The numerical method had the same transition curves as the perturbation method. Increased stable regions due to the inclusion of damping were calculated.

• Proceeding of EDISON Challenge
• /
• 2016.11a
• /
• pp.101-105
• /
• 2016

Prandtl's Lifting-line theory is the classical theory of calculating aerodynamic properties. Though it is classical method, it predicts the aerodynamic properties well. By lifting-line theory, high aspect ratio is critical factor to decrease induced drag. And 'elliptic-similar' wing also makes the minimum induced drag. But due to the problem of manufacturing, tapered wing is preferred and have been utilized. In this Paper, by using Edison CFD, verifying the classical lifting-line theory. To consider induced drag only, using Euler equation as governing equation instead of full Navier-Stokes equation. Refer to the theory, optimum taper ratio which makes the minimum induced drag is 0.3. Utilizing the CFD results, plotting oswald factor over various taper ratio and investigating whether the consequences are valid or not. As a result, solving Euler equation by EDISON CFD cannot guarantee the theoretical values because it is hard to set the proper grid to solve. Results are divided into two cases. One is the values are decreased gradually and another seems to following tendency, but values are all negative number.

• Journal of the Korean Chemical Society
• /
• v.14 no.1
• /
• pp.45-48
• /
• 1970

The WLF equation is derived from the theory of rate processes in conjunction with the theory of liquids of significant structures. The empirical parameters in the WLF equation are discussed and compared with the corresponding quantities in the derived equation.

• Korean Journal of Mathematics
• /
• v.14 no.1
• /
• pp.113-123
• /
• 2006

The arches may buckle in a symmetrical snap-through mode or in an asymmetry bifurcation mode if the load reaches a certain value. Each bifurcation curve develops as pressure increases. The governing equation is derived according to the bending theory. The balance of forces provides a nonlinear equilibrium equation. Bifurcation theory near trivial solution of the equation is developed, and the buckling pressures are investigated for various spring constants and opening angles.

• Honam Mathematical Journal
• /
• v.27 no.4
• /
• pp.609-619
• /
• 2005

We are concerned with the multiplicity of solutions of the nonlinear elliptic equation with Dirichlet boundary condition. We reveal the existence of m solutions of the nonlinear elliptic equation by a critical point theory, under some condition.

• Bulletin of the Korean Chemical Society
• /
• v.29 no.1
• /
• pp.33-37
• /
• 2008

A phenomenological theory of viscosity previously proposed by the present authors8 is applied to the corresponding state theory for the viscosity of liquid. Through the process of the formulation of the corresponding state equation, we can find the simple viscosity equation with no parameters in a reduced form. The liquid viscosities of various substances can be calculated using this equation when we know only the values of the molecular weight and critical constant of substances. A corresponding state equation for the viscosity of liquid from this theory may be applicable to predicting viscosities of various substances under varying temperature and pressure. As a result, this equation may be widely applied to chemical engineering.

• Nuclear Engineering and Technology
• /
• v.52 no.4
• /
• pp.681-688
• /
• 2020

The telegrapher's theory was used to develop a new formulation for the neutron noise equation. Telegrapher's equation is supposed to demonstrate a more realistic approximation for neutron transport phenomena, especially in comparison to the diffusion theory. The physics behind such equation implies that the signal propagation speed is finite, instead of the infinite as in the case of ordinary diffusion. This paper presents the theory and results of the development of a new method for calculation of the neutron noise using the telegrapher's equation as its basis. In order to investigate the differences and strengths of the new method against the diffusion based neutron noise, a comparison was done between the behaviors of two methods. The neutron noise based on SN transport considered as a precision measuring point. The Green's function technique was used to calculate the neutron noise based on telegrapher's and diffusion methods as well as the transport. The amplitude and phase of Green's function associated with the properties of the medium and frequency of the noise source were obtained and their behavior was compared to the results of the transport. It was observed, the differences in some cases might be considerable. The effective speed of propagation for the noise perturbations were evaluated accordingly, resulting in considerable deviations in some cases.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.34 no.1
• /
• pp.41-48
• /
• 1992

Various soil behaviors usually occurring in the geotechnical problems, such as, cutting and embankments, stability of slope, seepage, consolidations, shearing failures and liquefaction, should be predicted and analyzed in any way. An approach of these predictions may be followed by the development of the constitutive equations as first and subsequently solved by numerical methods. The purpose of this paper is develop the constitutive equation of sands uder monotonic or cyclic loadings. The constitutive equation which is based on elasto-plastic theory, modified anisotropic consolidated stress parameter by Sekiguchi et al and Pender's theory is derived. And the equation is included a new stress parameter, hardening function, Bauschinger's effects and Pender's theory. The model is later evaluated and confirmed the validity by the test data of Ottawa sand, Banwol sand Hongseong sand. The following conclustions may be drawn: 1. The consititutive equation which is based on elasto-plastic theory, modified anisotropic consolidated stress parpameter by Sekiguchi et al and Pender's theory is derived. The equation in included a new stress parameter, hardening function, Bauschinger's effect and Pender's theory. 2. For Ottawa sand, the result of the constitutive equation shows a better agreement than that of Oka et al. The result of axial strain agrees well with the tested data. However, the result of horizontal strain is little bit off for the cyclic loadings or large stress. It is thought that the deviation may be improved by considering Poisson's ratio and precise measurement of shear modulus. 3. Banwol sand is used for the strain and stress tests with different relative densitites and confining pressures. The predeicted result shows a good agreement with the tested data because the required material parameters were directly measurd and determined form this laboratory. 4. For Hongseong sand, the tests under same amplitude of cyclic deviatoric stress shows a similar result with the tested data in absolute strain. It shows the acute shape of turning point because the sine wave of input is used in the test but the serrated wave in prediction.

• Bulletin of the Korean Mathematical Society
• /
• v.23 no.2
• /
• pp.167-170
• /
• 1986

Let M be a von Neumann algebra and .alpha., .betha. be *-automorphisms of M satisfying the operator equation .alpha.+.alpha.$^{-1}$ =.betha.+.betha.$^{-1}$ This operator equation has been extensively studied and many important decomposition theorems have been obtained by several authors (for instance see [4], [5], [2], [1]). Originally, this operator equation arose in the paper of Van Daele on the new approach of the Tomita-Takesaki theory in the case of modular operators ([7]). In the case of one-parameter automorphism groups, this equation has produced a bounded and completely positive map which can play a role similar to the infinitesimal generator (for details see [6] and [1]). A recent and one of the most important applications of this equation has been in developing an anglogue of the Tomita-Takesaki theory for Jordan algebras by Haagerup [3]. One general result of this theory is the following.