• Journal of Power Electronics
• /
• 제14권4호
• /
• pp.778-787
• /
• 2014

This study presents an input filter resonance mitigation method for an AC-DC matrix converter. This method combines the advantages of the one-cycle control strategy and the active damping technique. Unnecessary sensors are removed, and system cost is reduced by employing the grid-side input currents as feedback to damp out LC resonance. A model that includes the proposed method and the input filter is established with consideration of the delay caused by the actual controller. A zero-pole map is employed to analyze model stability and to investigate virtual resistor parameter design principles. Based on a double closed-loop control scheme, the one-cycle control strategy does not require any complex modulation index control. Thus, this strategy can be more easily implemented than traditional space vector-based methods. Experimental results demonstrate the veracity of theoretical analysis and the feasibility of the proposed approach.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 B
• /
• pp.738-740
• /
• 2003

A lot of R&D on the diagnosis of stator winding insulation for large rotating machines has been carried out since the 1970s. The on-line partial discharge measurement has proved to be an effective technique in the evaluation of the state of stator insulation in high voltage rotating machines. It is well known that if the discharge pulses propagate through the winding conductor, they are attenuated and delayed. In the present study, to investigate the attenuation and the time delay of discharge pulses through the winding conductor, a series of tests were conducted using a model coils and slot. Thus it could be concluded that while the high frequency pulse propagates in radiation or end-winding coupling modes, the low frequency one does in a series mode through the coil conductor.

• 한국정보처리학회:학술대회논문집
• /
• 한국정보처리학회 2018년도 추계학술발표대회
• /
• pp.380-382
• /
• 2018

사이버 물리 시스템의 발달은 네트워크 기반 제어 시스템을 다양한 형태로 진화시키고 있다. 네트워크에서는 전송 지연과 전송 오류에 의해서 다양한 불규칙한 지연이 발생하고 지연에 강인한 제어기 설계가 요구되고 있다. 마코프 프로세서를 따르는 지연을 갖는 제어 시스템에서 제어기를 설계할 때에 많이 사용되는 모델중에 하나가 확장된 상태 벡터를 기반으로 한 마코프 점프 선형 시스템 모델이다. 본 연구에서는 이 모델을 이용하여 리아푸노프 안전성 조건으로부터 유도되는 선형 행렬 부등식의 안정성 조건으로부터 저복잡도를 가지고 제어기를 유도하는 직관적 방법을 제안한다. 제안된 알고리즘은 모의 실험을 통해서 성능을 확인하였으나, 직관적 방법 구조상에서 제한 조건의 수가 자유 변수의 수보다 많은 이유 때문에 성능이 배우 제한적임을 확인하였고, 이를 개선하기 위한 향후 연구가 요청됨을 확인하였다.

• 전기학회논문지P
• /
• 제65권3호
• /
• pp.178-182
• /
• 2016

FIDVR(Fault Induced Delayed Voltage Recovery) is a phenomenon that recovery of the system voltage level delays after the fault. Cause of FIDVR phenomenon is motor load characteristic about voltage and reactive power. In low voltage condition, the motor go to stall state that consume large amount of reactive power. As a result, the voltage recovery problem is that of repeated occurrences of sustained low voltage following faults on the system. In this paper, analysis the characteristics of the motor load. And using the korean power system actual data, perform a case studies to voltage delay recovery phenomenon alleviation method. Change of each parameters by analyzing the effect on system and selecting an influence parameter. In addition, dynamic characteristic analysis of the resulting difference in the proportion by the motor load in power systems, considering the effect on the voltage stability.

• Journal of Electrical Engineering and Technology
• /
• 제2권2호
• /
• pp.165-171
• /
• 2007

This paper proposes a new islanding detection method for inverter-interfaced distributed generators (DG). To detect islanding conditions, this paper calculates the phase angle variation of the system voltage by using the phase-locked loop (PLL) in the inverter controllers. Because almost all inverter systems are equipped with the PLL, the implementation of this method is fairly simple and economical for inverter-interfaced DGs. The detection time can also be shortened by reducing communication delay between the relays and the DGs. The proposed method is based on the fact that islanding conditions result in the frequency and voltage variation of the islanded area. The variation depends on the amount of power mismatch. To improve the accuracy of the detection algorithm, this paper injects small low-frequency reactive power mismatch to the output power of DG.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 D
• /
• pp.1970-1972
• /
• 2001

This paper is concerned with the $H_{\infty}$ controller design of linear systems subject to time-delay in the state and saturating controls. The controller is derived from the matrix inequalities whish are obtained by minimizing the $L_{2}$ gain from the disturbance to the measured output, and this can be done by LMI control toolbox. An example is presented to show the usefulness of our result.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제9권10호
• /
• pp.4054-4071
• /
• 2015

Named-Data Networking (NDN) is one of the promising approaches for the Future Internet to cope with the explosion and current usage pattern of Internet traffic. Content provider mobility in the NDN allows users to receive real-time traffic when the content providers are on the move. However, the current solutions for managing these mobile content providers suffer several issues such as long handover latency, high cost, and non-optimal routing path. In this paper, we survey main approaches for provider mobility in NDN and propose an optimal scheme to support the mobile content providers in the large-scale NDN domain. Our scheme predicts the movement of the provider and uses state information in the NDN forwarding plane to set up an optimal new routing path for mobile providers. By numerical analysis, our approach provides NDN users with better service access delay and lower total handover cost compared with the current solutions.

• 한국정보과학회:학술대회논문집
• /
• 한국정보과학회 2003년도 봄 학술발표논문집 Vol.30 No.1 (C)
• /
• pp.256-258
• /
• 2003

본 논문에서는, a$\times$b 출력 버퍼 스위치로 구성된 fat-tree 망의 성능 예측 모형을 제안하고, 스위치에 장착된 버퍼의 개수 증가에 따를 성능 향상 추이를 분석하였다. 제안한 성능 예측 모형은 먼저 네트웍 내부 임의 스위치 입력 단에 유입되는 데이터 패킷이 스위치 내부에서 전송되는 유형을 확률적으로 분석하여 수립되었다. 성능분석 모형은 스위치에 장착된 버퍼의 개수와 무관하게 버퍼를 장착한 a$\times$b 스위치의 성능, 네트웍 정상상태 처리율(Steady state Throughput, ST)과 네트웍 지연시간(Network Delay)을 간단한 확률식으로 구할 수 있다. 제안한 수학적 성능 분석 연구의 실효성 검증을 위하여 병행된 시뮬레이션 결과는 상호 미세한 오차 범위 내에서 오형의 예측 데이터와 일치하는 결과를 보여 분석 모형의 타당성을 입증하였다.

• Journal of Information Processing Systems
• /
• 제13권6호
• /
• pp.1487-1495
• /
• 2017

With increasing interests in renewables, more consumers are installing an energy storage system (ESS) in their backyards, and thus, the ESS will play a critical role in the emerging smart grid. Due to mechanical properties, however its operational dynamics must be well understood before connecting the ESS to the smart grid (and eventually to an IT system). To this end, we investigate charging and discharging processes in detail. This paper, then, proposes methods for four type tests (state of charge test, conversion efficiency test, response time test, and ramp rate test) that can assess the dynamics of the ESS. The proposed methods can capture accurate delay values of mechanical processes in the ESS, and it is expected for those values to help design real-time communication systems in the smart grid involving the ESS.

• 한국광학회지
• /
• 제14권3호
• /
• pp.224-229
• /
• 2003

2$\times$2 방향성 결합기와 단일모드 광섬유를 이용하여 무편광기를 구현하였다. 행렬식을 이용한 모의실험을 통해 편광도를 줄이는 방법을 이론적으로 설명하였고 이를 실험적으로 검증하였다. 0.05 nm 이하의 좁은 선폭을 가진 편광된 입력광원의 편광상태 변화에 대해 -20 dB의 출력 편광도를 얻을 수 있었다 광섬유 지연선의 길이를 광원의 가간섭 길이보다 충분히 길게 함으로써 입력광의 편광 변화에 의한 강도 잡음을 효과적으로 없앨 수 있음을 실험적으로 검증하였다.