• Korean Journal of Environmental Biology
• /
• v.39 no.4
• /
• pp.495-506
• /
• 2021

In this study, using a continuous behavior measurement technique, the short-term behavioral responses and tolerance limits of red seabream Pagrus major fingerlings to sudden exposure to low salinity in a controlled environment were observed. The activity of the fingerlings suddenly exposed to 21.4, 17.3, and 9.8 psu increased temporarily at the initial exposure to show irregular swimming behavior, but then recovered a stable activity pattern through rapid salinity adaptation. However, the organisms suddenly exposed to 7.3 and 4.3 psu could not withstand the salinity stress, and their swimming behavior was severely disturbed and all individuals died within 48 hours. The findings suggest that red seabream underwent a temporary salinity stress process at the beginning of the exposure to concentrations of 10.0 psu or higher. At these concentrations, osmotic control was possible within at least 11 hours, so stable metabolic activity was also possible. However, organisms suddenly exposed to concentrations below 5.0 psu exceeded the tolerance to low salinity and the sublethal limit. In red seabream exposed to this concentration range, severe behavioral and metabolic disturbances were observed, and death was observed due to osmotic control failure. In conclusion, a salinity range of 5.0 to 10.0 psu can be predicted to correspond to a concentration range in which the osmotic control ability of the red seabream fingerlings is lost, and sub-lethal reactions occur.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.1
• /
• pp.61-66
• /
• 2009

An analytical method based on solid-phase extraction and gas chromatography / mass spectrometry has been developed for measurement of acaricides (amitraz, bromopropylate, coumaphos, cymiazole, and tetradifon) in honey sample. In the stability test of acaricides in honey, amitraz underwent a rapid degradation into 2,4-dimethylaniline (DMA), 2,4-dimethylphenylformamide (DMPF), and N-(2,4-dimethylphenyl)-N'-methylformamidine (DMPMF), whileas other acaricides were found to be stable even for over three months. Extraction of five acaricides from 5g of honey sample was carried out by liquid-liquid extraction using 20mL of ethylacetate. For purification, Florisil-SPE cartridge with elution of 5mL of n-hexane/ acetone (55:45, v/v) was found to remove interferences effectively. Quantification was performed using gas chromatography / mass spectrometry in the selected ion monitoring mode. Spiking experiments were carried out to determine the recovery, precision, and limits of detection (LODs) of the method. The overall recovery values from honey spiked at 0.02 and 0.20 ${\mu}g/g$ levels, respectively, were found to be greater than 75% for all acaricides. The method detection limits for acaricides were ranged from 0.1 to 3 ppb. The developed method in this study was applied for the monitoring of acaricides in honey products collected from urban markets in Korea.

• Journal of Periodontal and Implant Science
• /
• v.26 no.1
• /
• pp.161-175
• /
• 1996

There were many reports that elevations in the levels of active and latent collagenase in gingival crevicular fluid(GCF) have been correlated positively with periodontal disease activity. To provide a simple diagnostic approach for testing GCF collagenolytic activity, the detection limit of enzyme activity was compared using radiofibril assay(Sodek et.al.1981) and spectrophotometric collagenolytic assay(Nethery et al. 1986). The detection limits of both assay for standard bacterial enzyme were similar and the radiofibril assay showed a little (1/2) lower detection limit for tad pole collagenase. To evaluate the relationship between periodontal tissue destruction and the collagenolytic activity, GCF was collected, and latent and active enzyme activities were measured by a spectrophotometric collagenolytic assay. Twelve subjects showing progressive lesions were selected according to the presence of immediate tissue destruction, frequent abscess formation, and increasing need for tooth extraction, and the absence of underlying systemic disease and previous antibiotic medication history within 6 months. Comparisons were made between sites with either: 1) inflammation with a previous history of progressive loss of periodontal tissue and bone support(2l progressive sites): 2) previous history of bone loss and periodontal destruction but now clinically stable(12 comparably stable sites); or 3) no loss of periodontal tissue and bone support(11 control sites including 5 gingivitis sites and 6 healthy sites). Active collagenase activity was the highest in the progressive sites and decreased in the order of the gingivitis sites, the stable sites, and the healthy sites. The total enzyme activity was $2{\sim}3$ fold higher in the progressive sites and the gingivitis sites, compared to the stable and the healthy sites. The ratio of active to total collagenolytic activity was twice in the progressive sites. Analysis of active collagenase level(5mU) and the ratio of active to total collagenolytic activity(0.8) as a diagnositic test indicates that these measurements have the sensitivity of 0.81 and 0.86, the specificity of 0.70 and 0.65, and the overall agreement of 0.75 and 0.73, respectively. Thus, this method has significant merits as a diagnostic tool to determine wherher the site is in a state of remission or progression.

• Journal of Advanced Marine Engineering and Technology
• /
• v.8 no.1
• /
• pp.85-99
• /
• 1984

The stability of the two-phase flow in a heated channel is of great importance in the design and operation of the boilers and light water nuclear reactors, because it can cause flow oscillations and lead to a violation of thermal limits with resultant overheating of the channels and cladding. This paper presents a systematic evaluation to the variation effects of the basic four (4) dimensionless parameters in a homogeneous equilibrium model. The flow stability is examined on the ground of static characteristic curves. The complicated transfer function of flow dynamics which gives consideration to the transport lag of density wave is derived, and the transient flow stability is analysed by applying the Nyquist stability criterion in control engineering. The analysis results summed up as follows 1. The coolant flow becomes stable in large friction number and specific flow, while it is unstabale in small friction number and flow. 2. Large phase-change number and Froude number destabilize the two-phase flow, but small numbers stabilize it. The effect to variation of phase-change number is more dominant compared with Froude number. 3. The dynamic analysis is required to hold the sufficient safety of heated channels since only static results does not keep it. The special attention could be payed in the design and operation of heat engines, because the unstaable region exists within the stable boundary at small and middle phase-change number and Froude number.

• Membrane and Water Treatment
• /
• v.4 no.4
• /
• pp.265-275
• /
• 2013

China is one of the countries with the highest reserves of coal bed methane (CBM) in the world. Likewise, the CBM industry is significantly growing in China. However, activities related to CBM development have led to more environmental problems, which include serious environmental damage and pollution caused by CBM-produced water. In this paper, the detailed characteristics of CBM-produced water in the southern Qinshui Basin were investigated and analyzed and compared with local surface water and coal mine drainage. Most of CBM-produced water samples are contaminated by higher concentration of total dissolved solids (TDS), K (Potassium), Na (Sodium) and $NH_4$. The alkalinity of the water from coalmines and CBM production was higher than that of the local surface water. The concentrations of some trace elements such as P (Phosphorus), Ti (Titanium), V (Vanadium), Cr (Chromium), Ni (Nickel), Zn (Zinc), Ge (Germanium), As (Arsenic), Rb (Rubidium), and Pd (Palladium) in water from the coalmines and CBM production are higher than the acceptable standard limits. The ${\delta}D$ and ${\delta}^{18}O$ values of the CBM-produced water are lower than those of the surface water. Similarly, the ${\delta}D$ values of the CBM-produced water decreased with increasing drainage time.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1998.06a
• /
• pp.395-398
• /
• 1998

Lithium insertion has been studied in a number of vanadium oxides with special regard to their application as the active materials in rechargeable lithium cells. Very high stoichiometric energy densities for lithium insertion are found for several of these materials. Some vanadium oxides, e.g. V$_2$ $O_{5}$ and V$_{6}$ $O_{13}$, are now being used in commercially developed rechargeable Li batteries. Another material which is receiving remarkable attention for this kind of cells is LiV$_3$ $O_{8}$. In variety of ternary lithium-vanadium oxides, the lithium content can be varied between certain limits without major changes in the vanadium oxygen lattice. In our worts, the oxides which do net form these thermodynamically stable bronzes can still accommodate large amounts of lithium at ambient temperature, forming kinetically stable insertion compounds. These compounds owe their existence to the whereas lithium is easily introduced into these open structures. The oxides investigated are rather poor electronic conductors; the conductivity decrease with increase in the lithium content. Improvements in the electrode fabrication technique are needed to alleviate this Problem.oblem.

• Proceedings of the KIEE Conference
• /
• 1998.07a
• /
• pp.244-246
• /
• 1998

Robust control for DC motor is needed according to the highest precision of industrial automation. However when a motor control system with PID controller has an effect of load disturbance, it is very difficult to guarantee the robustness of control system. As a compensation method solving this problem, in this paper, PID-supervision hybrid control method for motor control system is presented. If the PID control system (without the supervisory controller) is stable in the sense that the error is inside the constraint set, the supervisory control is idle. If the error hits the boundary of the constraint, the supervisory controller begins operation to force the error back to the constraint set. We prove that the PID-supervision hybrid control system is globally stable in the sense that the error is guaranteed to be within the tolerance limits specified by the system designer.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.6
• /
• pp.1560-1564
• /
• 2008

Robust control for DC motor is needed according to the highest precision of industrial automation. However, when a motor control system with PID controller has an effect of load disturbance, it is very difficult to guarantee the robustness of control system. In this paper, PID-Self Tuning control method for motor control system as a compensation method solving this problem is presented. If the PID control system is stable in the sense that the error is inside the constraint set, the supervisory control is idle. If the error hits the boundary of the constraint, the supervisory controller begins operation to force the error back to the constraint set. We prove that the PID-Self Tuning control system is globally stable in the sense that the error is guaranteed to be within the tolerance limits specified by the system designer.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.12 no.4
• /
• pp.70-74
• /
• 1998

Robust control for DC motor is needed according to the highest precision of industrial automation. However, when a motor control system with PID contoller has an effect of load disturbance, it is very difficult to guarantee the robustness of control system. In this paper, PID-supervision hybrid control methods for motor control system (without the supervisory controller) is stable in the sense that the error is inside the constraint set, the supervisory control is idle. If the error hits the boundary of the constraint, the supervisory controller beings operation to force the error back to the constraint set. We prove that the PID-supervision hybrid control system is globally stable in the sense that the error is guaranteed to be within the tolerance limits specified by the system designer.

• Journal of the Korean Society of Radiology
• /
• v.81 no.2
• /
• pp.250-271
• /
• 2020

Assessment of myocardial ischemia in patients with stable angina is important in deciding whether to treat coronary artery disease and in predicting clinical outcome. The fractional flow reserve is a standard reference for the diagnosis of myocardial ischemia, but this procedure has limitations because of its invasiveness. Coronary computed tomography angiography (CCTA) is now an established tool in the anatomic diagnosis of coronary artery disease; however, there are limits to the diagnosis of hemodynamically important stenosis that causes myocardial ischemia. In order to address this problem, studies using quantification of coronary atherosclerotic plaques, myocardial perfusion, and noninvasive calculation of fractional flow reserve based on CCTA have been actively conducted and recognized for their diagnostic value. In this review, several imaging techniques of CCTA used to assess myocardial ischemia are described.