• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.235-240
• /
• 2006

Ionospheric scintillation induces a rapid change in the amplitude and phase of radio wave signals. This is due to irregularities of electron density in the F-region of the ionosphere. It reduces the accuracy of both pseudorange and carrier phase measurements in GPS/satellite based Augmentation system (SBAS) receivers, and can cause loss of lock on the satellite signal. Scintillation is not as strong at mid-latitude regions such that positioning is not affected as much. Severe effects of scintillation occur mainly in a band approximately 20 degrees on either side of the magnetic equator and sometimes in the polar and auroral regions. Most scintillation occurs for a few hours after sunset during the peak years of the solar cycle. This paper focuses on estimation of the effects of ionospheric scintillation on GPS and SBAS signals using a software receiver. Software receivers have the advantage of flexibility over conventional receivers in examining performance. PC based receivers are especially effective in studying errors such as multipath and ionospheric scintillation. This is because it is possible to analyze IF signal data stored in host PC by the various processing algorithms. A L1 C/A software GPS receiver was developed consisting of a RF front-end module and a signal processing program on the PC. The RF front-end module consists of a down converter and a general purpose device for acquiring data. The signal processing program written in MATLAB implements signal acquisition, tracking, and pseudorange measurements. The receiver achieves standalone positioning with accuracy between 5 and 10 meters in 2drms. Typical phase locked loop (PLL) designs of GPS/SBAS receivers enable them to handle moderate amounts of scintillation. So the effects of ionospheric scintillation was estimated on the performance of GPS L1 C/A and SBAS receivers in terms of degradation of PLL accuracy considering the effect of various noise sources such as thermal noise jitter, ionospheric phase jitter and dynamic stress error.

• Journal of Advanced Navigation Technology
• /
• v.21 no.3
• /
• pp.272-278
• /
• 2017

In order to meet performance requirements specified by the ICAO in drone operation, a system that provides augmentation information such as SBAS is needed. However, the operating range of the drone is limited in situation where the drone can not received the SBAS message continuously. In this paper, we propose a system to transmit SBAS augmentation message using a separate communication channel assuming the SBAS satellite signal to the drone has been shielded. We implemented the proposed system and verified its performance in the static environment. The DGPS positioning results showed that the accuracy difference is about 10cm, which means the accuracy performance was very similar. In addition, the protection level calculated by the system also shows the difference within 2m from the value calculated by the airborne receiver.

• Journal of Korean Society for Geospatial Information Science
• /
• v.18 no.4
• /
• pp.93-99
• /
• 2010

Since the facility management for various facilities in urban area are conducted by general managers who have poor knowledge for surveying technology, it is not easy to trace the exact location of the facility in a short time with the GIS map only by themselves in the field. In order to improve it, VRS-RTK or SBAS DGPS system integrated with UMPC and PDA which is uploaded GIS field software are being used recently however lot of difficulties are still existed with the GPS positioning in urban area due to the lack of visible satellites, no reception of correction data and multipath error by the interruption of the high buildings and houses etc. Therefore, in this study, we applied with Network DGPS system which allows better reception of satellite signal and correction data even in dense housing areas with the use of GNSS receiver and CDMA mobile phone. Based on the analysis of field data, it was confirmed that standard deviations of the Network DGPS positioning are 0.3 to 0.84m with a very high positioning rate even in dense housing areas. Therefore, it was concluded that the Network DGPS system could be used widely to fast and accurate positioning for various facilities management works in dense housing areas in the future.

• Journal of Positioning, Navigation, and Timing
• /
• v.3 no.1
• /
• pp.25-30
• /
• 2014

Differential Global Positioning System-Correction Projection (DGPS-CP) algorithm, which has been suggested as a method of correcting pre-calculated position error by projecting range-domain correction to positional domain, is a method to improve the accuracy performance of a low price GPS receiver to 1 to 3 m, which is equivalent to that of DGPS, just by using a software program without changing the hardware. However, when DGPS-CP algorithm is actually realized, the error is not completely eliminated in a case where a reference station does not provide correction of some satellites among the visible satellites used in user positioning. In this study, the problem of decreased performance due to the difference in visible satellites between a user and a reference station was solved by applying the Multifunctional Transport Satellites (MTSAT) based Augmentation System (MASA) correction to DGPS-CP, instead of local DGPS correction, by using the Satellite Based Augmentation System (SBAS) operated in Japan. The experimental results showed that the accuracy was improved by 25 cm in the horizontal root mean square (RMS) and by 20 cm in the vertical RMS in comparison to that of the conventional DGPS-CP.