• The Transactions of the Korea Information Processing Society
• /
• v.1 no.2
• /
• pp.272-278
• /
• 1994

The paper proposes a test pattern generator and a signature analyzer for pseudoexhaustive testing of the combinational circuit part within a sequential circuit when performing built-in self test of the circuit. The test pattern generator can scan in the seed test pattern and generate exhaustive test patterns. The signature analyzer can perform the analysis of the circuit response and scan out the result. Such test pattern generator and signature analyzer have been developed using SRL(shift register latch) and LFSR(linear feedback shift register).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.10
• /
• pp.2129-2139
• /
• 2009

In this paper, we diagnose the fault in the CA analyzer by setting up the initial value such that the final test signature is a constant regardless of the circuit being tested. This method makes the CA test procedure short and clear. In addition, we detect the fault of the faulty input sequence by using the inverse matrix of the CA state transition matrix.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.53 no.11
• /
• pp.768-775
• /
• 2004

The SSA technique in the digital circuit test is required to be repeated the input pattern stream to n bits output nodes n times in case of using a multiplexor. Because the method adopting a parallel/serial bit convertor to remove this inefficiency has disadvantage of requiring the test time n times for a pattern, the test strategy is required, which can enhance the test productivity by reducing the test time based on simplified fault detection mechanism. Accordingly, this paper proposes a test strategy which enhances the test productivity and efficiency by appling PAS (Parallel Signature Analysis) technique to those after analyzing the structure and characteristics of the digital devices including TTL and CMOS family ICs as well as ROM and RAM. The PSA technique identifies the faults by comparing the reminder from good device with reminder from the tested device. At this time, the reminder is obtained by enforcing the data stream obtained from output pins of the tested device on the LFSR(Linear Feedback Shift Resister) representing the characteristic equation. Also, the method to obtain the optimal signature analyzer is explained by furnishing the short bit input streams to the long bit input streams to the LFSR having 8, 12, 16, 20bit input/output pins and by analyzing the occurring probability of error which is impossible to detect. Finally, the effectiveness of the proposed test strategy is verified by simulating the stuck at 1 errors or stuck at 0 errors for several devices on typical 8051 digital board.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.2
• /
• pp.273-280
• /
• 1999

This paper presents the design and implementation of circuit analyzer system for the convenient troubleshooting and diagnosis of the electronics appliance using the curve tracer technology of analog signature analysis. The circuit analyzer provides advanced troubleshooting capabilities to simplify testing newer technology components such as CMOS and MOS circuits, its built-in pulse generator lets thoroughly troubleshoot gate-fired devices such as SCRs, TRIACs and optocouplers. The circuit analyzer while the power to the circuitry testing is turned of, so that avoid an accidental short that could cause further damage, its allow to analyze the impedance state of a solid-state component, which makes it perfect for finding leakage or substrate damage that has brought a system or PCB down prematurely. Because it can compare suspect components to known-good equivalents, it's verified the ideal application for troubleshooting when documentation is missing or incomplete.

• The KIPS Transactions:PartC
• /
• v.8C no.1
• /
• pp.32-40
• /
• 2001

In this paper, we propose a high-speed modular multiplication algorithm which revises conventional Montgomery's algorithm. A hardware architecture is also presented to implement 1024-bit RSA cryptosystem for digital signature based on the proposed algorithm. Each iteration in our approach requires only one addition operation for two n-bit integers, while that in Montgomery's requires two addition operations for three n-bit integers. The system which is modelled in VHDL(VHSIC Hardware Description Language) is simulated in functionally through the use of $Synopsys^{TM}$ tools on a Axil-320 workstation, where Altera 10K libraries are used for logic synthesis. For FPGA implementation, timing simulation is also performed through the use of Altera MAX + PLUS II. Experimental results show that the proposed RSA cryptosystem has distinctive features that not only computation speed is faster but also hardware area is drastically reduced compared to conventional approach.

• Proceedings of the KIEE Conference
• /
• 1987.07b
• /
• pp.1503-1506
• /
• 1987

This paper proposes the self test method for 16 point FFT processor with systolic array architecture. To test efficiently and solve the increased hardware problems due to built-in self test, we change the normal registers into Linear Feedback Shift Registers(LFSR). LFSR can be served as a test pattern generator or a signature analyzer during self test operation, while LFSR a ordering register or a accumulator during normal operation. From the results of logic simulation for 16 point FFT processor by YSLOG, the total time is estimated in about. 21.4 [us].

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.18 no.3
• /
• pp.52-57
• /
• 1981

This paper deals with the development of a design approach to generate easily testable complex digital systems. As the technique is based on small testable building blocks (submodule) with the exhaustive testing circuits, it is not necessary for any automatic test equipment and signature analyzer. As a result ,the test time which is determined not by circuit complexity but sixte of the tarprest submodule, is not exhaustive and also, the circuit reliability is very high.

• Journal of the Korean earth science society
• /
• v.28 no.5
• /
• pp.572-584
• /
• 2007

The quantification of ammonia concentrations has received a lot of scientific attention. Numerous devices for the quantification of $NH_3$ in the ambient air have been developed to provide more technical possibilities for research in abating $NH_3$ emission from various source processes. For the proper quantification of $NH_3$, a number of sampling methods have been discussed by grouping them into different categories based on the principle of functioning. In general, active samplers employ pumps to draw air in, while passive samplers are exposed to air over a certain period of time to obtain integrated signature of $NH_3$. In case of the former, impingers and absorption flasks can be employed simultaneously with suitable absorbents to capture $NH_3$ passing through them. The methods of analysis include both in-situ and laboratory determination. In the laboratory, colorimetric or ion chromatographic methods are generally used for its quantification. In the field, a number of real time analyzers have been proven to be useful. These real time analyzers can be grouped according to their principle of operation. These analyzers may use the principle of spectroscopy (e.g. DOAS), photoacousticics (e.g. photoacoustic monitor) or Chemiluminescence ($NO_x$ analyzer). The automated annular denuder sampling system with on-line analyzer is also suitable for continuous monitoring of ammonia in air.

• Journal of Korean Society for Atmospheric Environment
• /
• v.31 no.5
• /
• pp.482-492
• /
• 2015

Ground-based measurements were conducted from January 6 to 12 of 2015 for understanding characteristics of nitrogen containing carbonaceous aerosols as 16 amino acids at the Mokpo National University, Korea. The detailed amino acid components such as Cystine ($(SCH_2CH(NH_2)CO_2H)_2$) and Methionine ($C_5H_{11}NO_2S$) and their sources were analyzed by High-Performance Liquid Chromatography with Fluorescence Detection (HPLC-FLD) for behavior of secondary products in particulate matter. In addition, organic carbon (OC) and elemental carbon (EC) based on the carbonaceous thermal distribution (CTD), which provides detailed carbon signature characteristics relative to analytical temperature, and water soluble organic carbon (WSOC) by total organic carbon (TOC) analyzer were used to understand the carbon compound behaviors. The backward trajectories were discussed for originations of carbonaceous aerosols as well. Different airmasses were classified with the amino acids and OC thermal signatures. The results can provide to understand the aging process influenced by the long-range transport from East Sea area.

• Journal of Korean Society for Atmospheric Environment
• /
• v.29 no.6
• /
• pp.722-733
• /
• 2013

Ground-based measurements were conducted from August 25 to September 8 of 2011 for understanding characteristics of carbonaceous aerosols measured at Gosan. Chemical components and their sources were discussed by analysis of organic compounds with identification of primary and secondary products in particulate matter. Thus, organic carbon (OC) and elemental carbon (EC) based on the carbonaceous thermal distribution (CTD), which provides detailed carbon signature characteristics relative to analytical temperature, was used to improve the carbon fractionation of the analytical method. In addition, organic compounds by gas chromatography technique with the backward trajectories were discussed for characteristics of carbonaceous aerosols. Different air-masses were classified related to the OC thermal signatures and the organic molecular markers such as aromatic acids and PAHs. We concluded that the aging process was influenced by the long-range transport from East Sea area.