• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2000.05a
• /
• pp.134-139
• /
• 2000

Evaporating heat transfer characteristics of R-22 were measured inside smooth horizontal copper tubes with inner diameters of 3.36 mm and 5.35 mm respectively. The experiments were conducted in the closed loop which was driven by a magnetic gear pump. Experiments were performed for the following range of variables ; mass velocity of refrigerants (200 to 400 $kg/m^2$ .s) saturation temperature ($0^{\circ}C, \; 5^{\circC$}) and quality (0 to 1.0) The main results obtained are as follows : Evaporating heat transfer coefficients in the small diameter tubes (ID<7 mm) were observed to be strongly affected by a variety of diameters and to differ from those in the large diameter tubes. The heat transfer coefficients of the small diameter tubes are higher than those of the large diameter tubes. Comparing the heat transfer coefficients between experimental results and some well-known previous predictions (Shah's correlation Gungor-Winterton's and Kandlikar's correlation) it was very difficult to apply those to small diameter tubes.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.282-282
• /
• 2013

The antimony sulfide ($Sb_2S_3$) thin films were deposited using the gas phase method which known as atomic layer deposition (ALD) on mesoporous micro-films. Tris (dimethylamido) antimony (III[$(Me_2N)_3Sb$] and hydrogensulfide ($H_2S$) were used as precursors to deposit $Sb_2S_3$. Self-terminating nature of $(Me_2N)_3Sb$ and $H_2S$ reaction were demonstrated by growth rate saturation versus precursors dosing time. Absorption spectra and extinction coefficient were investigated by UV-VIS spectroscopy. Scanning electron microscopic analysis and X-ray photoelectron spectroscopy (XPS) depth profile were employed to determine the conformal deposition.

• Journal of Biomedical Engineering Research
• /
• v.13 no.4
• /
• pp.299-306
• /
• 1992

For quantitative measurement of reflected light from a clinical diagnostic scrip, a prototype of reflectance photometer was designed. The strip loader and cassette were made to obtain more accurate re(leclance parameters. The strop was illuminated at $45^{\circ}C$ through optical fiber and the intensity of reflected light was determined at rectangulat angle using a photodiode. The kubelka-munk coefficient and reflection optical density were determined ar four different wavelengths(500,550,570 and 610nm) for blood glucose strip. For higher concentration than 300mg/dl about glucose, a saturation state of absorbance was observed at 500,550 and 570nm. The correlation between glucose concentration and parameters was the best at 610nm.

• Journal of Biomedical Engineering Research
• /
• v.7 no.1
• /
• pp.35-40
• /
• 1986

For quantitative measurement of reflected light from a clinical diagnostic strip, a prototype old reflectance photometer was designed. The strip loader and cassette were made to obtain more accurate reflectance parameters. The strip was illuminated at 45˚c through optical fiber and the intensity of reflected light was determined at rectanguLat angle using a photodiode. The kubelka-munk coefficient and reflection optical density were determined ar four different wavelengths(500, 550, 570 and 610nm) for blood glucose strip. For higher concentration than 300mg/41 about glucose, a saturation state of abforbance was observed at 500, 550 and 570nm. The correlation between glucose concentration and parameters was the best at 610nm.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.10 no.6
• /
• pp.674-682
• /
• 1998

In this study, thin film evaporation of water on low-fin tubes were experimentally investigated. Five low-fin tubes with different fin spacing and fin height were tested. Test range covered 0.146kg/ms $\leq$$\Gamma$$\leq$0.219kg/ms and 10㎾/$\m^2$$\leq$q $\leq$70㎾/$\m^2$. Saturation temperature was loot. Compared with the plain tube, low fin tubes enhanced the water film evaporation from 60% to 100%. Tubes with fin spacing smaller than 2mm and fin height higher than 1mm performed better than tubes with other fin configuration. However, when fin spacing was too small at high film flow or fin height was too high at low film flow, the performance decreased. The heat transfer coefficient slightly increased as the flow rate increased. Correlations are developed based on present data.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2001.09a
• /
• pp.235-238
• /
• 2001

Monod kinetics에 관련된 주요 생분해 파라미터를 도출하기 위하여 microcosm 규모의 배치실험에서 BTEX 화합물에 대해 분해능이 우수한 Pseudomonas aeruginosa을 이용해 다양한 농도의 벤젠에 대한 분해기작을 고찰하였다. 벤젠의 생분해율(D)과 Maximumspecific growth rate ($\mu$$_{max}$)는 기질의 농도가 증가할수록 높아지다가 최고점에 도달 후에 점차적으로 감소하였으며 이것은 어느 한계점 이상의 벤젠 농도가 미생물의 생분해에 방해 요소로 작용한다는 것을 나타낸다. 그러나 미생물에 의한 벤젠 분해의 상관관계를 나타내는 yield coefficient(Y)는 벤젠의 초기 농도가 낮을수록 높은 값을 나타내었다. Microbial decay constant( b)와 half-saturation constant(K$_{c}$)는 각각 0.21~0.48day$^{-1}$와 218mg/$\ell$로서 문헌값 보다 높은 수치를 나타내었다. 실험으로부터 결정된 생분해 파라미터들은 초기 벤젠 농도에 따라 큰 차이를 보이므로 생분해 모델링에 사용할 파라미터는 기질농도에 따라 적절하게 선택되어야 한다고 사료된다.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.03a
• /
• pp.921-926
• /
• 2010

To examine saturation characteristics of an unsaturated soil in the steep slope area with collapse, it separated dry season from rainy season and measured water content and permeability, and measured permeability by using a tension infiltrometer in the site. In addition, it conducted electrical resistivity survey to look into thickness of ground and geological structure of underground. The collapsed slope increased depth of weathered zone compared to upper slope, and there electrical resistivity anomalous zone caused by the filtrated underground water was observed. The permeability of the collapsed area was observed high compared to upper and lower slopes of retarding basin without collapse, and the permeability measured by dividing the dry season and rainy season was measured high in case of dry season.

• Proceedings of the Korean Fiber Society Conference
• /
• 1998.04a
• /
• pp.32-35
• /
• 1998

Polypropylene fibers are difficult to dye by conventional dyeing techniques due either to lack of dye receptor sites in their molecular structure to with the dye molecules may become attached, or to difficult of penetration of certain types of dye molecules into the structure$^1$. Although the diffusion coefficient of disperse dyes into polypropylene is quite high, the saturation values are very low.(omitted)

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11a
• /
• pp.377-384
• /
• 2000

The characteristics and prediction model of the shear strength for unsaturated residual soils was studied. In order to investigate the influence of the initial water content on the shear strength, unsaturated triaxial tests were carried out varying the initial water content, and the applicability of existing prediction models for the unsaturated shear strength was testified. It was shown that the soil - water characteristic curve and the shear strength of the unsaturated soil varied with the change of the initial water content. A sample compacted in the lower initial water content needs a higher suction to get the same degree of saturation while the shear strength of a sample with the lower initial water content displays a lower value. In order to apply the existing prediction models of the unsaturated shear strength to granite residual soils, a correction coefficient, α, on the internal friction angle, ø'was added.

• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.923-926
• /
• 2003

This paper presents a novel low voltage reference circuit under the MOS threshold voltage(V$_{th}$) in standard CMOS process. It is based on the weighted difference of the gate-source voltages of an NMOS and a PMOS operating in saturation region. The voltage reference is designed for low power OLED driver ICs. The proposed circuit is designed using 0.35${\mu}{\textrm}{m}$ CMOS technology. The minimum supply voltage is 2V, and the typical temperature coefficient is 99.6ppm/ C.C.