• Journal of the Microelectronics and Packaging Society
• /
• v.14 no.3
• /
• pp.65-71
• /
• 2007

For chip-stack package applications, Cu filling characteristics into trench vias of $75{\sim}10\;{\mu}m$ width and 3 mm length were investigated with variations of the electroplating current density and the speed of a rotating disc electrode (RDE). Cu filling characteristics into trench vias were improved with increasing the RDE speed. There was a Nernst relationship between half width of trench vias of Cu filling ratio higher than 95% and the minimum RDE speed, and the half width of trenches with 95% Cu filling ratio was linearly proportional to the reciprocal of root of the minimum RED speed.

• Corrosion Science and Technology
• /
• v.14 no.5
• /
• pp.218-225
• /
• 2015

The electrochemical behaviors of various metals with and without diamond-like-carbon (DLC) coating in 3.5 wt% NaCl solution were investigated. The effect of hydrodynamic conditions was focused by employing a rotating disc electrode (RDE). The experimental results showed that each bare metal had a more positive corrosion potential and a higher corrosion rate due to enhanced oxygen transport at the higher rotating speed of the RDE. DLC coating caused a substantial increase in the corrosion resistance of all metals studied. However, localized corrosion was still found in the DLC-coated metal at sites where deposition defects existed. Surface morphology examination was performed after the electrochemical test to confirm the roles of hydrodynamic conditions and DLC coating.

• Journal of Electrochemical Science and Technology
• /
• v.3 no.4
• /
• pp.165-171
• /
• 2012

An experimental study of mass transfer to an amalgamated copper rotating disc electrode has been employed to determine an empirical correlation for the mass transfer rate in laminar flow. The study was performed in a three-electrodes configuration using 0.1 M boric acid and 0.1M potassium chloride as supporting electrolyte with Zn (II) concentration in the range (25-100 mg $dm^{-3}$). Polarization curves at different zinc ion concentration are reported. Hydrogen and oxygen reduction has also been considered.The diffusion coefficients and mass transfer coefficient were obtained using limiting diffusion current technique based on zinc ion reduction. A least squares analysis indicates that the laminar flow results for 13067 < Re > 57552 and 550 < Sc > 1390 can be correlated by the following equation with correlation coefficient (CR) equal to 0.98: $sh=0.61Re^{0.5}Sc^{1/3}$.

• Journal of the Korean institute of surface engineering
• /
• v.28 no.4
• /
• pp.199-206
• /
• 1995

A kinetic study on the electrodeposition of Ni-Zn-P ternary alloys onto a steel in chloride solutions was carried out using a rotating disc electrode. The coatings were characterized using SEM/EPMA and A. A. analysis. The results showed that the plating rates of three components were increased with applied potential, disc rotating speed and temperature. The activation energies of Ni, Zn and P of the coatings were 6.1, 5.1 and 8.0 kcal/mole respectively. Therefore, the deposition rates were controlled partly by surface electrochemical reaction and partly by mass transport. As the potential, temperature of bath and rotating speed of cathode disc were raised, the vol. % ratios of Ni and P of coating layer were increased but that of Zn decreased. The effect of coating parameters on the surface morphology was also examined.

• Journal of the Korean Electrochemical Society
• /
• v.10 no.1
• /
• pp.43-47
• /
• 2007

Electrochemical rectification at electrode chemically modified with redox active agents isolated at monolayer level was considered. Formulation of the rising part of linear sweep voltammogram at steady and rotating disc electrode was introduced.

• Bulletin of the Korean Chemical Society
• /
• v.15 no.12
• /
• pp.1042-1045
• /
• 1994

A thin film of silver ferricyanide (Ag$_3$Fe(CN)$_6$) on a platinum or gold substrates can be reduced electrochemically to the salt of silver ferrocyanide in potassium nitrate solution. The color of these films are orange and these films are shown to be electrochromic. The voltammogram is shown the asymmetry of the oxidation compared to the reduction wave under various supporting electrolytes. The standard heterogeneous electron-transfer rate for these films and bare Pt electrode were 0.49 ${\times}$ l0$^{-2}$ and 1.30 ${\times}$ l0$^{-2}$ cm/s, respectively, obtained using a rotating disc electrode. Rough D$_0$ values, evaluated from the Levich equation, for Fe(CN)$_6^{3-/4-}$ at both SF thin film and a bare Pt disc electrode were shown as 1.2l ${\times}$ l0-6 and 0.94 ${\times}$ l0$^{-6}$ cm$^2$/s, respectively. The conductivities, as determined from the slops of the i-V curves for a ca. 1 mm sample for dried SF potassium rich and deficient bulk samples pressed between graphite electrodes, were 9.34 ${\times}$ l0$^{-9}$ and 5.80 ${\times}$ l0$^{-9}$ (${\Omega}$${\cdot}$cm)$^{-1}$, respectively.

• Bulletin of the Korean Chemical Society
• /
• v.16 no.6
• /
• pp.511-515
• /
• 1995

Since much studies have been performed concerning the electrochemical behaviors and the practical applications of PB based devices, little has yet reported to investigate the best condition for the preparation for PB thin films. As considered some factors(peak shape, peak current, and peak separation) from the i-V curves, the optimal condition in the film growth were investigated under various immersion solutions. An electron-transfer processes of Fe2+/Fe3+ and Fe(CN)63-/4- redox couples were considered by measuring the observed currents as a function of the rotation velocity. The standard heterogeneous electron-transfer rates for these films and bare Au disc electrode in 10-3 M Fe2+/Fe3+ solution, applied at +0.65 V vs. SCE, were 6.14 × 10-3 and 7.78 × 10-3 cm/s, respectively, obtained using a rotating disc electrode. In case of the addition of potassium ion, the rate constants for these Fe2+/Fe3+ system on thin films of PB and bare electrode were given a little high values. The electron transfer rate for 10-3 M Fe(CN)63-/4- were 4.55 × 10-3 and 6.84 × 10-3 cm/s, respectively. The conductivity as directly determined during obtained the voltammogram, was 2.2 × 10-7 (Ω·cm)-1. This value is similar magnitude to that calculated from bulk sample.

• Resources Recycling
• /
• v.31 no.5
• /
• pp.59-66
• /
• 2022

To investigate the rate-determining step of nickel, cobalt and copper electrowinning, experiments were conducted by varying the electrolyte temperature and agitation speed using a rotating disc electrode. Analyzing the rate-determining step by calculating the activation energy in the electrowinning process, it was found that nickel electrowinning is controlled by a mixed mechanism (partly by chemical reaction and partly by mass transport), cobalt is controlled by chemical reaction, and copper is controlled by mass transfer. Electrowinning of nickel, cobalt and copper was performed by varying the electrolyte temperature and agitation speed, and the comparison of the current efficiencies was used the determine the rate-determining step.

• Bulletin of the Korean Chemical Society
• /
• v.16 no.9
• /
• pp.819-823
• /
• 1995

Thin films of two kinds of Prussian Blue (PB)-modified, using iron(Ⅲ) complex instead of conventional FeCl3, were prepared on a gold substrate and these films were able to be electrochemically reduced in potassium nitrate solution. In case of PB-modified films prepared from Fe(Ⅲ)-ethylenediamine-N,N'-diacetic acid (FeEN3+)/K3Fe(CN)6 solution, the mid-peak potential was 0.156 V in 0.1 M KNO3 and it was found that potassium ion migrates into or out of the film during the electrolysis. These films were shown to be electrochromic. These films exhibited smaller peak separation than those formed from Fe(Ⅲ)-tartaric acid (FeTA3+)/K3Fe(CN)6 system. The diffusion coefficient of Fe(CN)63-/4- redox couple, evaluated using the fabricated Au rotating disc electrode(rde) previously reported, was in good agreement with the existing data. Two experimental procedures, including the voltammetry at relatively low scan rates and the rde study, have been used in order to characterize the electrode kinetics. The electrode kinetics of some redox couples (FeEN2+-FeEN3+ and FeTA2+-FeTA3+) on both PB-modified thin films and bare Au electrode were studied using a Au rde. In all cases the rate constants of electron transfer obtained with the PB-modified film electrodes were only slightly less than those obtained for the same reaction on bare Au disc electrodes. The conductivities, as determined from the slopes of the i-V curves for a ca. 1 mm sample for dried PB-modified potassium-rich and deficient bulk samples pressed between graphite electrodes, were 6.21 × 10-7 and 2.03 × 10-7(Ω·cm)-1, respectively.

• Nuclear Engineering and Technology
• /
• v.44 no.8
• /
• pp.939-944
• /
• 2012

Deposition potential, deposition time, square wave frequency, rotation speed of the rotating disc electrode, and palladium concentration were studied on a Glassy Carbon Electrode (GCE) in 0.01M HCl for the determination of palladium in High Level Nuclear Waste (HLNW) by anodic stripping voltammetry. Experimental conditions were optimized for the determination of palladium at two different, $10^{-8}$ and $10^{-7}M$, levels. Error and standard deviation of this method were under 1% for all palladium standard solutions. The developed technique was successfully applied as a subsidiary method for the determination of palladium in simulated high level nuclear waste with very good precision and high accuracy (under 1 % error and standard deviation).