• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.7A
• /
• pp.768-775
• /
• 2008

In this paper, we consider downlink throughput performances of multiuser orthogonal frequency division multiplexing with reduced channel information feedback schemes. Specifically, two types of reduced feedback schemes, namely, 1-bit per sub-carrier and selective feedback scheme are considered and compared with each other in terms of average network throughput. Since the strict throughput comparison for given number of feedback bits per user is quite difficult, rather we compare their general behaviors in various system configurations with different system parameters, which can give us an insight into practical system design with those reduced feedback schemes.

• East Asian mathematical journal
• /
• v.34 no.5
• /
• pp.661-681
• /
• 2018

In this paper, we discuss a reduced-order modeling for the Benjamin-Bona-Mahony-Burgers (BBMB) equation and its application to a distributed feedback control problem through the centroidal Voronoi tessellation (CVT). Spatial distcritization to the BBMB equation is based on the finite element method (FEM) using B-spline functions. To determine the basis elements for the approximating subspaces, we elucidate the CVT approaches to reduced-order bases with snapshots. For the purpose of comparison, a brief review of the proper orthogonal decomposition (POD) is provided and some numerical experiments implemented including full-order approximation, CVT based model, and POD based model. In the end, we apply CVT reduced-order modeling technique to a feedback control problem for the BBMB equation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.1
• /
• pp.108-122
• /
• 2014

Massive antenna array is an attractive candidate technique for future broadband wireless communications to acquire high spectrum and energy efficiency. However, such benefits can be realized only when proper channel information is available at the transmitter. Since the amount of the channel information required by the transmitter is large for massive antennas, the feedback is burdensome in practice, especially for frequency division duplex (FDD) systems, and needs normally to be reduced. In this paper a novel channel feedback reduction scheme based on the theory of distributed compressive sensing (DCS) is proposed to apply to massive antenna arrays with spatial correlation, which brings substantially reduced feedback load. Simulation results prove that the novel scheme is better than the channel feedback technique based on traditional compressive sensing (CS) in the aspects of mean square error (MSE), cumulative distributed function (CDF) performance and feedback resources saving.

• Phonetics and Speech Sciences
• /
• v.4 no.4
• /
• pp.109-115
• /
• 2012

This paper mainly aims to investigate how differently choral speech and altered auditory feedback (i.e., delayed auditory feedback, frequency-altered feedback) enhance speech fluency during sentence reading. To do this, a stuttering reduction rate was used and measured how much stuttering in frequency was reduced during each of the fluency enhancing conditions (i.e, typical choral reading, DAF, FAF) relative to typical solo reading. The results showed that stuttering frequency was reduced in the three fluency enhancing conditions and the highest mean value in stuttering reduction rate was observed during typical choral reading. Some discussion was provided in relation to the stuttering reduction rate observed during typical choral reading and its further speculation.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.8
• /
• pp.1592-1594
• /
• 2009

This paper presents an LMI-based method to design a reduced order output feedback sliding mode controller for a class of uncertain systems. Using LMIs we derive an existence condition of a reduced order sliding mode control law. And we give explicit formulas of the gain matrices. Finally, we give a numerical design example, together with a design algorithm.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.11
• /
• pp.5304-5322
• /
• 2018

Since designing a feedback topology is a practical way to implement interference alignment at reduced cost of channel state information (CSI) feedback, six feedback topologies have been presented in prior works for a K-user multiple-input multiple-output interference channel. To fully reveal the potential benefits of the feedback topology in terms of the saving of CSI overhead, we propose a new feedback topology in this paper. By efficiently performing dimensionality-decreasing at the transmitter side and aligning interference signals at a subset of receivers, we show that the proposed feedback topology obtains substantial reduction of feedback cost over the existing six feedback designs under the same antenna configuration.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.32B no.7
• /
• pp.943-951
• /
• 1995

In this paper the projective controls, previously derived to preserve the dynamic modes of a state-feedback reference system, are extended to allow the preservation of the modes of a general output-feedback reference system. In general, the extension allows projective controls to be used as a controller approximation technique, where a reduced-order controller is designed to approximate the closed-loop behavior of the higher-order reference controller. This extension is useful if the best available reference control for the system is an output-feedback control. An example shows that the increased design freedom of proposed design method allows the stabilization of a given plant using a lower-order controller than the projective controls with state-feedback reference.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 1998.10a
• /
• pp.286-294
• /
• 1998

This paper presents an experimental study on the performance of the active damper device by feedback variables. The damper is a mass-typed active device, which exerts the inertia control force on the building by AC servo motor. The control performance is experimentally analyzed considering the building response and the control force. It is found that the building response is greatly reduced by mass-typed device under the resonant and earthquake loading. Also, the experimental results show that the velocity feedback reduces the building responses with the smallest amount of control force than any other feedback variables.

• The Journal of Korea Robotics Society
• /
• v.5 no.1
• /
• pp.48-54
• /
• 2010

Ankle-foot orthosis with a pneumatic rubber actuator, which is intended for the assistance and the enhancement of ankle muscular activities was developed. In this study, the effectiveness of the system was investigated during plantarflexion motion of ankle joint. To find a effectiveness of the system, the subjects performed maximal voluntary isokinetic plantarflexion contraction on a Biodex-dynamometer. Plantarfexion torque of the ankle joint is assisted by subject's soleus muscle that is generated when ankle joint do plantarflexion motion. We used the muscular stiffness signal of a soleus muscle for feedback control of ankle-foot orthosis as physiological signal. For measurement of this signal, we made the muscular stiffness force sensor. We compared a muscular stiffness force of a soleus muscle between with feedback control and without it and a maximal plantarflexion torque between not wearing a ankle-foot orthosis, without feedback control wearing it and with feedback control wearing it in each ten elderly adults. The experimental result showed that a muscular stiffness force of a soleus muscle with feedback control was reduced and plantarflexion torque of an ankle joint only wearing ankle-foot orthosis was reduced but a plantarflexion torque with feedback control was increased. The amount of a increasing with feedback control is more higher than the amount of a decreasing only wearing it. Therefore, we confirmed the effectiveness of the developed ankle-foot orthosis with feedback control.

• Journal of the Korean Society for Industrial and Applied Mathematics
• /
• v.13 no.4
• /
• pp.293-305
• /
• 2009

In this article, we study a reduced-order modelling for distributed feedback control problem of the Burgers equations. Brief review of the centroidal Voronoi tessellation (CVT) are provided. A weighted (nonuniform density) CVT is introduced and low-order approximate solution and compensator-based control design of Burgers equation is discussed. Through weighted CVT (or CVT-nonuniform) method, obtained low-order basis is applied to low-order functional gains to design a low-order controller, and by using the low-order basis order of control modelling was reduced. Numerical experiments show that a solution of reduced-order controlled Burgers equation performs well in comparison with a solution of full order controlled Burgers equation.