• 한국항행학회논문지
• /
• 제10권2호
• /
• pp.138-144
• /
• 2006

본 논문에서는 와이브로와 무선랜 응용을 위한 이중 모우드 FET 믹서를 단일 게이트의 두 개 pHEMT를 캐스코드(cascode)로 연결하여 이중게이트 FET 믹서 형태로 구현하였다. 설계된 이중게이트 믹서는 와이브로와 무선랜 응용에서 DC 전력소모를 최소화하기위해 가변적인 변환이득을 갖도록 최적화되었다. 설계 믹서의 LO-RF간 격리도 특성은 2.3GHz~2.5GHz에서 약 20dB이다. LO신호가 0dBm이고 RF신호가 -50dBm일 때 믹서는 15dB의 변환이득을 갖는다. 수신되는 RF신호가 -50dBm에서 -20dBm까지 증가할 때 변환이득은 15dB에서 -2dB까지 바이어스에 따라 감소하게 된다. 가변 변환이득은 몇 가지 장점이 있다. 즉 IF단에서 AGC의 넓은 동작영역의 부담을 줄일 수 있고, 또한 믹서의 DC전력소모를 약 90% 절약할 수 있다.

• ETRI Journal
• /
• 제17권1호
• /
• pp.1-10
• /
• 1995

We have achieved very low threshold current densities with high light output powers for InGaAs/ GaAs surface-emitting lasers using a periodic gain active structure in which three quantum wells are inserted in two-wavelength-thick (2${\lambda}$ ) cavity. Air-post type devices with a diameter of 20~40${\mu}m$ exhibit a threshold current density of 380~410$A/cm^2$. Output power for a 40${\mu}m$ diameter device reaches over 11 mW. A simple theoretical calculation of the threshold and power performances indicates that the periodic gain structure has an advantage in achieving low threshold current density mainly due to the high coupling efficiency between gain medium and optical field. The deterioration of power, expected from the long cavity length of $2{\lambda}$, is negligible.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 하계종합학술대회 논문집
• /
• pp.191-194
• /
• 1999

The balanced amplifier is a practical amplifier to, implement a broadband amplifier that has flat gain and good input and output VSWR. Three-stage amplifier design procedure usually divided into three partition satisfying the following requirements : low noise figure, high gain and high power output. FHX35LG HEMT device is used in the design can be obtained low noise figure at the first-stage, MGA82563 MMIC device is used in the design can be maintained high gain at the second-stage, and AHI MMIC device is used in the design can be required high power output at the third-stage. The results of three-stage balanced amplifier show that power gain is about 40㏈, noise figure is less than 1.2㏈ at operating frequency.

• ETRI Journal
• /
• 제16권4호
• /
• pp.1-11
• /
• 1995

A GaAs power metal semiconductor field effect transistor (MESFET) operating at a voltage as low as 3.3V has been developed with the best performance for digital handheld phone. The device has been fabricated on an epitaxial layer with a low-high doped structure grown by molecular beam epitaxy. The MESFET, fabricated using $0.8{\mu}m$ design rule, showed a maximum drain current density of 330 mA/mm at $V_{gs}$ =0.5V and a gate-to-drain breakdown volt-age of 28 V. The MESFET tested at a 3.3 V drain bias and a 900 MHz operation frequency displayed an output power of 32.5-dBm and a power added efficiency of 68%. The associate power gain at 20 dBm input power and the linear gain were 12.5dB and 16.5dB, respectively. Two tone testing measured at 900.00MHz and 900.03MHz showed that a third-order intercept point is 49.5 dBm. The power MESFET developed in this work is expected to be useful as a power amplifying device for digital hand-held phone because the high linear gain can deliver a high power added efficiency in the linear operation region of output power and the high third-order intercept point can reduce the third-order intermodulation.

• 전기학회논문지P
• /
• 제59권3호
• /
• pp.253-257
• /
• 2010

The frequency is an important operation parameter for the control, protection, and stability of a power system. The frequency as a key index of power quality can be indicative of system abnormal conditions and disturbances. Due to the sudden change in generation and loads or faults in power system, the frequency is supposed to deviate from its nominal value. It is essential that the frequency must be maintained very close to its nominal frequency. An accurate monitoring of the power frequency is essential to optimal operation and prevention for wide area blackout. As most conventional frequency estimation schemes are based on DFT filter, it has been pointed out that the gain error could cause defects when the frequency is deviated from nominal value. This paper presents an advanced frequency estimation technique using gain compensation to improve the performance of DFT filter based techniques. To evaluate performance of the proposed algorithm, the 765kV T/L system in Korea is simulated by EMTP-RV software. The proposed technique can reduce the gain error caused when the power system frequency deviates from nominal value.

• Journal of Electrical Engineering and Technology
• /
• 제12권6호
• /
• pp.2099-2105
• /
• 2017

In a power system that has a high wind penetration, the output power fluctuation of a large-scale wind turbine generator (WTG) caused by the varying wind speed increases the maximum frequency deviation, which is an important metric to assess the quality of electricity, because of the reduced system inertia. This paper proposes a stable power-smoothing scheme of a doubly-fed induction generator (DFIG) that can suppress the maximum frequency deviation, particularly for a power system with a high wind penetration. To do this, the proposed scheme employs an additional control loop relying on the system frequency deviation that operates in combination with the maximum power point tracking control loop. To improve the power-smoothing capability while guaranteeing the stable operation of a DFIG, the gain of the additional loop is modified with the rotor speed and frequency deviation. The gain is set to be high if the rotor speed and/or frequency deviation is large. The simulation results based on the IEEE 14-bus system demonstrate that the proposed scheme significantly lessens the output power fluctuation of a WTG under various scenarios by modifying the gain with the rotor speed and frequency deviation, and thereby it can regulate the frequency deviation within a narrow range.

• 한국전자파학회논문지
• /
• 제14권7호
• /
• pp.762-768
• /
• 2003

본 논문은 IMT-2000 대역에서 동작하는 피드포워드 증폭기의 선형성 개선을 위한 이득 평탄도의 영향에 관한 것이다. 각 증폭기의 이득 평탄도에 대한 동작 특성을 조사하기 위하여 WCDMA 4FA 신호를 인가하여 최종 출력 10 W에서 측정하였다. 특히, 지연 선로, 위상, 크기의 부정합과 같이 선형성 개선에 영향을 미치는 요인 중 각 증폭기의 이득 평탄도의 변화에 따르는 선형성의 개선에 대하여 조사하였다. 전력 증폭기는 40 MHz, 오차 증폭기는 40 MHz, 80 MHz 대역에서 이득 평탄도를 변화시키면서 측정하였다. 측정 결과, 오프셋 5 MHz 지점에서 20 dB 이상의 개선 효과를 나타내기 위해서는 전력 증폭기는 1.5 dB, 오차 증폭기는 0.5 dB 이내의 이득 평탄도를 가져야 함을 확인하였다. 또한, 오차 증폭기의 이득 평탄도에 따라 피드포워드 증폭기의 선형성이 급격히 변화하였으며, 오차 증폭기의 이득 평탄도가 선형성 개선에 더 중요한 요소임을 확인하였다.

• Current Optics and Photonics
• /
• 제2권3호
• /
• pp.261-268
• /
• 2018

Stimulated polariton scattering (SPS) from the $A_1$ transverse optical (TO) modes of $BaTiO_3$ bulk crystal generating a terahertz (THz) wave with the noncollinear phase-matching (NPM) condition is theoretically investigated. To our best knowledge, this is the first report on THz wave generation from $BaTiO_3$ bulk crystal via SPS. Phase-matching (PM) characteristics in the NPM configuration are analyzed. Effective parametric gain lengths for the Stokes and THz waves in the NPM configuration are calculated. The effective parametric gain coefficient and absorption coefficient of the THz wave in $BaTiO_3$ are theoretically simulated. The THz phonon flux densities generated via SPS in $BaTiO_3$ are theoretically calculated by solving the coupled wave equations under the NPM condition. The PM characteristics and THz-wave parametric gain characteristics in $BaTiO_3$ are compared to those in $MgO:LiNbO_3$. The results of the analysis indicate that $BaTiO_3$ is an attractive optical crystal for efficient THz wave generation via SPS.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1998년도 추계종합학술대회 논문집
• /
• pp.633-636
• /
• 1998

In this study, power AlGaAs/InGaAs/GaAs PM-HEMT's for mm wave's were fabricated using Electron beam lithography and air-bridge techniques, and so on. DC and AC characteristics of the fabricated power PM-HEMTs were measured under the various bias conditions. For example, DC and RF characteristics such as S21 gain of 3.6 dB at 35 ㎓, current gain cut-off frequencies of 45 ㎓ and maximum oscillation frequencies of 100 ㎓ were carefully analyzed for design methodology of sub-mm wave power devices.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 1993년도 한국자동제어학술회의논문집(국제학술편); Seoul National University, Seoul; 20-22 Oct. 1993
• /
• pp.121-126
• /
• 1993

Artificial muscle actuators are used in various fields. Especially, they are applied to the power assist circuit to make use of their characteristics. The purpose of this paper is to and analyze the power assist circuit using an artificial muscle actuator. As a result, it is found that the operating feeling of the power assist circuit depends mainly on the flow gain of the pneumatic servo valve. The required flow gain is calculated from the proposed model, and the experimental results agreed with the calculated results.