• East Asian mathematical journal
• /
• 제21권1호
• /
• pp.27-39
• /
• 2005

We will define p-stack convergence spaces and show that each neighborhood structure is uniquely determined by p-stack convergence structure. Also, we will show that p-stack convergence spaces are a generalization of neighborhood spaces.

• 설비공학논문집
• /
• 제7권3호
• /
• pp.473-487
• /
• 1995

A loud speaker-driven zero-c.o.p. thermoacoustic refrigerator where an automotive catalytic converter is utilized as a stack has been fabricated and investigated experimentally. Without any heat exchangers at both ends of stack(and thus with zero c. o. p.), temperatures on the stack are measured and various heat transfer rates are calculated from the measured temperatures. Temperatures on the stack have been also calculated numerically using a finite difference method. The measured temperatures are in fair agreement with the calculated temperatures for lower frequency than 300Hz, however, the former deviates from the latter considerably for higher frequency. Two types of c. o. p. have been defined as appropriate to the experiment. While the nominal c. o. p. is zero(the condition in which the pumped heat flow rate in the pore exactly cancels the axial heat conduction down the stack), the true c. o. p. is found to be about 0.14 for 300Hz from the experiments.

• 한국대기환경학회지
• /
• 제9권3호
• /
• pp.255-256
• /
• 1993

Recently, Ghim and Son (1993) compared the air quality impacts of two point sources P1 and P3 in Seoul in the first quarter of 1988, whose emission rates were 99.9g/s and 49.4g/s, and whose stack heights were 75m and 21m. They said that higher concentrations from P3 in the nearby area were responsible for shorter stack height of P3. But concentrations were not raised so high only because the stack height was reduced from 75m to 21m. Volume of exit gas from P3 was also much smaller than that from P1.

• 한국인쇄학회지
• /
• 제29권1호
• /
• pp.61-74
• /
• 2011

Critical environmental elements for long term preservation of a paper are temperature, humidity, dust, light, contaminants in air, and mold. Especially, temperature and humidity need special care, because they can not only directly degrade paper but also affect the degradation of the other elements. Therefore methods to monitor variation of temperature and relative humidity were studied. One of the methods was to use preservation index for evaluating preservation environment. Since the evaluation for preservation environment of a stack room investigated firstly by D. K. Sebera, PI(preservation index) and TWPI(Time-Weighted Preservation Index) by IPI is made to evaluate relatively preservation environment in a stack room. T. Padfield developed method which could calculate easy PI and TWPI. In this study, the preservation environment of stack rooms for paper storage in NAK(National Archives Korea) was evaluated by PI and TWPI. PI and TWPI of stack rooms for paper storage in NAK maintained good condition but PI depended on season. Then the preservation environment of stack rooms for paper storage in NAK was required to maintain continuously PI and TWPI regardless of season change.

• 전기학회논문지P
• /
• 제58권4호
• /
• pp.609-614
• /
• 2009

A fuel-cell power system among various alternative power sources has many advantages such as comparatively independable circumstances, high-efficient, and heat-recyclable, thus it is now able to be up to hundreds MWh-scaled through improving feasibility and longevity of it. During the last few decades, numerous research results has been investigated to expand interest in fuel-cell technology. This study presents pressure distribution on the geometrical manifold structures, which are U-type and Z-type, of a planar-type fuel-cell stack by simulated with computational fluid dynamics(CFD). Then, electrical performance of a 200W fuel-cell stack, which is U-type, was diagnosed after pre-conditioning operation. The stack has electrical characteristics ; 22V, 10A, 220W, and current density $200mA/cm^2$.

• Membrane and Water Treatment
• /
• 제14권1호
• /
• pp.47-54
• /
• 2023

In this study, high concentrations of cadmium-containing wastewater were treated by electrodialysis (ED) with a channel stack. The limiting current density (LCD), cadmium removal efficiency, and current efficiency were investigated under each experimental condition according to the Reynolds number (Re), membrane area, and pH. With the increase in the film area to 111, 333, 555, and 777 cm² at Re (109.1), LCDs decreased to 408.11, 44.45, 35.32, and 13.64 A/m², respectively. The highest cadmium removal efficiency (99.6%) and current efficiency were obtained for the membrane area of 111 and 777 cm², respectively. Under changing Re in the pH range of 1 to 4, Re and LCD were proportional under the same pH condition, and pH and LCD tended to be inversely proportional under the same Re condition. Cadmium removal rate was the best at the pH range 3 - 4. It has been found that ED with channeled stacks can be successfully applied to treat wastewater containing high concentrations of cadmium.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2008년도 International Meeting on Information Display
• /
• pp.911-913
• /
• 2008

In this work, nonvolatile memory (NVM) devices for system on panel of flat panel display (FPD) were fabricated using low temperature polycrystalline silicon (LTPS) thin film transistor (TFT) technology with an oxide-nitride-oxynitride (ONOn) stack structure on glass. The results demonstrate that the NVM devices fabricated using the ONOn stack structure on glass have suitable switching characteristics for data storage with a low operating voltage, a threshold voltage window of more than 1.8 V between the programming and erasing (P/E) states after 10 years and its initial threshold voltage window (${\Delta}V_{TH}$) after $10^5$ P/E cycles.

• 한국포장학회지
• /
• 제23권2호
• /
• pp.97-101
• /
• 2017

Fruits are subjected to a variety of vibration stress during the transportation from a production area to markets. Vibration inputs are transmitted from the transporting vehicle through the packaged fruit. And the steady state vibration input may cause serious internal damage of fruit. Product quality of fruits declines by various factors while they are stored right after harvesting and among the substance in charge of post ripening action, ethylene ($C_2H_4$) biosynthesis increases fruits' respiration process after harvesting and decreases storage expectancy. Ethylene production of apples rapidly increases while storage duration becomes longer. This tendency is much clearer for the apples with vibration stress at input acceleration level. When there was no vibration stress, change in ethylene production level of apples are not very large during storage. Ethylene production rates inside the gas collecting container increased significantly ($p{\leq}0.05$) after 24 hours storage, particularly for apples with vibration stress ($0.7{\mu}l/kg{\cdot}hr$ (1st stack), $0.78{\mu}l/kg{\cdot}hr$ (2nd stack), $0.96{\mu}l/kg{\cdot}hr$ (3rd stack)); whereas less ethylene was produced in control apples ($0.18{\mu}l/kg{\cdot}hr$ during storage. Also ethylene production rates of apples according to the stack position were significantly different ($p{\leq}0.05$). The vibration stress clearly accelerated the degradation of apple quality during storage, resulting in increased ethylene production.

• 전기전자학회논문지
• /
• 제22권3호
• /
• pp.836-841
• /
• 2018

본 논문에서는 대표적인 ESD 보호회로인 SCR, LVTSCR을 기반으로 하여 특정한 어플리케이션의 요구 전압에 맞추어 설계하기 위한 Stack 기술에 대하여 서술한다. 또한 기존 구조와는 다른 SCR 기반의 ESD 보호회로를 제시하여 Stack기술에 적용함으로써, 주요 파라미터인 트리거 전압과 홀딩 전압의 변동에 대하여 검증한다. 새로이 추가되는 SCR 기반의 보호 회로의 경우 추가적인 N+, P+ 영역의 삽입으로 인해 보다 높은 홀딩 전압을 갖는 ESD 보호회로이다. 또한 시놉시스사의 T-CAD 시뮬레이터를 이용하여 제안된 ESD 보호회로의 전기적 특성을 검증을 실시하였다.

• 전기학회논문지P
• /
• 제58권4호
• /
• pp.563-567
• /
• 2009

The polymer electrolyte membrane fuel cell(PEMFC) with the advantages of low-operating temperature, high current density, low cost and volume, fast start-up ability, and suitability for discontinuous operation becomes the most reasonable and attractive power system for transportation vehicle and micro-grid power plant in a household. 200W PEM-type FCs system was integrated by this study, then the electrical characteristics and diagnosis of the fuel cell were analyzed with variations on mass flow rate and stack temperature. The ranges of the variations are 1~8L/min on $H_2$ volume and $20{\sim}70^{\circ}C$ on stack temperature.