• KIEAE Journal
• /
• v.7 no.4
• /
• pp.57-62
• /
• 2007

At the moment, the reduction of building energy consumption is a unavoidable task of mankind for conserving global environment. Decreasing overall U-value of building envelope and air infiltration, especially in Korean climate condition with clear four seasons, are the obvious solutions for the objective. Thus low glazing ratio with small window openings are required for heating and cooling load reduction in buildings. Using larger window openings could provide better natural ventilation but it also increases the direct solar radiation penetration into indoor space, heat gain in summer and heat loss in winter. On the other hand, the ventilation rates decreasing problem with smaller window openings could be occurred. As a solution for it, the use of casement window can cause increasing natural ventilation rates by wing wall effect. This paper focuses on deduce the most efficient opening type of casement window in Korean climate. To estimate ventilation performance of each opening types, CFD simulation was used. The best performance of opening type in every wind direction is opening both windows to the center and the most appropriate opening type for Korean climate is also opening both windows to center.

• The Journal of Korean Academy of Prosthodontics
• /
• v.31 no.2
• /
• pp.249-270
• /
• 1993

For understanding of anatomy, physiology, and diseases of human TMJ, it is required to evaluate quantitatively the movement of the disc and condyle head of mandible. The histologic section of cadaver TMJ were examined, and the magnification of the MR image and its details of anatomy were evaluated. And then a quantitative analytic method, by comparing the Sectograph and the MR image of vital human TMJ, was proposed. For this study, 15 subjects(Male, 24~35years) were selected from a prosthodontic examination randomly, and each subject’s five interocclusal rubber registration records were made on the ICP, and 5, 10, 15, and 20mmjaw opening positions. All subjects were radiographed with a Denar Quint Sectograph Image System(Denar Corp., USA), and imaged with a MRP-20EX MR Image System(0.2T, Permanent Magnet Type, Hitachi Medical Corp., Japan) using an 100mm diameter bilateral type surface coil. These images were traced on the acetate tracing paper, and analyzed In this study, the findings led to the following conclusions. 1. In comparison of the histologic section of autopsy specimen with the MR image at the same section, the size(dimension) of MR image was 70% of the real one. It was possible to recognize the shape of articular disc, anterior and posterior attachments, and adjacent soft tissues, because of the excellent reproducibility of anatomical structure. 2. When we compared the amount of joint space on MR image with that of joint space on sectograph, the amount of joint space on sectograph was significantly greater than that of joint space on MR image, except at the top of condylar head. 3. The position of minimum joint space on sectograph at intercuspal position didn't coincide with the middle position of articular disc on MR image, and was approximately in the anterior third of posterior band of articular disc. 4. The amount of condylar movement on MR image at opening movement was greater than that of articular disc movement. From Intercuspal position to 5mm jaw-opening movement, the condylar movement showed hinge one, and over the range 5mm jaw-opening it suggested hinge & translatory one. 5. In terms of area variation of articular disc measured on MR image in sagittal plane, the area of posterior band increased with increasing the amount of Jaw opening, but the area of anterior band decreased conversely.

• Journal of the Korea Furniture Society
• /
• v.12 no.2
• /
• pp.81-90
• /
• 2001

For opening and shutting function, door has some hardware such as hinges and the locks. The folding mechanism of hinges represent mobility, and the lock means stability. The opening and shutting door-the mobility-could be interpreted the movement from flat state to three-dimensional structure. The folding mechanism also would be understood variable feature to the space. This study focus on the Folding Furniture which adapted the good point of hinges to make efficient use of the space. The folding furniture presented in this study has not only artistic meaning which expand and apply structural function of hinges, but also flexible reanalysis on the environment and the space which change with social, economic and cultural trend.

• The Korean Journal of Physiology
• /
• v.11 no.1
• /
• pp.21-26
• /
• 1977

Many cases have been reported that a post spinal headache can be relieved immediately by an epidural injection of saline; and autologous blood also has recently been used successfully instead of saline. The changes of the cerebrospinal fluid pressure in 40 cases were observed in the present study in support of the concept; that a continuous leakage in association with hypovolemia and hypotension of the cerebrospinal fluid is the primary cause of a post spinal headache. Subarachnoid pressure increased immediately with saline injection into the lumber epidural space. A spinal needle was inserted into the subarachnoid space at the level of $L2{\sim}3$ and opening pressure of the cerebrospinal fluid was read. An epidural Tuohy needle was insertad at the$L3{\sim}4$ and 25m1 of saline was injected into the epidural space and the cerebrospinal fluid pressure was read in the sitting position. $\underline{Sitting\;Position:}$ Mean pressure after injection $555{\pm}(110.9)mm\;H_2O$, Pressure rise rise (%) 51.3%, Mean opening pressure $366{\pm}(52.2)mm\;H_{2}O$, $\underline{Lateral\;position:}$ Mean pressure after injection $308{\pm}(70.8)mm\;H_{2}O$, Pressure(%) 86.7%, Mean opening pressure $165{\pm}(42.6)mm\;H_{2}O$. These pressure changes responded almost simultaneously as saline was injected. This pressure rise of 51.3% in the sitting position and 86.7% in the lateral position are clinically very significant. Therefore, it is most possible that the immediate relieve of post, spinal headache by injection of fluid into the epidural space is simultaneous with the increase of the cerebrospinal fluid pressure.

• Journal of the Korean Institute of Educational Facilities
• /
• v.25 no.4
• /
• pp.19-30
• /
• 2018

The school classroom is a common living place where students spend 7 to 14 hours a day to prepare for their careers. Therefore, if the ventilation of the classroom is not properly performed, it may lead to the deterioration of learning ability due to the unclear air. The concentration of carbon dioxide in the classroom is reported to be high, and the increase in carbon dioxide concentration has a negative effect on the learner's academic performance. In this context, the purpose of this study is to propose a methodology for intelligent and responsive window opening-closing operation process that can reduce the concentration of $CO_2$ in the classroom in order to build a support space that can create an effective teaching-learning environment for adolescents. The specific objectives are as follows. First of all, we define the concept of window opening-closing operation. Secondly, twe develop the operation process of window opening-closing. Thirdly, we develop an algorithm for real-time window opening and closing (process) (Window Opening-Closing Operation Process). Finally, we verify the intelligent responsive window opening-closing operation process through developing examples of window opening-closing operation process using the parametric design program. This study is a preliminary study to develop algorithms necessary for window opening-closing operation. Based on the first-order algorithm, We simulated window opening-closing operations according to a hypothetical scenario. As a result, This study can show that the window is open and close depending on the $CO_2$ concentration, but the $CO_2$ concentration in the room is higher than outdoors. Consequentially, we suggest that it is necessary to develop an algorithm to supplement these results because window is often not working when the temperature difference between indoor and outdoor in winter is large.

• Computers and Concrete
• /
• v.31 no.3
• /
• pp.207-221
• /
• 2023

In this investigation, the interaction between opening space and neighboring joint has been examined by experimental test and Particle flow code in two dimension (PFC2D) simulation. Since, firs of all PFC was calibrated using Brazilian experimental test and uniaxial compression test. Secondly, diverse configurations of opening and neighboring joint were provided and tested by uniaxial test. 12 rectangular sample with dimension of 10 cm*10 cm was prepared from gypsum mixture. One quarter of tunnel and one and or two joint were drilled into the sample. Tunnel diameter was 5.5 cm. The angularities of joint in physical test were 0°, 45° and 90°. The angularities of joint in numerical simulation were 0°, 30°, 60°, -30°, -45°, -60° and its length were 2cm and 4cm. Loading rate was 0.016 m/s. Tensile strength of material was 4.5 MPa. Results shows that dominant type of crack which took place in the model was tensile cracks and or several shear bands develop within the model. The Final stress is minimum in the cases where oriented angle is negative. The failure stress decrease by decreasing the joint angle from 30° to 60°. In addition, the failure stress decrease by incrementing the joint angle from -30° to -60°. The failure stress was incremented by decreasing the number of notches. The failure stress was incremented by decreasing the joint length. The failure stress was incremented by decreasing the number of notches. Comparing experimental results and numerical one, showed that the failure stress is approximately identical in both conditions.

• Korean Institute of Interior Design Journal
• /
• v.18 no.4
• /
• pp.97-104
• /
• 2009

This thesis analyzed arrangement and mixture method of function elements, which are getting more important in museum planning. It used quantitative method, Space Syntax and Visibility Graph Analysis tool to analyze five case museums. Through this analysis, advantages and disadvantages of two methods were derived and case museums' arrangement and mixture attributes were grasped. Results of the analysis were derived differently by two kinds of plan form which were room to room type and open type. Open typed museum recorded similar graphs of Integration, Visual Integration and Visual Connectivity. Since whole space structures were relatively simple and structure of exhibition halls were opened, the results of Space Syntax and Visibility Graph Analysis had similar graphs. Room to room typed museum showed differences in Integration, Visual Integration and Visual Connectivity. In the result, the most accessible space was lobby and Mediation Space became the center of visibility. Also, the exhibition hall, where the opening of room to room typed exhibition hall was penetrated visually, became a center of visibility. Lobby space, which was close to entrance, had the highest Visibility Connectivity. As Space Syntax could analyze the museum as whole space structure, Space Syntax showed strength in room to room typed museum analysis compared to open typed museum analysis which has relatively simple structure. Visibility Graph Analysis could expect the flow of exhibit distance including visibility analysis unlike the flow of exhibit distance with space arrangement. The exhibition hall, which secures the sight to penetration of an opening, couldn't be analyzed in existing Space Syntax. However, it became the biggest advantages in Visibility Graph Analysis of room to room typed museum. Visibility Graph Analysis derived detailed results in exhibit arrangement so it will be the useful method not only for architecture but also for planning of exhibit arrangement in open typed museum. Through this study, various possibilities on Quantitative Analysis Method of Museum Architecture could be verified. However, the analysis still has limitation of second dimension. Therefore, diverse and liberal following study will be expected to accomplish.

• Archives of design research
• /
• v.19 no.2 s.64
• /
• pp.173-182
• /
• 2006

In church building, the worship space performing practical rituals and making a place of friendship and education has a role to accept the changing services with the times. And it is also distinguishable from the chaotic surroundings and is the space for religious experience of christian identity we cannot experience in our daily life. Therefore it is very important to investigate its characteristic as the space for religious experience. The important purpose of church building is to make up a worship space, and the chancel in worship space is said to be the core in church building, the center of all worship acts. Especially, today with the tendency of multi-functionalizing and opening in worship space, the chancel in worship space has a more special meaning as spatial, functional and symbolic center. The purpose of this study, with the worship space in domestic protestant churches, is to make up basic data for the worship space plan and interiordesign in church building by analyzing the characteristics of interior design for chancel, the core field of worship space. This study has researched the constituentcharacteristics of interior design for the chancel in worship space in domestic protestant churches in 10 years from 1995 to 2004. And found the worship space opening and multi-functionalizing with the changing times. From now on, the study on interior design for creative worship space should be researched positively for the purpose of expressing the christian identity and the opening and muti-functions, on the basis of christian theology.

• KIEAE Journal
• /
• v.13 no.6
• /
• pp.93-98
• /
• 2013

The purpose of this study is to analyze the rate of opening windows that makes residents of a flat-type apartment feel pleasant in summer time. A few conditions were simulated on the wind flow that pass through internal and external spaces of the flat-type apartment, utilizing CFX program. The simulation was made with the criteria for the rates of opening window at 20%, 50%, 70% and 100%. When the rate of window opening was more 50%, the wind speed(more than 1m/s) that makes the residents feel pleasant was observed in more 60% of the internal space. When the all windows of the apartments were opened, the heat island phenomenon was almost disappeared and the pleasant wind flow was more evenly distributed in the external spaces. If residents of apartments recognize the result of this study and practice in agrement on opening windows in summer, it is expected to contribute to minimizing the energy consumption for air conditioning.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2000.10a
• /
• pp.609-614
• /
• 2000

This paper is an experimental study of the normal strength concrete beam and high strength concrete beam for the analysis of bending and shear behavior. In building structure, the story height can be minimized by providing openings in beams which serves for the utility equipments passing through. The dead space in false ceiling increase construction cost, the good ceiling system such as beam with opening give to economical merits because of a substantial reduction in materials and construction cost. For the analysis on the mechanical behavior of the reinforced high strength and normal strength concrete beams with circular opening in the web, the stress concentration of the circular opening, crack pattern and reinforcing methods were studied. Twenty test pieces with different reinforcing methods and difference concrete strength were tested and their resisting forces and load deflection curves were defined in this study.