• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.485-488
• /
• 2005

The 2nd KOrea Multi-Purpose Satellite (KOMPSAT -2) has been developed by Korea Aerospace Research Institute (KARI) since 2000. Multi Spectral Camera (MSC) is the payload for KOMPSAT -2, which will provide the observation imagery around Korean peninsula with high resolution. KOMPSAT-2 has adopted X-band Tracking System (XTS) for transmitting earth observation data to ground station. For this, data which describes and controls the pre-defined motion of each on-board X-Band antenna in XTS, must be transmitted to the spacecraft as S-Band command and it is called as Tracking Parameter Files (TPF). In this paper, the result of the development of TPF Generation S/W for KOMPSAT-2 X-Band Antenna Motion Control.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.7
• /
• pp.778-784
• /
• 2008

In this paper, a chip antenna using multi-layer configuration for multi-band operation, such as GSM, DCS, pcs, WCDMA, and Mobile WiMAX for 2.3 GHz is proposed. This proposed antenna is a PIFA structure with multi-layer configuration fabricated on R04003 substrate(${\varepsilon}_r=3.4$) and its size is $22{\times}5.5{\times}4.0\;mm^3$. Multi-layer structure can effectively reduce the size of an antenna from a reuse of air-space and can achieve broad bandwidth due to decrement of parallel capacitances from the insertion air-gap to the middle layer. The proposed antenna has a broadband operation by the high order resonance modes and the resonance at the top layer. The measured bandwidths with over 45 % radiation efficiency are 80 MHz($880{\sim}960\;MHz$) at the lower band and 690 MHz($1,710{\sim}2,400\;MHz$) at the higher band.

• Journal of information and communication convergence engineering
• /
• v.13 no.4
• /
• pp.235-240
• /
• 2015

A decimation chain for multi-standard reconfigurable radios is presented for 900-MHz and 1,900-MHz dual-band cellular standards with a data interpolator based on the Lagrange method for adjusting the variable data rate to a fixed data rate appropriate for each standard. The two proposed configurations are analyzed and compared to provide insight into aliasing and the signal bandwidth by means of a newly introduced measure called interpolation error. The average interpolation error is reduced as the ratio of the sampling frequency to the signal BW is increased. The decimation chain and the multi-rate analog-to-digital converter are simulated to compute the interpolation error and the output signal-to-noise ratio. Further, a method to operate the above-mentioned chain under a compressed mode of operation is proposed in order to guarantee continuous packet connectivity for inter-radio-access technologies. The presented decimation chain can be applied to LTE, WCDMA, GSM multi-mode multi-band digital front-end which will ultimately lead to the software-defined radio.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.983-984
• /
• 2006

Multi-band VCO with fast response adaptive frequency calibration (AFC) technique is designed in 1.8V $0.18{\mu}m$ CMOS process. The possible operation is verified for 5.8GHz band, 5.2GHz band, and 2.4GHz band using the switchable L-C resonators for 802.11a/b/g WLAN applications. To linearize its frequency-voltage gain, optimized multiple MOS varactor biasing technique is used. In order to operate in each band frequency range with reduced VCO gain, 4-bit digitally controlled switched-capacitor bank is used and a wide-range digital logic quadricorrelator is implemented for fast frequency detector.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.3
• /
• pp.174-181
• /
• 2004

In this paper, we review the four receiver architectures and four methods for multi-standard receiver design. Propose reconfigurable RF block can be used for both low-IF and direct conversion architecture. Also, using reconfigurable mixer method, it can be operated at $2{\sim}6$ GHz range for multi-standard receiver. It consists of wideband mixer, filter, and automatic gain control amplifier and to get wide-band operation, $2{\sim}6$ GHz, wide-band mixer use flexible input matching method. Besides, to design multi-standard receiver, LNA bank that support each standard is necessary and it has good performance to compensate the performance of wide-band mixer. Finally, we design and simulate proposed reconfigurable RF block and to prove that it has acceptable performances for various wireless standards, the LNA bank that supports both IEEE 802.11a/b/g and WCDMA is also designed and simulated with it.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.6B
• /
• pp.403-410
• /
• 2008

In this paper, we investigate the performance of MMR system in Non-transparent mode. The IEEE 802.16j MMR system has two node of operation, Single-frame (in band) and Multi-frame (out band) mode. In the analysis, we assume that channel interference between MR-BS and RS, or between RSs anywhere in the given area is ignored. The performance is presented in terms of the delay and the frame efficiency by varying number of RS and BS coverage to RS coverage ratio and the maximum coverage area of a BS by varying traffic density. Analytical results show that the Single-frame is more efficient than Multi-frame in frame efficiency and coverage extension.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.11
• /
• pp.77-84
• /
• 2003

This paper presents a multi-functional microstrip spital antenna that operates in dual frequency bands. Several types of beam shape can be selected by controlling the phase difference of two spiral arms with the phase shifters located on each feed line. It has a normal beam at the lower frequency band, and four different patterns at the higher frequency band: normal beam, conical beam and two types of tilted beam. The antenna exhibits more than 10% of bandwidth at each band. The antenna is fabricated with conductor backed electromagnetic absorber in order to attain unidirectional radiation pattern and confirmed the multi-functionality by measurements.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.4
• /
• pp.772-779
• /
• 2015

In this paper,a reconfigurable multi-band mobile antenna with switching line for LTE band 13, GSM, K-PCS, WCDMA band. The proposed antenna is planar strip line design and composed of stub shorted to the ground plane and two switching line for proposed band operation. To obtain the optimized parameters, we used the simulator, Using the obtained parameters is fabricated. The numerical and experiment results demonstrated that the proposed antenna satisfied the -6 dB impedance bandwidth requirement while simultaneously covering when the state of sw1 and sw2 on for LTE band 13, the state of sw1 off and sw2 on for GSM, K-PCS, the state of sw1 off and sw2 off for WCDMA. Respectively and characteristics of gain and radiation patterns are determined for a reconfigurable multi-band mobile terminal.

• International journal of advanced smart convergence
• /
• v.10 no.4
• /
• pp.45-51
• /
• 2021

Polar transmitter can support multi-band and multi-mode operation. The efficiency of frequency usage can be increased if polar transmitters can transmit multi-carrier signals. In this paper the configuration of polar transmitters is investigated to generate multi-carrier signals. Spectrum and CCDF Simulation results of two-carrier signals generated by the polar transmitter can be used to design of PM and AM path in a polar transmitter.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.564-566
• /
• 2005

The relation between HPA (High Power Amplifier) and COMS (Communication Ocean Meteorological Satellite) multi-carrier is analyzed in this paper. MODAC (Meteorological and Ocean Data Application Center) has a primary mission to transmit processed data, HRIT (High Rate Information Transmission) and LRIT (Low Rate Information Transmission), which is normalized and calibrated by pre-processing. It is also replaced with the SOC (Satellite Operation Center) in emergency case and can transmit the command and ranging tones for operation of COMS. From the result of simulation with modelled HPA, it is found that the multi-carrier in one HPA can give rise to an inter-modulation which makes harmonic and spurious elements increase in-band. Under the environment of these increased parasitic elements, the degradation of multi-carrier's quality is estimated from the ratio of the amount of noise to total output power of HPA.