• JSTS:Journal of Semiconductor Technology and Science
• /
• v.3 no.2
• /
• pp.89-95
• /
• 2003

In this paper, we have designed and fabricated high conversion gain Q-band active sub-harmonic mixers for a receiver of millimeter wave wireless communication systems. The fabricated active sub-harmonic mixer uses 2nd harmonic signals of a low local oscillator (LO) frequency. The fabricated mixer was successfully integrated by using $0.1{\;}\mu\textrm{m}$GaAs pseudomorphic high electron mobility transistors (PHEMTs) and coplanar waveguide (CPW) structures. From the measurement, it shows that maximum conversion gain of 4.8 dB has obtained at a RF frequency of 40 GHz for 10 dBm LO power of 17.5 GHz. Conversion gain from the fabricated sub-harmonic mixer is one of the best reported thus far. And a phase noise of the 2nd harmonic was obtained -90.23 dBc/Hz at 100 kHz offset. The active sub-harmonic mixer also ensure a high degree of isolations, which are -35.8 dB from LO-to-IF and -40.5 dB from LO-to-RF, respectively, at a LO frequency of 17.5 GHz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.1
• /
• pp.85-91
• /
• 2012

In this paper, we implemented a Ka-band frequency synthesizer for millimeter wave seeker. we designed for high frequency resolution and frequency hopping response time in the digital synthesis method which uses DDS(Direct Digital Synthesizer). but frequency bandwidth was limited low frequency because DDS output frequency was limited 1/2 by system clock. thus, frequency synthesizer was converted to Ka-band using the frequency multiplier ${\times}4$ and local oscillator. proposed frequency synthesizer was bandwidth 500MHz, frequency switching time was $0.7{\mu}s$, spurious level was suppressed below -52dBc. phase noise was -99dBc/Hz at offset 100kHz and flatness was ${\pm}1dB$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.11
• /
• pp.1186-1193
• /
• 2009

In this paper, we propose DDS(Direct Digital Synthesizer) as a new implementation method of chirp LO(Local Oscillator) for compressive receiver applied for RFID signal detection in UHF band. We designed a receiver whose input frequency range is 908.5~914 MHz, DDL(Dispersive Delay Line) bandwidth is 6 MHz, and dispersion delay time is $13\;{\mu}s$. Chirp LO based on DDS is designed to meet $26\;{\mu}s$ sweep time and 12 MHz bandwidth for complete compressive mechanism. The measured 3 dB pulse width of the compressed signal of the fabricated receiver is 260 ns and the frequency resolution for simultaneous input signals is below 200 kHz. These performances indicate that the proposed chirp LO based on DDS and the compressive receiver is suitable for RFID signal detection in UHF band.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.3
• /
• pp.638-646
• /
• 2005

In recent wireless communications, direct conversion transceiver or If sampling SDR-based receivers have being designed as an alternative to conventional transceiver topologies. In direct conversion receiver a.chitectu.e, the 1.equency/phase offset between the RF input signal and the local oscillator signal is a major impairment factor even though the conventional AFC/APC compensates the service deterioration due to the offset. To rover the limited tracking range of the conventional method and effectively aid compensation scheme in terms of I/Q channel imbalances, the frequency/phase offset compensation in RF-front end signal stage is proposed in this paper. In RF-front end, the varying phase offset besides the fixed large frequency/phase offset are corrected by using early-late phase compensator. A more simple frequency and phase tacking function in digital signal processing stage of direct conversion receiver is effectively available by an ingenious frequency/phase offset tracking method in RF front-end stage.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.5
• /
• pp.869-876
• /
• 2001

In modern wireless communication, it has been regarded as a important problem for the spectrum efficiency to utilize the limited frequency-resource efficiently. In addition, the system architecture has been designed for low cost, low power consumption and ultra-lightweight. In this paper, we directly modulated the BCPFSK with a superior spectrum efficiency using the DDS and applied the direct conversion to the system architecture. Finally, we designed a transceiver which has the 433 MHz BCPFSK output and evaluated the system performance. In the measured result, we know that as for spectrum and the power efficiency, BCPFSK method is better than conventional one. Also, the results of the designed system is 433.92 MHz in center frequency and about 33 dBc in carrier suppression ratio. And we get the better results in local oscillator leakage and the spurious of the ISM out-band the same as -69dBc and under 60dBc.

• Journal of Korea Society of Industrial Information Systems
• /
• v.18 no.2
• /
• pp.35-40
• /
• 2013

In this paper, we propose a new image rejection receiver architecture using simultaneously the high-side and low-side injected LO signals. The proposed architecture has a lower noise figure (NF) performance and a higher linearity characteristic than the previous receiver architecture using a single LO signal. Also, the proposed receiver shows a higher IRR performance about 6dB than that of the previous Weaver image rejection architecture even though the same gain and phase errors between I-path and Q-path exist. To verify these characteristics, we derive an IRR formular of the proposed architecture as a function of mismatch parameters. And we demonstrate its formular's usefulness through the system simulation. Therefore, the proposed architecture will be widely used to implement the image rejection receiver due to its higher IRR performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.7A
• /
• pp.1028-1035
• /
• 1999

To increase the throughput of data transmission in burst-mode TDMA communication systems and also to get a good BER performance at the same time, it is essential to rapidly acquire the carrier while keeping the desirable tracking performance. To achieve this goal, in this paper, a new decision-directed carrier recovery algorithm is presented. The proposed scheme does not incorporate the PLL and suppress the Gaussian random process of input noise by the pre-stage low pass filter so as to get both the fast acquisition and a good performance. Through computer simulations, the performance of the scheme is analyzed with respect to the acquisition time and bit error rate. The cycle slip in the proposed scheme is seldom observed at very low SNR environment in contrast to the previous proposed one. Because of this merit, it is not required to do the differential encoding and decoding in the proposed scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.2A
• /
• pp.202-208
• /
• 2010

The performance of upstream transmission in SCM-PON is generally limited by the presence of OBI which is caused by the beating of two or more lasers. In this paper, we propose a novel approach for reducing OBI problem by using heterodyne detection with an additional LD as a local oscillator, resulting that the RF signal is shifted to the other spectal band. In addition, it is possible that the proposed method can provide the cost-effective solution thanks to the loop-back mechanism using R-SOA in ONUs. The performance is superior when the spectral width of LD is smaller and the power difference between the transmission LD and the oscillation LD is bigger. System configuration and design consideration are discussed. Performance of the systems is evaluated by simulator called OptSim. It is expected to provide WDM/SCM-PON system not only cost-effective but also efficient in increasing the number of subscribers.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.11
• /
• pp.1191-1197
• /
• 2003

In the multi-carrier OFDM communication system, the inter-carrier-interference(ICI) produced by phase noise in the transceiver local oscillator makes a severe influence on the system performance. In this paper, a new ICI self-cancellation scheme in the data-conversion type is proposed to reduce effectively the ICI. Also, the common phase error(CPE), ICI and carrier to interference power ratio(CIR) are found by the linear approximation of the phase noise. Then, the proposed method is compared with the conventional OFDM to analyze the efficiency of system performance improvement. When the number of subcarriers is 64, there are respectively the SNR gain of 0.6 ㏈ in the phase noise variance of 0.3 with QPSK and 1.5 ㏈ in the phase noise variance of 0.1 with 16 QAM at BER=10$\^$-3/. As a result, the performance degradation by ICI can be effectively lowered in the proposed system with ICI self. cancellation scheme, compared with the conventional OFDM system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.2
• /
• pp.115-122
• /
• 2016

In this paper, wideband Ku-band downconverter was designed to receiver digital satellite broadcasting. The low-nose downconverter was designed to form four local oscillator frequencies(9.75, 10, 10.75 and 11.3 GHz) representing a low phase noise due to VCO-PLL with respect to input signals of 10.7 to 12.75 GHz and 3-stage low noise amplifier circuit by broadband noise matching, and to select intermediate frequency bands by digital control. The developed low-noise downconverter exhibited the full conversion gain of 64 dB, and the noise figure of low-noise amplifier was 0.7 dB, the P1dB of output signal 15 dBm, and the phase noise -85 dBc@10kHz at the band 1 carrier frequency of 9.75 GHz. The low noise block downconverter(LNB) for wideband digital satellite broadcasting designed in this paper can be used for global satellite broadcasting LNB.