• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2021년도 가을 학술논문 발표대회
• /
• pp.246-247
• /
• 2021

This paper aims to quantitatively evaluate concrete quality factors according to the application of thermal insulated gang form. As a result of the experiment, it was found that the amount of calcium hydroxide produced increased in the insulated gang form than in the general gang form, and the thicker the insulation of the insulated gang form, the greater the amount of calcium hydroxide produced.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2015년도 춘계 학술논문 발표대회
• /
• pp.57-58
• /
• 2015

In this study, the experimental study on Thermal Performance of Insulated Forms with Different Insulating Methods at Low Temperature. For this study, placing insulated plywood based form between two constant temperature chamber that maintaining 10℃, decrease temperature of one chamber to -10℃ and -20℃. Each of steps, maintaining period of temperature was 1 hour. After placing the form, measure temperature of opposite side of the insulated form. As a result of experiment, temperature difference of rigid urethane was lowest.

• 한국건축시공학회지
• /
• 제20권1호
• /
• pp.53-60
• /
• 2020

본 논문은 동절기 콘크리트 보양 시 투입되는 에너지(전력) 소비량과 콘크리트 발열량 변화를 통해 단열갱폼의 단열성능을 검토하고자 하였다. 실험결과에 따르면, 일반갱폼은 콘크리트 타설 이후 12시간동안 에너지(전력) 소비가 3회 발생하게 된다. 반면 단열갱폼은 콘크리트 타설 후 21시간 동안 에너지(전력) 소비가 발생되지 않았다. 최종 전력 소비량은 일반갱폼이 단열갱폼보다 3.7배 높게 나타나 에너지(전력) 소비에서 단열갱폼의 우수한 성능을 확인할 수 있었다. 발열량 검토결과는 일반갱폼에서 콘크리트 타설 후 외기 온도변화에 따라 발열량이 크게 변하는 것을 알 수 있었다. 하지만 단열갱폼의 경우 프레임 일부에서 미비한 열손실이 발생했을 뿐 콘크리트 타설 직후부터 거푸집 탈형까지 일정한 발열패턴을 보여주고 있었다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2015년도 추계 학술논문 발표대회
• /
• pp.179-180
• /
• 2015

In this study, the experimental study on Insulation performance of insulated forms utilizing NT frame heat insulation at low Temperature. For this study, placing insulated TEGO film plywood based form between two constant temperature and humidity chamber that maintaining 10℃, decrease temperature of one chamber to -10℃ and -20℃. Each of steps, maintaining period of temperature was 1 hour. After placing the insulated form, measure temperature of outside if insulated form. As a result of experiment, temperature difference of Fumed Silica Vacuum insulation was lowest.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2019년도 춘계 학술논문 발표대회
• /
• pp.153-154
• /
• 2019

This study is a mock-up experiment prior to field application of insulated gang form. In order to investigate concrete Heating cost in winter, pre-comparison was made before application.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2017년도 추계 학술논문 발표대회
• /
• pp.135-136
• /
• 2017

This paper examines the efficiency of the application of conventional and insulated gang forms for curing and protection of concrete by comparing the amount of electric energy required therefor. In addition, a thermal vision camera was used to identify heat loss from surfaces of the gang forms after each placement of concrete. Experimental results, show that the heat loss at the submerged temperature was large at the submerged surface due to the large calorific value at the surface of the mold. The insulated gang form had some heat loss in the horizontal bars. In the case of adiabatic reforming, the pattern shows a constant calorific value over time. In conclusion, the insulation performance is better than that of general gang form.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2022년도 봄 학술논문 발표대회
• /
• pp.138-139
• /
• 2022

Through previous studies, it was reviewed how to improve the insulation performance of weak areas by installing heated wires as a solution to the corners pointed out as weak areas when applying the insulation gang form and the existing pouring areas.

• Journal of Electrical Engineering and Technology
• /
• 제10권4호
• /
• pp.1765-1772
• /
• 2015

The integrity of the gas insulated switchgear (GIS) is vital to the safety of an entire power grid. However, there are some limitations on the techniques of detecting and diagnosing partial discharge (PD) induced by insulation defects in GIS. This paper proposes a joint electro-chemical detection method to resolve the problems of incomplete PD data source and also investigates a new unique fault diagnosis method to enhance the reliability of data processing. By employing ultra-high frequency method for online monitoring and the chemical method for detecting SF6 decomposition offline, the acquired data can form a more complete interpretation of PD signals. By utilizing DS evidence theory, the diagnostic results with tests on the four typical defects show the validity of the new fault diagnosis system. With higher accuracy and lower computation cost, the present research provides a promising way to make a more accurate decision in practical application.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2011년도 추계 학술논문 발표대회
• /
• pp.51-52
• /
• 2011

This study is to propose a curing method for a concrete wall structure under severe cold climate. The curing methods of using heated cable, heated panel and insulated form were applied. Results showed that the concrete cured by the heated cable resulted in the highest temperature history and the highest strength development at 28 days. Further, it is believed that the curing methods of the heated panel and insulated form are also recommendable for the resistance of the early frost damage on the concrete in practice.

• 한국자원리싸이클링학회:학술대회논문집
• /
• 한국자원리싸이클링학회 1993년도 EARTH 발표논문초록
• /
• pp.5.3-5
• /
• 1993