• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.18 no.3
• /
• pp.97-100
• /
• 2008

Polar and non-polar GaN was grown by the HVPE on various substrates and influence of polarity has been investigated. The $10\;{\mu}m$ thickness GaN were grown by HVPE is along A-plane ($11{\bar{2}}0$), C-plane (0001) and M-Plane ($10{\bar{1}}0$) sapphire substrate respectively. Surface properties were observed by optical microscope and atomic force microscopy. High resolution X-ray diffraction (HR-XRD) confirms the wurtzite structure. The donor band exciton peak located at ${\sim}3.4\;eV$ and also located yellow luminescence peak at 2.2 eV. The polarity of the GaN film has a strong influence on the morphology and the optical properties.

• Journal of Hydrogen and New Energy
• /
• v.16 no.3
• /
• pp.238-243
• /
• 2005

Mg and Mg-based alloys are most important hydrogen storage materials. It is a lightweight and low-cost materials with high hydrogen storage capacity. However, the formation of hydride at high temperature, the deterioration effect, the hydriding and dehydriding kinetics are bad factor for application. In this study, Mg and Ni have been produced by hydrogen induced mechanical alloying(HIMA) process. The raw materials, Mg(purity 99.9%) chip and Ni(purity 99.95%) chip was prepared by using a planetary ball mill apparatus(FRITSCH pulverisette 5). The balls to chips mass ratio(BCR) are 30:1. The hydrogen pressure induced 2.0MPa and milling times were 12, 24, 48, 72, 96 hours with a rotating speed of 200rpm. X-ray diffraction(XRD) analysis was made to characterize the crystallite size and misfit strain. The crystallite size measured by laser particle size analysis(PSA). Microstructure changes were investigated by scanning electron microscopy(SEM) and the transmission electron microscopy(TEM). The hydrogen storage properties were evaluated by using an Sivert's type automatic pressure-composition-therm(PCT) apparatus.

• Journal of the Korean Chemical Society
• /
• v.37 no.2
• /
• pp.249-254
• /
• 1993

N-p-nitrophenyl poly(m-phenylene isophthalamide) was obtained from treatment of poly(m-phenylene isophthalamide) with sodium hydride in dimethyl sulfoxide followed by the addition of 1-fluoro-4-nitrobenzene in 43 wt% yield. Its inherent viscosity was 0.606 g/cm${\cdot}$sec determined from a solution of 0.125 g of the above polymer dissolved in 25 ml of 98% sulfuric acid at $30^{\circ}C.$ In order to synthesize poly(m-phenylene isophthalamide), 1,3-phenylenediamine is allowed to react with isophthaloyl chloride in chloroform in the presence of triethylamine and added triethylamine hydrochloride. The value of inherent viscosity is 0.560 g/cm${\cdot}$sec measured at the same condition. The substitution ratio of N-p-nitrophenyl poly(m-phenylene isophthalamide) was to be 16.7∼47.0% by using the $^1H-NMR$ integration. When the higher inherent viscosity of poly(m-phenylene isophthalamide) was used, lower substitution ratio would be calculated.

• Journal of the Korean Chemical Society
• /
• v.41 no.12
• /
• pp.645-652
• /
• 1997

Hydride complexes Cp*Ru(CO)(PR3)H (Cp*=η5-C5Me5, PR3=PMe3, PEt3, PMePh2, PPh3, PCy3)(4a-4f) were synthesized by the reaction of the corresponding chloro complex Cp*Ru(CO)(PR3)Cl (3a-3f) with various hydridic reagent (NaBH4, LiAlH4, LiBEt3H) or NaOMe. Irradiation of Cp*Ru(CO)(PCy3)H (5e) in C6D6 solution with UV light caused H/D exchange reaction between coordinated Cp*, PCy3 and/or Ru-H ligand proton and a deuterium of the deuterated aromatic solvent through a series of inter- and intramolecular C-H activation. The proposed mechanism was described.

• Journal of Hydrogen and New Energy
• /
• v.22 no.3
• /
• pp.380-385
• /
• 2011

$MgH_2$ was synthesized by hydriding chemical vapor deposition (HCVD). In this study, we examined the hydrogen storage property of $MgH_2$ synthesized by HCVD. The results of pressure-composition-temperature (PCT) measurement showed that the HCVDed $MgH_2$ reversibly absorbed hydrogen as much as 6 wt%. Each hydrogenation rate was very greater than the conventional alloy methods. The reason was that the particle size made by HCVD was small as approximately 1 ${\mu}m$. The PCT of $MgH_2$ made by HCVD methode was similar to a commercial $MgH_2$. The ${\Delta}H$ and ${\Delta}S$ value are respectively -76.8 $kJ/mol{\cdot}H_2$ and -137.4 $kJ/mol{\cdot}H_2$. Mg made by HCVD methode was activated easily than commercial Mg. Also the initial reaction rate was faster than that of commercial $MgH_2$. 70% of the total storage were stored during 400s.

• Resources Recycling
• /
• v.28 no.6
• /
• pp.18-25
• /
• 2019

In order to recover the cerium contained in the spent nickel metal hydride batteries (NiMH battery), the recovered rare earth complex precipitates from NIMH were converted into rare earth hydroxides through ion exchange reaction to react with NaOH aqueous solution at a reaction temperature of 70 ℃, for 4 hours. Rare earth hydroxides were oxidized by injecting air at 80 ℃ for 4 hours to oxidize Ce³⁺ to Ce⁴⁺. The oxidation rate of cerium was confirmed to be about 25 % through XPS, and the oxidized powder was separated from the rest of the rare earth using the difference in solubility in dilute sulfuric acid. The finally recovered powder has a crystal phase of cerium hydroxide (Ce(OH)₄). The cerium purity of the final product was about 94.6 %, and the recovery rate was 97.3 %.

• Journal of Powder Materials
• /
• v.25 no.3
• /
• pp.213-219
• /
• 2018

We report a method for preparing rare earth oxides ($Re_xO_y$) from the recycling process for spent Ni-metal hydride (Ni-MH) batteries. This process first involves a leaching of spent Ni-MH powders with sulfuric acid at $90^{\circ}C$, resulting in rare earth precipitates (i.e., $NaRE(SO_4)_2{\cdot}H_2O$, RE = La, Ce, Nd), which are converted into rare earth oxides via two different approaches: i) simple heat treatment in air, and ii) metathesis reaction with NaOH at $70^{\circ}C$. Not only the morphological features but also the crystallographic structures of all products are systematically investigated using field-emission scanning electron microscopy (FESEM) and X-ray diffraction (XRD); their thermal behaviors are also analyzed. In particular, XRD results show that some of the rare earth precipitates are converted into oxide form (such as $La_2O_3$, $Ce_2O_3$, and $Nd_2O_3$) with heat treatment at $1200^{\circ}C$; however, secondary peaks are also observed. On the other hand, rare earth oxides, RExOy can be successfully obtained after metathesis of rare earth precipitates, followed by heat treatment at $1000^{\circ}C$ in air, along with a change of crystallographic structures, i.e., $NaRE(SO_4)_2{\cdot}H_2O{\rightarrow}RE(OH)_3{\rightarrow}RE_xO_y$.

• Environmental Analysis Health and Toxicology
• /
• v.17 no.2
• /
• pp.109-115
• /
• 2002

This study was conducted to investigate the reference value of mercury (Hg) in liver and kidney of Korean population. The mercury concentration in 244‘sudden and unexpected death’autopsies (male: 180, female: 64) aged from 0 to 87 years was analyzed. The concentration of mercury was measured by atomic absorption spectrophotometer (Perkin-Elmer Model 5100) with mercury/hydride generating system (FIAS 400). The contents of mercury in liver and kidney fitted well the log-normal distribution rather than normal distribution. Geometric mean concentration of mercury in liver and kidney was 0.115 $\mu\textrm{g}$/g wet weight and 0.149 $\mu\textrm{g}$/g wet weight, respectively. Geometric mean concentration of mercury in female was higher than in male (p < 0.01). The mercury content in liver and kidney increased with age up to the forties and slightly decreased there-after. The regression model of mercury deposit in liver and kidney by age was predicted as the following equation : Log LHg : -1.0576＋0.0045$.$Age-0.0001$.$Age$^2$＋0.0873$.$Sex, Log KHg = -1.0576＋0.0152$.$Age-0.0002$.$Age$^2$＋0.1935$.$Sex. The liver burden of mercury was estimated to be 158.3∼161.3 $\mu\textrm{g}$ in male and 163.0∼166.9 $\mu\textrm{g}$ in female. The kidney burden of mercury was estimated to be 42.0∼42.9 $\mu\textrm{g}$ in male and 55.5∼57.1 $\mu\textrm{g}$ in female.

• Journal of Hydrogen and New Energy
• /
• v.10 no.1
• /
• pp.9-17
• /
• 1999

The hydriding and dehydriding kinetics were studied for a Mg-25wt.%Ni mixture which has the most excellent hydrogen-storage characteristics among many mechanically-alloyed mixtures. The hydriding and dehydriding rates were measured and the rate-controlling steps were determined by comparing the hydriding and dehydriding rates with the theoretical rate equations. The rate-controlling step in the hydriding reaction is the Knudsen flow and the ordinary gaseous diffusion of hydrogen molecules through interparticle channels, cracks, etc. in the various ranges of weight percentage of absorbed hydrogen $H_a$ below $H_a$=4.0. In the $H_a$ range 4.0 < $H_a{\leq}4.25$, the diffusion of hydrogen atoms through the growing hydride layer is considered the rate-controlling step. The rate-controlling step in the dehydriding reaction is the Knudsen flow and the ordinary gaseous diffusion of hydrogen molecules for all the ranges of weight percentage of desorbed hydrogen $H_d$.

• Journal of Hydrogen and New Energy
• /
• v.28 no.2
• /
• pp.156-165
• /
• 2017

This study quantitatively assessed the environmental impacts of fuel cell (FC) systems by performing life cycle assessment (LCA) and analyzed their energy efficiencies based on energy return on investment (EROI) and electrical energy stored on investment (ESOI). Molten carbonate fuel cell (MCFC) system and polymer electrolyte membrane fuel cell (PEMFC) system were selected as the fuel cell systems. Five different paths to produce hydrogen ($H_2$) as fuel such as natural gas steam reforming (NGSR), centralized naptha SR (NSR(C)), NSR station (NSR(S)), liquified petroleum gas SR (LPGSR), water electrolysis (WE) were each applied to the FCs. The environmental impacts and the energy efficiencies of the FCs were compared with rechargeable batteries such as $LiFePO_4$ (LFP) and Nickel-metal hydride (Ni-MH). The LCA results show that MCFC_NSR(C) and PEMFC_NSR(C) have the lowest global warming potential (GWP) with 6.23E-02 kg $CO_2$ eq./MJ electricity and 6.84E-02 kg $CO_2$ eq./MJ electricity, respectively. For the impact category of abiotic resource depletion potential (ADP), MCFC_NGSR(S) and PEMFC_NGSR(S) show the lowest impacts of 7.42E-01 g Sb eq./MJ electricity and 7.19E-01 g Sb eq./MJ electricity, respectively. And, the energy efficiencies of the FCs are higher than those of the rechargeable batteries except for the case of hydrogen produced by WE.