• 한국환경보건학회지
• /
• 제17권2호
• /
• pp.41-47
• /
• 1991

A study on the effects of volumetric loading rate, surface loading rate and hydraulic. retention time (HRT) for the anaerobic treatment was conducted with the anaerobic fixed-film process using synthetic wastewater at lower temperature than that of conventional anaerobic treatment. The results are as follows 1. Alkalinity and pH value decreased as the hydraulic retention time increased 2. Increase of the volumetric lodaing rate led to increasl of effluent COD concentration and decrease of COD removal efficiency. 3. The removed volumetric loading rate increased linearly according to the increase of the volumrtric loading rate. 4. Similarly, the linear increase of the removed surface loading rate was noticed with an increase of the surface loading rate.

• 한국환경보건학회지
• /
• 제27권3호
• /
• pp.43-48
• /
• 2001

Terephthalic acid and ethylene glycol resulting form the weight-reduction process of polyester make trouble in the operation of activated sludge process. Also, polyester weight loss wastewater shows high pH, high organic strength and wide variation of organic loading. Therefore, this study was conducted in order to improve treatment efficiency by activated sludge process with Pseudomonas sp degrading components of polyester weight loss wastewater. The CO $D_{Mn}$ and BO $S_{5}$ of the waste wastewater were 560~3,000 mg/$\ell$ and 8000~3,000 mg/$\ell$, respectively. pH was 11.8~12.3. COD removal efficiency by activated sludge-coagulation process with Pseudomonas sp was 94.1~95.8% for 35 hr of hydraulic retention time. Total organic carbon removal efficiency was 97.1%. Ethylene glycol and terephthalic acid in the wastewater were completely degraded during 32 hr of hydraulic retention time.e.

• 한국환경보건학회지
• /
• 제27권3호
• /
• pp.11-20
• /
• 2001

An anaerobic sludge-aerobic fixed-bed biofilm(packed with ceramic support carrier of 1 inch size) reactor system was built up to treat textile wastewater. The efficiency of reactor system was examined by determining the effects of textile wastewater ratio(from 25% to 100% at HRT 24 h). The influent range of SCOD concentration and color were 1,036~1,357 mg/L, and 1,487~1,853 degree, respectively. When textile wastewater ratio was 100% and hydraulic retention time was 24 hours, SCOD removal efficiency by the anaerobic stage were 39.2% 100% and hydraulic retention time was 24 hours, SCOD removal efficiency by the anaerobic stage were 39.2% and the removal efficiency of the whole system were 75.8%. Color removal efficiency by the anaerobic stage were 45.4%(soluble color), and the removal efficiency of the whole system were 70.2%. In the A/A reactor system, the aerobic stage played an important role in removing both color and COD as well as anaerobic stage.

• 한국환경보건학회지
• /
• 제27권3호
• /
• pp.81-85
• /
• 2001

The aim of this study was to evaluate on the removal effect of total nitrogen and posphorus in municipal wastewater by decreasing hydraulic retention time(HRT) from 6 hour to 4 hour on CNR process using influent as a Carbon Source. CNR(Cilium Nutrient Romoval) is the process combining $A^2$/O process with cilium media of H2L corporation. The removal efficiencies for BOD$_{5}$, T-N and T-P were 81.1%, 61.4%, 61.4%, respectively. The removal efficiency of nitrogen and posphorus were low by decreasing hydraulic retention time(HRT) from 6 hour to 4 hour on CNR process.s.

• 환경위생공학
• /
• 제14권4호
• /
• pp.172-179
• /
• 1999

In this research, biological treatability test was conduced using seawater flocculated tannery wastewater by fixed biofilm reactor. During one cycle, the removal efficiency of organic corbon obtained with fixed biofilm process for treating tannery wastewater was considerably greater than that with activated sludge process. As the hydraulic retention time increased form 0.5day to 4day, removal efficiency of organic carbon was increased from 72% to 87.3%. Attached biomass in media increased with influent organic loading up to 29g MLSS/L, that could reduce the specific organic loading rate. The continual measurement of attached biomass was possible for the operation of the biofilm reactor. Equal and low nitrication rates were observed in both suspended growth activated sludge process and fixed biofilm process, despite commercial nitrifier was seeded. Through the process of treating the tannery wastewater, EC50 values which is measured by the use of Ceriopdaphnia dubia, were decreased to the extent of 50% after treatment of seawater flocculation and of 83% after biological treatment, respectively, compared to those of the untreated wastewater.

• 환경위생공학
• /
• 제14권4호
• /
• pp.110-116
• /
• 1999

This study was conducted to investigate the contaminants removal efficiency and the optimal operating parameters by the internal recycle rate (IRR) in the combining A2/O process with fixed film. The average removal efficiency of BOD and COD was 92.5%~94.6%, 73.9%~87.0% in RUN 1 and 91.9%~94.7%, 77.7%~89.0% in RUN 2, respectively. Organic removal efficiency, at two different hydraulic retention time of 10 and 14hr, was similar. At 50% of the internal recycle rate, organic removal efficiency was somewhat higher than the other. Total nitrogen (T-N) and total phosphorus (T-P) were removed, highly, at 50% of internal recycle rate. It could be suggested by this study that the optimum internal recycle rate is 50% and hydraulic retention time is 14hr.

• 한국환경과학회지
• /
• 제19권3호
• /
• pp.371-377
• /
• 2010

The purpose of this study is to investigate treatment efficiency in dyeing wastewater treatment by the high rate aeration system(HRA) and a combination of the HRA with magnetized wastewater treatment system(MWS). At the hydraulic retention time of 16hr, 24hr, 30hr, BOD removal efficiencies of HRA system were 93%, 96% and 98%, combination of the HRA with MWS system were 94%, 96.8% and 98.2%, respectively. In ease of COD, at the hydraulic retention time of 16hr, 24hr, 30hr, COD removal efficiencies of HRA system were 66%, 77.1% and 83.1%, combination of the HRA with MWS system were 70.2%, 80.1% and 86.6%, respectively. The comparison of the HRA and combination of the HRA with MWS, effluent BOD of the former was 22.7mg/${\ell}$ and the latter was 19.4mg/${\ell}$, theretore biological treatment efficiency identified to increase by the MWS.

• 한국환경과학회지
• /
• 제8권1호
• /
• pp.95-100
• /
• 1999

Process intensification without any increase in bed requires the exploitation of fluid mechanical phenomena as the basis for elegant solutions to the process engineering problems which result from the need to retain and control the immobilized biomass, and for biomass recovery. The fluidized bed biological reactor provides a solution to these needs. The wastewater treatment characteristics of the fluidized bed was filled with sand media. Indirect aeration were studied experimentally. The researcher was filled with sand particle size(0.60~0.42mm) in three reactors with different section area(A)/height(H), in the state BOD loading 4.5kg-$BOD_5/m^3$ㆍd, and under the fixed state of hydraulic retention time for around 32 minutes.

• 한국물환경학회지
• /
• 제29권6호
• /
• pp.808-812
• /
• 2013

A new type of microbial fuel cell (MFC) with anaerobic membrane filter was designed to produce bioelectricity and to treat domestic sewage at relatively high organic loading rate (OLR) of $6.25kgCOD/m^3/day$ and short hydraulic retention time (HRT) of 1.9 h. A following aeration system was applied to ensure effluent water quality in continuous operation. Glucose was supplemented to increase the influent concentration of domestic sewage. Influent substrate of 95% was removed via the MFC and following aeration system and the corresponding maximum power density was $25.6mW/m^3$. External resistor of $200{\Omega}$ and air-cathode system contributed better MFC performance comparing to $2000{\Omega}$ and dissolved oxygen as a catholyte.

• KSBB Journal
• /
• 제20권6호
• /
• pp.443-446
• /
• 2005

음식물 쓰레기로부터의 연속 수소 생성 실험을 다양한 수리학적 체류시간(HRT; 18, 21, 24, 30, 36, 42 h)에서 수행하였다. 음식물쓰레기는 분쇄와 알칼리 처리를 거쳐 27.0 g COD/L(average VS 4.4%)의 농도로 fed-batch 형태로 주입되었으며, 반응조 내의 pH는 $5.3{\pm}0.1$ 이상으로 유지되었다. 126일 간의 운전을 통해 유기성 폐기물로부터의 연속 수소 생성이 안정적으로 진행될 수 있음을 확인하였다. 수소 생성 효율은 HRT에 따라 변하였으며, 30 h에서 가장 높은 수치를(25.8 mL $H_2/g\;VS_{added}$, 0.36 mol $H_2/mol\;hexose_{added}$, 0.91 L $H_2/L/d$) 보였다. 대부분의 조건에서 가장 양이 많은 부산물은 노말부티르산이었으며, 수소생성이 증가함에 따라 노말부티르산의 생성이 증가하였다. 이소프로판을 역시 수소 생성과 관련이 있는 나타났다. 반면, 아세트산의 생성량은 수소생성과 반대되는 경향을 보여 수소 소모 아세트산 생성 경로로 발생되는 양이 많았다고 사료된다. 한편 산발효 효율은 $53.3{\sim}65.7%$인 것으로 나타나 기존 산 발효를 수소발효가 대체할 수 있음을 확인하였다.