• Journal of Environmental Science International
• /
• v.28 no.3
• /
• pp.291-301
• /
• 2019

This study was conducted to investigate the effect of salt concentration and turbidity on the inactivation of Artemia sp. by electrolysis, UV photolysis, electrolysis+UV process to treat ballast water in the presence of brackish water or muddy water caused by rainfall. The inactivation at different salt concentrations (30 g/L and 3 g/L) and turbidity levels (0, 156, 779 NTU) was compared. A decrease in salt concentration reduced RNO (OH radical generation index) degradation and TRO (Total Residual Oxidant) production, indicating that a longer electrolysis time is required to achieve a 100% inactivation rate in electrolysis process. In the UV process, the higher turbidity results in lower UV transmittance and lower inactivation efficiency of Artemia sp. Higher the turbidity resulted in lower ultraviolet transmittance in the UV process and lower inactivation efficiency of Artemia sp. A UV exposure time of over 30 seconds was required for 100% inactivation. Factors affecting inactivation efficiency of Artemia sp. in low salt concentration are in the order: electrolysis+UV > electrolysis > UV process. In the case of electrolysis+UV process, TRO is lower than the electrolysis process, but RNO is more decomposed, indicating that the OH radical has a greater effect on the inactivation effect. In low salt concentrations and high turbidity conditions, factors affecting Artemia sp. inactivation were in the order electrolysis > electrolysis+UV > UV process. When the salt concentration is low and the turbidity is high, the electrolysis process is affected by the salt concentration and the UV process is affected by turbidity. Therefore, the synergy due to the combination of the electrolysis process and the UV process was small, and the inactivation was lower than that of the single electrolysis process only affected by the salt concentration.

• Korean Journal of Ecology and Environment
• /
• v.45 no.3
• /
• pp.314-321
• /
• 2012

To quantitatively assess the effects of turbidity on egg development and larval fish survival, a laboratory fish rearing experiment was applied to different life stages (newly hatched larval stage, juvenile stage and pre-adult stage) of the Zacco platypus, one of the most universal and tolerant species in Korea. According to the stress index of turbidity in water with exposure time, three different treatments, including a reference condition (1~7 NTU) as well as intermediate (20~150 NTU) and high turbidity conditions (400~1,000 NTU) were applied, and egg hatching and larval fish mortality rates were observed. The mortality rates of newly hatched larval fish were significantly different among treatments (ANOVA, $F_{2,3}$=17.79, p<0.05). Average rates of survival to hatching were 20.9% (${\pm}0.1%$) for reference condition, 11% (${\pm}6.9%$) for intermediate level and 3.2% (${\pm}3.7%$) for high level conditions, respectively. A sudden change of mortality at the high level was observed within 5 days of the experiment. About 84% of juvenile fish survived until 20 experimental periods under conditions of reference turbidity, while survival under conditions of intermediate turbidity was over 80% of larval fish until day 13 of the experiment, but dropped to less than 10% after day 14 and 15 of two experiments. Fish mortality appeared from day 6 of the high turbidity experiment, and 50% mortality was achieved at day 9 to 10 of experiment. Full mortality occurred at day 14 of the experiment (RM-ANOVA, $F_{2,38}$, p<0.005). In the pre-adult stage experiment, no mortality was observed during the experiment at reference level treatment (20 days), while only slight mortality rates were observed for both intermediate and high levels until day 5 of the experiment, however, no further fish died in either experiment. It was significantly different compared to reference condition (RM-ANOVA, $F_{2,20}$=8.28, p<0.01), but no difference was observed between intermediate and high level conditions. Consequently, this tolerant species has been determined to be well adapted to high levels of turbidity in its adult stage, but more vulnerable throughout earlier life stages.

• Journal of Korean Society of Water and Wastewater
• /
• v.12 no.3
• /
• pp.107-117
• /
• 1998

In order to removal turbidity at high turbidity, this study was carried to evaluate the coagulants(Alum, PACl, PACS) that was suited the characteristics of raw water in water treatment plants and to determinate the optimum method of lime feed. When the optimum coagulant was selected the organic matter removal was also investigated as $UV_{254}$. PACl, lime first feed had the highest turbidity removal efficiency rate as above 99.1% and then $UV_{254}$ removal rate was obtained over than 88.0%. If you had the necessary of the lime feed, among the method of lime feed time interval feed largely was improved than simultaneous feed. Also, lime feed dose had about 1/5 of coagulants dose in case of Alum and PACl, but always PACS should be considerated lime dose.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.1
• /
• pp.39-46
• /
• 2009

A method to improve water treatment efficiency by coagulant overdosing for high pH raw water at a drinking water treatment plant (WTP) which had no pH adjusting facilities was investigated. Poly aluminum chloride (PACl) was used for coagulant, and turbidity removal efficiency was evaluated as a function of PACl dosage increases. pH and turbidity of supernatant of jar-tester were 7.10 and 0.50 NTU respectively, when the turbidity, pH, alkalinity, water temperature, conductivity of raw water were 1.75 NTU, 9.38, 46.5 mg/L, $6.4^{\circ}C$, $400{\mu}s/cm$, respectively. Turbidity of settled water was reduced from 2.18 NTU to 0.28 NTU (87% reduction) when PACl dosage was increased from 16 mg/L to 45 mg/L at a full scale WTP. This can be attributed to the recovery of coagulant efficiency by pH reduction with the increase of coagulant dose, however coagulation efficiency was reduced with the formation of Al(OH)4- by PACl addition at higher pH. Coagulant overdosing was proven to be a rapid and effective method for high pH raw water, which can be applied at drinking WTP.

• Journal of Environmental Science International
• /
• v.15 no.3
• /
• pp.237-242
• /
• 2006

The purpose of this research was to investigate the efficiency of coagulants dose after backwashing. The turbidity of initial effluent was high after backwashing in the rapid sand filtration and the high turbidity was almost removed by coagulants dose into filter-sand after backwashing. It was found that the turbidity of initial effluent was well removed by all kinds of the coagulants used in this study. When filtration was performed input water with differentiated pH's, the turbidity of effluent was low at the range of pH 5 - pH 7. But the removal was not good about over pH 9. This result was considered into the existence forms of aluminium, $Al(OH)^{2+}\;and\;{Al(OH)_2}^+$ at pH 5. Cryptosporidiums of effluent were 4/ml for ten minutes immediately after back washing and 3/ml until sixty minutes. However, the case of coagulant dose after backwashing, Cryptosporidiums of effluent were 0.5/ml for ten minutes with no detection after twenty minutes.

• Food Science of Animal Resources
• /
• v.21 no.1
• /
• pp.32-37
• /
• 2001

The study investigated the effects of protein concentration, EGTA and strength of hydrostatic pressure on pH, viscosity and turbidity for ultra filtrated skim milk retentates. The results showed that hydrostatic pressure treatments up to 600 MPa did not affect the viscosity of skim milk, while the turbidity of skim milk increased at higher than 200 MPa. Addition of EGTA caused reduction in turbidity of skim milk, two times (2SR) and three times (3SR) concentrated skim milk retentates. Viscosity for 2SR and 3SR increased proportionally to the amount of EGTA, but viscosity of skim milk was not influenced by EGTA. High pressure treatment also did not cause any difference in viscosity and turbidity of skim milk. However, this treatment decreased viscosity and turbidity for 2SR and 3SR. In particular, 200 MPa treatment showed to induce a higher decrease in turbidity compared with 400 MPa.

• Korean Journal of Ecology and Environment
• /
• v.41 no.1
• /
• pp.73-80
• /
• 2008

Present study aims to investigate the effect of muddy water on the gill and the kidney tissues of Zacco koreanus under high turbidity rearing condition. The gill of Z. koreanus showed abnormal shapes in its secondary lamellae and a rough surface with impure debris in the high level of turbidity and the longer raising period condition. In addition, the gills showed the edema, the exfoliation of epithelial cell, and the fusion of the secondary lamellae. In case of kidney tissue, the atrophied glomerulus was observed, and the empty space in Bowman's capsule was wider. The SOD activities in both gill and kidney tissues were increased in proportion to the high level of turbidity. On the while, CAT and GPX activities were shown constant level in the gill, but were increased in the kidney in the high turbid muddy water. These results indicate that the harmful radicals which generate by high level of turbidity could be removed partly by antioxidant enzymes in the kidney. The concentrations of micro heavy metal ions accumulated in the gill increased drastically at the 1,000 NTU. Based on the above results, it is considered that the exposure to the high level of turbidity for long period may affect on the structures of tissues, and change the enzymatic balance in Z. koreanus, causing the fatal disease.

• Journal of Korean Society on Water Environment
• /
• v.22 no.5
• /
• pp.933-942
• /
• 2006

In this study, temperature, turbidity, suspended paniculate matter (SPM) distribution and mineral characteristics were investigated to explain spatial distribution of the turbid-water environment of Yongdam reservoir in July, 2005. Six stations were selected along a longitudinal axis of the reservoir and sampling was conducted in four depths of each station. Water temperature was showed the typical stratified structure by the effects of irradiance and inflow. Content of inorganic matter in suspended particles increased with the concentration of suspended particulate matter (SPM) due to the reduction of ash-free dry matter (AFDM). Turbidity ranged from 0.6 to 95.1 NTU and the maximum turbidity value of each station sharply increased toward downstream from upstream. The high turbidity layers were located at the depth between 12~16 m. Particle size ranged from 0.435 to $482.9{\mu}m$. day and silt-sized particles corresponded 91.9~98.9% and 1.1~8.0% in total numbers of SPM, respectively. Turbidity showed high correlations with clay (r=0.763, p<0.05) and silt content (r=0.870, p<0.05).Inorganic matter content (r=0.960, p<0.01) was more correlated with turbidity than organic matter (r=0.823, p<0.05). Mineral characterization using x-ray diffraction and electron probe microanalyzer demonstrated that the major minerals contained in the SPM were kaolinite, illite, vermiculite and smectite. As results of this study, surface water discharge as well as small size of the SPM were suggested as long-term interfering factors in settling down the turbid water in the reservoir.

• Journal of Industrial Technology
• /
• v.27 no.B
• /
• pp.221-227
• /
• 2007

This research investigates the turbidity and flow of river for an year, 2005, in order to examine the relation of the generation of turbidity according to the outflow of min water. For this research, the region of Jawoon river where is the area of high land vegetable growing in the upper Soyang Reservoir is selected to observe actual floating materials that generate negative nutrition and turbidity of the Reservoir water and the changes of water quality by raining of each month. In addition, the researcher has conducted statistical inspection methods, such as correlation analysis and regression analysis on strength of raining force, and rain continuance time among the elements affecting the outflow of floating materials.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.45 no.2
• /
• pp.126-137
• /
• 2003

The feasibility study of UV-disinfection system was performed for disinfection of effluent from wastewater treatment plant. Three low-pressure UV lamps of 17, 25, and 41 W were examined with various flow rates. Low-pressure UV lamps of 17W were examined with various turbidity, DOM (dissolved organic matter), and SS (suspended solid). The pilot plant was a flow-through type UV-disinfection system, and the range of exposure time varied from 5 to 40 seconds, turbidity from 0 to 40 NTU, DOM from 0 to 30 mg/L, and SS from 10 to 40 mg/L. The 41W lamp demonstrated complete disinfection showing no survival ratio in all the experimental conditions, and generally 17W and 25W lamps also showed high removal ratio over 97%. For the same UV dose (UV intensity times exposure time), high intensity-short exposure conditions showed better disinfection efficiency than low intensity-long exposure conditions. While the effects of turbidity and DOM were not apparent, the effects of SS was significant on the disinfection efficiency which indicates that SS control before UV-disinfection appears to be necessary to increase removal efficiency. Considering characteristics of effluent from existing wastewater treatment plants, cost-effectiveness, stable performance, and minimum maintenance, the flow-through type UV-disinfection system with high intensity and low-pressure lamps was thought to be a competitive disinfection system for wastewater reclamation.