• Journal of the Korea Society of Computer and Information
• /
• v.11 no.1 s.39
• /
• pp.1-10
• /
• 2006

Load redistribution algorithm is a critical factor in computer system. In a receiver-initiated load redistribution algorithm, receiver(underloaded processor) continues to send unnecessary request messages for load transfer until a sender(overloaded processor) is found while the system load is light. Therefore, it yields many problems such as low CPU utilization and system throughput because of inefficient inter-processor communications until the receiver receives an accept message from the sender in this environment. This paper presents an approach based on genetic. algorithm(GA) for dynamic load redistribution in heterogeneous distributed systems. In this scheme the processors to which the requests are sent off are determined by the proposed GA to decrease unnecessary request messages.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.49 no.2
• /
• pp.62-69
• /
• 2000

In this paper, we design a GA-fuzzy precompensated PID controller for the load frequency control of two-area interconnected power system. Here, a fuzzy precompensated PID controller is designed as a fuzzy logic-based precompensation approach for PID controller. This scheme is easily implemented simply by adding a fuzzy precompensator to an existing PID controller. And we optimize the fuzzy precompensator with a genetic algorithm for complements the demerit such as the difficulty of the component selection of fuzzy controller, namely, scaling factor, membership function and control rules. Simulation results show that the proposed control technique is superior to a conventional PID control and a fuzzy precompensated PID control in dynamic responses about the load disturbances of power system and is convinced robustness reliableness in view of structure.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.8
• /
• pp.1164-1171
• /
• 2012

Recently, machine olfactory systems as an artificial substitute of the human olfactory system are being studied actively because they can scent dangerous gases and identify the type of gases in contamination areas instead of the human. In this paper, we present an effective design method for the gas identification system. Even though dimensionality reduction is the very important part, in pattern analysis, We handled effectively the dimensionality reduction by grouping the sensors of which the measured patterns are similar each other, where genetic algorithms were used for combination optimization. To identify the gas type, we constructed the hierarchical rule base with two frames by using rough set theory. The first frame is to accept measurement characteristics of each sensor and the other one is to reflect the identification patterns of each group. Thus, the proposed methods was able to accomplish effectively dimensionality reduction as well as accurate gas identification. In simulation, we demonstrated the effectiveness of the proposed methods by identifying five types of gases.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.16 no.5
• /
• pp.562-567
• /
• 2006

Model Predictive Control(MPC) system uses the current input which minimizes the difference between the desired output and the estimated output in the receding horizon scheme. In many cases (for example, system with constraints or nonlinear system), however, it is not easy to find the optimal solution to the above problem. In this paper, we show that real number coding genetic algorithm can be used to solve the optimal problem for MPC effectively. Also, we show by simulation that the real coding algorithm is mote natural and advantageous than the digital coding one.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.5
• /
• pp.930-936
• /
• 2008

CMOS image monitoring system for optimal measuring the activity of biosensor is developed using genetic algorithm. Most of living organism in water as water flea, fish, etc are frequently used as biological sensor for monitoring the water quality. It is very difficult to measure the activity of biosensor by image sensor because the value of measurement is varied with gathering method of biosensor images. The suggested monitoring system can optimally measures the activity of biosensor by genetic algorithm. The system is implemented with FPGA into the small hardware which is excellent in terms of the price and performance.

• Journal of Creative Information Culture
• /
• v.4 no.3
• /
• pp.221-230
• /
• 2018

Collaborative filtering technique is a major method of recommender systems and has been successfully implemented and serviced in real commercial online systems. However, this technique has several inherent drawbacks, such as data sparsity, cold-start, and scalability problem. Clustering-based collaborative filtering has been studied in order to handle scalability problem. This study suggests a collaborative filtering system which utilizes genetic algorithms to improve shortcomings of K-means algorithm, one of the widely used clustering techniques. Moreover, different from the previous studies that have targeted for optimized clustering results, the proposed method targets the optimization of performance of the collaborative filtering system using the clustering results, which practically can enhance the system performance.

• Structural Engineering and Mechanics
• /
• v.87 no.3
• /
• pp.211-219
• /
• 2023

The structural health of a pipeline is usually assessed by visual inspection. In addition to the fact that this method is expensive and time consuming, inspection of the whole structure is not possible due to limited access to some points. Therefore, adopting a damage detection method without the mentioned limitations is important in order to increase the safety of the structure. In recent years, vibration-based methods have been used to detect damage. These methods detect structural defects based on the fact that the dynamic responses of the structure will change due to damage existence. Therefore, the location and extent of damage, before and after the damage, are determined. In this study, fuzzy genetic algorithm has been used to monitor the structural health of the pipeline to create a fuzzy automated system and all kinds of possible failure scenarios that can occur for the structure. For this purpose, the results of an experimental model have been used. Its numerical model is generated in ABAQUS software and the results of the analysis are used in the fuzzy genetic algorithm. Results show that the system is more accurate in detecting high-intensity damages, and the use of higher frequency modes helps to increase accuracy. Moreover, the system considers the damage in symmetric regions with the same degree of membership. To deal with the uncertainties, some error values are added, which are observed to be negligible up to 10% of the error.

• International Journal of Control, Automation, and Systems
• /
• v.1 no.3
• /
• pp.289-300
• /
• 2003

In this paper, we introduce an identification method in Fuzzy Relation-based Fuzzy Neural Networks (FRFNN) through a hybrid identification algorithm. The proposed FRFNN modeling implement system structure and parameter identification in the efficient form of "If...., then... " statements, and exploit the theory of system optimization and fuzzy rules. The FRFNN modeling and identification environment realizes parameter identification through a synergistic usage of genetic optimization and complex search method. The hybrid identification algorithm is carried out by combining both genetic optimization and the improved complex method in order to guarantee both global optimization and local convergence. An aggregate objective function with a weighting factor is introduced to achieve a sound balance between approximation and generalization of the model. The proposed model is experimented with using two nonlinear data. The obtained experimental results reveal that the proposed networks exhibit high accuracy and generalization capabilities in comparison to other models.er models.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2008.05a
• /
• pp.776-779
• /
• 2008

It is expect that Microarray technique be direct classification and diagnosis of Genetic data have abnomal data value because DNA technique. It is necessary that many noses that is abnomal data in sampling genetic data. So in this paper reported sampling method in exiting study then suggests new data classific system and modeling method using EP by Matlab about three dataset.

• Proceedings of the Korea Inteligent Information System Society Conference
• /
• 1999.10a
• /
• pp.323-335
• /
• 1999

In this paper, we propose a new hybrid model of artificial neural networks(ANNs) and genetic algorithm (GA) to optimal feature transformation and feature weighting. Previous research proposed several variants of hybrid ANNs and GA models including feature weighting, feature subset selection and network structure optimization. Among the vast majority of these studies, however, ANNs did not learn the patterns of data well, because they employed GA for simple use. In this study, we incorporate GA in a simultaneous manner to improve the learning and generalization ability of ANNs. In this study, GA plays role to optimize feature weighting and feature transformation simultaneously. Globally optimized feature weighting overcome the well-known limitations of gradient descent algorithm and globally optimized feature transformation also reduce the dimensionality of the feature space and eliminate irrelevant factors in modeling ANNs. By this procedure, we can improve the performance and enhance the generalisability of ANNs.