• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.12
• /
• pp.781-785
• /
• 2016

With trend of the miniaturization and the high-functionalizing of mobile communication system, low-loss microwave dielectric materials are widely used for high frequency communication components. These dielectric materials should be co-sintered with highly electric-conducting metal such as silver or copper for high-frequency and thick film process application. Sintering temperature of $Ca(Li_{1/3}Nd_{2/3})_{0.2}Ti_{0.8}]O_{3-{\delta}}$, which has excellent dielectric properties such as ${\varepsilon}_r$ above 40, quality factor ($Q{\cdot}f_0$) above 16,000 GHz, and TCF (temperature coefficient of resonant frequency) of $-20{\sim}-10ppm/^{\circ}C$, is reported as high as $1,175^{\circ}C$, so it could not be co-sintered with silver or copper. Therefore in this study, low-temperature melting glasses of Zn-B-O and Zn-B-Si-O systems were added to $Ca[(Li_{1/3}Nb_{2/3})_{0.8}Ti_{0.2}]O_{3-{\delta}}$ to lower its sintering temperature under $900^{\circ}C$ without losing excellency of dielectric properties. With 15 weight % of Zn-B-Si-O glass and sintered at $875^{\circ}C$, specimen showed density of $4.11g/cm^3$, ${\varepsilon}_r$ of 40.1, $Q{\cdot}f_0$ of 4,869 GHz, and TCF of $-5.9ppm/^{\circ}C$. With 15 weight % of Zn-B-O glass and sintered at $875^{\circ}C$, specimen showed density of $4.14g/cm^3$, ${\varepsilon}_r$ of 40.4, $Q{\cdot}f_0$ of 7,059 GHz, and TCF of $-0.92ppm/^{\circ}C$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.31 no.4
• /
• pp.216-220
• /
• 2018

The piezoelectric properties of $0.65Pb(Zr_{1-x}Ti_x)O_3-0.35Pb(Zn_{1/6}Ni_{1/6}Nb_{2/3})O_3$ ($PZT_x-PZNN$) ceramics with $0.530{\leq}x{\leq}0.555$ were investigated for application to piezoelectric energy harvesters. Although a morphotropic phase boundary (MPB) was found at approximately x = 0.545, the ceramic with the highest figure of merit (FOM) ($d_{33}{\times}g_{33}$) was observed at a composition of x = 0.540. Values of this figure of merit, $d_{33}{\times}g_{33}$, of $19.6pm^2/N$ and $20.2pm^2/N$ were obtained from $PZT_{0.540}-PZNN$ ceramics sintered at $920^{\circ}C$ and $950^{\circ}C$, respectively. A high output power of $937{\mu}W$ and a high power density of $3.3mW/cm^3$ were obtained from unimorph-type piezoelectric energy harvesters fabricated using $PZT_{0.540}-PZNN$ ceramic sintered at $920^{\circ}C$ for 4h.

• Korean Journal of Optics and Photonics
• /
• v.19 no.3
• /
• pp.199-207
• /
• 2008

Wavelength converting devices with a ridge-type waveguide in periodically poled $MgO:LiNbO_3$ are made and characterized. The experimental results are compared with theoretical analysis on the effects of waveguide dimension and duty ratio of the periodically poled structure. To show the relationship of the conversion efficiency to those factors, a new measurement system is configured. That experimental results show that the center wavelength, normalized conversion efficiency and full width half maximum of the conversion efficiency curve are 1067.45 nm, 90.7%/$Wcm^2$ and 0.17 nm, respectively. Also, the estimated results of the duty period and full width half maximum of the conversion efficiency from theoretical calculations agreed well with experimental results with the errors of 0.016 ${\mu}m$ and 0.01 nm.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.11a
• /
• pp.563-566
• /
• 2000

The effect of CuO and CuO-B $i_2$ $O_3$ additives on microwave dielectric properties of (P $b_{0.45}$C $a_{0.55}$)[F $e_{0.5}$N $b_{0.5}$)$_{0.9}$S $n_{0.1}$] $O_3$were investigated to decrease the sintering temperature for usage of Low Temperature Co-firing Ceramics (LTCC). The (P $b_{0.45}$C $a_{0.55}$)[F $e_{0.5}$N $b_{0.5}$)$_{0.9}$S $n_{0.1}$] $O_3$ceramics was sintered at 11$65^{\circ}C$. In order to decrease the sintering temperature, CuO and Cuo-B $i_2$ $O_3$ were added in the (Pb,Ca)[(Fe,Nb)Sn] $O_3$ with CuO-B $i_2$ $O_3$. For the addition of 0.4 wt.% CuO, the sintered density and the dielectric constant of the ceramics were revealed the maximum values of the 6.06g/c $m^2$ and 83 respectively and temperature coefficient of resonance frequency ($\tau$$_{f}$) shifted to the positive value. As increasing B $i_2$ $O_3$to the (Pb,Ca)[(Fe,Nb)Sn] $O_3$ with CuO-B $i_2$ $O_3$with 0.2 wt.% CuO, the sintered density, the $\varepsilon$$_{r}$ and the Q was decreased, and $\tau$$_{f}$ was minimized at 0.2 wt.% CuO, and 0.2 wt.% B $i_2$ $O_3$. For this composition, dielectric properties were $\varepsilon$$_{r}$ of 81, Q. $f_{0}$ of 4400 GHz, and $\tau$$_{f}$ of 5 ppm/$^{\circ}C$ at sintering temperature of 100$0^{\circ}C$. the relationship between the microstructure and properties of ceramics was studied by X-ray diffraction(XRD), scanning electron microscopy(SEM).copy(SEM).oscopy(SEM).copy(SEM).EM).

• Journal of Soil and Groundwater Environment
• /
• v.14 no.1
• /
• pp.51-60
• /
• 2009

A series of experiments was performed to develop an optimized analytical procedure for the analysis of explosives in soil by HPLC with soil samples collected at two live-fire military shooting ranges. The minimum amount of soil to be collected, Wmin, for the analysis of explosive compounds was 125g, based on the segregation and homogeneity constants that account for soil heterogeneity and non-homogeneous distribution of target explosive compounds. The optimization of extraction and HPLC analytical conditions were also studied based on analytes CV values. The most effective soil/ extractant ratio was estimated to be 10g-pretreated soil/20 mL acetonitrile as extractant. The optimized HPLC elution conditions for the separation of US EPA designated 14 explosive compounds, were column temperature 30${\circ}C$, eluents ratio of isopropanol: acetonitrile: water = 18 : 12: 70, and flow rate of 0.8 mUmin at 230 nm. However, UV wavelength 254 nm was better for the analysis of NB, 2,4-DNT, 2NT, 4NT, and 3NT.

• Journal of Sericultural and Entomological Science
• /
• v.50 no.1
• /
• pp.1-4
• /
• 2012

A new silkworm variety "DaeBakJam" for spring rearing season is F1 hybrid between Jam155, a japanese race bred from introduction breeding and Jam156, a chinese race from introduction breeding. In the local adaptability test performed at 8 local areas in spring of 2010, the hatchability rate of DaeBakJam was recorded 96% similar to DaePoongJam. The larval period was 3 hour shorter than DaePoongJam. The pupation percentage was recorded 0.2% higher than DaePoongJam. Single cocoon weight (2.72 g) and Cocoon yield (25.4 kg) was higher than DaePoongJam. The concentration of DNJ was measured 3.28 mg in DaePoongJam, lower than DaePoongJam (3.48 mg). Test of the artificial diet of DaeBakJam showed bad adaptability of the artificial diet for larval period from 1st to 3rd, but KumOkJam showed excellent adaptability of the artificial diet. In the Paecilomyces tenuipes production ability test, the pupal weight of DaeBakJam was 1.69 g/individual, higher than DaePoongJam (1.59 g/individual).

• Journal of the Korean Ceramic Society
• /
• v.39 no.2
• /
• pp.159-163
• /
• 2002

A single phase perovskite relaxor ferroelectric PMN-PT-BT was prepared by a single calcination and the modified mixed oxide process. It was accomplished by ball-milling PbO, $Nb_2O_5,\;Ti(OC_3H_7)_4,\;BaCO_3,\;and\;Mg(NO_3)_2$ instead of MgO, removing the solvent, and then followed by calcination at 900$^{\circ}C$ for 2h. The specimen sintered at 1100$^{\circ}C$/2h showed the sintered density of 7.83 g/$cm^3$, room temperature dielectric constant of 22000, and dielectric loss of 2.5%. Addition of 1.0 mole% (0.3 wt%) of Ag as $AgNO_3$ and followed by calcination at 550$^{\circ}C$/2h lowered the sintering temperature to 900$^{\circ}C$. It still showed the sintered density of 7.88 g/$cm^3$, room temperature dielectric constant of 20000 and dielectric loss of 2.4%.

• Korean Journal of Microbiology
• /
• v.55 no.1
• /
• pp.33-38
• /
• 2019

Ochratoxin A (OTA), one of mycotoxins produced mainly by Aspergillus is a common contaminant of stored grains, posing health hazards to human and livestock. The aim of this study is to explore ability of isolated bacteria Bacillus subtilis AF13 and Streptomyces shenzhenensis YR226 to remove OTA. AF13 and YR226 could remove 94.23 and 97.73% of OTA ($100{\mu}g/L$), respectively during 24 h incubation in NB medium. When cultures of two strains were separated into washed cells and cell-free supernatant, the supernatant of both strains removed more than 90% of $100{\mu}g/L$ OTA, and 98.88% of OTA could be also removed by the washed cells of YR226. OTA removal occurred in a few second by the supernatant of both strains, and treatments of autoclaving, proteinase K and chymotrypsin did not affect the OTA removal by the culture supernatants, which indicate that some thermostable and non-proteinaceous substances secreted by these bacteria may be involved in OTA removal in these two bacteria. These results suggest that AF13 and YR226 can be used to remove OTA from OTA-contaminated grains and feeds, and therefore decrease economic damage in agriculture and feed industry.

• Advances in Traditional Medicine
• /
• v.8 no.3
• /
• pp.260-265
• /
• 2008

Annona reticulata belonging to the family Annonaceae is traditionally used as anthelmintic and it is reported to have anticancer activity. Free radicals are known to be involved in various types of diseases like cancer, diabetes, neurological disorders etc. The present study was aimed to evaluate free radical scavenging property of methanol extract of the leaves of Annona reticulata in some in vitro models e.g. DPPH, nitric oxide, superoxide and lipid peroxide radical model. The extract showed good dose-dependent free radical scavenging property in all the models. $IC_{50}$ values were found to be 3.22, 170.01, 25.12 and $140.12\;{\mu}g/ml$ respectively in DPPH, nitric oxide, superoxide and lipid peroxidation inhibition assays. Reductive ability of the extract was also tested based on potassium ferricyanide reduction where dose dependant reducing capability was observed. Measurement of total phenolic compounds by Folin-Ciocalteu's phenol reagent indicated that 1mg of the extract contained $146.20\;{\mu}g$ equivalent of pyrocatechol. The findings ascertain promising free radical scavenging property of the extract and the antioxidant property of the extract may be due to the high content of phenolic compounds.

• Progress in Superconductivity
• /
• v.12 no.1
• /
• pp.12-16
• /
• 2010

We have measured the trapped field of YBCO bulk with different configuration by applying the magnetic field of $Nb_3Sn$ superconducting magnet. Initially the circular type of YBCO bulk superconductor was prepared and then hole, parallel to the c-axis and located at the center of bulk was mechanically drilled. The YBCO bulk with hole was filled with resin. Typical size of hole in YBCO bulk was 10 mm in diameter. Trapped field characteristics were compared with different specimen conditions. Our preliminary result indicates the increment rate of trapped field, 0.232 kG, measured on the YBCO without hole was much higher than that, 0.011 kG, measured on YBCO with hole.