• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.7
• /
• pp.1398-1405
• /
• 2016

As wireless sensor networks become eligible as well as useful in several controled systems where surrounding environments are likely to be monitored, their stabilization become important research challenge. Generally, stabilization is mostly dependent on reliability of sensing value. To achieve such reliability in wireless sensor networks, the most of previous research work have tendency to deploy the same type of multiple sensor units on one node. However, these mechanisms lead to deployment problem by increasing cost of sensor node. Moreover, it may decrease reliability in the operation due to complex design. In order to solve this problem, in this paper, we propose a new validation scheme which is based on prediction and frequency value. In the proposed scheme, we take into exceptional cases account, for example, outbreak of fire. Finally, we demonstrate that the proposed scheme can detect abnormal sensing value more than 13 percent as compared to previous work through diverse simulation scenarios.

• Journal of Sensor Science and Technology
• /
• v.23 no.6
• /
• pp.409-415
• /
• 2014

We had presented an inductive type intraocular pressure sensor (L-sensor) in previous work. The distance between a micro coil and a ferrite on the membrane was modulated by pressure, and as a result the inductance and resonant frequency were changed. However, L-sensor has some problems to implant in eyes. First problem is low sensitivity. When L-sensor was implanted in rabbit's eyes, resonant frequency of L-sensor was very hard to detect. Second problem is biocompatibility. Size of L-sensor is $6{\times}7{\times}1.2mm$. When L-sensor was implanted in the eyes, it caused the inflammation. Therefore, this study suggests an inductive and capacitive type IOP sensor (LCsensor). The sensitivity of the LC-sensor 27.3 kHz/mmHg under 60mmHg. It is much larger than 14 kHz/mmHg of the L-sensor. And the size of LC-sensor is 47% smaller than L-sensor. After 2 weeks from the implantation of LC-sensor into rabbit eyes, we measured the changes of resonant frequency of LC-sensor according to increased IOP by Balanced Salt Solution (BSS) injection. As a result, the sensitivity of LC-sensor in in vivo test is 25 kHz/mmHg. That is similar to the sensitivity of in vitro test.

• KIPS Transactions on Software and Data Engineering
• /
• v.4 no.9
• /
• pp.347-356
• /
• 2015

Due to the rapid development of IoT(Internet of Things) technology, traditional taxis are connected through dispatchers and location systems. Typically, modern taxis have embedded with GPS(Global Positioning System), which aims for obtaining the route information. By analyzing the frequency of taxi trip events, we can find the frequent route for a given query time. However, a scalability problem would occur when we convert the raw location data of taxi trip events into the analyzed frequency information due to the volume of location data. For this problem, we propose a NoSQL based top-K query system for taxi trip events. First, we analyze raw taxi trip events and extract frequencies of all routes. Then, we store the frequency information into hash-based index structure of MongoDB which is a document-oriented NoSQL database. Efficient top-K query processing for frequent route is done with the top of the MongoDB. We validate the efficiency of our algorithms by using real taxi trip events of New York City.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.25 no.3
• /
• pp.360-366
• /
• 2017

In commercial vehicles such as frame-based mid-size trucks, it is easy to reduce vibration caused by driveline with the cab mount system. There are no critical driveline vibration problems associated with these vehicles up to now. However, in the case of a similar grade of monocoque type mini-bus, there are no effective vibration isolation components such as a cab mount. Vibration caused by driveline is quite a complex problem to understand in terms of which part governs the phenomenon and how the problem can be solved. Thus, we have to manage the design factor about the driveline and mount system strictly at the early stage of vehicle development. Low frequency vibration caused by the driveline system is investigated in this study. We created the CAE driveline model and analyze low frequency vibration. Then contribution analysis about each design factor of driveline and mount system is performed. Finally, we can obtain the optimized design factor for a driveline system of a mini-bus, which is verified by the vehicle test results.

• The Journal of Engineering Geology
• /
• v.25 no.2
• /
• pp.281-290
• /
• 2015

Log density data were collected and compared with the core density data throughout the southern Korean Peninsula. The comparison reveals that the log densities obtained from gamma-gamma log are much lower than the core densities obtained from laboratory density measurement of core samples. The anomalously low log densities can be attributed to the small-source density log data. Correlation analysis reveals differences between densities derived from the two methods, indicating that a data quality problem arises when using small-source log data. The problem is probably due to the fact that small-source data have not been obtained under ideal conditions for maintaining the appropriate relationship between gamma response and formation density. The frequency distribution characteristics of formation density in the southern Korean Peninsula could be determined using the core and the standard-source log data which are well-correlated.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.1
• /
• pp.152-167
• /
• 2016

This paper investigates the simultaneous wireless information and power transfer (SWIPT) for two-hop orthogonal frequency division multiplexing (OFDM) decode-and-forward (DF) relay network, where a relay harvests energy from radio frequency signals transmitted by a source and then uses the harvested energy to assist information transmission from the source to its destination. The power splitting receiver is considered at the relay. To explore the performance limit of such a SWIPT-enabled system, a resource allocation (RA) optimization problem is formulated to maximize the achievable information rate of the system, where the power allocation, the subcarrier pairing and the power splitting factor are jointly optimized. As the problem is non-convex and there is no known solution method, we first decompose it into two separate subproblems and then design an efficient RA algorithm. Simulation results demonstrate that our proposed algorithm can achieve the maximum achievable rate of the system and also show that to achieve a better system performance, the relay node should be deployed near the source in the SWIPT-enabled two-hop OFDM DF relay system, which is very different from that in conventional non-SWIPT system where the relay should be deployed at the midpoint of the line between the source and the destination.

• Journal of Korea Multimedia Society
• /
• v.10 no.8
• /
• pp.958-966
• /
• 2007

In this paper, we implement a sound-enhanced MPEG-1 audio decoder on embedded OS Platform. Low bit rate lossy audio codecs such as MP3, OGG, and AAC for mitigating the problems in storage space and network bandwidth suffer a major common problem such as a loss of high frequency fidelity of audio signal. This high frequency loss will reproduce only a band-limited low-frequency part of audio in the standard CD-quality audio. In order to overcome this problem, we embedded a sound enhancement algorithm into the MPEG-1 audio decoder and then the algorithms optimized according to the characteristic of the MPEG-1 audio layer I, II, III were implemented on an embedded OS platform. From the experimental results with spectrum analysis and listening test, we confirm the superiority of the proposed system compared to the standard MPEG-1 audio decoder.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.17 no.1
• /
• pp.100-113
• /
• 2018

The Proximity Service, which is one of the most popular network capacity improvement methods, uses the frequency reuse in order to increase the frequency efficiency. As a result, inter-cell interference between cellular and proximity service users occurs at a cell edge. In this paper, we proposed a mitigation scheme for inter-cell interference, where we suggested a new function of and eNB with ProSe function exchanging information about ProSe parameters and ProSe user equipment with neighboring cells via the X2 interface. As the first step, the resource which did not cause the inter-cell interference problem were pre-allocated through the frequency sensing in the ProSe direct discovery. As the next step, the inter-cell interference problem was solved by reallocating appropriate resources based on the ProSe application code, the ProSe application QoS, the ProSe application ID and validity timer in ProSe direct communication.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.9
• /
• pp.930-937
• /
• 2014

Inverse synthetic aperture radar (ISAR) images can be generated by radar which radiates the electromagnetic wave to a target and receives signal reflected from the target. ISAR images can be widely used to target detection and recognition. This paper proposed a method of generation of high resolution ISAR images by synthesizing frequency spectrums of each stepped chirp waveform in one burst and sub-sampling in frequency domain. This process is performed over entire bursts during coherent processing interval. Conventional ISAR image generation method using stepped frequency waveform has a severe problem of short unambiguous range, loading to ghost phenomenon. However, this problem can be resolved by the proposed method. In simulations, we generate high resolution ISAR image of the moving target which is Boeing-737 aircraft model composed of several ideal point scatterers.

• Geophysics and Geophysical Exploration
• /
• v.24 no.4
• /
• pp.164-170
• /
• 2021

Frequency-domain and time-domain induced polarization methods can provide spectral information about subsurface media. Analysis of spectral characteristics has been studied mainly in the frequency-domain, however, time-domain induced polarization research has recently become popular. In this study, assuming a homogeneous half-space model, an inversion method was developed to extract Cole-Cole parameters from the measured secondary potential or electrical resistivity. Since the Cole-Cole parameters of chargeability, time constant, and frequency index are not independent of each other, various problems, such as slow convergence rate, initial model problem, local minimum problem, and divergence, frequently occur when conventional nonlinear inversion is applied. In this study, we developed an effective inversion method using the initial model close to the true model by introducing a grid search method. Finally, the validity of the developed inversion method was verified using inversion experiments.