• Transactions of the Korean Society of Mechanical Engineers B
• /
• 제29권10호
• /
• pp.1092-1100
• /
• 2005

In the present study, characteristics of steady state laminar flows of a straight duct connected to a 180$^{o}$ curved duct were examined in the entrance region through experimental and numerical analyses. For the analysis, the governing equations of laminar flows in the Cartesian coordinate system were applied. Flow characteristics such as velocity profiles and secondary flows were investigated numerically and experimentally in a square cross-sectional straight duct by the PIV system and a CFD code(STAR CD). For the PIV measurement, smoke particles produced from mosquito coils. The experimental data were obtained at 9 points dividing the test sections by 400 3m. Experimental and numerical results can be summarized as follows. 1) Reynolds number, Re was increased, dimensionless velocity profiles at the outer wall were increased due to the effect of the centrifugal force and secondary flows. 2) The intensity of a secondary flow became stronger at the inner wall rather than the outer wall regardless of Reynolds number. Especially, fluid dynamic phenomenon called conner impact were observed at dimensionless axial position, x/D$_{h}$=50.

• Journal of the Korean Society of Marine Environment & Safety
• /
• 제18권5호
• /
• pp.455-460
• /
• 2012

In this paper, an experimental and numerical investigation of transition characteristics in a square-sectional curved duct flow under Centrifugal force is presented. The experimental study is carried out to measure axial velocity profiles by using Laser Doppler Velocimeter (LDV) system. Computational fluid dynamic (CFD) simulation was performed using the commercial CFD code FLUENT to investigate the transition characteristics. The flow development is found to depend upon Dean number and curvature ratio. The velocity profiles in center of the duct have lower value than those of the inner and outer walls because of the centrifugal forces.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• 제22권9호
• /
• pp.1335-1348
• /
• 1998

Flow characteristics in transitional boundary layers on a flat plate were experimentally investigated under three different freestream conditions i. e. uniform flow with 0.1 % and 3.7% freestream turbulent intensity and cylinder-wake with 3.7% maximum turbulent intensity. Instantaneous streamwise velocities in laminar, transitional and turbulent boundary layers were measured by I-type hot-wire probe. For estimation of wall shear stresses on the flat plate, measured mean velocities near the wall were applied to the principle of Computational Preston Tube Method (CPM). Distributions of skin friction coefficients were reasonably predicted in all developed boundary layers. Intermittency profiles, which were estimated using Conditional Sampling Technique in transitional boundary layers, were also consistent with previously published data. It was predicted that the incoming turbulent intensity had more influence on transition onset point and transition process than freestream turbulent intensity existed just over the transition region. It was also confirmed that non-turbulent and turbulent profiles in transitional boundary layers could not be simply treated as Blasius and fully turbulent profiles.

• Proceedings of the SAREK Conference
• /
• 대한설비공학회 2006년도 하계학술발표대회 논문집
• /
• pp.773-778
• /
• 2006

Velocity profiles inside a partially filled pipline have been investigated experimentally. To measure the velocity fields, a particle image velocimetry (PIV), which is a recent quantitative visualization technique, is applied. The velocity profile inside a circular pipe is well known, but if the pipe is partially filled, the problem is entirely different in the sense that the velocity distribution is significantly affected by the slope of pipe and filled water level, and so on. In order to calculate exact flow rate in the open channel or partially filled pipeline, three-dimensional velocity distributions at a given cross-sectional area are measured and compared the flow rates with the previously known empirical formula of Manning equation. The results show that the velocity profiles at center plane is considerably different from each other when the slope and water level change. Thus, The three-dimensional velocity profile can be the most plausible estimate for the exact flow rate.

• Advances in concrete construction
• /
• 제15권4호
• /
• pp.241-249
• /
• 2023

The unsteady mixed convection Casson type MHD nanofluid flow in the stagnation point with motile microorganism around a spinning sphere is investigated. Time dependent flow dynamics is considered. Similarity transformations have been employed to transfer the governing partial differential structure into ordinary differential structure. The impact of distinct parameters is examined via tables and graphs. The impact of rotational parameter (spin) on profiles of velocity profiles, temperature and concentration is revealed for unsteady mixed convection Casson type MHD nanofluid flow. It is observed that it is clear that rotational parameter has a great effect on non-dimensional primary velocity component but rotational parameter has a slight impact on non-dimensional secondary velocity component. The validity of the current investigation is authorized through comparing the existing outcomes with previous published literature.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• 제14권3호
• /
• pp.222-231
• /
• 2002

The ADP is an advanced piece of oceanographic equipment that measures water speed and direction profiles from the acoustic Doppler principle. In recent years, the strength of the acoustic backscatter obtained from ADP has been used to measure vertically suspended sediment concentration(SSC) profiles. In this study, an ADP was installed in coastal waters near Yumsan, on the west coast of Korea, and flow and sediment data were gathered simultaneously. SSC concentrations were calculated from the acoustic backscatter strengths adjusted by using calibrated acoustic coefficients. The observed SSC profiles were compared with analytical solutions and showed good agreement. Simultaneously, the suspended material fluxes were analyzed in detail. ADP was very useful for measuring the vertically distributed suspended sediment concentrations and flow velocity profiles.

• Journal of the Korean Society of Propulsion Engineers
• /
• 제2권2호
• /
• pp.30-37
• /
• 1998

This paper investigates the linear stability of wakes with special emphasis on the effect of chemical reaction. Velocity and density profiles for laminar flows are obtained from analytic profiles as well as from simulation. Wakes have two generalized inflection points and two unstable modes-sinuous and varicose modes. For analytical laminar profiles, sinuous modes are more unstable than varicose modes irrespective of density variation, which shows wakes will be destabilized by sinuous modes. Large velocity difference and density difference lead to more unstable wakes due to large momentum difference. For simulated laminar profiles, chemical reaction with stoichiometric chemistry increases temperature and stabilizes the flow due to increase in compressible reacting wades, flow becomes stable as velocity increases due to viscous dissipation.

• International Journal of Vascular Biomedical Engineering
• /
• 제1권1호
• /
• pp.24-31
• /
• 2003

As endothelial cells are subject to flow shear stress, it is important to determine the detailed velocity distribution in microvessels in the study of mechanical interactions between blood and endothelium. This paper describes a velocity field of the arteriole in the rat mesentery using an intravital microscope and high-speed digital video system obtained by a highly accurate PIV technique. Red blood cells (RBCs) velocity distributions with spatial resolutions of $0.8{\times}0.8{\mu}m$ were obtained even near the wall in the center plane of the arteriole. By making ensemble-averaged time-series of velocity distributions, velocity profiles over different cross-sections were calculated for comparison. The shear rate at the vascular wall also evaluated on the basis of the ensemble-averaged profiles. It was shown that the velocity profiles were blunt in the center region of the vessel cross-section while they were steep in the near wall region. The wall shear rates were significantly small, compared with those estimated from the Poiseuille profiles.

• Transactions of the Korean Society of Mechanical Engineers
• /
• 제12권2호
• /
• pp.349-358
• /
• 1988

Natural convection velocity and temperature profiles are obtained approximately in the core at boundary layer flow regime for varying Prandtl number in a low aspect ratio rectangular Enclosure. Analysis is based on the formally obtained core flow equations using the multiple scales method. Results show good agreement with the existing works for $P_{r}$ ~ 1. No comparison, however, is possible yet for $P_{r}$ >> 1 and $P_{r}$ < 1 due to the lack of available date. It is shown here that boundary layer flow regimes are governed by two parameters, A $R_{a}$$^{1}$4/ and A( $P_{r}$ $R_{a}$)$^{1}$4 for $P_{R}$.geq. 1 and $P_{r}$ < 1 respectively.ely.ively.ely.y.

• Ocean Science Journal
• /
• 제43권2호
• /
• pp.81-90
• /
• 2008

A study of estuarine flows during a neap tide was performed using 13-hour roving acoustic Doppler current profiles (ADCP) and conductivity-temperature-depth (CTD) profiles in the Altamaha River estuary, Georgia, U.S.A. The least-squared harmonic analysis method was used to fit the tidal ($M_2$) component and separate the flow into two components: the tidal and residual ($M_2$-removed) flows. We applied this method to depth-averaged data. Results show that the $M_2$ component demonstrates over 95% of the variability of observation data. As the flow was dominated by the $M_2$ tidal component in a narrow channel, the tidal ellipse distribution was essentially a back-and-forth motion. The amplitude of $M_2$ velocity component increased slightly from the river mouth (0.45 m/sec) to land (0.6 m/sec) and the phase showed fairly constant values in the center of the channel and rapidly decreasing values near the northern and southern shoaling areas. The residual flow and transport calculated from depth-averaged flow shows temporal variability over the tidal time scale. Strong landward flows appeared during slack waters which may be attributed to increased baroclinic forcing when turbulent mixing decreases.